Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) £16.70 — The mileage charge is 2.20 × 6 = £13.20. Adding the fixed fee: £13.20 + £3.50 = £16.70. A candidate who forgets the fixed fee gives just the mileage charge, £13.20. A candidate who adds the fixed fee to the per-mile rate before multiplying by the number of miles, (3.50 + 2.20) × 6, gets £34.20. A candidate who rounds £2.20 down to £2 gets 2 × 6 + 3.50 = £15.50.
- (c) y = −x + 30 — Method: in a linear model the value at the start is the constant term and the steady rate of change is the gradient, which is negative when the quantity is falling. Working: at x = 0 the candle is 30 cm tall, so the constant term is 30; it loses 1 cm every hour, so the gradient is −1 and the height after x hours is y = −x + 30. Answer: y = −x + 30. The distractors: y = x + 30 comes from taking the rate as +1 and making the candle grow rather than shrink; y = 30x − 1 comes from building the model correctly as 30 − 1x and then copying it into the form y = mx + c with the two numbers left where they stood, so the starting height 30 ends up multiplying x and the hourly 1 is left behind as the constant being taken away; y = −30x + 1 comes from reading the two numbers the other way round, taking 30 cm per hour as the rate and 1 cm as the starting height, which burns 30 cm an hour from a candle only 1 cm tall.
- (b) x = 4 — Method: every point on a vertical line has the same x-coordinate, so its equation sets x equal to a number, and that number is the x-coordinate of any point known to be on the line. Working: the line is vertical and passes through (4, 7), whose x-coordinate is 4, so every point on the line has x-coordinate 4 and the equation is x = 4. Answer: x = 4. The distractors: y = 7 is the horizontal line through the same point, obtained by fixing the y-coordinate instead of the x-coordinate; x = 7 uses the right form but takes the y-coordinate of the point rather than its x-coordinate; y = 4x treats the 4 as a gradient and gives a sloping line through the origin, which does not pass through (4, 7) at all.
- (a) (2, 7) — Midpoint = ((x1+x2)/2, (y1+y2)/2) = ((−3+7)/2, (5+9)/2) = (4/2, 14/2) = (2, 7). (4, 14) comes from adding the coordinates correctly but forgetting to divide by 2. (2, 9) comes from correctly averaging the x-coordinates but simply copying the y-coordinate of the second point instead of averaging the y-coordinates. (5, 2) comes from subtracting the coordinates instead of adding them before halving: ((7−(−3))/2, (9−5)/2) = (5, 2).
- (b) x = y/3 − 2 — The bracket containing x has been multiplied by 3, so divide both sides by 3 first, which gives y/3 = x + 2. Subtracting 2 from both sides then leaves y/3 − 2 = x, so x = y/3 − 2. Taking the 2 away before dividing gives (y − 2)/3, which divides the 2 by 3 as well, although the 2 was never divided in the original formula. Adding 2 rather than subtracting it gives y/3 + 2, and multiplying by 3 instead of dividing gives 3y − 2.
- (d) Yes, since expanding 6(x − 1) gives 6x − 6. — Expand the bracket: 6(x − 1) = 6 × x − 6 × 1 = 6x − 6, which matches the second expression exactly, so the student is correct for every value of x. Saying 6(x − 1) means 6x − 1 comes from multiplying only the x and forgetting to multiply the 1 by 6. Saying brackets always change an expression's value is not true — expanding here gives back an equivalent expression, not a different one. The identity holds for every value of x, not just whole numbers, since both sides are expanded algebraically, not tested by substitution.
- (a) x = (y + 9) / 2 — Method: undo the subtraction of 9 first, then undo the multiplication by 2. Working: y = 2x − 9, so adding 9 to both sides gives y + 9 = 2x, then dividing both sides by 2 gives x = (y + 9) / 2. The value x = (y − 9) / 2 comes from a sign error, keeping the −9 instead of moving it to +9. The value x = 2(y + 9) comes from multiplying by 2 instead of dividing. The value x = y / 2 + 9 comes from dividing by 2 before adding 9, the wrong order of operations, instead of dividing the whole bracket.
- (c) Line D — Method: the steeper of two lines is the one whose gradient is greater, and the gradient of a line through two points is the change in y divided by the change in x. Working: line C rises 2 for a run of 4, so its gradient is 2 ÷ 4 = 1/2; the other line rises 2 for a run of 2, so its gradient is 2 ÷ 2 = 1; since 1 is greater than 1/2, it is line D that is the steeper. Answer: Line D. The distractors: Line C is chosen by comparing the x-coordinates and calling the line that reaches further along the x-axis the steeper one; They are equally steep comes from comparing only the y-coordinates, which are both 2, without dividing by the two different runs; There is not enough information comes from believing that a gradient can only be measured off a drawn graph, when two points on a line are enough to work it out.
- (d) x < 7 — Method: add 10 to both sides to leave x on its own; adding the same number to both sides never changes the direction of an inequality. Working: adding 10 to both sides of x − 10 < −3 leaves x on the left and −3 + 10 on the right, and −3 + 10 = 7, so x < 7. Answer: x < 7. The distractors: x > 7 comes from turning the sign round while adding, as though every move flipped it; x < −13 comes from subtracting 10 from both sides instead of adding it, giving −3 take away 10; x < 13 comes from ignoring the minus sign on −3 and working out 3 + 10 instead.
- (c) 6 km/h — Total distance = 8 + 4 = 12 km. Total time = 1 hour + 0.5 hours resting + 0.5 hours = 2 hours. Average speed = total distance ÷ total time = 12 ÷ 2 = 6 km/h. A speed of 8 km/h comes from leaving the resting time out of the total time: 12 ÷ 1.5 = 8. A speed of 4 km/h comes from dividing by too much time, such as double-counting the rest period: 12 ÷ 3 = 4. A speed of 12 km/h simply gives the total distance and forgets to divide by the total time at all.
- (a) 4 — Method: set up the equation 35 + 20h = 115, then subtract the fixed fee and divide by the hourly rate. Working: 20h = 115 − 35 = 80; h = 80 ÷ 20 = 4. Answer: 4 hours. 5.75 comes from dividing the whole £115 by £20 without first subtracting the fixed fee: 115 ÷ 20 = 5.75. 2.71 comes from swapping the fee and the rate round, subtracting £20 and dividing by £35: (115 − 20) ÷ 35 ≈ 2.71. 7.5 comes from adding the fixed fee instead of subtracting it: (115 + 35) ÷ 20 = 7.5.
- (b) £47, and T=15+8h is a formula (relates T and h). — The charge is £15 fixed plus £8 for each hour: T=15+8h, so for h=4, T=15+8×4=15+32=47. Because T=15+8h relates two different quantities, the total charge T and the number of hours h, it is a formula, not an equation — an equation is solved for one particular value of an unknown, but this relationship holds for every value of h a job might last. A candidate who forgets to include the fixed £15 fee would compute only 8×4=32. A candidate who adds the three numbers in the formula together instead of multiplying the hourly rate by the number of hours would compute 15+8+4=27. A candidate who correctly finds the charge but mistakes the formula for an equation, treating it as something to be solved for one specific value of h rather than a general relationship between T and h, would pick the correct charge with the wrong classification.
- (c) −2 — Method: rearrange the equation into the form y = mx + c, then read off the gradient. Working: 3y = 12 − 6x, so dividing every term by 3 gives y = 4 − 2x, so the gradient is −2. Answer: the gradient is −2. 2 comes from dropping the negative sign after dividing by 3. 4 comes from using the y-intercept, 4, instead of the gradient. −6 comes from reading off the coefficient of x before dividing the whole equation by 3.
- (a) x = 6 or x = −4 — We need two numbers that multiply to −24 and add to −2: these are −6 and 4, since −6 × 4 = −24 and −6 + 4 = −2. So x² − 2x − 24 = (x − 6)(x + 4) = 0, giving x = 6 or x = −4. A candidate who swaps the signs, using 6 and −4 the wrong way round in the brackets, gets x = −6 or x = 4. A candidate who picks the wrong factor pair, 8 and −3 (which multiply to −24 but add to +5, not −2), gets (x + 8)(x − 3) = 0 and answers x = −8 or x = 3. A candidate who makes both factors negative gets x = −6 or x = −4, which would require the constant term to be +24, not −24.
- (d) (0, −10) — The y-intercept occurs where x = 0. Substituting x = 0 into y = x² + 3x − 10 gives y = 0 + 0 − 10 = −10, so the graph crosses the y-axis at (0, −10). The option (0, 3) mistakenly uses the coefficient of x instead of the constant term. The option (0, 10) makes a sign error, dropping the negative from the constant term. The option (−10, 0) swaps the x- and y-coordinates, which would instead be a point on the x-axis, not the y-axis.
Build your own mix at the worksheet builder.