Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A rule turns each input x into an output y. An input of 1 gives an output of 1, an input of 2 gives an output of 4 and an input of 3 gives an output of 9. Work out the rule.
- 2.Solve 3x − 5 = 4.
- 3.Write down the expression that means the same as m² × m × 3.
- 4.A table shows values of y = x² − x − 6 for x from −3 to 4: at x = −3, y = 6; x = −2, y = 0; x = −1, y = −4; x = 0, y = −6; x = 1, y = −6; x = 2, y = −4; x = 3, y = 0; x = 4, y = 6. Using the table, write down the two roots of x² − x − 6 = 0.y = x²
- 5.Expand and simplify 2(a + 6) − 2(a − 7)
- 6.The graph of y = 20/x is drawn for x > 0. As the value of x increases, what happens to the value of y?
- 7.A quadratic curve has a minimum turning point at (3, −4). Which of these statements about the curve must be true?
- 8.A fundraising chain letter starts with 3 people taking part in round 1. Each following round has 4 times as many people taking part as the round before. Work out the number of people taking part in round 4.
- 9.The graph of a straight line has equation y = 4x − 5. Beth says the y-intercept is 4. Work out the correct y-intercept.y = 4x − 5
- 10.Work out the gradient of the straight line with equation y = (2x/5) − 3.
- 11.The diagram shows the graph of the cost, in pounds, of a taxi journey plotted against the distance travelled, in miles, for journeys of up to 4 miles. The same fixed charge and the same cost per mile apply to longer journeys. Work out the cost of a 6-mile journey.
- 12.The first four terms of a sequence are 4, 6, 8, 10. Work out an expression, in terms of n, for the nth term.
- 13.Solve 5x² − 15x = 0.
- 14.Solve x² − 2x − 24 = 0.
- 15.The simultaneous equations x = 2 and x + y = 9 are given. Work out the value of y.
Answer key
- (c) y = x² — Method: test a candidate rule against every pair given, not just one — a rule that fits one pair and fails another is not the rule. Working: the outputs 1, 4, 9 rise by 3 and then by 5, so they are not going up in equal steps and the input is not simply multiplied by a fixed number; comparing each output with its own input gives 1 × 1 = 1, 2 × 2 = 4 and 3 × 3 = 9, and all three pairs fit. Answer: y = x². The distractors: y = 3x comes from fitting only the last pair, where 3 × 3 = 9, and reading that 3 as a multiplier; y = 3x − 2 comes from assuming a multiply-then-add rule and using the first step in the outputs, 4 − 1 = 3, as the multiplier — it fits the first two pairs and fails the third; y = 2x comes from fitting only the pair 2 and 4 and reading every output as double its input.
- (d) 3 — Method: add the constant term to both sides first, then divide by the coefficient of x. Working: 3x = 4 + 5 = 9; x = 9 ÷ 3 = 3. Answer: x = 3. −1/3 comes from a sign error when moving the 5, subtracting instead of adding: 3x = 4 − 5 = −1, then x = −1/3. 6 comes from subtracting the coefficient 3 instead of dividing by it: 9 − 3 = 6. 9 comes from correctly finding 3x = 9 but forgetting to divide by 3.
- (d) 3m³ — Method: multiply the powers of m by adding their indices, then bring the number coefficient to the front. Working: m² × m has indices 2 and 1; add them to get 3, giving m³, then × 3 gives 3m³. Answer: 3m³. 3m² comes from multiplying the indices instead of adding them: 2 × 1 = 2, giving m², then × 3 = 3m². m³ comes from correctly combining the m's but dropping the coefficient 3. m⁶ comes from multiplying the index by the coefficient instead of writing the coefficient in front: taking the 2 in m² and the 3 to give m raised to the power 2 × 3, which is m⁶, with the lone m left out.
- (d) x = −2 and x = 3 — The roots are the x-values where y = 0. Reading the table, y = 0 at x = −2 and at x = 3, so these are the two roots. Choosing x = −3 and x = 4 picks the endpoints of the table, where y = 6, not where y = 0. Choosing x = −1 and x = 2 picks values near the curve's lowest points, where y = −4, not where the curve crosses the axis. Choosing x = 0 and x = 1 picks the two x-values in the middle of the table without checking their y-values, which are both −6, not 0.
- (d) 26 — Method: expand both brackets, treating the second as multiplication by −2 so that both of its terms change sign, then collect like terms. Working: 2(a + 6) = 2a + 12 and −2(a − 7) = −2a + 14, so the expression becomes 2a + 12 − 2a + 14; the a terms give 2a − 2a = 0, so no term in a survives, and the numbers give 12 + 14 = 26. Answer: 26. The distractors: −2 comes from expanding the second bracket as −2a − 14, so that the numbers give 12 − 14; 4a − 2 comes from adding 2(a − 7) instead of subtracting it, giving 2a + 12 + 2a − 14; 13 comes from multiplying the 2 over only the first term of each bracket, giving 2a + 6 − 2a + 7.
- (b) y decreases towards zero but never reaches it — Method: as x gets larger, dividing 20 by a bigger number gives a smaller result, so y decreases; because 20/x can never be exactly zero for any positive x, the curve gets closer to zero without ever reaching it, so y decreases towards zero but never reaches it. Distractor origins: 'y increases towards a limit but never reaches it' has the relationship backwards, treating y as increasing when it is actually decreasing; 'y decreases at a steady rate and reaches zero' wrongly assumes the graph behaves like a straight line that eventually hits zero; 'y stays the same however large x becomes' wrongly assumes there is no change in y at all.
- (b) It crosses the x-axis, since the minimum is below it. — A minimum turning point at (3, −4) means the lowest value the curve reaches is y = −4, which is below the x-axis (y = 0); since the curve opens upward from there, it must rise up through y = 0 on both sides, crossing the x-axis twice. Saying it does not cross confuses 'the minimum is negative' with 'the whole curve stays negative' — a minimum below the axis guarantees the curve rises above it elsewhere. Saying it touches the x-axis once at (3, −4) mistakes the turning point itself for a root — the turning point is not on the x-axis at all here, since its y-coordinate is −4, not 0. Saying it is impossible to tell ignores that the two facts given — that the turning point is a minimum, and that its y-coordinate is negative — are together enough to decide the number of crossings without knowing the equation.
- (b) 192 — This is a geometric sequence with first term 3 and common ratio 4: round 2 has 3 × 4 = 12, round 3 has 12 × 4 = 48, round 4 has 48 × 4 = 192. A candidate who applies the ×4 multiplier four times instead of three gets 3 × 4⁴ = 768. A candidate who wrongly treats the growth as arithmetic, taking the round 2 figure of 12 as a fixed amount added each round, gets 3, 15, 27, 39. A candidate who forgets the starting 3 people and just works out 4⁴ gets 256.
- (d) −5 — In y = mx + c, the y-intercept is c, the constant term, not the coefficient of x. Here c = −5, so the y-intercept is −5. 4 is Beth's value, the coefficient of x (the gradient), not the intercept. 5 comes from taking the constant term but dropping its negative sign. −4 comes from taking the gradient but giving it the sign of the intercept.
- (a) 2/5 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = (2x/5) − 3, the coefficient of x is 2/5. Answer: the gradient is 2/5. −3 comes from confusing the gradient with the y-intercept. 5/2 comes from inverting the fraction that multiplies x. −2/5 comes from wrongly carrying the negative sign from the −3 term onto the coefficient of x.
- (b) £14 — Method: read the fixed charge (the cost at 0 miles) and the rate (the cost per extra mile) from the graph, then use them to work out the cost for a distance beyond the part that is plotted. Working: the graph shows a fixed charge of £2 at 0 miles, and the cost rises by £2 for every extra mile, so for 6 miles the cost is £2 + (£2 × 6) = £2 + £12 = £14. Answer: £14. Distractor refutation: £12 comes from multiplying the rate by the distance and leaving out the £2 fixed charge. £8 comes from misreading the rate as £1 per mile instead of £2 per mile. £24 comes from adding the fixed charge to the rate first and then multiplying the total by the distance, instead of multiplying the rate by the distance and then adding the fixed charge.
- (c) 2n + 2 — Method: find the common difference between consecutive terms, then find the constant that fits the first term. Working: 6 − 4 = 2, 8 − 6 = 2, 10 − 8 = 2, so the terms increase by 2 each time and the nth term has the form 2n + c. Substituting n = 1: 2(1) + c = 4, so c = 2. Answer: the nth term is 2n + 2. The value 2n comes from using only the common difference and leaving out the constant c entirely. The value 2n + 4 comes from using the first term itself as c, without subtracting the common difference to find the true constant. The value 2n − 2 comes from a sign error when working out c, giving −2 instead of +2.
- (c) x = 0 or x = 3 — Method: take out the common factor 5x: 5x(x − 3) = 0, so 5x = 0 or x − 3 = 0, giving x = 0 or x = 3. Distractor origins: x = 0 or x = 15 comes from forgetting to divide the second term by the common factor 5x correctly, leaving 15 instead of 3; x = 3 loses the solution x = 0 by dividing both sides by x; x = 5 or x = 3 mistakes the coefficient 5 itself for one of the solutions.
- (a) x = 6 or x = −4 — We need two numbers that multiply to −24 and add to −2: these are −6 and 4, since −6 × 4 = −24 and −6 + 4 = −2. So x² − 2x − 24 = (x − 6)(x + 4) = 0, giving x = 6 or x = −4. A candidate who swaps the signs, using 6 and −4 the wrong way round in the brackets, gets x = −6 or x = 4. A candidate who picks the wrong factor pair, 8 and −3 (which multiply to −24 but add to +5, not −2), gets (x + 8)(x − 3) = 0 and answers x = −8 or x = 3. A candidate who makes both factors negative gets x = −6 or x = −4, which would require the constant term to be +24, not −24.
- (b) y = 7 — Method: one of the equations already gives the value of x, so that value is substituted into the other equation. Working: replacing x with 2 in x + y = 9 gives 2 + y = 9, so y = 9 − 2 = 7. Answer: y = 7, and the pair x = 2 with y = 7 satisfies both equations. The distractors: y = 11 comes from rearranging x + y = 9 as y = 9 + x and adding instead of subtracting; y = 9 comes from ignoring the x term and reading the total as the value of y; y = 4.5 comes from halving 9, as though x and y had to be equal.
Build your own mix at the worksheet builder.