Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 20 — Method: the paper has run out when S = 0, so substitute S = 0 into the equation and solve for t. Working: 0 = 480 − 24t, so 24t = 480, and t = 480 / 24 = 20. Answer: it takes 20 minutes. The value 480 comes from giving the starting number of sheets, the intercept of the equation, instead of solving for t. The value 456 comes from working out 480 − 24 and stopping after one step instead of solving the equation fully. The value 0.05 comes from inverting the division, working out 24 / 480 instead of 480 / 24.
- (a) −7 — The coefficient of xy is the number multiplying that exact term, including its sign: in 4x²y − 7xy + 2, the term in xy is −7xy, so the coefficient is −7. Answering 7 correctly picks out the number but drops the minus sign that belongs to it. Answering 4 picks the coefficient of the x²y term instead of the xy term — x²y and xy are different terms because their powers of x differ. Answering −5 combines −7 with the constant term +2, as though the coefficient of xy included the number with no letter attached to it. The coefficient of xy is −7.
- (d) £195 — Substituting x = 3 into y = 45x + 60 gives y = 45 × 3 + 60 = 135 + 60 = 195. A candidate who forgets to add the call-out fee would get only 45 × 3 = £135. A candidate who adds the hours to the fee and the rate instead of multiplying would get 45 + 60 + 3 = £108. A candidate who multiplies both the hourly rate and the call-out fee by the number of hours would get 45 × 3 + 60 × 3 = £315.
- (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
- (a) 11 — Method: work out each term separately using the rule n² − 3, then subtract. Working: 6th term = 6² − 3 = 36 − 3 = 33. 5th term = 5² − 3 = 25 − 3 = 22. Difference: 33 − 22 = 11. Answer: 11. 8 comes from subtracting the constant −3 once at the end instead of it already being included in both terms, (36 − 25) − 3. 1 comes from working out (6 − 5)² instead of finding 6² and 5² separately and then subtracting. −11 comes from subtracting in the wrong order, the 5th term minus the 6th term instead of the 6th minus the 5th.
- (b) −0.5 — Method: gradient = change in height ÷ horizontal distance, and the height decreases so the change is negative. Working: change in height = 5 − 25 = −20, horizontal distance = 40, so gradient = −20 ÷ 40 = −0.5. Answer: the gradient is −0.5. 0.5 comes from dropping the negative sign, ignoring that the zip-line descends. 2 comes from inverting the gradient, dividing the horizontal distance by the drop in height instead of the other way round. −0.8 comes from dividing the drop by the platform height, 25, instead of by the horizontal distance, 40.
- (d) x = 9 or x = −9 — Taking the square root of both sides of x² = 81 gives x = ±9, i.e. x = 9 or x = −9, since both 9² and (−9)² equal 81. A candidate who forgets the negative square root gives only x = 9. A candidate who halves 81 instead of taking its square root gets x = 40.5. A candidate who squares 81 instead of taking its square root gets x = 6561.
- (d) x = −2 and x = 3 — The roots are the x-values where y = 0. Reading the table, y = 0 at x = −2 and at x = 3, so these are the two roots. Choosing x = −3 and x = 4 picks the endpoints of the table, where y = 6, not where y = 0. Choosing x = −1 and x = 2 picks values near the curve's lowest points, where y = −4, not where the curve crosses the axis. Choosing x = 0 and x = 1 picks the two x-values in the middle of the table without checking their y-values, which are both −6, not 0.
- (d) 12 — Method: substitute the value into both terms, remembering that subtracting a negative number has the same effect as adding the matching positive number. Working: n² = (−3) × (−3) = 9, and subtracting n means subtracting −3, which adds 3, so the calculation is 9 + 3 = 12. Answer: 12. The distractors: 6 comes from subtracting 3 rather than subtracting −3, giving 9 − 3; −6 comes from squaring −3 as −9 while still adding the 3, giving −9 + 3; −3 comes from reading n² as 2n, giving 2 × (−3) = −6 and then −6 + 3.
- (b) b = a/5 — Writing 5b means 5 × b, so b has been multiplied by 5. The inverse of multiplying by 5 is dividing by 5, and dividing both sides by 5 gives a/5 = b, which is written b = a/5. Multiplying both sides by 5 instead gives 5a, which applies the operation a second time; treating the 5 as though it were added gives a − 5; writing 5/a turns the fraction upside down.
- (b) 21 — Method: find the gap between neighbouring terms, then add one gap to the last term that is known. Working: 9 − 5 = 4, 13 − 9 = 4 and 17 − 13 = 4, so 4 is added each time; the 5th term is one step on from the 4th term, so it is 17 + 4. Answer: 21. The distractors: 25 comes from adding the 4 twice and landing on the 6th term; 20 comes from multiplying the position by the common difference, 5 × 4, and ignoring the fact that the sequence starts at 5 rather than at 4; 22 comes from adding the first term, 5, to 17 instead of adding the common difference.
- (d) It crosses the x-axis at x = 3 and x = −3. — y = x² − 9 factorises as (x − 3)(x + 3), since 9 = 3², so the curve crosses the x-axis at x = 3 and x = −3. Saying it crosses once at x = 9 mistakes the constant term for a root directly, without taking its square root. Saying it crosses at x = 9 and x = −9 makes the same mistake but adds a sign either way. Saying it does not cross the x-axis confuses the y-intercept, which is negative at (0, −9), with the number of times the curve meets the x-axis — a negative y-intercept combined with an upward-opening curve guarantees it crosses the x-axis twice.
- (a) 2/5 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = (2x/5) − 3, the coefficient of x is 2/5. Answer: the gradient is 2/5. −3 comes from confusing the gradient with the y-intercept. 5/2 comes from inverting the fraction that multiplies x. −2/5 comes from wrongly carrying the negative sign from the −3 term onto the coefficient of x.
- (a) 4 — Rectangle 1: P = 2(9 + 4) = 2 × 13 = 26 cm. Rectangle 2: P = 2(6 + 5) = 2 × 11 = 22 cm. Difference = 26 − 22 = 4 cm. 2 comes from finding the difference between (l + w) for each rectangle, 13 − 11 = 2, but forgetting to double it. 26 comes from giving rectangle 1's whole perimeter instead of the difference between the two. 6 comes from doubling only the change in length, 2 × (9 − 6), and ignoring that the width also changed.
- (a) It touches the x-axis once, only at x = 4. — (x − 4)² is a square, so it equals zero only when x − 4 = 0, that is at x = 4 — the curve just touches the x-axis there rather than crossing it, since a square cannot be negative on either side to cross through. Saying it crosses at x = 4 and x = −4 wrongly introduces a plus-or-minus, as if taking a square root of x, rather than recognising the bracket is already squared and only zero once. Saying it never touches the x-axis forgets that a squared term CAN equal zero, even though it can never be negative. Saying it crosses at x = 2 and x = −2 confuses (x − 4)² with the different expression x² − 4.
Build your own mix at the worksheet builder.