Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 6x(2x + 3) — The highest common factor of 12x² and 18x is 6x. Dividing each term by 6x gives 12x² ÷ 6x = 2x and 18x ÷ 6x = 3, so 12x² + 18x = 6x(2x + 3). A candidate who only takes out the number 6 (missing the x) gets 6(2x² + 3x), which is not fully factorised. A candidate who only takes out 2x (missing the extra factor of 3 in 6) gets 2x(6x + 9), also not fully factorised — the bracket still shares a common factor. A candidate who takes out 3x instead of the full 6x gets 3x(4x + 6), which again is not fully factorised since 4x + 6 shares a common factor of 2.
- (c) w/6 — Method: a ÷ b is written as a fraction a/b, with the number being divided (w) on top. Working: w ÷ 6 = w/6. Answer: w/6. 6/w comes from writing the numbers the wrong way round, putting the 6 on top instead of w. 6w comes from reading the ÷ sign as ×, multiplying instead of dividing. w − 6 comes from reading ÷ as −, subtracting instead of dividing.
- (b) £14 — Method: read the fixed charge (the cost at 0 miles) and the rate (the cost per extra mile) from the graph, then use them to work out the cost for a distance beyond the part that is plotted. Working: the graph shows a fixed charge of £2 at 0 miles, and the cost rises by £2 for every extra mile, so for 6 miles the cost is £2 + (£2 × 6) = £2 + £12 = £14. Answer: £14. Distractor refutation: £12 comes from multiplying the rate by the distance and leaving out the £2 fixed charge. £8 comes from misreading the rate as £1 per mile instead of £2 per mile. £24 comes from adding the fixed charge to the rate first and then multiplying the total by the distance, instead of multiplying the rate by the distance and then adding the fixed charge.
- (c) The cost, in pounds, for each extra gigabyte of data used — In C = 15 + 2g, the number multiplying g is the gradient, which gives the extra cost for each extra unit of g — here, £2 for each extra gigabyte. 'The fixed monthly fee, in pounds' describes the constant term 15, not the coefficient of g. 'The total number of gigabytes included in the plan' misreads the coefficient as a quantity of data rather than a cost per gigabyte. 'The cost … for each extra 2 gigabytes' doubles the unit the coefficient actually applies to — it is the cost for each single extra gigabyte.
- (b) the first and the third — Method: the sign of a product depends only on the signs of the two numbers multiplied: like signs give a positive product and unlike signs a negative one, so look for the quadrants in which both coordinates carry the same sign. Working: in the first quadrant x and y are both positive, and positive times positive is positive; in the third quadrant both are negative, and negative times negative is positive as well; in the second quadrant x is negative while y is positive, and in the fourth x is positive while y is negative, so each of those gives a negative product. Answer: the first and the third. The distractors: 'the second and the fourth' comes from applying the rule for a NEGATIVE product, unlike signs, to a positive one; 'the first and the second' comes from testing only the y-coordinate and keeping the quadrants where the height is positive; 'the first and the fourth' comes from testing only the x-coordinate in the same way.
- (b) y = 1/x — A graph with two separate curved branches must have a value of x that is excluded from it, creating a break in the curve. For y = 1/x, x = 0 is excluded, so the graph splits into one branch where x and y are both positive, and one where x and y are both negative. y = x² is a single U-shaped curve with no break, even though it has two 'arms'. y = x³ is one continuous curve that passes through the origin without any break. y = 2x + 1 is a single straight line; even though it passes through regions where x and y share the same sign, it is one continuous line, not two separate branches.
- (b) (−2, 0) — Method: a graph meets the x-axis where the y-value is 0, so setting y = 0 turns the equation into a linear equation in x. Working: 0 = 3x + 6 gives 3x = −6, so x = (−6) ÷ 3 = −2 and the meeting point is (−2, 0). Answer: (−2, 0). The distractors: (2, 0) comes from solving 3x = −6 and then dropping the minus sign from the result; (0, 6) is the y-axis crossing, found by substituting x = 0 instead of y = 0; (6, 0) comes from reading the constant 6 straight off as the x-coordinate, without dividing by 3 and without changing its sign.
- (a) 20 — Method: the paper has run out when S = 0, so substitute S = 0 into the equation and solve for t. Working: 0 = 480 − 24t, so 24t = 480, and t = 480 / 24 = 20. Answer: it takes 20 minutes. The value 480 comes from giving the starting number of sheets, the intercept of the equation, instead of solving for t. The value 456 comes from working out 480 − 24 and stopping after one step instead of solving the equation fully. The value 0.05 comes from inverting the division, working out 24 / 480 instead of 480 / 24.
- (b) x ≤ 5 — Method: divide out the bracket first, then undo the number term; the inequality sign turns round only if both sides are multiplied or divided by a negative number. Working: dividing both sides of 2(x − 1) ≤ 8 by 2 gives x − 1 ≤ 4, and 2 is positive so the ≤ is unchanged; adding 1 to both sides gives x ≤ 5. Answer: x ≤ 5. The distractors: x ≤ 3 comes from subtracting 1 from 4 instead of adding 1 to both sides; x ≤ 4 comes from stopping at 8 ÷ 2 = 4 and never undoing the −1 inside the bracket; x < 5 comes from reading ≤ as a strict inequality, which wrongly leaves the boundary value out of the solution set.
- (b) x = 7, y = 3 — Method: one equation contains +y and the other −y, so adding them removes y; the value found is then substituted back to get the other letter. Working: adding x + y = 10 and x − y = 4 gives 2x = 14, so x = 7; substituting into x + y = 10 gives 7 + y = 10, so y = 3. Answer: x = 7, y = 3, and 7 − 3 = 4 as required. The distractors: x = 7, y = 4 comes from finding x correctly and then taking the 4 in x − y = 4 to be the value of y; x = 5, y = 5 comes from splitting the total of 10 equally and never using the difference; x = 14, y = −4 comes from adding the equations to 2x = 14 and forgetting to halve, so that x is taken as 14 and y as 10 − 14.
- (a) −7 — The coefficient of xy is the number multiplying that exact term, including its sign: in 4x²y − 7xy + 2, the term in xy is −7xy, so the coefficient is −7. Answering 7 correctly picks out the number but drops the minus sign that belongs to it. Answering 4 picks the coefficient of the x²y term instead of the xy term — x²y and xy are different terms because their powers of x differ. Answering −5 combines −7 with the constant term +2, as though the coefficient of xy included the number with no letter attached to it. The coefficient of xy is −7.
- (c) (−4, 7) — Left of the origin means negative x, and up means positive y, so the point is (−4, 7). (4, 7) comes from forgetting that 'left' means the x-coordinate is negative. (−4, −7) comes from treating 'up' as a negative direction instead of positive. (7, −4) comes from swapping the x- and y-coordinates.
- (a) y = −2x − 1 — Method: the gradient is the change in y divided by the change in x with both differences taken in the same order, and the constant then comes from substituting either point into y = mx + c. Working: m = (−9 − 3) ÷ (4 − (−2)) = (−12) ÷ 6 = −2, so the line is y = −2x + c; substituting (−2, 3) gives 3 = −2 × (−2) + c = 4 + c, so c = 3 − 4 = −1. Answer: y = −2x − 1. The distractors: y = −2x + 1 comes from rearranging 3 = 4 + c the wrong way round and taking the constant as 4 − 3; y = 2x + 7 comes from losing the minus sign when −12 is divided by 6 and then substituting correctly, 3 = 2 × (−2) + c; y = −(1/2)x + 2 comes from writing the gradient upside down as the change in x over the change in y, 6 ÷ (−12).
- (b) 3 — Method: a term is any part of an expression separated from the rest by a + or − sign, including a number on its own. Working: 8 − 3x + 5x² splits at the + and − signs into 8, −3x and 5x² — that is three separate terms. Answer: 3. Ryan's answer of 2 comes from wrongly excluding the number 8, thinking a term must contain a letter. 5 comes from miscounting by treating the coefficients and powers as separate terms as well as the letters. 1 comes from treating the whole expression as a single term because it is written without brackets.
- (d) 66 — 6 and (4x + 3) are correct factors of 24x + 18. — Substituting x=2 into 24x+18: 24×2+18=48+18=66. Checking the factorisation: 6×4x=24x and 6×3=18, so 6(4x+3)=24x+18, matching the original expression — 6 and (4x+3) are correctly identified as factors. A candidate who substitutes x=2 into (4x+3) but forgets to multiply by the factor 6 afterwards would compute just 4×2+3=11. A candidate who adds 24 and 18 together before multiplying by x, instead of multiplying 24 by x first, would compute (24+18)×2=84. A candidate who distributes the 6 over only the first term inside the brackets, forgetting the second, would check the factorisation as 6×4x=24x but leave the 3 unmultiplied, getting 24x+3 instead of 24x+18 — and would wrongly conclude that 6 and (4x+3) are not correct factors.
Build your own mix at the worksheet builder.