Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.Ben writes n + 4 ≤ 9. Which statement describes what Ben has written? Give a reason for your answer.
- 2.The line y = 3x + 6 meets the x-axis at one point. Work out the coordinates of that point.y = 3x + 6
- 3.Write down the gradient of the line with equation y = 7x − 2.y = 7x − 2
- 4.The expression 6n + 15 is written as 3(2n + 5). Which statement is correct?
- 5.A pattern is made from tiles. Pattern 1 uses 4 tiles, pattern 2 uses 7 tiles, pattern 3 uses 10 tiles and pattern 4 uses 13 tiles, with each pattern using 3 more tiles than the one before. Work out an expression, in terms of n, for the number of tiles used in pattern n.
- 6.A car's speed-time graph shows the following: its speed increases steadily from 0 m/s to 20 m/s over the first 10 seconds, then stays constant at 20 m/s for the next 15 seconds. Work out the total distance travelled in the first 25 seconds.
- 7.Aisha saves money each week. In week 1 she has saved £15 in total, in week 2 she has saved £23 in total, in week 3 she has saved £31 in total and in week 4 she has saved £39 in total, with the total increasing by the same amount each week. Work out an expression, in terms of n, for the total amount she has saved, in pounds, after week n.
- 8.Simplify 5x + 3y − 2x + y.
- 9.Solve 6x − 5 = 3x + 13.
- 10.Work out the value of 2(x + 2) when x = −5
- 11.Solve x² − 2x − 24 = 0.
- 12.The point A lies on the x-axis. Which statement about A must be true?
- 13.A geometric sequence starts at 3, and each term after that is found by multiplying the term before it by 2. Write down the first four terms.
- 14.Point P has coordinates (2, −5). P is reflected in the x-axis to point Q. Write down the coordinates of Q.
- 15.A speed-time graph for a car shows the speed increasing steadily from 5 m/s to 17 m/s over 6 seconds. Work out the acceleration of the car, in m/s².
Answer key
- (d) An inequality, because ≤ compares the two sides — The symbol ≤ means 'is less than or equal to', so the statement compares the sizes of the two sides instead of saying they are equal: that makes it an inequality. Solving it gives n ≤ 5, a whole range of values rather than the single value an equation would give. An identity has to be true for every value of the letter, and this fails at n = 6, so it is not one. A formula works one quantity out from another, and there is only one letter here.
- (b) (−2, 0) — Method: a graph meets the x-axis where the y-value is 0, so setting y = 0 turns the equation into a linear equation in x. Working: 0 = 3x + 6 gives 3x = −6, so x = (−6) ÷ 3 = −2 and the meeting point is (−2, 0). Answer: (−2, 0). The distractors: (2, 0) comes from solving 3x = −6 and then dropping the minus sign from the result; (0, 6) is the y-axis crossing, found by substituting x = 0 instead of y = 0; (6, 0) comes from reading the constant 6 straight off as the x-coordinate, without dividing by 3 and without changing its sign.
- (b) 7 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = 7x − 2, the coefficient of x is 7. Answer: the gradient is 7. −2 comes from confusing the gradient with the y-intercept. −7 comes from a sign error, treating the coefficient of x as negative. 2 comes from using the y-intercept but dropping its sign.
- (c) 3 and 2n + 5 are both factors of 6n + 15 — Factors are the parts multiplied together to make an expression; terms are the parts added together. In 3(2n + 5) the 3 and the bracket 2n + 5 are multiplied, so both of them are factors of 6n + 15. The parts added together are 6n and 15, and those are its two terms, not its factors. A factor need not be a number: a bracket containing letters is a factor in exactly the same way.
- (b) 3n + 1 — Method: find how many more tiles each pattern uses, then find the constant by adjusting pattern 1's total. Working: each pattern uses 3 more tiles than the last, so the coefficient of n is 3. The constant is pattern 1's total minus the common difference: 4 − 3 = 1. Answer: the nth term is 3n + 1. 3n + 4 comes from using pattern 1's total, 4, as the constant without subtracting the common difference. 3n − 2 comes from a slip in working out the constant, subtracting the common difference twice (4 − 3 − 3 = −2) instead of once. n + 3 comes from swapping the common difference and the constant.
- (d) 400 m — The distance travelled equals the area under the speed-time graph. The first 10 seconds form a triangle with base 10 and height 20, giving an area of 0.5 × 10 × 20 = 100 m. The next 15 seconds form a rectangle with base 15 and height 20, giving an area of 15 × 20 = 300 m. The total distance is 100 + 300 = 400 m. The option 500 m treats the whole 25 seconds as travelled at the constant 20 m/s, ignoring that the speed was building up during the first 10 seconds: 25 × 20 = 500. The option 300 m only counts the constant-speed section and forgets the triangle section entirely. The option 200 m comes from working out the triangle's area without halving it (10 × 20 = 200) and forgetting the rectangle altogether.
- (c) 8n + 7 — Method: find the weekly increase, then find the constant by adjusting the week 1 total. Working: the total goes up by £8 each week (23 − 15 = 8), so the coefficient of n is 8. The constant is the week 1 total minus the common difference: 15 − 8 = 7. Answer: the nth term is 8n + 7. 8n + 15 comes from using the week 1 total, 15, as the constant without subtracting the common difference. 8n − 1 comes from a slip in working out the constant, subtracting the common difference twice (15 − 8 − 8 = −1) instead of once. 7n + 8 comes from swapping the weekly increase and the constant.
- (c) 3x + 4y — Collect the x terms: 5x − 2x = 3x. Collect the y terms: 3y + y = 4y. So 5x + 3y − 2x + y = 3x + 4y. A candidate who subtracts the y terms instead of adding them (3y − y) gets 3x + 2y. A candidate who adds 2x instead of subtracting it (5x + 2x) gets 7x + 4y. A candidate who wrongly combines the x and y terms into a single term gets 6xy.
- (d) 6 — Method: collect the x-terms on one side and the constants on the other, then divide by the remaining coefficient of x. Working: 6x − 3x = 13 + 5, so 3x = 18, x = 18 ÷ 3 = 6. Answer: x = 6. 2.67 comes from a sign error when moving the 5, subtracting instead of adding: 3x = 13 − 5 = 8, x = 8 ÷ 3 ≈ 2.67. 2 comes from a sign error when moving the x-term, adding instead of subtracting: 9x = 18, x = 2. 18 comes from correctly finding 3x = 18 but forgetting to divide by 3.
- (c) −6 — Method: substitute the value, work out the bracket first, then multiply what the bracket comes to by 2. Working: the bracket gives (−5) + 2 = −3, and multiplying by 2 gives 2 × (−3) = −6. Answer: −6. The distractors: −3 comes from working out the bracket correctly but stopping there and never multiplying by 2; −1 comes from multiplying the 2 inside the bracket by the 2 outside before adding, giving −5 + 4; −8 comes from multiplying only the x by 2 and leaving the 2 inside the bracket unchanged, giving −10 + 2.
- (a) x = 6 or x = −4 — We need two numbers that multiply to −24 and add to −2: these are −6 and 4, since −6 × 4 = −24 and −6 + 4 = −2. So x² − 2x − 24 = (x − 6)(x + 4) = 0, giving x = 6 or x = −4. A candidate who swaps the signs, using 6 and −4 the wrong way round in the brackets, gets x = −6 or x = 4. A candidate who picks the wrong factor pair, 8 and −3 (which multiply to −24 but add to +5, not −2), gets (x + 8)(x − 3) = 0 and answers x = −8 or x = 3. A candidate who makes both factors negative gets x = −6 or x = −4, which would require the constant term to be +24, not −24.
- (a) y = 0 — Method: in the pair (x, y) the first coordinate measures how far left or right of the origin a point is and the second how far above or below the x-axis it is, so a point on an axis has one of those measurements equal to zero. Working: the x-axis is the horizontal line through the origin, so a point sitting on it is neither above nor below that line and its second coordinate is zero, while its first coordinate may be positive, negative or zero. Answer: y = 0. The distractors: x = 0 is the condition for lying on the y-axis, the other axis; x > 0 comes from assuming a point on the x-axis must be to the right of the origin, which is true only of part of that axis; x = y holds only at the origin, which is one point of the x-axis rather than a property shared by all of them.
- (d) 3, 6, 12, 24 — Method: a term-to-term rule is applied to the term just written, so start with the first term and use the rule three more times. Working: the first term is 3; 3 × 2 = 6 is the second; 6 × 2 = 12 is the third; 12 × 2 = 24 is the fourth. Answer: 3, 6, 12, 24. The distractors: 3, 5, 7, 9 comes from adding 2 each time instead of multiplying by 2; 3, 9, 27, 81 comes from multiplying by the first term, 3, instead of by the multiplier 2 the rule gives; 6, 12, 24, 48 comes from doubling before writing anything down, so the list starts one term too late and the given first term is missing.
- (c) (2, 5) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate: Q = (2, 5). (−2, −5) comes from reflecting in the y-axis instead, which changes the sign of the x-coordinate. (−2, 5) comes from reflecting in both axes. (2, −5) comes from not applying the reflection at all.
- (a) 2 m/s² — Method: acceleration = change in speed ÷ time = (17 − 5) ÷ 6 = 12 ÷ 6 = 2 m/s². Distractor origins: 12 m/s² stops after finding the change in speed and forgets to divide by the time; 22 m/s² adds the two speeds instead of subtracting them, and also forgets to divide by time (5 + 17 = 22); 72 m/s² multiplies the change in speed by the time instead of dividing (12 × 6 = 72).
Build your own mix at the worksheet builder.