⏱️ Ten-minute starters — Foundation

Answer key

1. (b) 3p — p + p + p means three lots of p added together, and repeated addition of the same term is written as a coefficient: 3p. Writing p³ mistakes the repeated addition for repeated multiplication, as if the expression had been p × p × p. Writing 3 + p adds the number of terms (3) onto p as a separate constant, instead of writing 3 as a coefficient of p. Writing just p forgets to count the terms at all, as though repeating the same letter makes no difference. The simplified expression is 3p.
2. (c) 4 × 10⁴ — 8 ÷ 2 = 4, and 6 − 2 = 4, so each project receives 4 × 10⁴ pounds. Multiplying the exponents instead of subtracting them gives 6 × 2 = 12, so 4 × 10¹². Adding the exponents instead of subtracting them gives 6 + 2 = 8, so 4 × 10⁸. Subtracting the coefficients instead of dividing them gives 8 − 2 = 6, so 6 × 10⁴.
3. (c) y = −x + 30 — Method: in a linear model the value at the start is the constant term and the steady rate of change is the gradient, which is negative when the quantity is falling. Working: at x = 0 the candle is 30 cm tall, so the constant term is 30; it loses 1 cm every hour, so the gradient is −1 and the height after x hours is y = −x + 30. Answer: y = −x + 30. The distractors: y = x + 30 comes from taking the rate as +1 and making the candle grow rather than shrink; y = 30x − 1 comes from building the model correctly as 30 − 1x and then copying it into the form y = mx + c with the two numbers left where they stood, so the starting height 30 ends up multiplying x and the hourly 1 is left behind as the constant being taken away; y = −30x + 1 comes from reading the two numbers the other way round, taking 30 cm per hour as the rate and 1 cm as the starting height, which burns 30 cm an hour from a candle only 1 cm tall.
4. (a) (5, 7) — Method: a midpoint is the mean of the two end points, so for each coordinate (start + end) ÷ 2 = midpoint; rearranging that gives end = 2 × midpoint less the start. Working: for x, (1 + x) ÷ 2 = 3, so 1 + x = 6 and x = 5. For y, (3 + y) ÷ 2 = 5, so 3 + y = 10 and y = 7. B is therefore (5, 7). Answer: (5, 7). The distractors: (2, 2) comes from subtracting A from the midpoint, (3 − 1, 5 − 3), which gives the step from A to the midpoint and stops there instead of taking that same step a second time; (4, 8) comes from adding A to the midpoint, (3 + 1, 5 + 3), without doubling the midpoint first; (6, 10) comes from doubling the midpoint, (2 × 3, 2 × 5), and then forgetting to take A off.
5. (b) 22.8% — Relative frequency as a percentage is the faulty count divided by the total, then multiplied by 100: 33 ÷ 145 × 100 = 22.76, which rounds to 22.8%. Giving 33.0% as the answer uses the frequency, 33, directly as a percentage without dividing by the total 145 at all. Rounding 22.76 down to 22.7% instead of up applies the wrong rounding direction at the first decimal place. Finding the relative frequency of the bulbs that were NOT faulty first: 145 − 33 = 112, and 112 ÷ 145 × 100 = 77.24, answers the opposite question and rounds to 77.2%.
6. (c) 67 — Method: the mean is the total of the values divided by how many values there are, so add first and divide second. Working: the total is 50 + 83 + 68 = 201 points and three matches were played, so the mean is 201 ÷ 3 = 67 points. Answer: 67. The distractors: 68 comes from writing down the median, the middle value of 50, 68, 83, instead of the mean; 33 comes from working out the range, 83 − 50, which measures spread and not centre; 100.5 comes from dividing the total by 2 instead of by the 3 matches played.
7. (a) 31.4 — Method: first find the circumference of one turn using π × diameter, then multiply by the number of turns. Working: circumference = 3.14 × 0.5 = 1.57 m; total distance = 1.57 × 20 = 31.4 m. A student who answers 15.7 has mistakenly halved the diameter again before multiplying, using 0.25 m instead of 0.5 m. A student who answers 3.14 has simply written down π itself, without completing the circumference or multiplying by the number of turns. A student who answers 62.8 has mistakenly doubled the diameter to 1 m before multiplying, treating the given length as a radius. Answer: 31.4 m.
8. (a) 4:3:1 — Convert every part to the same unit: 2 m = 200 cm, so the ratio is 200 : 150 : 50. Dividing all three parts by 50 gives 4 : 3 : 1. Writing 2 : 150 : 50 has not converted 2 m into centimetres, so the units do not match. Writing 3 : 4 : 1 has the first two parts the wrong way round. Writing 4 : 3 : 2 comes from an arithmetic slip on the last part: 50 ÷ 50 = 1, not 2.
9. (a) The median, as the one very large wage does not move it — Method: an average describes a population well when it sits close to most of the values, so compare what each average does when one value lies far from the rest. Working: in order the wages are 420, 440, 460, 480 and 1,500, so the median is the third of the five, £460. The mean uses every wage: 420 + 440 + 460 + 480 + 1,500 = 3,300 and 3,300 ÷ 5 = 660, so the mean is £660. Four of the five people earn less than £660, and the nearest of those four wages is £180 below it, so £660 describes nobody at the garage; £460 sits inside the group of four similar wages. Answer: the median, as the one very large wage does not move it, while that same wage drags the mean £200 above the median. The distractors: saying the median is always larger than the mean is an invented rule, and here the median £460 is smaller than the mean £660; saying the mean is the only average that uses all five wages is true as far as it goes, but using a value and being dragged by it are the same thing when that value is £1,500; saying £660 lies between the smallest and largest wage is true of every mean ever calculated, so it proves nothing about whether this one is typical.
10. (a) 15:1 — Write the ratio distance : petrol using the numbers in the question: 90 : 6. Divide both parts by their highest common factor, 6, to give 15 : 1. (1:15 comes from writing the ratio the wrong way round, petrol : distance. 5:2 comes from dividing only the distance by 6 and leaving the 6 litres unchanged, giving 15:6, which does simplify to 5:2 — the error is the step before, because both parts of a ratio must be divided by the same number. 14:1 comes from subtracting at the first step instead of dividing, 90 − 6 = 84, and then writing 84 : 6 and dividing both parts by 6 to get 14 : 1; subtracting has no part in simplifying a ratio.)
11. (c) t = 1 second and t = 5 seconds — The ball is at ground level when h = 0, which happens when either bracket is zero. t − 1 = 0 gives t = 1, and 5 − t = 0 gives t = 5. The option with t = −1 makes a sign error solving the first bracket. The option with t = −5 makes a sign error solving the second bracket, treating 5 − t = 0 as if it gave a negative solution. The option with t = 4 seconds is an arithmetic slip in solving 5 − t = 0.
12. (c) 45 — Three of the ten numbers (8, 9 and 10) are greater than 7, so the probability is 3/10, and 150 × 3/10 = 45. Writing 105 is wrong because 150 × 7/10 = 105 uses the seven numbers that are NOT greater than 7 (1 to 7), the opposite of what is asked. Writing 60 is wrong because it counts 7, 8, 9 and 10 as four numbers greater than 7, wrongly including 7 itself: 150 × 4/10 = 60. Writing 50 is wrong because 150 ÷ 3 = 50 divides by the count of favourable numbers instead of multiplying by the correct fraction of the spinner. The expected number of spins landing on a number greater than 7 is 45.