Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 3 — Method: substitute the given value into the formula and carry out the subtraction in the order the formula is written. Working: replacing m with 8 gives L = 8 − 5, and 8 − 5 = 3. Answer: 3. The distractors: 13 comes from adding 5 to 8 instead of subtracting it; 40 comes from reading m − 5 as a multiplication and working out 8 × 5; −3 comes from subtracting the wrong way round and working out 5 − 8.
- (a) −7 — The coefficient of xy is the number multiplying that exact term, including its sign: in 4x²y − 7xy + 2, the term in xy is −7xy, so the coefficient is −7. Answering 7 correctly picks out the number but drops the minus sign that belongs to it. Answering 4 picks the coefficient of the x²y term instead of the xy term — x²y and xy are different terms because their powers of x differ. Answering −5 combines −7 with the constant term +2, as though the coefficient of xy included the number with no letter attached to it. The coefficient of xy is −7.
- (d) 3n + 2 — The common difference is 3 (8−5=3), so the expression starts 3n. To match the first term when n=1, 3×1+c=5, so c=2: the nth term is 3n+2. A candidate who uses the first term itself as the constant, instead of first term minus the common difference, would write 3n+5 (giving 8, 11, 14, 17 — one term too high throughout). A candidate who omits the constant term altogether would write just 3n (giving 3, 6, 9, 12, not matching the sequence at all). A candidate who adds the common difference to n instead of multiplying would write n+3 (giving 4, 5, 6, 7, far too small).
- (d) 5 — Each term is found by multiplying the previous term by the common ratio, 0.5: 80, 40, 20, 10, and the next term is 10 × 0.5 = 5. A candidate who instead subtracts the same amount each time (repeating the last difference of 10) would reach 10 − 10 = 0. A candidate who divides by 4 instead of by 2 would reach 10 ÷ 4 = 2.5. A candidate who multiplies by 2 instead of dividing (reversing the direction of the sequence) would reach 10 × 2 = 20.
- (b) 6x − 3 = 4x + 9 — Method: multiply every term inside the bracket by the number outside it; the right-hand side stays as it is given. Working: 3 × 2x = 6x and 3 × (−1) = −3, so 3(2x − 1) = 6x − 3. Answer: 6x − 3 = 4x + 9. 6x − 1 = 4x + 9 comes from multiplying only the 2x by 3 and leaving the −1 unchanged. 5x − 3 = 4x + 9 comes from adding the 3 to the 2 instead of multiplying, treating 3 × 2x as (3 + 2)x = 5x. 6x − 4 = 4x + 9 comes from working out 3 × (−1) as −1 − 3 = −4 instead of 3 × (−1) = −3.
- (a) 4x + 2 — Expand the bracket: 4(x − 2) = 4x − 8. Then add the 10 that follows the bracket: 4x − 8 + 10 = 4x + 2. The option 4x − 8 comes from expanding the bracket correctly but then forgetting to add the 10. The option 4x + 8 comes from forgetting to multiply the 2 inside the bracket by 4 (treating it as 4x − 2 instead of 4x − 8), then adding 10. The option 4x + 18 comes from a sign error when expanding — treating 4 × (−2) as +8 instead of −8, giving 4x + 8, then adding 10.
- (b) 7 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = 7x − 2, the coefficient of x is 7. Answer: the gradient is 7. −2 comes from confusing the gradient with the y-intercept. −7 comes from a sign error, treating the coefficient of x as negative. 2 comes from using the y-intercept but dropping its sign.
- (b) y = 2x − 3 — A straight-line graph has an equation of the form y = mx + c, where x appears only to the power 1. Of the four equations, y = 2x − 3 fits this form, so it gives a straight line. y = x² − 3 has x squared, so it gives a curved (quadratic) graph, not a straight line. y = x³ − 3 has x cubed, so it gives a cubic curve. y = 3/x has x on the bottom of a fraction, so it gives a reciprocal curve with two branches.
- (c) 100 — Method: apply the position-to-term rule straight to the position asked for, since it does not depend on the term before it. Working: the rule squares the position number and the position is 10, so the term is 10², which means 10 × 10. Answer: 100. The distractors: 81 comes from squaring 9 instead of 10, one position short; 20 comes from multiplying the position by 2 instead of squaring it; 1000 comes from cubing the position, 10 × 10 × 10, instead of squaring it.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (a) 7 — Subtract 4 from both sides: 3h ≤ 21. Divide both sides by 3: h ≤ 7, so the greatest whole number of hours is 7. A candidate who forgets the £4 fixed fee solves 3h ≤ 25, getting h ≤ 8.33, rounded down to 8. A candidate who adds the £4 instead of subtracting it solves 3h ≤ 29, getting h ≤ 9.67, rounded down to 9. A candidate who reaches h ≤ 7 but wrongly assumes the boundary value cannot be used, thinking that spending the whole £25 is not allowed, answers 6.
- (a) x ≈ 6.70 — Since the two roots sum to 7, the other root is 7 − 0.30 = 6.70. The option 7.30 comes from adding the given root to 7 instead of subtracting it. The option 6.30 comes from subtracting 0.70 (one minus the given root) rather than the given root itself. The option 0.70 confuses the required root with the amount by which the given root falls short of 1.
- (d) Yes: the 8th term is 50 − 8 × 7 = −6, which is negative. — Method: find the 8th term by subtracting 8 a total of 7 times from the first term, since the 1st term itself needs 0 subtractions. Working: 8th term = 50 − 8 × 7 = 50 − 56 = −6, which is negative, so Priya is correct. Answer: Yes, the 8th term is 50 − 8 × 7 = −6, which is negative. The "50 − 8 × 6 = 2" option subtracts 8 only six times instead of seven, an off-by-one error in counting the steps. The "50 − 8 × 8 = −14" option subtracts 8 eight times instead of seven, the opposite off-by-one error. The claim that repeated subtraction "can never go negative" ignores that subtracting enough times from any starting value eventually gives a negative result.
- (c) −2 — Method: rearrange the equation into the form y = mx + c, then read off the gradient. Working: 3y = 12 − 6x, so dividing every term by 3 gives y = 4 − 2x, so the gradient is −2. Answer: the gradient is −2. 2 comes from dropping the negative sign after dividing by 3. 4 comes from using the y-intercept, 4, instead of the gradient. −6 comes from reading off the coefficient of x before dividing the whole equation by 3.
- (c) y = 3x + 5 — Method: find the gradient from the two points, then substitute one point into y = mx + c to find c. Working: gradient = (14 − 2) ÷ (3 − (−1)) = 12 ÷ 4 = 3. Using the point (3, 14): 14 = 3(3) + c, so 14 = 9 + c, giving c = 5. Answer: y = 3x + 5. y = 6x − 4 comes from mishandling the negative x-coordinate, treating 3 − (−1) as 3 − 1 = 2, so the gradient becomes 12 ÷ 2 = 6, and then c = 14 − 18 = −4. y = 3x + 23 comes from a sign error isolating c, adding 9 to 14 instead of subtracting it: c = 14 + 9 = 23. y = x/3 + 13 comes from dividing the change in x by the change in y instead of the other way round, giving a gradient of 4 ÷ 12 = 1/3, and then c = 14 − 1 = 13.
Build your own mix at the worksheet builder.