Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A sequence has the position-to-term rule: the term is the square of the position number. Its first four terms are 1, 4, 9, 16. Work out the 10th term.
- 2.A rule turns each input x into an output y. The inputs are x = 1, 2, 3, 4 and the matching outputs are y = −5, −3, −1 and one missing value. Work out the missing value of y.
- 3.Which of these rules generates the sequence 6, 11, 16, 21, …?
- 4.Tom is asked to classify the statement 5(2x − 3) = 10x − 15. Which statement about it is correct?
- 5.A colony of bacteria doubles in number every hour. At 9am there are 5 bacteria in the colony. Work out how many bacteria there will be at 12 noon.
- 6.The point F has x-coordinate −1 and lies 6 units above the x-axis. Write down the coordinates of F.
- 7.A delivery van's distance-time graph shows the following: it travels 9 km in the first 15 minutes at a steady speed, stops for 45 minutes to unload, then travels a further 21 km in the next 30 minutes, also at a steady speed. Work out the average speed, in km/h, for the whole journey.
- 8.The volume of a cuboid is given by the formula V = lwh. Work out V, in cm³, when l = 2, w = 3 and h = 6.
- 9.A photo printing service has two adverts for its price. Advert A: cost in pounds = 3(2n + 4) for n photos. Advert B: cost in pounds = 6n + 12. A customer says the two adverts always charge the same amount. Is the customer correct?
- 10.A rule turns each input into an output. An input of 0 gives an output of −1, an input of 1 gives an output of 1, and an input of 2 gives an output of 3. Work out the rule, writing the input as x and the output as y.
- 11.A rope of length L metres is cut into 6 equal pieces, and 4 metres is then removed from one piece. Write an expression, in metres, for the length of that piece after the cut.
- 12.A graph has equation y = −2x² + 5. Which statement about its shape is correct?y = -2x² + 5
- 13.The nth term of a sequence is 4n − 3. Work out the 7th term of the sequence.
- 14.A water tank empties according to y = −5x + 200, where y is the number of litres left after x minutes. Work out the coordinates of the point where this graph crosses the x-axis.y = -5x + 200
- 15.A candle is 30 cm tall when lit and burns at a constant rate. After burning for 5 minutes, its height is 20 cm. The height h cm after t minutes is given by h = 30 − mt. Work out the value of m.
Answer key
- (c) 100 — Method: apply the position-to-term rule straight to the position asked for, since it does not depend on the term before it. Working: the rule squares the position number and the position is 10, so the term is 10², which means 10 × 10. Answer: 100. The distractors: 81 comes from squaring 9 instead of 10, one position short; 20 comes from multiplying the position by 2 instead of squaring it; 1000 comes from cubing the position, 10 × 10 × 10, instead of squaring it.
- (d) 1 — Method: find the step in the outputs for each step of 1 in the input, write the rule from that step and from one pair of values, then apply the rule to the last input. Working: the outputs −5, −3, −1 rise by 2 while x rises in ones, so x is multiplied by 2; at x = 1, 2 × 1 = 2 while y = −5, so 7 is subtracted, giving y = 2x − 7; at x = 4 the rule gives 2 × 4 = 8 and 8 − 7 = 1. Answer: y = 1. The distractors: 3 comes from carrying the outputs on one step too far, to x = 5; 0 comes from assuming the outputs −5, −3, −1 carry on by adding 1 rather than by adding 2; 8 comes from doubling the input and forgetting to subtract the 7.
- (c) 5n + 1 — Method: find the common difference, then use it as the coefficient of n in the position-to-term rule, and find the constant by checking against the first term. Working: the common difference is 5, so the rule has the form 5n + c. Using the 1st term: 5(1) + c = 6, so c = 1. The rule is 5n + 1. Answer: 5n + 1. 5n − 1 uses the correct coefficient but the wrong sign for the constant. 6n comes from using the first term as the coefficient of n instead of the common difference — it matches the 1st term by coincidence but fails from the 2nd term onward. n + 5 swaps the coefficient and the constant around, using the common difference as the constant instead of the coefficient of n.
- (b) An identity, since both sides are equal for every x. — Expanding the left-hand side: 5(2x−3)=10x−15, which is exactly the same as the right-hand side for every value of x, so it is an identity, not an equation that is only true for one particular x. A candidate who treats every equals-sign statement as an equation, without checking whether it holds for all values of x, would choose the equation option. A candidate who mistakes it for a formula is assuming it relates two different letters or quantities, but only x appears — there is no second variable such as area or cost — so it is not a formula. A candidate who mistakes it for an inequality is assuming the two sides are only equal for particular values of x, but expanding shows they are identical for every value, not just some.
- (a) 40 — From 9am to 12 noon is 3 hours, so the population doubles three times: 5 × 2³ = 40. A candidate who counts the elapsed time as 4 hours (an off-by-one counting error) would reach 5 × 2⁴ = 80. A candidate who counts it as only 2 hours would reach 5 × 2² = 20. A candidate who misreads 'doubles' as 'increases by 2' each hour would compute 5 + 3 × 2 = 11.
- (b) (−1, 6) — '6 units above the x-axis' gives a y-coordinate of 6, and the x-coordinate is given as −1, so F = (−1, 6). (6, −1) comes from swapping the x- and y-coordinates. (−1, −6) comes from treating 'above' as a negative direction instead of positive. (1, 6) comes from dropping the negative sign on the given x-coordinate.
- (d) 20 km/h — Method: total distance = 9 + 21 = 30 km. Total time = 15 + 45 + 30 = 90 minutes = 1.5 hours. Average speed = total distance ÷ total time = 30 ÷ 1.5 = 20 km/h. Distractor origins: 40 km/h ignores the 45-minute stop, dividing the total distance by the travel time only (30 km ÷ 45 minutes = 40 km/h); 39 km/h averages the two section speeds, 36 km/h and 42 km/h, instead of using total distance over total time; 36 km/h uses only the first section's speed (9 km in 15 minutes), ignoring the second section and the stop.
- (d) 36 cm³ — V = lwh = 2 × 3 × 6 = 36 cm³. A candidate who adds all three numbers instead of multiplying gets 2 + 3 + 6 = 11 cm³. A candidate who multiplies only two of the three numbers, forgetting the length, gets w × h = 3 × 6 = 18 cm³. A candidate who multiplies l × w and w × h separately and adds the two products gets (2 × 3) + (3 × 6) = 6 + 18 = 24 cm³.
- (a) They always charge the same, since 3(2n + 4) = 6n + 12. — Expand Advert A's formula by multiplying both terms inside the bracket by 3: 3 × 2n = 6n, and 3 × 4 = 12, giving 3(2n + 4) = 6n + 12, which is identical to Advert B's formula — so the two adverts always charge the same amount, whatever n is. Getting 6n + 4 comes from multiplying the 2n by 3 but leaving the 4 unmultiplied. Getting 2n + 7 comes from adding 3 to the bracket instead of multiplying by it. Saying it depends on n avoids expanding the bracket at all — once expanded, both formulas are identical for every value of n, so the cost can be compared directly.
- (b) y = 2x − 1 — Method: in a rule that multiplies and then adds, the multiplier is the step in the outputs for each step of 1 in the input, and the number added on is the output when the input is 0. Working: the inputs 0, 1, 2 rise in ones while the outputs −1, 1, 3 rise by 2 each time, so the input is multiplied by 2; an input of 0 gives 2 × 0 = 0 and the output must be −1, so 1 is subtracted. Answer: y = 2x − 1, checked against the last pair by 2 × 2 − 1 = 3. The distractors: y = 2x + 1 comes from finding the multiplier 2 correctly and then reading the output at an input of 0 as +1 instead of −1; y = x − 1 comes from taking the multiplier as 1 because the inputs go up in ones, instead of using the step in the outputs; y = 3x − 1 comes from reading the largest output, 3, as the multiplier.
- (d) L/6 − 4 — Method: find the length of one equal piece first (divide by 6), then apply the later change (subtract 4) to that piece. Working: one piece is L/6 metres; removing 4 metres from it gives L/6 − 4. Answer: L/6 − 4. L/6 + 4 comes from adding the 4 metres instead of removing it. (L − 4)/6 comes from removing the 4 metres from the whole rope before cutting it into pieces, the wrong order. 4 − L/6 comes from subtracting the piece length from 4 instead of the other way round.
- (d) It is n-shaped, since the x² coefficient is negative. — The coefficient of x² is −2, which is negative, so the quadratic curve opens downward — shaped like an n, with a maximum turning point. Saying it is U-shaped focuses only on x² being non-negative and ignores that the −2 in front of it flips the whole curve to open downward. Saying it is a straight line confuses having a constant term with being linear — any equation with an x² term is a curve, not a line. Saying it repeatedly rises and falls like a wave describes a trigonometric graph such as y = sin x, not a quadratic.
- (b) 25 — Substitute n = 7: 4 × 7 − 3 = 28 − 3 = 25. Forgetting to subtract 3 gives 4 × 7 = 28. Subtracting 3 from 7 before multiplying by 4, 4 × (7 − 3) = 16, applies the operations in the wrong order. Substituting n = 8 by miscounting the position gives 4 × 8 − 3 = 29.
- (a) (40, 0) — Method: a graph crosses the x-axis where y = 0, which in this context is the moment the tank holds no water, so substituting y = 0 and solving gives the time. Working: 0 = −5x + 200 gives 5x = 200, so x = 200 ÷ 5 = 40 and the crossing point is (40, 0); the tank is empty after 40 minutes. Answer: (40, 0). The distractors: (0, 200) is the y-axis crossing, the 200 litres in the tank at the start, found by substituting x = 0 instead of y = 0; (200, 0) comes from reading the constant 200 as the x-coordinate without dividing by the 5 litres lost each minute; (0, 40) has the right number in the wrong place, with the time written as a y-coordinate.
- (a) 2 — The candle's height falls from 30 cm to 20 cm, a drop of 10 cm, over 5 minutes, so m = 10 ÷ 5 = 2. 10 comes from using the drop in height but forgetting to divide by the time. 0.5 comes from dividing the time by the drop instead of the drop by the time (5 ÷ 10). 4 comes from dividing the final height by the time, 20 ÷ 5, instead of using the drop in height.
Build your own mix at the worksheet builder.