⏱️ Ten-minute starters — Foundation

Answer key

1. (b) 14 — Substitute n=4 into 3n+2: 3×4+2=14. A candidate who adds 3 and n instead of multiplying would compute 3+4+2=9. A candidate who substitutes the wrong term number, n=3, would reach 3×3+2=11. A candidate who forgets to add the constant term would compute just 3×4=12.
2. (b) The relative frequency is settling near 0.5 — Method: turn each result into a relative frequency before comparing them, because it is the relative frequency, and not the difference between the two counts, that tends towards the theoretical probability. Working: after 10 flips the relative frequency of a head is 7 ÷ 10 = 0.7, which is a long way from 0.5. After 1000 flips it is 528 ÷ 1000 = 0.528, which is much closer to 0.5. Meanwhile the gap between the two counts has grown rather than shrunk: it was 7 − 3 = 4 after 10 flips and is 528 − 472 = 56 after 1000 flips. Answer: the relative frequency is settling near 0.5, which is what an unbiased experiment does as the sample grows. The distractors: saying the counts are levelling out is the usual form of this idea and the figures contradict it, since the gap went from 4 to 56; saying the coin is biased treats 28 extra heads in 1000 flips as proof, when 0.528 sits close to 0.5 and a fair coin gives results like this often; saying the next flip is more likely to be a tail is the gambler's fallacy, since each flip stays at 1/2 whatever came before.
3. (d) £8262 — A fall of 15% is a multiplier of 0.85 and a fall of 10% is a multiplier of 0.9, and each multiplier acts on the value at the start of its own year. After year 1: 12000 × 0.85 = 10200. After year 2: 10200 × 0.9 = 9180. After year 3: 9180 × 0.9 = 8262. The value 3 years after the car was bought is £8262. Adding the percentages to make a single fall of 35% would be wrong, because the later falls are taken from smaller values.
4. (b) 5 m — Method: the brace, the width and the height form a right-angled triangle in which the brace faces the right angle, so it is the hypotenuse and Pythagoras' theorem applies, a² + b² = c². Working: c² = 3² + 4² = 9 + 16 = 25, so c = √25 = 5. Answer: 5 m. The distractors: 7 m comes from adding the two sides, 3 + 4, instead of adding their squares; 25 m comes from stopping at c² = 25 and forgetting to take the square root; 12 m comes from multiplying 3 × 4, which gives the area of the gate in square metres and not a length across it.
5. (b) 3n + 1 — Method: find how many more tiles each pattern uses, then find the constant by adjusting pattern 1's total. Working: each pattern uses 3 more tiles than the last, so the coefficient of n is 3. The constant is pattern 1's total minus the common difference: 4 − 3 = 1. Answer: the nth term is 3n + 1. 3n + 4 comes from using pattern 1's total, 4, as the constant without subtracting the common difference. 3n − 2 comes from a slip in working out the constant, subtracting the common difference twice (4 − 3 − 3 = −2) instead of once. n + 3 comes from swapping the common difference and the constant.
6. (a) 5.8 — The horizontal distance is 3 and the vertical distance is 5, so using Pythagoras' theorem the distance is √(3² + 5²) = √34 = 5.8 (1 d.p.). A candidate who adds the two differences instead of using Pythagoras gets 3 + 5 = 8.0. A candidate who works out 3² + 5² = 34 but forgets to take the square root gets 34.0. A candidate who subtracts the squares instead of adding them gets √(5² − 3²) = √16 = 4.0.
7. (a) 0.62 miles — The gradient of the line is the change in miles divided by the change in kilometres: 31 ÷ 50 = 0.62, so 1 kilometre converts to 0.62 miles. Dividing the wrong way round, 50 ÷ 31 = 1.612..., rounds to 1.61 miles — that finds how many kilometres are in 1 mile, not the reverse. Doubling the gradient, 1.24 miles, comes from using 62 ÷ 50 instead of 31 ÷ 50. Reading off the y-coordinate of the given point without dividing by the x-coordinate gives 31.00 miles, which is the number of miles for 50 kilometres, not for 1 kilometre.
8. (c) £9.70 — F = 2.50 + 1.20 × 6 = 2.50 + 7.20 = £9.70. £7.20 comes from forgetting to add the £2.50 fixed charge. £10.20 comes from adding the 2.50 to the number of miles before multiplying by 1.20, 1.20 × (6 + 2.50). £22.20 comes from adding the fixed charge and the rate together first and then multiplying by the miles, (2.50 + 1.20) × 6.
9. (a) 7.7 m — AB is parallel to DC, so those two sides are each parallel to another side. BC and AD are stated to be not parallel to each other, so neither one is parallel to any other side — these are the two sides that need edging. Adding these: 3.2 + 4.5 = 7.7 m, so 7.7 m is correct. 7.6 m comes from an arithmetic slip when adding 3.2 and 4.5. 15.4 m comes from doubling the correct total, mistakenly assuming edging strip is needed along both faces of each side. 4.5 m comes from using only the longer of the two non-parallel sides and forgetting to add the shorter one.
10. (b) 750,000,000 — Method: multiplying by 10⁸ moves the decimal point eight places to the right, and every empty place is filled with a zero. Working: 10⁸ = 100,000,000, and moving the decimal point in 7.5 eight places to the right gives 7.5 × 100,000,000. Answer: 750,000,000. The distractors: 7,500,000,000 comes from removing the decimal point first to make 75 and then writing eight zeros after it, which carries the digits one place too far; 600 comes from reading 10⁸ as 10 × 8 = 80 and working out 7.5 × 80; 0.000000075 comes from moving the decimal point eight places to the left, as though the index were negative.
11. (c) 70 cm — Method: convert the real length to centimetres, then divide by the scale factor. Working: 84 m = 8400 cm. 8400 ÷ 120 = 70 cm. Wrong options: 0.7 cm comes from dividing 84 by 120 without converting metres to centimetres; 1,008,000 cm comes from multiplying instead of dividing (8400 × 120); 7 cm comes from converting 84 m to 840 cm (using ×10 instead of ×100) before dividing.
12. (c) (2, 5) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate: Q = (2, 5). (−2, −5) comes from reflecting in the y-axis instead, which changes the sign of the x-coordinate. (−2, 5) comes from reflecting in both axes. (2, −5) comes from not applying the reflection at all.