Printable · GCSE Foundation · ages 14-16
Gradients and intercepts of linear functions worksheet — GCSE Foundation
Fifteen questions on "gradients and intercepts of linear functions" — DfE statement A10. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Non-calculator
Answer key: Gradients and intercepts of linear functions worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 5 — Method: gradient = change in y ÷ change in x between the two points. Working: change in y = 9 − 4 = 5, change in x = 1 − 0 = 1, so gradient = 5 ÷ 1 = 5. Answer: the gradient is 5. 13 comes from adding the y-values instead of subtracting them. 4 comes from using the y-value at x = 0 instead of the change in y between the two points. 1/5 comes from inverting the gradient, dividing the change in x by the change in y instead of the other way round.
- (d) 4 — Method: compare the equation with the general form y = mx + c after writing the x term first, then read off the coefficient of x. Working: y = 6 + 4x can be written as y = 4x + 6, so comparing with y = mx + c gives m = 4. Answer: the gradient is 4. The value 6 comes from reading off the constant, written first in the equation, and treating it as the gradient because it comes before the x term. The value 10 comes from adding the two numbers in the equation, 6 + 4, instead of reading off the coefficient of x. The value 24 comes from multiplying the two numbers in the equation, 6 × 4, instead of reading off the coefficient of x.
- (a) 8 — Method: rate = height gained ÷ time taken. Working: height gained = 52 − 20 = 32 m, time taken = 4 minutes, so rate = 32 ÷ 4 = 8 metres per minute. Answer: the rate is 8 metres per minute. 32 comes from working out the height gained but forgetting to divide by the time taken. 13 comes from dividing the final height, 52, by the time taken instead of the height gained. 5 comes from dividing the starting height, 20, by the time taken instead of the height gained.
- (a) 20 — Method: the paper has run out when S = 0, so substitute S = 0 into the equation and solve for t. Working: 0 = 480 − 24t, so 24t = 480, and t = 480 / 24 = 20. Answer: it takes 20 minutes. The value 480 comes from giving the starting number of sheets, the intercept of the equation, instead of solving for t. The value 456 comes from working out 480 − 24 and stopping after one step instead of solving the equation fully. The value 0.05 comes from inverting the division, working out 24 / 480 instead of 480 / 24.
- (d) −2 — Method: a gradient can only be read off an equation that is written in the form y = mx + c, so y has to be made the subject first. Working: subtracting 2x from both sides of 2x + y = 8 gives y = −2x + 8, and comparing that with y = mx + c gives m = −2. Answer: −2. The distractors: 2 comes from reading the coefficient of x straight off the equation as it is printed, without rearranging, so the change of sign is missed; 8 comes from reading the constant as the gradient, confusing m with c; −1/2 comes from rearranging correctly and then writing the gradient upside down, as the change in x over the change in y.
- (b) −1 — Method: in the form y = mx + c the gradient m is the number multiplying x, and an x term written with no number in front of it has a coefficient of 1. Working: y = −x + 3 is the same equation as y = (−1)x + 3, so comparing it with y = mx + c gives m = −1 and c = 3. Answer: −1. The distractors: 1 comes from taking the coefficient as 1 and leaving the minus sign out of the answer; 3 comes from reading the constant as the gradient, confusing m with c; −3 comes from moving the minus sign across to the constant term and then reading the gradient off that term instead of the x term.
- (b) 20 — The rate is the gradient: the change in litres divided by the change in time. From 2 to 7 minutes, the tank gains 150 − 50 = 100 litres over 7 − 2 = 5 minutes, so the rate is 100 ÷ 5 = 20 litres per minute. 100 comes from working out the change in litres but forgetting to divide by the change in time. 25 comes from using only the first reading, 50 ÷ 2, and ignoring the second reading entirely. 0.05 comes from dividing the change in time by the change in litres instead of the other way round, 5 ÷ 100.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (a) 2/5 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = (2x/5) − 3, the coefficient of x is 2/5. Answer: the gradient is 2/5. −3 comes from confusing the gradient with the y-intercept. 5/2 comes from inverting the fraction that multiplies x. −2/5 comes from wrongly carrying the negative sign from the −3 term onto the coefficient of x.
- (d) −3 — Method: rewrite the equation in the form y = mx + c, then read off the gradient. Working: y = 4 − 3x can be written as y = −3x + 4, so comparing with y = mx + c gives m = −3. Answer: the gradient is −3. The value 3 comes from ignoring the negative sign on the x term. The value 4 comes from reading off the y-intercept instead of the gradient. The value −4 comes from a sign error, applying the negative sign to the intercept instead of the gradient.
- (b) 7 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = 7x − 2, the coefficient of x is 7. Answer: the gradient is 7. −2 comes from confusing the gradient with the y-intercept. −7 comes from a sign error, treating the coefficient of x as negative. 2 comes from using the y-intercept but dropping its sign.
- (a) (40, 0) — Method: a graph crosses the x-axis where y = 0, which in this context is the moment the tank holds no water, so substituting y = 0 and solving gives the time. Working: 0 = −5x + 200 gives 5x = 200, so x = 200 ÷ 5 = 40 and the crossing point is (40, 0); the tank is empty after 40 minutes. Answer: (40, 0). The distractors: (0, 200) is the y-axis crossing, the 200 litres in the tank at the start, found by substituting x = 0 instead of y = 0; (200, 0) comes from reading the constant 200 as the x-coordinate without dividing by the 5 litres lost each minute; (0, 40) has the right number in the wrong place, with the time written as a y-coordinate.
- (c) 3 — Method: a point that lies on a graph makes its equation true, so substituting the coordinates into y = mx + 6 leaves an equation in m alone. Working: substituting x = −2 and y = 0 gives 0 = m × (−2) + 6, which rearranges to −2m = −6, so m = (−6) ÷ (−2) = 3. Answer: 3. The distractors: −3 comes from dividing −6 by 2 and keeping the minus sign, overlooking that the divisor is negative too, so the two signs cancel; −2 comes from writing down the x-coordinate of the given point in place of the gradient; 6 comes from reading the constant in y = mx + 6 as the gradient, confusing m with c.
- (b) 3 — Method: rearrange the equation into the form y = mx + c first, then read off the gradient. Working: dividing 4y = 12x + 20 by 4 gives y = 3x + 5, so the gradient is 3. The value 12 comes from reading the coefficient of x before dividing the equation by 4. The value 20 comes from using the constant term of the unsimplified equation instead of the gradient. The value 5 comes from finding the y-intercept, 20 / 4 = 5, and giving that instead of the gradient.
- (b) −0.5 — Method: gradient = change in height ÷ horizontal distance, and the height decreases so the change is negative. Working: change in height = 5 − 25 = −20, horizontal distance = 40, so gradient = −20 ÷ 40 = −0.5. Answer: the gradient is −0.5. 0.5 comes from dropping the negative sign, ignoring that the zip-line descends. 2 comes from inverting the gradient, dividing the horizontal distance by the drop in height instead of the other way round. −0.8 comes from dividing the drop by the platform height, 25, instead of by the horizontal distance, 40.
Build your own mix at the worksheet builder.