Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) t = 5 — The maximum height occurs halfway between the two times when the ball is at ground level: the midpoint of t = 1 and t = 9 is (1 + 9) ÷ 2 = 5, so the ball reaches its maximum height at t = 5 seconds. Getting t = 4 comes from halving the DIFFERENCE between the times, 9 − 1 = 8, then 8 ÷ 2 = 4, instead of finding their midpoint. Getting t = 8 uses that difference, 9 − 1 = 8, as if the gap between the two times were itself the time of the maximum. Getting t = 10 adds the two times, 1 + 9 = 10, but forgets to divide by 2.
- (c) x + 18 — Expand −3(2x − 6) by multiplying both terms by −3: −3 × 2x = −6x and −3 × (−6) = 18, giving 7x − 6x + 18 = x + 18. Writing x − 18 comes from not flipping the sign of the −6 inside the bracket, so −3 × (−6) is treated as −18 instead of +18. Writing x + 6 comes from forgetting to multiply the −6 by 3, only carrying its sign. Writing 13x − 18 comes from treating the whole bracket as being added rather than subtracted, so 3(2x − 6) = 6x − 18 is added to 7x.
- (b) 64 — Method: a position-to-term rule is applied straight to the position number, so a term far along the sequence can be found without writing out the terms in between. Working: the rule multiplies the position by itself and the position asked for is 8, so the term is 8 × 8. Answer: 64. The distractors: 16 comes from multiplying the position by 2 instead of by itself; 81 comes from working out 9 × 9, one position too far along; 8 comes from writing down the position number itself as the term.
- (d) x = 3 — The table is symmetrical about the turning point: y = 0 at both x = 1 and x = 5, and the lowest value, y = −4, occurs exactly halfway between them, at x = 3. Choosing x = 5 picks one of the roots rather than the midpoint between them. Choosing x = 1 picks the other root for the same reason. Choosing x = 6 picks the x-value where y returns to its starting value of 5, which is not the turning point.
- (c) (−4, 7) — Left of the origin means negative x, and up means positive y, so the point is (−4, 7). (4, 7) comes from forgetting that 'left' means the x-coordinate is negative. (−4, −7) comes from treating 'up' as a negative direction instead of positive. (7, −4) comes from swapping the x- and y-coordinates.
- (d) 2n + 7 > 15 — An inequality compares two expressions using a symbol other than an equals sign, such as < or >. "2n + 7" is just an expression — it has no equals or inequality sign at all, so a candidate mistaking any bare expression for an inequality would choose this. "2n + 7 = 15" is an equation: it uses an equals sign and is only true for one particular value of n, so a candidate confusing an equation with an inequality would choose this. "P = 2n + 7" is a formula, since it relates two different letters, P and n, with an equals sign, so a candidate confusing a formula with an inequality would choose this. "2n + 7 > 15" is an inequality: it compares an expression with a number using a > sign.
- (a) 5x − 3 = 12 — 5x − 3 = 12 is an equation with exactly one solution: adding 3 and dividing by 5 gives x = 3, and no other value works. 5x − 3 = 5x − 3 is true for every value of x, since both sides are identical — it has infinitely many solutions, not one. 5x − 3 > 12 is an inequality: any value of x greater than 3 satisfies it, so it has a whole range of solutions, not a single one. 5x − 3 = 5x + 2 has no solution at all, since subtracting 5x from both sides leaves −3 = 2, which is never true. The equation with exactly one solution is 5x − 3 = 12.
- (d) 12 — Method: substitute the value into both terms, remembering that subtracting a negative number has the same effect as adding the matching positive number. Working: n² = (−3) × (−3) = 9, and subtracting n means subtracting −3, which adds 3, so the calculation is 9 + 3 = 12. Answer: 12. The distractors: 6 comes from subtracting 3 rather than subtracting −3, giving 9 − 3; −6 comes from squaring −3 as −9 while still adding the 3, giving −9 + 3; −3 comes from reading n² as 2n, giving 2 × (−3) = −6 and then −6 + 3.
- (b) One turning point. — Every quadratic graph, one with an x² term and no higher power of x, has exactly one turning point, since it is a single U-shaped or n-shaped curve. Saying two turning points describes a cubic graph, which can rise, turn, then turn again. Saying no turning points describes a straight line, which has none. Saying four turning points greatly overestimates how many times a simple quadratic curve changes direction — that would need a much higher power of x.
- (a) 9 — Method: the gaps in this sequence are not constant, so work out each of the two terms named from the rule and then subtract the earlier from the later. Working: the 5th term is 5² + 1 = 25 + 1 = 26 and the 4th term is 4² + 1 = 16 + 1 = 17, so the difference is 26 − 17. Answer: 9. The distractors: 7 comes from using the 3rd and 4th terms, one position too early, 17 − 10; 11 comes from using the 5th and 6th terms, one position too late, 37 − 26; 1 comes from subtracting the position numbers, 5 − 4, instead of the terms themselves.
- (d) Formula A gives £39 and Formula B gives £39, and since 3(2n + 5) expands to 6n + 15 for every value of n, the stallholder is correct. — Formula A: 3(2 × 4 + 5) = 3 × 13 = £39. Formula B: 6 × 4 + 15 = 24 + 15 = £39. Expanding Formula A algebraically gives 3(2n + 5) = 6n + 15, which is identical to Formula B for every value of n, not just n = 4, so the stallholder is correct — this is an identity, not a coincidence. The option giving £29 for Formula A comes from multiplying only the 2n by 3 and forgetting to also multiply the 5, then adding the unmultiplied 5: 3 × 2 × 4 = 24, + 5 = 29. The two options that reach the correct numbers but reject the stallholder's claim both use faulty reasoning — matching values at one value of n, or counting terms, does not decide whether two expressions are identical for every n; expanding the bracket does.
- (d) x ≤ 30 — Method: add the fixed cost to the cost of x balloons, set that total against the £150 limit with the sign that 'at most' calls for, then solve. Working: the total spend is 60 + 3x pounds, so 60 + 3x ≤ 150; subtracting 60 from both sides gives 3x ≤ 90; dividing both sides by 3, a positive number, gives x ≤ 30. Answer: x ≤ 30. The distractors: x ≤ 90 comes from taking the cake off the budget and stopping at 3x ≤ 90, reading the 90 as a number of balloons when it is the money left for them; x ≤ 50 comes from dividing the whole £150 by 3 and leaving the cake out of the calculation altogether; x ≥ 30 comes from reading 'at most' as 'at least', which reverses the condition.
- (b) 4, 12, 36, 108 — Method: multiply the previous term by 3 each time, starting from the first term. Working: 4 × 3 = 12, 12 × 3 = 36, 36 × 3 = 108. Answer: 4, 12, 36, 108. 4, 7, 10, 13 comes from adding 3 each time instead of multiplying by 3, confusing this with an arithmetic sequence. 4, 12, 15, 18 comes from multiplying correctly to get the second term, then switching to adding 3 for the rest. 12, 36, 108, 324 comes from listing the terms after the first term, missing off the starting value of 4.
- (d) −3 — Method: rewrite the equation in the form y = mx + c, then read off the gradient. Working: y = 4 − 3x can be written as y = −3x + 4, so comparing with y = mx + c gives m = −3. Answer: the gradient is −3. The value 3 comes from ignoring the negative sign on the x term. The value 4 comes from reading off the y-intercept instead of the gradient. The value −4 comes from a sign error, applying the negative sign to the intercept instead of the gradient.
- (c) The cost, in pounds, for each extra gigabyte of data used — In C = 15 + 2g, the number multiplying g is the gradient, which gives the extra cost for each extra unit of g — here, £2 for each extra gigabyte. 'The fixed monthly fee, in pounds' describes the constant term 15, not the coefficient of g. 'The total number of gigabytes included in the plan' misreads the coefficient as a quantity of data rather than a cost per gigabyte. 'The cost … for each extra 2 gigabytes' doubles the unit the coefficient actually applies to — it is the cost for each single extra gigabyte.
Build your own mix at the worksheet builder.