Printable · GCSE Foundation · ages 14-16
Gradients and intercepts of linear functions worksheet — GCSE Foundation
Fifteen questions on "gradients and intercepts of linear functions" — DfE statement A10. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Non-calculator
Answer key: Gradients and intercepts of linear functions worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) −2 — Method: rearrange the equation into the form y = mx + c, then read off the gradient. Working: 3y = 12 − 6x, so dividing every term by 3 gives y = 4 − 2x, so the gradient is −2. Answer: the gradient is −2. 2 comes from dropping the negative sign after dividing by 3. 4 comes from using the y-intercept, 4, instead of the gradient. −6 comes from reading off the coefficient of x before dividing the whole equation by 3.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (b) −3 — Method: the gradient of a straight line is the change in y divided by the change in x, with the two coordinates taken in the same order in the numerator as in the denominator. Working: going from (−1, 5) to (3, −7), the change in y is −7 − 5 = −12 and the change in x is 3 − (−1) = 4, so the gradient is −12 ÷ 4 = −3. Answer: −3. The distractors: 3 comes from subtracting the y-coordinates in one order and the x-coordinates in the other, giving 12 ÷ 4; −1/3 comes from dividing the change in x by the change in y instead of the other way round, giving 4 ÷ (−12); −6 comes from working out 3 − (−1) as 3 − 1 = 2, so that the change in y is divided by 2 rather than by 4.
- (c) The cost, in pounds, for each extra gigabyte of data used — In C = 15 + 2g, the number multiplying g is the gradient, which gives the extra cost for each extra unit of g — here, £2 for each extra gigabyte. 'The fixed monthly fee, in pounds' describes the constant term 15, not the coefficient of g. 'The total number of gigabytes included in the plan' misreads the coefficient as a quantity of data rather than a cost per gigabyte. 'The cost … for each extra 2 gigabytes' doubles the unit the coefficient actually applies to — it is the cost for each single extra gigabyte.
- (a) 1 — Method: the value of y when x = 0 is where the line meets the y-axis, which is the constant c in y = mx + c, so the gradient is worked out from the two given points first and the constant follows by substituting one of them. Working: m = (16 − 7) ÷ (5 − 2) = 9 ÷ 3 = 3, so the line is y = 3x + c; substituting x = 2 and y = 7 gives 7 = 3 × 2 + c, so c = 7 − 6 = 1, and the value of y when x = 0 is that constant. Answer: 1. The distractors: 3 comes from stopping at the gradient and offering it as the intercept; 4 comes from stepping back from x = 2 to x = 0 by one unit of x instead of two, 7 − 3 = 4; −1 comes from working the constant out as mx − y, 3 × 2 − 7 = −1, instead of y − mx.
- (a) 8 — Method: rate = height gained ÷ time taken. Working: height gained = 52 − 20 = 32 m, time taken = 4 minutes, so rate = 32 ÷ 4 = 8 metres per minute. Answer: the rate is 8 metres per minute. 32 comes from working out the height gained but forgetting to divide by the time taken. 13 comes from dividing the final height, 52, by the time taken instead of the height gained. 5 comes from dividing the starting height, 20, by the time taken instead of the height gained.
- (a) 2/5 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = (2x/5) − 3, the coefficient of x is 2/5. Answer: the gradient is 2/5. −3 comes from confusing the gradient with the y-intercept. 5/2 comes from inverting the fraction that multiplies x. −2/5 comes from wrongly carrying the negative sign from the −3 term onto the coefficient of x.
- (c) Line D — Method: the steeper of two lines is the one whose gradient is greater, and the gradient of a line through two points is the change in y divided by the change in x. Working: line C rises 2 for a run of 4, so its gradient is 2 ÷ 4 = 1/2; the other line rises 2 for a run of 2, so its gradient is 2 ÷ 2 = 1; since 1 is greater than 1/2, it is line D that is the steeper. Answer: Line D. The distractors: Line C is chosen by comparing the x-coordinates and calling the line that reaches further along the x-axis the steeper one; They are equally steep comes from comparing only the y-coordinates, which are both 2, without dividing by the two different runs; There is not enough information comes from believing that a gradient can only be measured off a drawn graph, when two points on a line are enough to work it out.
- (d) (0, 4) — Method: in the form y = mx + c the constant c is the y-coordinate of the point where the line crosses the y-axis, and every point on that axis has x-coordinate 0. Working: comparing y = 2x + 4 with y = mx + c gives c = 4, and substituting x = 0 confirms y = 2 × 0 + 4 = 4, so the crossing point is (0, 4). Answer: (0, 4). The distractors: (4, 0) is the same pair of numbers written in the wrong order and is a point on the x-axis; (0, 2) comes from reading the gradient 2 as the intercept, confusing m with c; (−2, 0) is where the line crosses the x-axis, found by solving 0 = 2x + 4 instead.
- (d) (3, 0) — Method: every point on the x-axis has y-coordinate 0, so substituting y = 0 into the equation and solving gives the x-coordinate of the crossing point. Working: 0 = 2x − 6 gives 2x = 6, so x = 6 ÷ 2 = 3 and the graph crosses the x-axis at (3, 0). Answer: (3, 0). The distractors: (0, −6) is where the graph crosses the y-axis, found by substituting x = 0 rather than y = 0; (−3, 0) comes from moving the 6 across the equals sign without changing its sign, giving 2x = −6; (6, 0) comes from reading the constant straight off as the crossing point and never dividing by the gradient 2.
- (d) 8 — Method: compare the equation with y = mx + c, where c is the y-intercept. Working: in y = 3x + 8, the constant term is 8. Answer: the y-intercept is 8. 3 comes from confusing the y-intercept with the gradient. −8 comes from a sign error, treating the constant term as negative. 11 comes from wrongly adding the gradient and the constant term together.
- (b) No, because their gradients are 2 and −2 — Method: two lines are parallel exactly when their gradients are equal as signed numbers, so m is read from each equation written in the form y = mx + c and the two are compared. Working: y = 2x + 1 has gradient 2 and y = −2x + 3 has gradient −2; those are not equal, so the lines are not parallel, and indeed one slopes upwards while the other slopes downwards. Answer: No, because their gradients are 2 and −2. The distractors: saying yes because both gradients have size 2 comes from comparing the sizes of the gradients and ignoring their signs; saying yes because the gradients add to 0 comes from using a sum of zero as the test for parallel lines instead of equality of gradients; saying no because the y-intercepts are 1 and 3 reaches the right verdict by the wrong route, since the intercepts decide where the lines sit rather than whether they are parallel.
- (d) −3 — Method: rewrite the equation in the form y = mx + c, then read off the gradient. Working: y = 4 − 3x can be written as y = −3x + 4, so comparing with y = mx + c gives m = −3. Answer: the gradient is −3. The value 3 comes from ignoring the negative sign on the x term. The value 4 comes from reading off the y-intercept instead of the gradient. The value −4 comes from a sign error, applying the negative sign to the intercept instead of the gradient.
- (a) 2 — The candle's height falls from 30 cm to 20 cm, a drop of 10 cm, over 5 minutes, so m = 10 ÷ 5 = 2. 10 comes from using the drop in height but forgetting to divide by the time. 0.5 comes from dividing the time by the drop instead of the drop by the time (5 ÷ 10). 4 comes from dividing the final height by the time, 20 ÷ 5, instead of using the drop in height.
- (b) 3 — Method: rearrange the equation into the form y = mx + c first, then read off the gradient. Working: dividing 4y = 12x + 20 by 4 gives y = 3x + 5, so the gradient is 3. The value 12 comes from reading the coefficient of x before dividing the equation by 4. The value 20 comes from using the constant term of the unsimplified equation instead of the gradient. The value 5 comes from finding the y-intercept, 20 / 4 = 5, and giving that instead of the gradient.
Build your own mix at the worksheet builder.