Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 28 cm — Method: rate = 12 cm ÷ 3 min = 4 cm per minute. Depth after 7 minutes = 4 × 7 = 28 cm. Distractor origins: 84 cm multiplies the given depth by 7 directly, without first finding the rate per minute (12 × 7 = 84); 24 cm simply doubles the given depth instead of scaling correctly by the ratio of times; 16 cm combines the numbers with subtraction and addition (12 − 3 + 7 = 16) instead of finding a rate.
- (c) 2(x + 4) ≡ 2x + 8 — 2(x + 4) ≡ 2x + 8 is an identity because expanding the bracket on the left gives exactly the right-hand side for every value of x — try any number and both sides match. 2(x + 4) = 20 is an equation: expanding gives 2x + 8 = 20, which is only true for the single value x = 6. 2(x + 4) = 2x + 4 is not true for any value of x at all: expanding the left side gives 2x + 8, which can never equal 2x + 4 since 8 ≠ 4. x + 4 = 2x is also an equation, true only for the single value x = 4. The identity is 2(x + 4) ≡ 2x + 8.
- (d) x² − 6x + 9 — Method: squaring a bracket means multiplying that bracket by itself, so expand (x − 3)(x − 3) term by term and then collect like terms. Working: x × x = x², x × (−3) = −3x, (−3) × x = −3x and (−3) × (−3) = 9, giving x² − 3x − 3x + 9, and the two middle terms collect to −6x. Answer: x² − 6x + 9. The distractors: x² − 3x + 9 comes from writing down only one of the two middle products instead of both; x² + 6x + 9 comes from treating (−3) × x as +3x, so the middle terms are added rather than subtracted; x² − 9 comes from treating the square as the difference of two squares (x − 3)(x + 3).
- (d) y = 4 — Method: substitute x = 6 into y = 24/x: y = 24 ÷ 6 = 4. Distractor origins: y = 18 subtracts instead of dividing (24 − 6 = 18); y = 144 multiplies instead of dividing (24 × 6 = 144); y = 30 adds instead of dividing (24 + 6 = 30).
- (c) 5n + 1 — Method: find the common difference, then use it as the coefficient of n in the position-to-term rule, and find the constant by checking against the first term. Working: the common difference is 5, so the rule has the form 5n + c. Using the 1st term: 5(1) + c = 6, so c = 1. The rule is 5n + 1. Answer: 5n + 1. 5n − 1 uses the correct coefficient but the wrong sign for the constant. 6n comes from using the first term as the coefficient of n instead of the common difference — it matches the 1st term by coincidence but fails from the 2nd term onward. n + 5 swaps the coefficient and the constant around, using the common difference as the constant instead of the coefficient of n.
- (c) 6 — Method: rate = amount of fuel used ÷ time taken. Working: fuel used = 50 − 38 = 12 litres, time taken = 2 hours, so rate = 12 ÷ 2 = 6 litres per hour. Answer: the rate is 6 litres per hour. 44 comes from finding the average of the two fuel amounts, (50 + 38) ÷ 2, instead of the fuel used. 12 comes from working out the fuel used but forgetting to divide by the time taken. 19 comes from dividing the remaining fuel, 38, by the time taken instead of the fuel used.
- (d) It is n-shaped, since the x² coefficient is negative. — The coefficient of x² is −2, which is negative, so the quadratic curve opens downward — shaped like an n, with a maximum turning point. Saying it is U-shaped focuses only on x² being non-negative and ignores that the −2 in front of it flips the whole curve to open downward. Saying it is a straight line confuses having a constant term with being linear — any equation with an x² term is a curve, not a line. Saying it repeatedly rises and falls like a wave describes a trigonometric graph such as y = sin x, not a quadratic.
- (d) 3m³ — Method: multiply the powers of m by adding their indices, then bring the number coefficient to the front. Working: m² × m has indices 2 and 1; add them to get 3, giving m³, then × 3 gives 3m³. Answer: 3m³. 3m² comes from multiplying the indices instead of adding them: 2 × 1 = 2, giving m², then × 3 = 3m². m³ comes from correctly combining the m's but dropping the coefficient 3. m⁶ comes from multiplying the index by the coefficient instead of writing the coefficient in front: taking the 2 in m² and the 3 to give m raised to the power 2 × 3, which is m⁶, with the lone m left out.
- (d) 5n − 1 — The common difference is 5 (9−4=5), so the expression starts 5n. To match the first term when n=1, 5×1+c=4, so c=−1: the nth term is 5n−1. A candidate who uses the first term itself as the constant, instead of first term minus the common difference, would write 5n+4 (giving 9, 14, 19, 24 — one term too high throughout). A candidate who omits the constant term altogether would write just 5n (giving 5, 10, 15, 20, not matching the sequence). A candidate who adds the common difference to n instead of multiplying would write n+5 (giving 6, 7, 8, 9, far too small).
- (c) 2x + 12 — Multiply every term inside the bracket by 2: 2 × x = 2x and 2 × 6 = 12, so 2(x + 6) = 2x + 12. Writing 2x + 6 comes from multiplying only the x-term and leaving the 6 unchanged. Writing x + 12 comes from multiplying only the 6 and leaving the x unchanged. Writing 2x + 8 comes from adding 2 and 6 instead of multiplying them.
- (d) 28 — The height decreases by 8 cm at each bounce after the first, so the nth bounce reaches 60−(n−1)×8 cm. For the 5th bounce: 60−4×8=60−32=28. A candidate who subtracts 8 one time too many, five times instead of four, would compute 60−5×8=20. A candidate who adds the decrease instead of subtracting it, a sign error, would compute 60+4×8=92. A candidate who works out only the total decrease and forgets to include the starting height of 60 cm would compute just 5×8=40.
- (d) x = −2 and x = 3 — The roots are the x-values where y = 0. Reading the table, y = 0 at x = −2 and at x = 3, so these are the two roots. Choosing x = −3 and x = 4 picks the endpoints of the table, where y = 6, not where y = 0. Choosing x = −1 and x = 2 picks values near the curve's lowest points, where y = −4, not where the curve crosses the axis. Choosing x = 0 and x = 1 picks the two x-values in the middle of the table without checking their y-values, which are both −6, not 0.
- (c) x = 2 or x = 3 — Method: factorise into two brackets whose numbers multiply to the constant term and add to the coefficient of x, then set each bracket equal to zero. Working: two numbers that multiply to 6 and add to −5 are −2 and −3, so x² − 5x + 6 = (x − 2)(x − 3) = 0; then x − 2 = 0 gives x = 2 and x − 3 = 0 gives x = 3. Answer: x = 2 or x = 3. The distractors: x = −2 or x = −3 comes from reading the numbers inside the brackets as the solutions instead of changing their signs; x = 1 or x = 6 comes from taking the first factor pair of 6 without checking that the pair adds to −5; x = 5 or x = 6 comes from reading the solutions straight off the 5 and the 6 in the equation.
- (d) 3, 6, 12, 24 — Method: a term-to-term rule is applied to the term just written, so start with the first term and use the rule three more times. Working: the first term is 3; 3 × 2 = 6 is the second; 6 × 2 = 12 is the third; 12 × 2 = 24 is the fourth. Answer: 3, 6, 12, 24. The distractors: 3, 5, 7, 9 comes from adding 2 each time instead of multiplying by 2; 3, 9, 27, 81 comes from multiplying by the first term, 3, instead of by the multiplier 2 the rule gives; 6, 12, 24, 48 comes from doubling before writing anything down, so the list starts one term too late and the given first term is missing.
- (c) 16 km/h — Method: total distance = 12 + 8 = 20 km. Total time = 30 + 30 + 15 = 75 minutes = 1.25 hours. Average speed = total distance ÷ total time = 20 ÷ 1.25 = 16 km/h. Distractor origins: 20 km/h gives the total distance without ever dividing by the total time; 24 km/h uses only the speed of the first stage (12 km in 30 minutes), ignoring the second stage and the rest; 28 km/h averages the two separate stage speeds, 24 km/h and 32 km/h, instead of using total distance over total time.
Build your own mix at the worksheet builder.