Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) (0, −7) — At the y-axis, x = 0, so y = 2(0) − 7 = −7, giving the point (0, −7). A candidate who drops the negative sign on the constant term would write (0, 7). A candidate who swaps the coordinates, confusing the y-intercept with an x-intercept, would write (−7, 0). A candidate who uses the gradient, 2, as the x-coordinate instead of 0 would write (2, −7).
- (c) The 5 must multiply both terms inside the bracket, so 5(x + 2) expands to 5x + 10, which is never equal to 5x + 2 for any value of x. — Expanding the bracket correctly, 5(x + 2) = 5x + 10, since the 5 multiplies both the x and the 2. This is never equal to 5x + 2, since that would require 10 = 2. The option claiming 5(x + 2) means 5 × x + 2 ignores that the 5 must multiply the whole bracket, not just the x-term. The option about working out the bracket first with a value of x misunderstands algebraic expansion, which holds for every x, not just specific ones. The option about addition before multiplication misapplies the order of operations to bracket expansion, which always distributes the outer factor over every term inside, whatever x is.
- (c) Yes; x = (y + 5)/2 is right — Sam's method is correct throughout: adding 5 to both sides gives y + 5 = 2x, and dividing both sides by 2 gives x = (y + 5)/2, so Sam is right. The option giving x = (y − 5)/2 assumes 5 should be subtracted again, but 2x − 5 = y means 5 has already been subtracted, so it must be added back, not taken away a second time. The option giving x = y/2 + 5 divides only the y term by 2 and leaves the 5 unhalved, which is not a valid rearrangement. The option agreeing Sam is correct but changing step 2 to x = 2(y + 5) confuses '2x' with 'x divided by 2' — since x is multiplied by 2, the inverse is division, not multiplication. Sam's working, and his final formula x = (y + 5)/2, are both correct.
- (b) 3p — p + p + p means three lots of p added together, and repeated addition of the same term is written as a coefficient: 3p. Writing p³ mistakes the repeated addition for repeated multiplication, as if the expression had been p × p × p. Writing 3 + p adds the number of terms (3) onto p as a separate constant, instead of writing 3 as a coefficient of p. Writing just p forgets to count the terms at all, as though repeating the same letter makes no difference. The simplified expression is 3p.
- (d) 10 — The right angle is at (1, 1). The vertical side has length 5 − 1 = 4 and the horizontal side has length 6 − 1 = 5, so the area is (4 × 5) ÷ 2 = 20 ÷ 2 = 10. A candidate who forgets to halve the product of the two sides gets 4 × 5 = 20. A candidate who forgets to subtract the shared vertex's coordinate and uses the raw coordinates 6 and 5 as the side lengths gets (6 × 5) ÷ 2 = 30 ÷ 2 = 15. A candidate who uses only one side length as the area gets 5.
- (d) 6 — Method: rearrange the formula to make d the subject, then substitute C = 133. Working: C = 25 + 18d, so subtracting 25 from both sides gives C − 25 = 18d, then dividing by 18 gives d = (C − 25) / 18. Substituting C = 133: d = (133 − 25) / 18 = 108 / 18 = 6. The value 7.4 comes from dividing 133 by 18 without subtracting the fixed £25 first (133 / 18 ≈ 7.4). The value 4.6 comes from pairing the numbers the wrong way round, working out (133 − 18) / 25 = 4.6. The value 90 comes from subtracting both 25 and 18 from 133 instead of dividing by 18.
- (d) 7a + 56 — Method: multiplying a single term over a bracket means every term inside the bracket is multiplied by the term outside. Working: 7 × a = 7a and 7 × 8 = 56, and the two products are added because the bracket contains an addition. Answer: 7a + 56. The distractors: 7a + 15 comes from adding 7 and 8 instead of multiplying them; 7a + 8 comes from multiplying only the first term inside the bracket and copying the 8 across unchanged; a + 56 comes from multiplying only the 8 and copying the a across unchanged.
- (b) £14 — Method: read the fixed charge (the cost at 0 miles) and the rate (the cost per extra mile) from the graph, then use them to work out the cost for a distance beyond the part that is plotted. Working: the graph shows a fixed charge of £2 at 0 miles, and the cost rises by £2 for every extra mile, so for 6 miles the cost is £2 + (£2 × 6) = £2 + £12 = £14. Answer: £14. Distractor refutation: £12 comes from multiplying the rate by the distance and leaving out the £2 fixed charge. £8 comes from misreading the rate as £1 per mile instead of £2 per mile. £24 comes from adding the fixed charge to the rate first and then multiplying the total by the distance, instead of multiplying the rate by the distance and then adding the fixed charge.
- (a) x + 3 — Method: "years older" is an addition, and the number of years is added to the age that is known in terms of the letter. Working: Jack's age is x, and Kwame is 3 years older, so Kwame's age is x + 3. Answer: x + 3. The distractors: x − 3 comes from reading "older" as "younger" and subtracting instead of adding; 3x comes from reading "3 years older" as "3 times as old" and multiplying; 3 − x comes from writing the calculation the wrong way round, taking Jack's age from the 3 rather than adding.
- (a) −2 and 2 — Method: the graph crosses the x-axis where y = 0, so read the two crossing points straight off the curve. Working: the curve meets the horizontal axis two squares to the left of the origin and two squares to the right, at x = −2 and x = 2. Answer: −2 and 2. Distractor refutation: −4 and 4 comes from reading the value where the curve crosses the y-axis, −4, and using that value and its positive partner as the x-axis crossings instead. −2 and 3 comes from misreading the right-hand crossing point one square out along the grid, taking it where the curve is already above the axis. 0 and 2 comes from confusing the lowest point of the curve, which sits on the y-axis at x = 0, with one of the crossing points.
- (b) 3 — Method: a term is any part of an expression separated from the rest by a + or − sign, including a number on its own. Working: 8 − 3x + 5x² splits at the + and − signs into 8, −3x and 5x² — that is three separate terms. Answer: 3. Ryan's answer of 2 comes from wrongly excluding the number 8, thinking a term must contain a letter. 5 comes from miscounting by treating the coefficients and powers as separate terms as well as the letters. 1 comes from treating the whole expression as a single term because it is written without brackets.
- (d) m³n — m × m × m × n means three m's multiplied together, then multiplied by n, which is written as m³n. Putting the power of 3 on n instead of m, mn³, puts the power on the wrong letter. Writing 3mn treats the repeated multiplication as if it were repeated addition, as if it meant 3 × m × n. Writing m³ + n adds the n instead of multiplying it in.
- (d) 68, and it is a formula — Substituting C = 20 gives F = 1.8 × 20 + 32 = 36 + 32 = 68. The statement F = 1.8C + 32 is a formula because it expresses a general relationship between F and C that holds for any value of C, not just C = 20. A candidate who gets the correct value but calls it an equation is confusing "has an equals sign" with "is an equation" — an equation is only true for particular value(s) of the unknown, whereas this relationship is used to calculate rather than to be solved. A candidate who forgets to multiply C by 1.8 and just adds 32 to 20 gets 52. A candidate who multiplies correctly but forgets to add 32 gets 36.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (c) S = P + C — Method: S has C subtracted from it, so undo that subtraction by adding C to both sides. Working: P + C = S − C + C, so P + C = S, which is written S = P + C. Answer: S = P + C. S = P − C repeats the formula's own operation instead of its inverse. S = C − P subtracts the wrong way round. S = PC multiplies the two given quantities instead of adding them.
Build your own mix at the worksheet builder.