⏱️ Ten-minute starters — Foundation

Answer key

1. (d) 3 : 2 : 5 — The highest common factor of 45, 30 and 75 is 15. Divide each part by 15: 45 ÷ 15 = 3, 30 ÷ 15 = 2 and 75 ÷ 15 = 5, giving 3 : 2 : 5. Giving 9 : 6 : 15 divides by 5, a common factor but not the highest one. Giving 15 : 10 : 25 divides by 3 only, even further from simplest form. Giving 2 : 3 : 5 has the first two parts swapped.
2. (b) Interpolation — The salary is being estimated for a value of x between 1 and 15, which is inside the range of x-values that were actually plotted, so this is interpolation. Extrapolation would apply if the estimate used a value of x below 1 or above 15, outside the plotted range. Correlation describes the relationship between the two variables, not the reliability of an estimate, and causation describes one variable actually causing a change in the other, which is a different idea altogether — neither is the word being asked for here.
3. (b) −3 — Method: the gradient of a straight line is the change in y divided by the change in x, with the two coordinates taken in the same order in the numerator as in the denominator. Working: going from (−1, 5) to (3, −7), the change in y is −7 − 5 = −12 and the change in x is 3 − (−1) = 4, so the gradient is −12 ÷ 4 = −3. Answer: −3. The distractors: 3 comes from subtracting the y-coordinates in one order and the x-coordinates in the other, giving 12 ÷ 4; −1/3 comes from dividing the change in x by the change in y instead of the other way round, giving 4 ÷ (−12); −6 comes from working out 3 − (−1) as 3 − 1 = 2, so that the change in y is divided by 2 rather than by 4.
4. (a) 216 — The cube numbers are formed by cubing 1, 2, 3, 4, 5, ..., so the next one is 6³ = 216. A candidate who squares 6 instead of cubing it gets 6² = 36. A candidate who assumes the sequence doubles each time gets 125 × 2 = 250. A candidate who uses 5 × 6² instead of 6 × 6 × 6 gets 180.
5. (b) (60 + 4.5π) cm² — Method: find the area of the rectangle and the area of the semicircle separately, then add them. Working: the rectangle has area 10 × 6 = 60 cm². The semicircle has radius 3 cm, so its area is half of π × 3² = half of 9π = 4.5π cm². Total area = (60 + 4.5π) cm². Answer: (60 + 4.5π) cm². (60 + 18π) cm² comes from using the diameter (6 cm) as the radius in the semicircle area formula: half of π × 6² = 18π. (60 + 9π) cm² comes from forgetting to halve the full circle's area: π × 3² = 9π. (60 + 3π) cm² comes from finding the semicircle's arc length instead of its area: half of 2 × π × 3 = 3π.
6. (c) 3 — Gradient = (change in y) ÷ (change in x) = (11 − 5) ÷ (4 − 2) = 6 ÷ 2 = 3. A candidate who puts the change in x over the change in y instead would get 2 ÷ 6 = 1/3. A candidate who subtracts the y-coordinates in the reverse order, but not the x-coordinates, would get (5 − 11) ÷ (4 − 2) = −3. A candidate who adds the coordinates instead of subtracting them would get (11 + 5) ÷ (4 + 2) = 16/6 = 8/3.
7. (c) 8 — Method: substitute x = 3 into each expression in turn, working out the bracket first in the expression that has one and the multiplication first in the expression that does not. Working: 2(x + 1) gives 2 × (3 + 1) = 2 × 4 = 8, and 2x + 2 gives 2 × 3 + 2 = 6 + 2 = 8, so both expressions take the value 8, as Grace claims. Answer: 8. The distractors: 7 comes from multiplying only the x inside the bracket and then adding the 1, giving 2 × 3 + 1; 10 comes from reading 2x + 2 as 2(x + 2) and working out 2 × 5; 6 comes from substituting into 2x and stopping before the 2 is added.
8. (d) (4, 3) — The sides are parallel to the axes: the missing vertex must share the y-coordinate 3 with (−2, 3) and the x-coordinate 4 with (4, −3), giving (4, 3). (−4, 3) comes from a sign error on the x-coordinate. (4, −9) comes from continuing the pattern of the given points by subtracting 6 from the y-coordinate again instead of matching it to (−2, 3). (3, 4) comes from swapping the x- and y-coordinates.
9. (d) 1.2 × 10⁵ — 4 × 3 = 12, and 3 + 1 = 4, giving 12 × 10⁴ — but 12 is not between 1 and 10, so this must be rewritten as 1.2 × 10⁵. Stopping at 12 × 10⁴ without rewriting it leaves the coefficient out of range. Rewriting 12 as 1.2 but leaving the exponent at 4 instead of increasing it to 5 gives 1.2 × 10⁴, which is ten times too small. Adding the coefficients instead of multiplying them gives 4 + 3 = 7, so 7 × 10⁴.
10. (b) 8.5 m — First apply the scale to convert the plan length to a real length in centimetres: 3.4 × 250 = 850 cm. Then convert centimetres to metres by dividing by 100: 850 ÷ 100 = 8.5, so the wall is 8.5 m long. Choosing 850 m applies the scale correctly but forgets to convert the answer from centimetres into metres. Choosing 0.85 m divides by 1000 instead of 100, confusing the centimetre-to-metre conversion with a metre-to-kilometre one. Choosing 3.4 m ignores the scale factor completely and just restates the plan length as if it were already the real length.
11. (c) 090 — Method: bearings are measured clockwise from north; east is a quarter turn clockwise. Working: a quarter turn is 90°, written with a leading zero as three figures. A student who answers 009 has kept the correct digits but put the leading zero in the wrong place. A student who answers 180 has confused east with south. A student who answers 270 has confused east with west. Answer: 090.
12. (d) 3.75 — 45 minutes is 45 ÷ 60 = 0.75 of an hour, so 3 hours 45 minutes = 3.75 hours. Getting 3.45 comes from writing the minutes directly after the decimal point instead of converting them to a fraction of an hour. Getting 3.67 comes from misreading 45 minutes as 40 minutes and converting 40 ÷ 60 instead. Getting 4.15 comes from rounding 45 minutes up to the next whole hour and adding the remainder as if it were more minutes past that hour.