⏱️ Ten-minute starters — Foundation

Answer key

1. (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
2. (c) base angles of an isosceles triangle are equal — Because AB = AC, triangle ABC is isosceles, and the base angles of an isosceles triangle — the two angles opposite the equal sides — are always equal, which is why angle C equals angle B, 70°. Angles in a triangle adding up to 180° is a true fact about the triangle as a whole, but it is not the reason two specific angles are equal to each other. Corresponding angles are equal is a fact about parallel lines cut by a transversal, which does not apply inside a single triangle like this. Vertically opposite angles are equal is a fact about two lines crossing, not about a triangle's base angles.
3. (d) 4 — Method: collect the x terms on one side and the number terms on the other. Working: subtract 3x from both sides: 4x − 5 = 11. Add 5 to both sides: 4x = 16. Divide by 4: x = 4. Answer: 4. 0.6 comes from adding the x terms instead of subtracting when collecting them, 7x + 3x = 10x, and also subtracting the constants the wrong way round, 11 − 5 = 6, giving 10x = 6. 1.5 comes from correctly collecting the x terms as 4x but subtracting the constants the wrong way round, 11 − 5 instead of 11 + 5. −4 comes from moving the x terms to the wrong side, giving 3x − 7x instead of 7x − 3x, along with a matching sign error on the constants.
4. (d) 71° — Alternate angles between parallel lines are equal. Since angle HMN and angle MNK are alternate angles, angle MNK = angle HMN = 71°.
5. (c) 5 × 10⁻³ — Method: in standard form the coefficient must be at least 1 and less than 10, and for a number smaller than 1 the index is negative and counts the places the decimal point moves to the right. Working: the only significant digit is 5, so the coefficient is 5; moving the decimal point in 0.005 three places to the right gives 5, so the index is −3. Answer: 5 × 10⁻³. The distractors: 0.5 × 10⁻² is the same value written the wrong way, because 0.5 is smaller than 1 and so is not an allowed coefficient; 5 × 10⁻² comes from counting the two zeros after the decimal point instead of the three places the point moves; 5 × 10³ comes from taking the index as positive, which describes a number in the thousands rather than one smaller than 1.
6. (b) (5, −2) — Method: subtract column vectors by subtracting the bottom vector's top number from the top vector's top number, and doing the same for the bottom numbers. Working: top numbers 7 − 2 = 5; bottom numbers 3 − 5 = −2. Answer: u − v = (5, −2). A candidate who drops the negative sign gets (5, 2). A candidate who works out v − u instead of u − v gets (−5, 2). A candidate who adds instead of subtracts gets (9, 8).
7. (a) 8 — Both points share the x-coordinate, so the distance between them is the difference between the y-coordinates: 3 − (−5) = 8. A candidate who mistakenly uses the equal x-coordinates instead of the y-coordinates gets 4 − 4 = 0. A candidate who adds the y-coordinates instead of subtracting them gets 3 + (−5) = −2. A candidate who reads off only point B's y-coordinate as the distance gets 3.
8. (b) 2 — A rhombus is a special parallelogram, so opposite sides are parallel — that is two pairs of parallel sides. A quadrilateral with only one pair of parallel sides is a trapezium, not a rhombus, so 1 is wrong. A kite has 0 pairs of parallel sides, not a rhombus. There are only two pairs of opposite sides in a quadrilateral altogether, so 4 is not possible. The correct answer is 2.
9. (b) 1 — Method: for data in a frequency table, find the position of the median using (n + 1) ÷ 2, then read off the value at that position from the cumulative frequencies. Working: there are 19 pupils, so the median is the 10th value. The cumulative frequencies are 7 (up to 0 pets), 10 (up to 1 pet), 14 (up to 2 pets) and 19 (up to 3 pets). The 10th value falls at the end of the '1 pet' group, so the median is 1 pet. Giving 0 pets is the mode — the category with the highest frequency, 7 — not the median. Giving 3, the highest number of pets minus the lowest, finds the range, a different statistic entirely. Giving 19 states the total number of pupils, not a number of pets at all. Find the middle POSITION first, then read off the value it belongs to — do not confuse it with the mode, the range or the total.
10. (c) 80 cm² — Method: a composite shape made of two rectangles that do not overlap has an area equal to the sum of the two rectangle areas, so work out each area and add them. Working: the first rectangle has area 12 × 4 = 48 cm² and the second has area 4 × 8 = 32 cm², so the total is 48 + 32 = 80. Answer: 80 cm². The distractors: 48 cm² comes from working out the larger rectangle only and treating it as the whole shape; 32 cm² comes from working out the smaller rectangle only; 28 cm comes from adding the four given lengths, 12 + 4 + 4 + 8, which is a distance rather than an area and so carries a plain centimetre unit.
11. (a) 2978 — A rise of 6% is a multiplier of 1.06, applied once for each year. After year 1: 2500 × 1.06 = 2650. After year 2: 2650 × 1.06 = 2809. After year 3: 2809 × 1.06 = 2977.54, which is 2978 to the nearest whole number. Multiplying by 1.18 in one go would be wrong, because the second and third years grow from larger numbers than the first.
12. (c) 90° — Method: the sectors of a pie chart share the 360° at the centre of the chart in the same proportion as the data, so a sector's angle is its share of the data multiplied by 360°. Working: a share of 25% is the fraction 25/100, which is one quarter of the whole chart, and one quarter of 360° is 360 ÷ 4 = 90°. Answer: 90°, an angle in degrees rather than a percentage. The distractors: 25° comes from sharing out 100 instead of 360, so the percentage is written straight down as a number of degrees; 14.4° comes from dividing 360 by 25 instead of multiplying 360 by the fraction 25/100, which is the division done the wrong way round; 45° comes from taking a quarter of 180° instead of a quarter of 360°, treating the pie chart as a semicircle.