Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.Expand 2(x + 12)
- 2.A car park charges by the hour. Parking for 1 hour costs £5, 2 hours costs £9, 3 hours costs £13 and 4 hours costs £17, with the cost increasing by the same amount for each extra hour. Work out an expression, in terms of n, for the cost, in pounds, of parking for n hours.
- 3.A speed-time graph for a car shows the speed increasing steadily from 5 m/s to 17 m/s over 6 seconds. Work out the acceleration of the car, in m/s².
- 4.Write down the y-intercept of the line with equation y = 3x + 8.y = 3x + 8
- 5.Expand 4(2x − 3).
- 6.A plumber charges a call-out fee plus an hourly rate for a job. The total cost, £C, for a job lasting h hours is given by the formula C = 40 + 25h. What does the number 40 represent in this formula?
- 7.y = 5x − 1. Work out the value of y when x = 3.y = 5x − 1
- 8.Simplify 5x + 3y − 2x + y.
- 9.Which of these is a factor of 15x + 20?
- 10.A ball is dropped and bounces. The height of each bounce after the first is 8 cm less than the bounce before it. The first bounce reaches 60 cm. Work out the height of the 5th bounce.
- 11.A ball's height, h metres, t seconds after being thrown follows h = (t − 1)(9 − t). Given that the ball is at ground level at t = 1 and t = 9, work out at what time t the ball reaches its maximum height, using symmetry.
- 12.Work out the value of a² − 2b when a = −3 and b = 4.
- 13.A sequence has the position-to-term rule n² − 3, where n is the position number. Work out the difference between the 6th term and the 5th term.
- 14.A wall is tiled in rows, and every row uses the same number of tiles. One row uses 10 tiles, two rows use 20 tiles and three rows use 30 tiles. Work out how many tiles are needed for 7 rows.
- 15.The point C is 6 units to the right of the origin and 0 units up. Write down the coordinates of C.
Answer key
- (a) 2x + 24 — Method: multiply each term inside the bracket by the 2 in front of it. Working: 2 × x = 2x and 2 × 12 = 24, and the products are added because the bracket contains an addition. Answer: 2x + 24. The distractors: 2x + 12 comes from multiplying only the x by 2 and copying the 12 across unchanged; 24x comes from multiplying 2 by 12 and then attaching the letter to that product, as though the two terms inside the bracket could be joined into one; 2x + 14 comes from adding 2 and 12 instead of multiplying them.
- (a) 4n + 1 — Method: find the increase in cost per hour, then find the constant by adjusting the 1-hour cost. Working: the cost goes up by £4 for each extra hour (9 − 5 = 4), so the coefficient of n is 4. The constant is the 1-hour cost minus the common difference: 5 − 4 = 1. Answer: the nth term is 4n + 1. 4n + 5 comes from using the 1-hour cost, 5, as the constant without subtracting the common difference. 4n − 3 comes from a slip in working out the constant, subtracting the common difference twice (5 − 4 − 4 = −3) instead of once. n + 4 comes from swapping the hourly increase and the constant.
- (a) 2 m/s² — Method: acceleration = change in speed ÷ time = (17 − 5) ÷ 6 = 12 ÷ 6 = 2 m/s². Distractor origins: 12 m/s² stops after finding the change in speed and forgets to divide by the time; 22 m/s² adds the two speeds instead of subtracting them, and also forgets to divide by time (5 + 17 = 22); 72 m/s² multiplies the change in speed by the time instead of dividing (12 × 6 = 72).
- (d) 8 — Method: compare the equation with y = mx + c, where c is the y-intercept. Working: in y = 3x + 8, the constant term is 8. Answer: the y-intercept is 8. 3 comes from confusing the y-intercept with the gradient. −8 comes from a sign error, treating the constant term as negative. 11 comes from wrongly adding the gradient and the constant term together.
- (c) 8x − 12 — Multiply each term inside the bracket by 4: 4 × 2x = 8x and 4 × (−3) = −12, so 4(2x − 3) = 8x − 12. A candidate who forgets to multiply the second term by 4 gets 8x − 3. A candidate who makes a sign error, treating 4 × (−3) as +12, gets 8x + 12. A candidate who adds 4 to the bracket instead of multiplying gets 2x + 1.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (a) 14 — Substituting x = 3: y = 5(3) − 1 = 15 − 1 = 14. A candidate who stops after the multiplication and forgets to subtract 1 gets 15. A candidate who adds 1 instead of subtracting gets 16. A candidate who incorrectly treats the expression as 5 × (3 − 1) gets 10.
- (c) 3x + 4y — Collect the x terms: 5x − 2x = 3x. Collect the y terms: 3y + y = 4y. So 5x + 3y − 2x + y = 3x + 4y. A candidate who subtracts the y terms instead of adding them (3y − y) gets 3x + 2y. A candidate who adds 2x instead of subtracting it (5x + 2x) gets 7x + 4y. A candidate who wrongly combines the x and y terms into a single term gets 6xy.
- (a) 5 — A factor of the whole expression must divide every term exactly. 15x + 20 = 5(3x + 4), so 5 is a factor. Distractor origins: 3 divides 15x exactly but does not divide 20 exactly; 4 divides 20 exactly but does not divide 15x exactly; 10 also divides 20 exactly but does not divide 15x exactly, so it is a factor of only one term, not of the whole expression.
- (d) 28 — The height decreases by 8 cm at each bounce after the first, so the nth bounce reaches 60−(n−1)×8 cm. For the 5th bounce: 60−4×8=60−32=28. A candidate who subtracts 8 one time too many, five times instead of four, would compute 60−5×8=20. A candidate who adds the decrease instead of subtracting it, a sign error, would compute 60+4×8=92. A candidate who works out only the total decrease and forgets to include the starting height of 60 cm would compute just 5×8=40.
- (d) t = 5 — The maximum height occurs halfway between the two times when the ball is at ground level: the midpoint of t = 1 and t = 9 is (1 + 9) ÷ 2 = 5, so the ball reaches its maximum height at t = 5 seconds. Getting t = 4 comes from halving the DIFFERENCE between the times, 9 − 1 = 8, then 8 ÷ 2 = 4, instead of finding their midpoint. Getting t = 8 uses that difference, 9 − 1 = 8, as if the gap between the two times were itself the time of the maximum. Getting t = 10 adds the two times, 1 + 9 = 10, but forgets to divide by 2.
- (a) 1 — a² − 2b = (−3)² − 2(4) = 9 − 8 = 1. A candidate who squares −3 but keeps the negative sign gets −9 − 8 = −17. A candidate who forgets to square a and substitutes it as −3 gets −3 − 8 = −11. A candidate who adds instead of subtracting 2b gets 9 + 8 = 17.
- (a) 11 — Method: work out each term separately using the rule n² − 3, then subtract. Working: 6th term = 6² − 3 = 36 − 3 = 33. 5th term = 5² − 3 = 25 − 3 = 22. Difference: 33 − 22 = 11. Answer: 11. 8 comes from subtracting the constant −3 once at the end instead of it already being included in both terms, (36 − 25) − 3. 1 comes from working out (6 − 5)² instead of finding 6² and 5² separately and then subtracting. −11 comes from subtracting in the wrong order, the 5th term minus the 6th term instead of the 6th minus the 5th.
- (c) 70 — Method: the numbers of tiles form a sequence in which the same amount is added for each extra row, so the total for a number of rows is that amount multiplied by the number of rows. Working: 20 − 10 = 10 and 30 − 20 = 10, so each row adds 10 tiles; 7 rows therefore need 7 lots of 10, that is 7 × 10. Answer: 70. The distractors: 80 comes from counting one row too many and giving the total for 8 rows; 17 comes from adding the 10 tiles to the 7 rows instead of multiplying; 10 comes from giving the number of tiles in a single row rather than the total for all the rows.
- (a) (6, 0) — Method: a pair of coordinates records movement from the origin, the across movement written first and the up or down movement second. Working: C is 6 units to the right of the origin, so the across number is 6; it is 0 units up, so the up number is 0; written in order that gives (6, 0), a point on the x-axis. Answer: (6, 0). The distractors: (0, 6) comes from writing the two movements the wrong way round; (0, 0) comes from reading '0 units up' as meaning the point never left the origin at all, which ignores the movement across; (7, 0) comes from counting the origin itself as the first unit while counting 6 units to the right.
Build your own mix at the worksheet builder.