Printable · GCSE Foundation · ages 14-16
Algebra worksheet — GCSE Foundation
Fifteen questions across the algebra statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Algebra worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 10 — The right angle is at (1, 1). The vertical side has length 5 − 1 = 4 and the horizontal side has length 6 − 1 = 5, so the area is (4 × 5) ÷ 2 = 20 ÷ 2 = 10. A candidate who forgets to halve the product of the two sides gets 4 × 5 = 20. A candidate who forgets to subtract the shared vertex's coordinate and uses the raw coordinates 6 and 5 as the side lengths gets (6 × 5) ÷ 2 = 30 ÷ 2 = 15. A candidate who uses only one side length as the area gets 5.
- (d) 8(7x − 3) — Method: find the highest common factor of the two terms, write it in front of a bracket and divide each term by it. Working: 56 = 8 × 7 and 24 = 8 × 3, so the highest common factor is 8; dividing gives 56x ÷ 8 = 7x and 24 ÷ 8 = 3, and the subtraction sign stays between them. Answer: 8(7x − 3), which multiplies back out to 56x − 24. The distractors: 8(7x + 3) comes from dropping the minus sign of −24 while dividing; 8(56x − 3) comes from dividing only the number term by 8 and leaving 56x untouched inside the bracket; 8(7x − 16) comes from subtracting 8 from 24 instead of dividing 24 by 8.
- (b) 37 — The terms are 7, 13, 19, 25, 31, 37 — each found by adding 6 to the term before, so the 6th term is 37. Adding 6 six times to the first term instead of five times, 7 + 6 × 6 = 43, treats the first term as if it were before the sequence starts. Stopping one term early gives the 5th term, 31. Stopping two terms early gives the 4th term, 25.
- (b) (−4, 3) — Method: in a rectangle whose sides are parallel to the axes only two different x-coordinates and two different y-coordinates appear, and each of them is shared by a pair of vertices, so the missing vertex takes the x-coordinate and the y-coordinate that so far appear only once. Working: the x-coordinates given are −4, 2 and 2, so 2 is already used twice and −4 is used once; the y-coordinates given are −1, −1 and 3, so −1 is already used twice and 3 is used once; the fourth vertex therefore has x = −4 and y = 3. Answer: (−4, 3). The distractors: (3, −4) comes from picking the two unpaired coordinates correctly and then writing them in the wrong order; (−4, −5) comes from matching the 4-unit vertical side but measuring it downwards from (−4, −1) instead of upwards; (8, 3) comes from carrying on round the shape with the horizontal step used earlier, adding 6 to the x-coordinate of (2, 3) instead of closing the rectangle.
- (d) 12 — Method: call the younger brother's age x, write the elder brother's age in terms of x, and form an equation from the total. Working: the elder brother is x + 6, so x + (x + 6) = 30; simplifying gives 2x + 6 = 30, subtracting 6 from both sides gives 2x = 24, and dividing by 2 gives x = 12. Checking: 12 and 18 add up to 30 and differ by 6. Answer: 12. The distractors: 18 comes from solving correctly and then giving the elder brother's age, which is not the age asked for; 15 comes from halving 30 and ignoring the 6-year difference altogether; 24 comes from taking 6 off the total, 30 − 6 = 24, and giving that as an age.
- (a) x < 7 — Subtract 5 from both sides: x < 12 − 5, so x < 7. A candidate who adds 5 instead of subtracting gets x < 17. A candidate who subtracts the wrong way round gets x < −7. A candidate who correctly finds 7 but wrongly flips the inequality (as if dividing by a negative had happened) writes x > 7.
- (a) 1 — Method: the value of y when x = 0 is where the line meets the y-axis, which is the constant c in y = mx + c, so the gradient is worked out from the two given points first and the constant follows by substituting one of them. Working: m = (16 − 7) ÷ (5 − 2) = 9 ÷ 3 = 3, so the line is y = 3x + c; substituting x = 2 and y = 7 gives 7 = 3 × 2 + c, so c = 7 − 6 = 1, and the value of y when x = 0 is that constant. Answer: 1. The distractors: 3 comes from stopping at the gradient and offering it as the intercept; 4 comes from stepping back from x = 2 to x = 0 by one unit of x instead of two, 7 − 3 = 4; −1 comes from working the constant out as mx − y, 3 × 2 − 7 = −1, instead of y − mx.
- (b) p = 3n — n = p/3 means p has been divided by 3, so to make p the subject, multiply both sides by 3: p = 3n. Writing p = n/3 leaves the formula exactly as it was, without undoing the division. Writing p = n − 3 mistakes division for subtraction and takes 3 away from n instead of multiplying. Writing p = 3/n incorrectly flips the fraction upside down rather than multiplying n by 3. The correct rearrangement is p = 3n.
- (d) 36 cm³ — V = lwh = 2 × 3 × 6 = 36 cm³. A candidate who adds all three numbers instead of multiplying gets 2 + 3 + 6 = 11 cm³. A candidate who multiplies only two of the three numbers, forgetting the length, gets w × h = 3 × 6 = 18 cm³. A candidate who multiplies l × w and w × h separately and adds the two products gets (2 × 3) + (3 × 6) = 6 + 18 = 24 cm³.
- (d) x = 3 — The table is symmetrical about the turning point: y = 0 at both x = 1 and x = 5, and the lowest value, y = −4, occurs exactly halfway between them, at x = 3. Choosing x = 5 picks one of the roots rather than the midpoint between them. Choosing x = 1 picks the other root for the same reason. Choosing x = 6 picks the x-value where y returns to its starting value of 5, which is not the turning point.
- (c) 71 — Method: square x first, then multiply by 3, then subtract 4, following the order of operations. Working: x² = 5² = 25; 3 × 25 = 75; 75 − 4 = 71. Answer: 71. 221 comes from squaring (3x) as a whole first: (3 × 5)² = 225, then − 4 = 221, squaring the coefficient along with x. 75 comes from correctly working out 3x² but forgetting to subtract the 4. 3 comes from subtracting the 4 from x before squaring: (5 − 4)² × 3 = 3, doing the operations in the wrong order.
- (c) 4 — Method: subtract 3 from both sides, then divide by 4. Working: 4x = 19 − 3 = 16, so x = 16 ÷ 4 = 4. Answer: 4. 4.75 comes from dividing 19 by 4 directly, without subtracting 3 first. 3.75 comes from subtracting 4 instead of 3 before dividing. 5.5 comes from a sign error, adding 3 to 19 instead of subtracting it.
- (c) 10x − 15 — Expand the bracket first: 3(2x − 5) = 6x − 15. Then add the 4x: 6x − 15 + 4x = 10x − 15. The option 10x − 5 comes from forgetting to multiply the 5 inside the bracket by 3 (treating it as 6x − 5), then adding 4x. The option 10x + 15 comes from a sign error when expanding, treating 3 × (−5) as +15 instead of −15, then adding 4x. The option 6x − 15 comes from expanding the bracket correctly but forgetting to add the 4x term at all.
- (d) 3m³ — Method: multiply the powers of m by adding their indices, then bring the number coefficient to the front. Working: m² × m has indices 2 and 1; add them to get 3, giving m³, then × 3 gives 3m³. Answer: 3m³. 3m² comes from multiplying the indices instead of adding them: 2 × 1 = 2, giving m², then × 3 = 3m². m³ comes from correctly combining the m's but dropping the coefficient 3. m⁶ comes from multiplying the index by the coefficient instead of writing the coefficient in front: taking the 2 in m² and the 3 to give m raised to the power 2 × 3, which is m⁶, with the lone m left out.
- (c) y = 9x + 3 — Method: in a linear cost model the charge that is paid once is the constant term and the charge made for each item is the coefficient of x. Working: each pizza costs £9, so x pizzas cost 9x pounds; the £3 delivery fee is paid once whatever the value of x, so it is added on as a constant and the total cost is y = 9x + 3. Answer: y = 9x + 3. The distractors: y = 3x + 9 comes from swapping the two charges over, treating the £3 delivery as a per-pizza cost and the £9 as the one-off charge; y = 9x leaves out the delivery fee altogether, which undercharges every order by £3; y = 12x comes from adding the delivery fee to the price of each pizza, £9 + £3 = £12 each, so the fee is charged once per pizza instead of once per order.
Build your own mix at the worksheet builder.