Printable · GCSE Foundation · ages 14-16
Gradients and intercepts of linear functions worksheet — GCSE Foundation
Fifteen questions on "gradients and intercepts of linear functions" — DfE statement A10. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Non-calculator
Gradients and intercepts of linear functions worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.Work out the coordinates of the point where the graph of y = 2x − 6 crosses the x-axis.y = 2x − 6
- 2.A candle is 30 cm tall when lit and burns at a constant rate. After burning for 5 minutes, its height is 20 cm. The height h cm after t minutes is given by h = 30 − mt. Work out the value of m.
- 3.A straight line passes through the points (2, 7) and (5, 16). Work out the value of y when x = 0.
- 4.A straight line has equation 4y = 12x + 20. Work out the gradient of the line.y = 12x + 20
- 5.The line y = 3x + 6 meets the x-axis at one point. Work out the coordinates of that point.y = 3x + 6
- 6.A car's fuel tank contains 50 litres when it starts a journey. After travelling for 2 hours, it contains 38 litres, and fuel is used at a constant rate. Work out the rate at which fuel is used, in litres per hour.
- 7.Line C passes through (0, 0) and (4, 2). Line D passes through (0, 0) and (2, 2). Write down which of the two lines is the steeper.
- 8.Write down the coordinates of the point where the line y = 2x + 4 crosses the y-axis.y = 2x + 4
- 9.Write down the gradient of the line with equation y = 7x − 2.y = 7x − 2
- 10.A printer starts a job with 480 sheets of paper loaded and prints at a steady rate. The number of sheets left, S, after t minutes is given by S = 480 − 24t. Work out how many minutes it takes for the paper to run out completely.
- 11.A water tank empties according to y = −5x + 200, where y is the number of litres left after x minutes. Work out the coordinates of the point where this graph crosses the x-axis.y = -5x + 200
- 12.Work out the gradient of the straight line that passes through the points (−1, 5) and (3, −7).
- 13.Write down the gradient of the line with equation y = 6 + 4x.
- 14.Work out the gradient of the straight line with equation y = (2x/5) − 3.
- 15.The graph of a straight line has equation y = 4x − 5. Beth says the y-intercept is 4. Work out the correct y-intercept.y = 4x − 5
Answer key
- (d) (3, 0) — Method: every point on the x-axis has y-coordinate 0, so substituting y = 0 into the equation and solving gives the x-coordinate of the crossing point. Working: 0 = 2x − 6 gives 2x = 6, so x = 6 ÷ 2 = 3 and the graph crosses the x-axis at (3, 0). Answer: (3, 0). The distractors: (0, −6) is where the graph crosses the y-axis, found by substituting x = 0 rather than y = 0; (−3, 0) comes from moving the 6 across the equals sign without changing its sign, giving 2x = −6; (6, 0) comes from reading the constant straight off as the crossing point and never dividing by the gradient 2.
- (a) 2 — The candle's height falls from 30 cm to 20 cm, a drop of 10 cm, over 5 minutes, so m = 10 ÷ 5 = 2. 10 comes from using the drop in height but forgetting to divide by the time. 0.5 comes from dividing the time by the drop instead of the drop by the time (5 ÷ 10). 4 comes from dividing the final height by the time, 20 ÷ 5, instead of using the drop in height.
- (a) 1 — Method: the value of y when x = 0 is where the line meets the y-axis, which is the constant c in y = mx + c, so the gradient is worked out from the two given points first and the constant follows by substituting one of them. Working: m = (16 − 7) ÷ (5 − 2) = 9 ÷ 3 = 3, so the line is y = 3x + c; substituting x = 2 and y = 7 gives 7 = 3 × 2 + c, so c = 7 − 6 = 1, and the value of y when x = 0 is that constant. Answer: 1. The distractors: 3 comes from stopping at the gradient and offering it as the intercept; 4 comes from stepping back from x = 2 to x = 0 by one unit of x instead of two, 7 − 3 = 4; −1 comes from working the constant out as mx − y, 3 × 2 − 7 = −1, instead of y − mx.
- (b) 3 — Method: rearrange the equation into the form y = mx + c first, then read off the gradient. Working: dividing 4y = 12x + 20 by 4 gives y = 3x + 5, so the gradient is 3. The value 12 comes from reading the coefficient of x before dividing the equation by 4. The value 20 comes from using the constant term of the unsimplified equation instead of the gradient. The value 5 comes from finding the y-intercept, 20 / 4 = 5, and giving that instead of the gradient.
- (b) (−2, 0) — Method: a graph meets the x-axis where the y-value is 0, so setting y = 0 turns the equation into a linear equation in x. Working: 0 = 3x + 6 gives 3x = −6, so x = (−6) ÷ 3 = −2 and the meeting point is (−2, 0). Answer: (−2, 0). The distractors: (2, 0) comes from solving 3x = −6 and then dropping the minus sign from the result; (0, 6) is the y-axis crossing, found by substituting x = 0 instead of y = 0; (6, 0) comes from reading the constant 6 straight off as the x-coordinate, without dividing by 3 and without changing its sign.
- (c) 6 — Method: rate = amount of fuel used ÷ time taken. Working: fuel used = 50 − 38 = 12 litres, time taken = 2 hours, so rate = 12 ÷ 2 = 6 litres per hour. Answer: the rate is 6 litres per hour. 44 comes from finding the average of the two fuel amounts, (50 + 38) ÷ 2, instead of the fuel used. 12 comes from working out the fuel used but forgetting to divide by the time taken. 19 comes from dividing the remaining fuel, 38, by the time taken instead of the fuel used.
- (c) Line D — Method: the steeper of two lines is the one whose gradient is greater, and the gradient of a line through two points is the change in y divided by the change in x. Working: line C rises 2 for a run of 4, so its gradient is 2 ÷ 4 = 1/2; the other line rises 2 for a run of 2, so its gradient is 2 ÷ 2 = 1; since 1 is greater than 1/2, it is line D that is the steeper. Answer: Line D. The distractors: Line C is chosen by comparing the x-coordinates and calling the line that reaches further along the x-axis the steeper one; They are equally steep comes from comparing only the y-coordinates, which are both 2, without dividing by the two different runs; There is not enough information comes from believing that a gradient can only be measured off a drawn graph, when two points on a line are enough to work it out.
- (d) (0, 4) — Method: in the form y = mx + c the constant c is the y-coordinate of the point where the line crosses the y-axis, and every point on that axis has x-coordinate 0. Working: comparing y = 2x + 4 with y = mx + c gives c = 4, and substituting x = 0 confirms y = 2 × 0 + 4 = 4, so the crossing point is (0, 4). Answer: (0, 4). The distractors: (4, 0) is the same pair of numbers written in the wrong order and is a point on the x-axis; (0, 2) comes from reading the gradient 2 as the intercept, confusing m with c; (−2, 0) is where the line crosses the x-axis, found by solving 0 = 2x + 4 instead.
- (b) 7 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = 7x − 2, the coefficient of x is 7. Answer: the gradient is 7. −2 comes from confusing the gradient with the y-intercept. −7 comes from a sign error, treating the coefficient of x as negative. 2 comes from using the y-intercept but dropping its sign.
- (a) 20 — Method: the paper has run out when S = 0, so substitute S = 0 into the equation and solve for t. Working: 0 = 480 − 24t, so 24t = 480, and t = 480 / 24 = 20. Answer: it takes 20 minutes. The value 480 comes from giving the starting number of sheets, the intercept of the equation, instead of solving for t. The value 456 comes from working out 480 − 24 and stopping after one step instead of solving the equation fully. The value 0.05 comes from inverting the division, working out 24 / 480 instead of 480 / 24.
- (a) (40, 0) — Method: a graph crosses the x-axis where y = 0, which in this context is the moment the tank holds no water, so substituting y = 0 and solving gives the time. Working: 0 = −5x + 200 gives 5x = 200, so x = 200 ÷ 5 = 40 and the crossing point is (40, 0); the tank is empty after 40 minutes. Answer: (40, 0). The distractors: (0, 200) is the y-axis crossing, the 200 litres in the tank at the start, found by substituting x = 0 instead of y = 0; (200, 0) comes from reading the constant 200 as the x-coordinate without dividing by the 5 litres lost each minute; (0, 40) has the right number in the wrong place, with the time written as a y-coordinate.
- (b) −3 — Method: the gradient of a straight line is the change in y divided by the change in x, with the two coordinates taken in the same order in the numerator as in the denominator. Working: going from (−1, 5) to (3, −7), the change in y is −7 − 5 = −12 and the change in x is 3 − (−1) = 4, so the gradient is −12 ÷ 4 = −3. Answer: −3. The distractors: 3 comes from subtracting the y-coordinates in one order and the x-coordinates in the other, giving 12 ÷ 4; −1/3 comes from dividing the change in x by the change in y instead of the other way round, giving 4 ÷ (−12); −6 comes from working out 3 − (−1) as 3 − 1 = 2, so that the change in y is divided by 2 rather than by 4.
- (d) 4 — Method: compare the equation with the general form y = mx + c after writing the x term first, then read off the coefficient of x. Working: y = 6 + 4x can be written as y = 4x + 6, so comparing with y = mx + c gives m = 4. Answer: the gradient is 4. The value 6 comes from reading off the constant, written first in the equation, and treating it as the gradient because it comes before the x term. The value 10 comes from adding the two numbers in the equation, 6 + 4, instead of reading off the coefficient of x. The value 24 comes from multiplying the two numbers in the equation, 6 × 4, instead of reading off the coefficient of x.
- (a) 2/5 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = (2x/5) − 3, the coefficient of x is 2/5. Answer: the gradient is 2/5. −3 comes from confusing the gradient with the y-intercept. 5/2 comes from inverting the fraction that multiplies x. −2/5 comes from wrongly carrying the negative sign from the −3 term onto the coefficient of x.
- (d) −5 — In y = mx + c, the y-intercept is c, the constant term, not the coefficient of x. Here c = −5, so the y-intercept is −5. 4 is Beth's value, the coefficient of x (the gradient), not the intercept. 5 comes from taking the constant term but dropping its negative sign. −4 comes from taking the gradient but giving it the sign of the intercept.
Build your own mix at the worksheet builder.