Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 4 — Method: set up the equation 35 + 20h = 115, then subtract the fixed fee and divide by the hourly rate. Working: 20h = 115 − 35 = 80; h = 80 ÷ 20 = 4. Answer: 4 hours. 5.75 comes from dividing the whole £115 by £20 without first subtracting the fixed fee: 115 ÷ 20 = 5.75. 2.71 comes from swapping the fee and the rate round, subtracting £20 and dividing by £35: (115 − 20) ÷ 35 ≈ 2.71. 7.5 comes from adding the fixed fee instead of subtracting it: (115 + 35) ÷ 20 = 7.5.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (c) x = −2 or x = 7 — Method: each factor equals zero in turn. From x + 2 = 0, x = −2. From x − 7 = 0, x = 7. So x = −2 or x = 7. Distractor origins: x = 2 or x = −7 flips both signs the wrong way; x = −2 or x = −7 wrongly makes both solutions negative; x = 2 or x = 7 ignores the signs in the brackets completely.
- (a) 2 — The candle's height falls from 30 cm to 20 cm, a drop of 10 cm, over 5 minutes, so m = 10 ÷ 5 = 2. 10 comes from using the drop in height but forgetting to divide by the time. 0.5 comes from dividing the time by the drop instead of the drop by the time (5 ÷ 10). 4 comes from dividing the final height by the time, 20 ÷ 5, instead of using the drop in height.
- (a) 3y² — 'y squared, multiplied by 3' means the square is applied to y only, and the result is then multiplied by 3, written as 3y². Writing y³ mistakes the multiplication by 3 for an extra factor of y, adding to the power instead of using a coefficient. Writing (3y)² squares the whole of 3y, including the 3, which gives 9y² rather than 3y² — the square should apply to y alone. Writing 3 + y² adds the 3 instead of multiplying by it. The expression for 'y squared, multiplied by 3' is 3y².
- (d) 50/3 — Method: call the smaller number x, write the larger number in terms of x and use the total. Working: the larger number is 2x, so x + 2x = 50, that is 3x = 50 and x = 50/3. Answer: 50/3, since 50/3 added to 100/3 makes 50 and 100/3 is twice 50/3. The distractors: 100/3 is the larger of the two numbers rather than the smaller one asked for; 25 comes from halving 50 and treating the two numbers as equal; 24 comes from reading 'twice the smaller number' as 'two more than the smaller number' and solving x + (x + 2) = 50.
- (d) −5 — In y = mx + c, the y-intercept is c, the constant term, not the coefficient of x. Here c = −5, so the y-intercept is −5. 4 is Beth's value, the coefficient of x (the gradient), not the intercept. 5 comes from taking the constant term but dropping its negative sign. −4 comes from taking the gradient but giving it the sign of the intercept.
- (a) −5 — Method: apply the machine's operation to the input, and carry the sign of the input through the multiplication. Working: the machine gives 5 × (−1); a positive number multiplied by a negative number gives a negative result, and 5 × 1 = 5, so the output is 5 below zero. Answer: −5, which is one lot of −1 taken five times. The distractors: 5 comes from working out 5 × 1 and losing the minus sign of the input; 4 comes from adding 5 to −1 instead of multiplying; −6 comes from subtracting 5 from −1 instead of multiplying.
- (b) y = 7 — Method: one of the equations already gives the value of x, so that value is substituted into the other equation. Working: replacing x with 2 in x + y = 9 gives 2 + y = 9, so y = 9 − 2 = 7. Answer: y = 7, and the pair x = 2 with y = 7 satisfies both equations. The distractors: y = 11 comes from rearranging x + y = 9 as y = 9 + x and adding instead of subtracting; y = 9 comes from ignoring the x term and reading the total as the value of y; y = 4.5 comes from halving 9, as though x and y had to be equal.
- (c) The 5 must multiply both terms inside the bracket, so 5(x + 2) expands to 5x + 10, which is never equal to 5x + 2 for any value of x. — Expanding the bracket correctly, 5(x + 2) = 5x + 10, since the 5 multiplies both the x and the 2. This is never equal to 5x + 2, since that would require 10 = 2. The option claiming 5(x + 2) means 5 × x + 2 ignores that the 5 must multiply the whole bracket, not just the x-term. The option about working out the bracket first with a value of x misunderstands algebraic expansion, which holds for every x, not just specific ones. The option about addition before multiplication misapplies the order of operations to bracket expansion, which always distributes the outer factor over every term inside, whatever x is.
- (a) 36 km/h — Speed is distance ÷ time. Convert 25 minutes to hours: 25 ÷ 60 = 5/12 hours. Then 15 ÷ (5/12) = 15 × 12/5 = 36 km/h. Dividing 15 by 25 without converting minutes to hours gives 0.6 km/h. Multiplying 15 by 25/60 instead of dividing by it gives 6.25 km/h. Working out the speed in km per minute, 0.6, and then multiplying by 24 instead of 60 gives 14.4 km/h.
- (d) 4n + 2 — Method: find the common difference, then find the constant by adjusting the first term. Working: 10 − 6 = 4, 14 − 10 = 4, so the common difference is 4 and the coefficient of n is 4. The constant is the first term minus the common difference: 6 − 4 = 2. Answer: the nth term is 4n + 2. 4n + 6 comes from using the first term, 6, as the constant without subtracting the common difference. 4n − 2 comes from working out the constant the wrong way round, as the common difference minus the first term (4 − 6 = −2) instead of the first term minus the common difference. 6n + 4 comes from swapping the common difference and the first term.
- (a) 3y² — There is one 3 in the product and the letter y appears twice. A number that multiplies a letter is written in front of it as the coefficient, so the 3 goes at the front. The two ys multiply each other, so the letter carries an index of 2. The shortest correct way of writing the product is therefore 3y². Note that (3y)² would mean 3 × y × 3 × y, which squares the coefficient as well, while 3 + y² turns a multiplication into an addition and y³ treats the coefficient as a third factor of y.
- (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
- (a) 19 — Each time x increases by 1, y increases by 3 (4, 7, 10, 13 — a constant difference of 3). So at x = 4, y = 13 + 3 = 16, and at x = 5, y = 16 + 3 = 19. A candidate who stops one step early, giving the value for x = 4 instead of x = 5, answers 16. A candidate who overcounts and adds three steps of 3 instead of two from x = 3 gets 13 + 9 = 22. A candidate who mistakes the y-intercept (4) for the common difference and adds 4 twice from x = 3 gets 13 + 8 = 21.
Build your own mix at the worksheet builder.