Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A charity's fundraising total, T pounds, over d days follows T = (d − 3)(30 − d) for 3 ≤ d ≤ 30, where T = 0 marks the start and end of the campaign. Work out how many days the campaign runs for, from start to end.
- 2.A student says that (x + 4)² is equivalent to x² + 16. For which value of x do the two expressions give the SAME result, making it look (misleadingly) like the student could be right?
- 3.Which of these rules generates the sequence 6, 11, 16, 21, …?
- 4.The point A lies on the x-axis. Which statement about A must be true?
- 5.Solve 2x² = 18.
- 6.The first four terms of a sequence are 5, 8, 11, 14. Work out an expression, in terms of n, for the nth term.
- 7.Make b the subject of the formula a = 5b.
- 8.Make x the subject of the formula y = 5x + 3.y = 5x + 3
- 9.A stack of firewood has 3 logs in the top layer. Each layer below has 4 more logs than the layer above it. Work out the number of logs in the 6th layer from the top.
- 10.The formula for the perimeter of a rectangle is P = 2(l + w). One rectangle has l = 9 cm and w = 4 cm. A second rectangle has l = 6 cm and w = 5 cm. Work out how many cm greater the perimeter of the first rectangle is than the perimeter of the second.
- 11.The formula for the area of a trapezium is A = (a + b)h / 2, where a and b are the parallel side lengths and h is the height. Make h the subject of the formula.
- 12.A scout leader is 44 years old and one of the scouts is 16 years old. Work out how many years it will be until the leader is exactly twice as old as the scout.
- 13.The first five cube numbers are 1, 8, 27, 64, 125. Write down the next cube number in the sequence.
- 14.A cyclist's distance-time graph shows the following: she travels 12 km in the first 30 minutes at a steady speed, then rests for 30 minutes, then travels a further 8 km in the next 15 minutes. Work out her average speed, in km/h, for the whole journey.
- 15.A line segment has one endpoint at (−6, 2) and its midpoint at (−1, 5). Work out the coordinates of the other endpoint.
Answer key
- (c) 27 days — The campaign starts at d = 3 and ends at d = 30, so it runs for 30 − 3 = 27 days. Getting 33 days comes from adding the two values, 3 + 30 = 33, instead of subtracting them. Getting 30 days uses only the end day and ignores that the campaign did not start at day 0. Getting 24 days comes from subtracting the start day twice, 30 − 3 − 3 = 24, instead of once.
- (c) x = 0 — Expand (x + 4)² correctly: (x + 4)² = x² + 8x + 16. This equals x² + 16 only when 8x is zero, i.e. when x = 0 — at every other value of x the two expressions differ by 8x. Choosing x = 4 confuses the constant inside the bracket with the value of x that makes the expressions match. Choosing x = −4 makes the same confusion but with the sign flipped. Choosing x = 8 mistakes the coefficient of the middle term, 8x, for the value of x itself.
- (c) 5n + 1 — Method: find the common difference, then use it as the coefficient of n in the position-to-term rule, and find the constant by checking against the first term. Working: the common difference is 5, so the rule has the form 5n + c. Using the 1st term: 5(1) + c = 6, so c = 1. The rule is 5n + 1. Answer: 5n + 1. 5n − 1 uses the correct coefficient but the wrong sign for the constant. 6n comes from using the first term as the coefficient of n instead of the common difference — it matches the 1st term by coincidence but fails from the 2nd term onward. n + 5 swaps the coefficient and the constant around, using the common difference as the constant instead of the coefficient of n.
- (a) y = 0 — Method: in the pair (x, y) the first coordinate measures how far left or right of the origin a point is and the second how far above or below the x-axis it is, so a point on an axis has one of those measurements equal to zero. Working: the x-axis is the horizontal line through the origin, so a point sitting on it is neither above nor below that line and its second coordinate is zero, while its first coordinate may be positive, negative or zero. Answer: y = 0. The distractors: x = 0 is the condition for lying on the y-axis, the other axis; x > 0 comes from assuming a point on the x-axis must be to the right of the origin, which is true only of part of that axis; x = y holds only at the origin, which is one point of the x-axis rather than a property shared by all of them.
- (d) x = 3 or x = −3 — Method: get x² on its own with a coefficient of 1, then take the square root of both sides and keep both the positive and the negative root. Working: dividing 2x² = 18 by 2 gives x² = 9, and the square root of 9 is 3, so x = 3 or x = −3; both check, because 2 × 9 = 18 either way. Answer: x = 3 or x = −3. The distractors: x = 9 or x = −9 comes from dividing by 2 and then forgetting to take the square root; x = 4 or x = −4 comes from subtracting 2 from 18 instead of dividing by it, giving x² = 16; x = 6 or x = −6 comes from multiplying by 2 instead of dividing, giving x² = 36.
- (d) 3n + 2 — The common difference is 3 (8−5=3), so the expression starts 3n. To match the first term when n=1, 3×1+c=5, so c=2: the nth term is 3n+2. A candidate who uses the first term itself as the constant, instead of first term minus the common difference, would write 3n+5 (giving 8, 11, 14, 17 — one term too high throughout). A candidate who omits the constant term altogether would write just 3n (giving 3, 6, 9, 12, not matching the sequence at all). A candidate who adds the common difference to n instead of multiplying would write n+3 (giving 4, 5, 6, 7, far too small).
- (b) b = a/5 — Writing 5b means 5 × b, so b has been multiplied by 5. The inverse of multiplying by 5 is dividing by 5, and dividing both sides by 5 gives a/5 = b, which is written b = a/5. Multiplying both sides by 5 instead gives 5a, which applies the operation a second time; treating the 5 as though it were added gives a − 5; writing 5/a turns the fraction upside down.
- (b) x = (y − 3)/5 — To make x the subject of y = 5x + 3, first subtract 3 from both sides to get y − 3 = 5x, then divide both sides by 5: x = (y − 3)/5. Writing x = (y + 3)/5 keeps the division correct but does not change the sign of the 3 when moving it across. Writing x = y/5 − 3 divides only the y term by 5 and leaves the 3 as a separate subtraction, instead of subtracting first and dividing the whole expression. Writing x = 5(y − 3) applies the correct order of subtracting 3 first, but then multiplies by 5 instead of dividing — the inverse of 5x is division, not multiplication. The correct rearrangement is x = (y − 3)/5.
- (a) 23 — The number of logs increases by 4 for each layer down, starting from 3 in the top layer, so the nth layer has 3+(n−1)×4 logs. For the 6th layer: 3+5×4=3+20=23. A candidate who adds the difference of 4 six times instead of five, treating the top layer as needing an addition too, would compute 3+6×4=27. A candidate who uses 4n instead of 4n−1, omitting the adjustment for the first layer, would compute 4×6=24. A candidate who subtracts the common difference, 4, instead of 1 when adjusting the multiplier would compute 4×6−4=20.
- (a) 4 — Rectangle 1: P = 2(9 + 4) = 2 × 13 = 26 cm. Rectangle 2: P = 2(6 + 5) = 2 × 11 = 22 cm. Difference = 26 − 22 = 4 cm. 2 comes from finding the difference between (l + w) for each rectangle, 13 − 11 = 2, but forgetting to double it. 26 comes from giving rectangle 1's whole perimeter instead of the difference between the two. 6 comes from doubling only the change in length, 2 × (9 − 6), and ignoring that the width also changed.
- (d) h = 2A / (a + b) — Method: undo the multiplication by 1/2 by multiplying both sides by 2, then undo the multiplication by (a + b) by dividing both sides by it. Working: A = (a + b)h / 2, so multiplying both sides by 2 gives 2A = (a + b)h, then dividing both sides by (a + b) gives h = 2A / (a + b). The value h = A / (a + b) comes from forgetting to multiply by 2 to clear the 1/2 first. The value h = 2A / a + b comes from dividing only by a and leaving b outside the fraction, instead of dividing by the whole bracket (a + b). The value h = (a + b) / (2A) comes from inverting the fraction.
- (b) 12 years — Method: call the number of years t, add t to both ages, and form an equation from the comparison at that future time. Working: in t years the leader will be 44 + t and the scout will be 16 + t, so 44 + t = 2(16 + t); expanding gives 44 + t = 32 + 2t, and subtracting t and 32 from both sides gives t = 12. Checking: in 12 years the leader will be 56 and the scout 28, and 56 = 2 × 28. Answer: 12 years. The distractors: 6 years comes from halving the leader's present age instead, so that the scout has to reach 22, which takes 6 years; 14 years comes from halving the 28-year gap between the two ages; 28 years comes from giving the age gap itself as the number of years.
- (a) 216 — The cube numbers are formed by cubing 1, 2, 3, 4, 5, ..., so the next one is 6³ = 216. A candidate who squares 6 instead of cubing it gets 6² = 36. A candidate who assumes the sequence doubles each time gets 125 × 2 = 250. A candidate who uses 5 × 6² instead of 6 × 6 × 6 gets 180.
- (c) 16 km/h — Method: total distance = 12 + 8 = 20 km. Total time = 30 + 30 + 15 = 75 minutes = 1.25 hours. Average speed = total distance ÷ total time = 20 ÷ 1.25 = 16 km/h. Distractor origins: 20 km/h gives the total distance without ever dividing by the total time; 24 km/h uses only the speed of the first stage (12 km in 30 minutes), ignoring the second stage and the rest; 28 km/h averages the two separate stage speeds, 24 km/h and 32 km/h, instead of using total distance over total time.
- (d) (4, 8) — The other endpoint is found from 2 × midpoint − known endpoint: x = 2 × (−1) − (−6) = −2 + 6 = 4, y = 2 × 5 − 2 = 10 − 2 = 8, giving (4, 8). (−3.5, 3.5) comes from averaging the given endpoint and the midpoint as if they were the two endpoints of a segment, instead of working backwards from the midpoint. (5, 3) comes from working out (−1 − (−6), 5 − 2) instead of doubling the midpoint before subtracting. (4, 5) comes from correctly finding the x-coordinate but copying the midpoint's y-coordinate of 5 instead of doubling it.
Build your own mix at the worksheet builder.