Printable · GCSE Foundation · ages 14-16

Gradients and intercepts of linear functions worksheet — GCSE Foundation

Fifteen questions on "gradients and intercepts of linear functions" — DfE statement A10. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.

VersionsA only A + B A + B + Csame questions, different order

AnswersQuestions only With answer key Key only

CalculatorMixed Non-calculator (Paper 1)Calculator (Papers 2 and 3)

New sheet

Answer key: Gradients and intercepts of linear functions worksheet — GCSE Foundation

Maths · GCSE Foundation · A10 · Gradients and intercepts of linear functions · 15 questions

MathsUKwww.geekhero.co.uk

(b) −1 — Method: in the form y = mx + c the gradient m is the number multiplying x, and an x term written with no number in front of it has a coefficient of 1. Working: y = −x + 3 is the same equation as y = (−1)x + 3, so comparing it with y = mx + c gives m = −1 and c = 3. Answer: −1. The distractors: 1 comes from taking the coefficient as 1 and leaving the minus sign out of the answer; 3 comes from reading the constant as the gradient, confusing m with c; −3 comes from moving the minus sign across to the constant term and then reading the gradient off that term instead of the x term.
(d) −2 — Method: a gradient can only be read off an equation that is written in the form y = mx + c, so y has to be made the subject first. Working: subtracting 2x from both sides of 2x + y = 8 gives y = −2x + 8, and comparing that with y = mx + c gives m = −2. Answer: −2. The distractors: 2 comes from reading the coefficient of x straight off the equation as it is printed, without rearranging, so the change of sign is missed; 8 comes from reading the constant as the gradient, confusing m with c; −1/2 comes from rearranging correctly and then writing the gradient upside down, as the change in x over the change in y.
(a) 20 — Method: the paper has run out when S = 0, so substitute S = 0 into the equation and solve for t. Working: 0 = 480 − 24t, so 24t = 480, and t = 480 / 24 = 20. Answer: it takes 20 minutes. The value 480 comes from giving the starting number of sheets, the intercept of the equation, instead of solving for t. The value 456 comes from working out 480 − 24 and stopping after one step instead of solving the equation fully. The value 0.05 comes from inverting the division, working out 24 / 480 instead of 480 / 24.
(d) −3 — Method: rewrite the equation in the form y = mx + c, then read off the gradient. Working: y = 4 − 3x can be written as y = −3x + 4, so comparing with y = mx + c gives m = −3. Answer: the gradient is −3. The value 3 comes from ignoring the negative sign on the x term. The value 4 comes from reading off the y-intercept instead of the gradient. The value −4 comes from a sign error, applying the negative sign to the intercept instead of the gradient.
(b) −0.5 — Method: gradient = change in height ÷ horizontal distance, and the height decreases so the change is negative. Working: change in height = 5 − 25 = −20, horizontal distance = 40, so gradient = −20 ÷ 40 = −0.5. Answer: the gradient is −0.5. 0.5 comes from dropping the negative sign, ignoring that the zip-line descends. 2 comes from inverting the gradient, dividing the horizontal distance by the drop in height instead of the other way round. −0.8 comes from dividing the drop by the platform height, 25, instead of by the horizontal distance, 40.
(a) 2/5 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = (2x/5) − 3, the coefficient of x is 2/5. Answer: the gradient is 2/5. −3 comes from confusing the gradient with the y-intercept. 5/2 comes from inverting the fraction that multiplies x. −2/5 comes from wrongly carrying the negative sign from the −3 term onto the coefficient of x.
(b) 7 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = 7x − 2, the coefficient of x is 7. Answer: the gradient is 7. −2 comes from confusing the gradient with the y-intercept. −7 comes from a sign error, treating the coefficient of x as negative. 2 comes from using the y-intercept but dropping its sign.
(a) (40, 0) — Method: a graph crosses the x-axis where y = 0, which in this context is the moment the tank holds no water, so substituting y = 0 and solving gives the time. Working: 0 = −5x + 200 gives 5x = 200, so x = 200 ÷ 5 = 40 and the crossing point is (40, 0); the tank is empty after 40 minutes. Answer: (40, 0). The distractors: (0, 200) is the y-axis crossing, the 200 litres in the tank at the start, found by substituting x = 0 instead of y = 0; (200, 0) comes from reading the constant 200 as the x-coordinate without dividing by the 5 litres lost each minute; (0, 40) has the right number in the wrong place, with the time written as a y-coordinate.
(c) Line D — Method: the steeper of two lines is the one whose gradient is greater, and the gradient of a line through two points is the change in y divided by the change in x. Working: line C rises 2 for a run of 4, so its gradient is 2 ÷ 4 = 1/2; the other line rises 2 for a run of 2, so its gradient is 2 ÷ 2 = 1; since 1 is greater than 1/2, it is line D that is the steeper. Answer: Line D. The distractors: Line C is chosen by comparing the x-coordinates and calling the line that reaches further along the x-axis the steeper one; They are equally steep comes from comparing only the y-coordinates, which are both 2, without dividing by the two different runs; There is not enough information comes from believing that a gradient can only be measured off a drawn graph, when two points on a line are enough to work it out.
(b) −3 — Method: the gradient of a straight line is the change in y divided by the change in x, with the two coordinates taken in the same order in the numerator as in the denominator. Working: going from (−1, 5) to (3, −7), the change in y is −7 − 5 = −12 and the change in x is 3 − (−1) = 4, so the gradient is −12 ÷ 4 = −3. Answer: −3. The distractors: 3 comes from subtracting the y-coordinates in one order and the x-coordinates in the other, giving 12 ÷ 4; −1/3 comes from dividing the change in x by the change in y instead of the other way round, giving 4 ÷ (−12); −6 comes from working out 3 − (−1) as 3 − 1 = 2, so that the change in y is divided by 2 rather than by 4.
(d) (0, 4) — Method: in the form y = mx + c the constant c is the y-coordinate of the point where the line crosses the y-axis, and every point on that axis has x-coordinate 0. Working: comparing y = 2x + 4 with y = mx + c gives c = 4, and substituting x = 0 confirms y = 2 × 0 + 4 = 4, so the crossing point is (0, 4). Answer: (0, 4). The distractors: (4, 0) is the same pair of numbers written in the wrong order and is a point on the x-axis; (0, 2) comes from reading the gradient 2 as the intercept, confusing m with c; (−2, 0) is where the line crosses the x-axis, found by solving 0 = 2x + 4 instead.
(d) 4 — Method: compare the equation with the general form y = mx + c after writing the x term first, then read off the coefficient of x. Working: y = 6 + 4x can be written as y = 4x + 6, so comparing with y = mx + c gives m = 4. Answer: the gradient is 4. The value 6 comes from reading off the constant, written first in the equation, and treating it as the gradient because it comes before the x term. The value 10 comes from adding the two numbers in the equation, 6 + 4, instead of reading off the coefficient of x. The value 24 comes from multiplying the two numbers in the equation, 6 × 4, instead of reading off the coefficient of x.
(d) −5 — In y = mx + c, the y-intercept is c, the constant term, not the coefficient of x. Here c = −5, so the y-intercept is −5. 4 is Beth's value, the coefficient of x (the gradient), not the intercept. 5 comes from taking the constant term but dropping its negative sign. −4 comes from taking the gradient but giving it the sign of the intercept.
(c) 5 — Method: gradient = change in y ÷ change in x between the two points. Working: change in y = 9 − 4 = 5, change in x = 1 − 0 = 1, so gradient = 5 ÷ 1 = 5. Answer: the gradient is 5. 13 comes from adding the y-values instead of subtracting them. 4 comes from using the y-value at x = 0 instead of the change in y between the two points. 1/5 comes from inverting the gradient, dividing the change in x by the change in y instead of the other way round.
(a) 2 — The candle's height falls from 30 cm to 20 cm, a drop of 10 cm, over 5 minutes, so m = 10 ÷ 5 = 2. 10 comes from using the drop in height but forgetting to divide by the time. 0.5 comes from dividing the time by the drop instead of the drop by the time (5 ÷ 10). 4 comes from dividing the final height by the time, 20 ÷ 5, instead of using the drop in height.

Build your own mix at the worksheet builder.