⏱️ Ten-minute starters — Foundation

Answer key

1. (a) 105° — The interior angles of a pentagon add up to (5 − 2) × 180° = 540°. Subtracting the three known angles, 540 − 100 − 110 − 120 = 210°, and this 210° is shared equally between the two angles marked x°, so each one is 210 ÷ 2 = 105°. 210° stops one step early, giving the total of the two unknown angles instead of one of them. 108° is the interior angle of a regular pentagon, which does not apply here since this pentagon's angles are not all equal. 55° comes from halving one of the given angles, 110°, instead of halving the remaining total.
2. (d) 10 — Method: the distance between two points is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal and vertical gaps, so work out both gaps first, handling the negative coordinates carefully, and then apply Pythagoras' theorem. Working: the horizontal gap is 5 − (−3) = 5 + 3 = 8 and the vertical gap is 4 − (−2) = 4 + 2 = 6. Then d² = 8² + 6² = 64 + 36 = 100, so d = √100 = 10. Answer: 10. The distractors: 14 comes from adding the two gaps, 8 + 6, instead of adding their squares and taking the root; 100 comes from stopping at the sum of the squares and never taking the square root; 50 comes from reaching 100 correctly and then halving it instead of taking its square root, a candidate who has read the last step as “halve” rather than “root”.
3. (a) 12 — A cube has 6 square faces, 12 edges and 8 vertices. The edges are the straight lines where two faces meet: 4 edges around the top face, 4 edges around the bottom face, and 4 vertical edges joining them, giving 4 + 4 + 4 = 12. A candidate who counts the vertices instead of the edges answers 8. A candidate who counts the faces instead answers 6. A candidate who counts only the edges around the top face, forgetting the bottom face and the vertical edges, answers 4. The correct number of edges is 12.
4. (b) (8, −6) — Multiplying a column vector by a scalar multiplies both numbers in the vector by that scalar: 2p = (2×4, 2×(−3)) = (8, −6). (8, −3) doubles the top number but leaves the bottom number, −3, unchanged. (4, −6) doubles the bottom number but leaves the top number, 4, unchanged. (8, 6) doubles both numbers correctly in size but loses the negative sign on the bottom number.
5. (b) 1 : 3 — Write the two lengths as a ratio: 5 : 15. Divide both parts by their highest common factor, 5, to give 1 : 3. Writing 3 : 1 swaps the order, comparing B to A instead of A to B. Leaving the ratio as 5 : 15 has not been simplified. Finding 1 : 2 comes from comparing the smaller length to the gap between the two lengths (15 − 5 = 10, then wrongly simplifying 5 : 10), not from comparing the two lengths themselves.
6. (c) 2/3 — Method: fractions with the same denominator are added by adding the numerators and leaving the denominator alone, because the parts are already the same size. Working: 1/3 + 1/3 has numerators 1 + 1 = 2 and the denominator stays as 3, giving 2/3. Answer: 2/3. The distractors: 2/6 comes from adding the denominators as well as the numerators, 1 + 1 over 3 + 3; 2/9 comes from adding the numerators but multiplying the denominators, 1 + 1 over 3 × 3; 1/9 comes from multiplying throughout instead of adding, 1 × 1 over 3 × 3.
7. (c) 16 cm — Corresponding sides of similar triangles are all in the same ratio. Use the pair whose lengths are both known: the scale factor from triangle ABC to triangle PQR is 12 ÷ 6 = 2. Since QR corresponds to BC, multiply BC by that scale factor: 8 × 2 = 16, so QR = 16 cm.
8. (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
9. (b) Yes, because 14.8 cm rounds to 15 cm to the nearest cm — Method: a recorded measurement is not an exact length; it stands for every length that rounds to it, so the two records agree if one rod can produce both. Working: Ben's record of 14.8 cm to the nearest 0.1 cm means the rod is between 14.75 cm and 14.85 cm, and 14.8 is nearer to 15 than to 14, so a rod of that length is recorded as 15 cm to the nearest centimetre. Both records can therefore come from the same rod. Answer: Yes, because 14.8 cm rounds to 15 cm to the nearest cm. The distractors: the claim that 14.8 cm rounds to 15.0 cm to 1 decimal place is false, since 14.8 cm is already written to 1 decimal place and stays 14.8 cm; the claim that it rounds to 14 cm is false, because 14.8 is 0.2 away from 15 and 0.8 away from 14; the claim that the two lengths are not the same treats each record as an exact length, when each is only a rounded record of one rod.
10. (c) x = 0 or x = −7 — Factorising: x² + 7x = x(x + 7) = 0, so x = 0 or x + 7 = 0, giving x = 0 or x = −7. A candidate who divides both sides of the original equation by x, which loses the solution x = 0, gets only x = −7. A candidate who makes a sign error solving x + 7 = 0 gets x = 0 or x = 7. A candidate who misreads the coefficient and doubles it gets x = 0 or x = −14.
11. (c) 140 — Method: the mean shares the total equally between the items, so add the values and then divide by how many there are. Working: the total is 120 + 200 + 160 + 80 = 560 pages and there are 4 books, so the mean is 560 ÷ 4 = 140 pages. Answer: 140. The distractors: 560 comes from stopping at the total number of pages and never dividing by 4; 280 comes from dividing the total by 2 instead of by the 4 books; 120 comes from working out the range, 200 − 80, which measures spread instead of centre.
12. (c) h = V / (lw) — Method: undo the multiplication by lw by dividing both sides by lw. Working: V = lwh, so dividing both sides by lw gives h = V / (lw). The value h = V − lw comes from subtracting lw instead of dividing by it. The value h = Vlw comes from multiplying by lw instead of dividing. The value h = lw / V comes from inverting the fraction, dividing lw by V instead of V by lw.