Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.Three vertices of a rectangle are (−4, −1), (2, −1) and (2, 3). The sides of the rectangle are parallel to the axes. Write down the coordinates of the fourth vertex.
- 2.A rectangle has area 24x + 18. Ffion factorises the area as 6(4x + 3). Work out the value of the area when x = 2, and decide whether 6 and (4x + 3) are correctly identified as factors of 24x + 18.
- 3.Solve 3(2x − 1) = 27
- 4.The simultaneous equations y = 3 and 4x − y = 9 are given. Work out the value of x.
- 5.Which of these equations gives a graph shaped like a U, symmetrical about a vertical line?
- 6.Point P has coordinates (5, 2). Point P is rotated 180° about the origin to point Q. Write down the coordinates of Q.
- 7.A rectangular field has length (3a + 2) metres and width (a − 1) metres. Write a simplified expression for the perimeter of the field.
- 8.Which of these points lies in the first quadrant?
- 9.Solve x² − 100 = 0.
- 10.A market stall's cost of hiring n tables is modelled by two formulas: Formula A: C = 3(2n + 5); Formula B: C = 6n + 15, where C is in pounds. A stallholder says the two formulas always give the same cost. Work out the cost given by each formula when n = 4, and use your results to decide whether the stallholder is correct.
- 11.The height, h metres, of a ball t seconds after a stopwatch is started follows h = (t − 1)(5 − t) for 1 ≤ t ≤ 5, where h = 0 means the ball is at ground level. Work out the two times at which the ball is at ground level.
- 12.The nth term of a sequence is 4n − 3. Work out the 7th term of the sequence.
- 13.Solve 4(x − 3) = 2x + 6.
- 14.Factorise fully 56x − 24
- 15.The solution set of an inequality is x ≥ 7. Write down the value that does NOT satisfy this inequality.
Answer key
- (b) (−4, 3) — Method: in a rectangle whose sides are parallel to the axes only two different x-coordinates and two different y-coordinates appear, and each of them is shared by a pair of vertices, so the missing vertex takes the x-coordinate and the y-coordinate that so far appear only once. Working: the x-coordinates given are −4, 2 and 2, so 2 is already used twice and −4 is used once; the y-coordinates given are −1, −1 and 3, so −1 is already used twice and 3 is used once; the fourth vertex therefore has x = −4 and y = 3. Answer: (−4, 3). The distractors: (3, −4) comes from picking the two unpaired coordinates correctly and then writing them in the wrong order; (−4, −5) comes from matching the 4-unit vertical side but measuring it downwards from (−4, −1) instead of upwards; (8, 3) comes from carrying on round the shape with the horizontal step used earlier, adding 6 to the x-coordinate of (2, 3) instead of closing the rectangle.
- (d) 66 — 6 and (4x + 3) are correct factors of 24x + 18. — Substituting x=2 into 24x+18: 24×2+18=48+18=66. Checking the factorisation: 6×4x=24x and 6×3=18, so 6(4x+3)=24x+18, matching the original expression — 6 and (4x+3) are correctly identified as factors. A candidate who substitutes x=2 into (4x+3) but forgets to multiply by the factor 6 afterwards would compute just 4×2+3=11. A candidate who adds 24 and 18 together before multiplying by x, instead of multiplying 24 by x first, would compute (24+18)×2=84. A candidate who distributes the 6 over only the first term inside the brackets, forgetting the second, would check the factorisation as 6×4x=24x but leave the 3 unmultiplied, getting 24x+3 instead of 24x+18 — and would wrongly conclude that 6 and (4x+3) are not correct factors.
- (b) 5 — Method: expand the bracket first, then solve the resulting linear equation. Working: 3(2x − 1) = 6x − 3, so 6x − 3 = 27. Add 3 to both sides: 6x = 30. Divide by 6: x = 5. Answer: 5. 4 2/3 comes from multiplying only the 2x inside the bracket by 3 and forgetting to multiply the −1 as well, giving 6x − 1 = 27. 4 comes from a sign error when expanding, writing 6x + 3 instead of 6x − 3. 4.5 comes from dividing 27 by 3 to get 2x − 1 = 9, then forgetting to add 1 back before dividing by 2, using 2x = 9 instead of 2x = 10.
- (c) 3 — Substituting y = 3 into 4x − y = 9 gives 4x − 3 = 9, so 4x = 12, and x = 3. A candidate who adds 3 instead of subtracting it, making a sign error when substituting, would get 4x + 3 = 9, so 4x = 6 and x = 1.5. A candidate who forgets to divide by 4 after finding 4x = 12 would write x = 12. A candidate who subtracts 4 instead of dividing by it would get 12 − 4 = 8.
- (a) y = x² + 2 — A quadratic equation, with x², gives a graph shaped like a symmetrical U (or an upside-down U). Of the four equations, y = x² + 2 is quadratic, so it gives this U-shape. y = x³ + 2 is cubic, giving an S-shaped curve rather than a symmetrical U. y = 2x + 2 is linear, giving a straight line. y = 2/x is reciprocal, giving two separate curved branches rather than a single U-shape.
- (b) (−5, −2) — A rotation of 180° about the origin reverses the sign of both coordinates, so Q = (−5, −2). A candidate who reverses the sign of only the y-coordinate, as if reflecting in the x-axis, gets (5, −2). A candidate who reverses the sign of only the x-coordinate, as if reflecting in the y-axis, gets (−5, 2). A candidate who swaps the coordinates instead of reversing their signs gets (2, 5).
- (c) 8a + 2 — The perimeter of a rectangle is twice the length plus twice the width: P = 2(3a + 2) + 2(a − 1) = (6a + 4) + (2a − 2) = 8a + 2. Answering 5a adds the length and width once each but doubles only one of them, missing that a rectangle has two of each side. Answering 8a + 6 distributes the 2 into (a − 1) correctly as far as 2a, but then adds 2 instead of subtracting it, as though the bracket had been (a + 1). Answering 12a + 8 uses the length for all four sides instead of using the length twice and the width twice, as if the field were a square with side (3a + 2). The perimeter of the field is (8a + 2) metres.
- (d) (3, 5) — Method: the quadrant a point lies in is decided by the signs of its two coordinates, and in the first quadrant both coordinates are positive. Working: (−2, 3) has a negative x-coordinate, so it sits to the left of the y-axis; (4, −1) has a negative y-coordinate, so it sits below the x-axis; (−1, −4) has both coordinates negative; only (3, 5) has a positive x-coordinate and a positive y-coordinate. Answer: (3, 5). The distractors: (−2, 3) is chosen by candidates who check only the y-coordinate and take a positive height as enough; (4, −1) is chosen by those who check only the x-coordinate; (−1, −4) is chosen by those who number the quadrants from the bottom left, so that the region with two negative coordinates is called the first.
- (a) x = 10 or x = −10 — Rearranging, x² = 100. Taking the square root of both sides gives x = ±10, i.e. x = 10 or x = −10. A candidate who forgets the negative root gives only x = 10. A candidate who halves 100 instead of taking its square root gets x = 50. A candidate who applies the ± sign to 100 itself instead of to its square root gets x = 100 or x = −100.
- (d) Formula A gives £39 and Formula B gives £39, and since 3(2n + 5) expands to 6n + 15 for every value of n, the stallholder is correct. — Formula A: 3(2 × 4 + 5) = 3 × 13 = £39. Formula B: 6 × 4 + 15 = 24 + 15 = £39. Expanding Formula A algebraically gives 3(2n + 5) = 6n + 15, which is identical to Formula B for every value of n, not just n = 4, so the stallholder is correct — this is an identity, not a coincidence. The option giving £29 for Formula A comes from multiplying only the 2n by 3 and forgetting to also multiply the 5, then adding the unmultiplied 5: 3 × 2 × 4 = 24, + 5 = 29. The two options that reach the correct numbers but reject the stallholder's claim both use faulty reasoning — matching values at one value of n, or counting terms, does not decide whether two expressions are identical for every n; expanding the bracket does.
- (c) t = 1 second and t = 5 seconds — The ball is at ground level when h = 0, which happens when either bracket is zero. t − 1 = 0 gives t = 1, and 5 − t = 0 gives t = 5. The option with t = −1 makes a sign error solving the first bracket. The option with t = −5 makes a sign error solving the second bracket, treating 5 − t = 0 as if it gave a negative solution. The option with t = 4 seconds is an arithmetic slip in solving 5 − t = 0.
- (b) 25 — Substitute n = 7: 4 × 7 − 3 = 28 − 3 = 25. Forgetting to subtract 3 gives 4 × 7 = 28. Subtracting 3 from 7 before multiplying by 4, 4 × (7 − 3) = 16, applies the operations in the wrong order. Substituting n = 8 by miscounting the position gives 4 × 8 − 3 = 29.
- (d) 9 — Method: expand the brackets fully first, then collect the x-terms and constants before dividing. Working: 4(x − 3) = 4x − 12, so 4x − 12 = 2x + 6; 4x − 2x = 6 + 12; 2x = 18; x = 9. Answer: x = 9. 4.5 comes from expanding only the x-term in the bracket and forgetting to multiply the 3, giving 4x − 3 = 2x + 6, then 2x = 9, x = 4.5. −3 comes from a sign error when expanding, giving 4x + 12 = 2x + 6, then 2x = −6, x = −3. 3 comes from a sign error collecting the x-terms, adding instead of subtracting: 4x + 2x = 6 + 12, so 6x = 18, x = 3.
- (d) 8(7x − 3) — Method: find the highest common factor of the two terms, write it in front of a bracket and divide each term by it. Working: 56 = 8 × 7 and 24 = 8 × 3, so the highest common factor is 8; dividing gives 56x ÷ 8 = 7x and 24 ÷ 8 = 3, and the subtraction sign stays between them. Answer: 8(7x − 3), which multiplies back out to 56x − 24. The distractors: 8(7x + 3) comes from dropping the minus sign of −24 while dividing; 8(56x − 3) comes from dividing only the number term by 8 and leaving 56x untouched inside the bracket; 8(7x − 16) comes from subtracting 8 from 24 instead of dividing 24 by 8.
- (d) 6 — Method: a value satisfies x ≥ 7 when it is greater than 7 or exactly equal to 7, so test each value against the boundary. Working: 8 is greater than 7 and 100 is greater than 7, so both satisfy the inequality; 7 is equal to the boundary and ≥ includes equality, so 7 satisfies it as well; 6 is less than 7, so 6 is the one value that fails. Answer: 6. The distractors: 7 is chosen by candidates who read ≥ as a strict 'greater than' and so shut the boundary value out of the solution set; 8 is chosen by reading the question as asking which value DOES satisfy the inequality and taking the smallest such value; 100 is chosen by the same misreading, taking instead the value furthest above the boundary.
Build your own mix at the worksheet builder.