Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A solid rubber ball has a radius of 3 cm. Work out the volume of the ball. Use π = 3.14.
- 2.Two straight roads cross at a junction. The angle between them, measured with a protractor, is 118°. What is the size of the angle vertically opposite to it?
- 3.A hiker walks on a bearing of 065°. She then turns clockwise through 90° and continues walking in a straight line. What bearing is she now walking on?
- 4.A trapezium has an area of 45 cm², a perpendicular height of 5 cm, and one parallel side of length 10 cm. Work out the length of the other parallel side.
- 5.A crane's hook starts at the point (3.4, 9.5) on a construction site plan measured in metres. It moves along the vector to pick up a beam, then along the vector to place it. Work out the single column vector that describes the hook's overall movement from its start position to where it places the beam.
- 6.A cylinder has a radius of 5 cm. Its volume is 471 cm³. Using π = 3.14, work out the height of the cylinder.
- 7.The angle between north and a footpath is 35°, measured clockwise from north. What is the three-figure bearing of the footpath?
- 8.A scale drawing shows a room that is 5 cm wide. The real room is 15 m wide. Write the scale of the drawing in the form 1 : n.
- 9.A sector of a circle has radius 9 cm and angle 120°. Using π = 3.14, work out the arc length of the sector, to 1 decimal place.
- 10.Loose sweets are sold at £1.20 per 100 g. Work out the cost of 350 g of sweets.
- 11.In a right-angled triangle, θ is one of the acute angles. Write down the trigonometric ratio, in terms of the opposite and adjacent sides, that is used to find θ.
- 12.A sector of a circle has an angle of 90° and an arc length of 15.7 cm. Using π = 3.14, work out the radius of the circle.
- 13.In triangle ABC the angle at C is 90°, AC = 8 cm and the angle at A is 30°. Work out the length of BC. Give your answer to 1 decimal place.
- 14.A kitchen scale is marked in equal divisions of 20 g. The pointer rests three divisions past the 400 g mark. Work out the reading on the scale.
- 15.A sector of a circle has an angle of 90° and an area of 78.5 cm². Using π = 3.14, work out the radius of the circle.
Answer key
- (a) 113.04 cm³ — Method: the volume of a sphere is (4 ÷ 3) × π × r³. Cube the radius, multiply by π, then multiply by 4 and divide by 3. Working: r³ = 3³ = 27, then 3.14 × 27 = 84.78, then 84.78 × 4 = 339.12 and 339.12 ÷ 3 = 113.04. Answer: 113.04 cm³. The distractors: 84.78 cm³ comes from stopping at πr³ and leaving out the four thirds; 37.68 cm³ comes from squaring the radius instead of cubing it, (4 ÷ 3) × 3.14 × 9; 28.26 cm³ comes from using πr², the area of a circle, and labelling it as a volume.
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
- (c) 155° — Turning clockwise adds to the bearing. Starting on a bearing of 065° and turning clockwise through 90° gives 065° + 90° = 155°. A candidate who instead subtracts, working out 90° − 65° = 25°, has performed the wrong operation, giving 025°. A candidate who turns anticlockwise instead of clockwise works out 065° − 90°, which gives a negative number, and adding 360° to fix this gives 335° — the bearing for turning the other way. A candidate who thinks turning does not change the bearing at all keeps the answer as 065°. The new bearing, turning clockwise, is 155°.
- (c) 8 cm — Area of a trapezium = (sum of parallel sides) ÷ 2 × height, so 45 = (a + 10) ÷ 2 × 5. Dividing 45 by 5 gives 9, so (a + 10) ÷ 2 = 9, meaning a + 10 = 18, so a = 18 − 10 = 8 cm. A pupil who correctly finds that the two parallel sides add up to 18 but forgets to subtract the known side of 10 cm gives the sum of both parallel sides, 18 cm, as the answer. A pupil who then adds 10 again by mistake instead of subtracting gets 18 + 10 = 28 cm. A pupil who halves the correct answer by mistake gets 8 ÷ 2 = 4 cm. The correct length of the other parallel side is 8 cm.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (d) 18.8 cm — Arc length is a fraction of the full circumference. Here 120 ÷ 360 = 1/3, and the full circumference is 2 × 3.14 × 9 = 56.52 cm, so the arc is 56.52 ÷ 3 = 18.84 cm, which rounds to 18.8 cm. Forgetting the fraction and giving the full circumference rounds to 56.5 cm. Using 9 cm as a diameter instead of a radius gives an arc of 9.4 cm. Using 120 ÷ 180 instead of 120 ÷ 360 for the fraction gives an arc of 37.7 cm.
- (a) £4.20 — 350 g is 3.5 lots of 100 g, since 350 ÷ 100 = 3.5, so the cost is 3.5 × £1.20 = £4.20. Multiplying the mass in grams directly by the price, without dividing by 100 first, gives £420.00. Working out 100 ÷ 350 instead of 350 ÷ 100 inverts the ratio and gives about £0.34. Rounding 350 g down to 300 g gives 3 × £1.20 = £3.60.
- (c) tan θ = opposite/adjacent — The tangent ratio is defined as tan θ = opposite/adjacent, so this is the ratio that connects the opposite and adjacent sides. "sin θ = opposite/adjacent" wrongly labels this ratio as sine, when sine actually connects the opposite side and the hypotenuse. "cos θ = opposite/adjacent" wrongly labels it as cosine, when cosine connects the adjacent side and the hypotenuse. "tan θ = adjacent/opposite" uses the correct ratio name but has the opposite and adjacent sides the wrong way round.
- (b) 10 cm — Arc length = (angle ÷ 360) × 2 × π × r, so 15.7 = (90 ÷ 360) × 2 × 3.14 × r = 1.57r, giving r = 15.7 ÷ 1.57 = 10 cm. (2.5 cm comes from forgetting the angle fraction and dividing by 2π alone; 20 cm comes from leaving out the factor of 2 in the arc length formula before dividing; 5 cm comes from dividing the arc length by π alone, ignoring both the angle fraction and the factor of 2.)
- (d) 4.6 cm — Method: BC is opposite the 30° angle and AC is next to it, so the ratio that links the two is tan θ = opposite ÷ adjacent. Working: tan 30° = BC ÷ 8, so BC = 8 × tan 30° = 4.6188…, which is 4.6 to 1 decimal place. Answer: 4.6 cm. The distractors: 13.9 cm comes from dividing by tan 30° instead of multiplying by it; 4.0 cm comes from using sin 30°, which treats the 8 cm side as the hypotenuse when it is the side next to the 30° angle; 6.9 cm comes from using cos 30° in place of tan 30°, which gives the wrong pair of sides.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
- (a) 10 cm — Sector area is (angle ÷ 360) × π × radius². Here 90 ÷ 360 = 1/4, and 1/4 × 3.14 = 0.785, so radius² is 78.5 ÷ 0.785 = 100, and the radius is √100 = 10 cm. Stopping after finding radius² and not taking the square root gives 100 cm. Treating 78.5 as the area of the WHOLE circle, ignoring the 90° fraction, gives radius² = 78.5 ÷ 3.14 = 25, so a radius of 5 cm. Correctly finding a radius of 10 cm but then doubling it, mistaking the question for asking the diameter, gives 20 cm.
Build your own mix at the worksheet builder.