Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A ladder of length 7 m leans against a vertical wall. The foot of the ladder is 3 m from the base of the wall. Work out how high up the wall the ladder reaches. Give your answer correct to 1 decimal place.
- 2.A cake recipe takes 135 minutes from start to finish. Write this time as hours and minutes.
- 3.A solid cone has a base radius of 6 cm and a vertical height of 10 cm. Work out the volume of the cone. Use π = 3.14 and give your answer correct to 1 decimal place.
- 4.A robotic arm's tip starts at the point (12.5, −4.25) on a grid measured in centimetres. It moves by the vector to pick up a component, then by the vector to place it. Work out the coordinates of the tip after both moves.
- 5.A sector of a circle has radius 6 cm and an arc length of 15.7 cm. Using π = 3.14, work out the angle of the sector.
- 6.A scale drawing shows a room that is 5 cm wide. The real room is 15 m wide. Write the scale of the drawing in the form 1 : n.
- 7.A triangular flag has a base of 40 cm and a perpendicular height of 25 cm. Work out its area.
- 8.A fish tank is a cuboid measuring 40 cm long, 25 cm wide and 30 cm high. Water is poured in to a depth of 20 cm. Work out the volume of water in the tank, in litres.
- 9.A solid rubber ball has a radius of 3 cm. Work out the volume of the ball. Use π = 3.14.
- 10.A water tank is a cube with edges of length 2 m. Work out how many cubic centimetres the tank holds when it is full.
- 11.A crane's hook starts at the point (3.4, 9.5) on a construction site plan measured in metres. It moves along the vector to pick up a beam, then along the vector to place it. Work out the single column vector that describes the hook's overall movement from its start position to where it places the beam.
- 12.A sailmaker cuts two triangular sail panels from a pattern. Panel X has a 10 m side, with angles of 50° and 75° at its two ends. Panel Y also has a 10 m side, with angles of 50° and 75° at its two ends, in the same arrangement. The sailmaker wants to check the panels will match exactly, without cutting a third measurement. Which condition proves the two panels are congruent?
- 13.A circular coaster has a radius of 4 cm. Work out the circumference of the coaster. Give your answer in terms of π.
- 14.A circular clock face has a radius of 9 cm. Work out the circumference of the clock face. Use π = 3.14. Give your answer to 1 decimal place.
- 15.A hiker starts by walking on a bearing of 245°. She turns clockwise through 50°, then turns clockwise through a further 15°, and continues walking in a straight line. What bearing is she now walking on?
Answer key
- (c) 6.3 m — By Pythagoras' theorem, the height = √(7² − 3²) = √(49 − 9) = √40 = 6.32...≈ 6.3 m. "6.4 m" rounds 6.32...m up to 6.4 instead of correctly rounding it down to 6.3. "4.0 m" comes from subtracting the two given lengths directly, 7 − 3 = 4, instead of subtracting their squares. "10.0 m" comes from adding the two given lengths, 7 + 3 = 10, instead of using Pythagoras' theorem at all.
- (c) 2 hours 15 minutes — Divide the total minutes by 60: 135 ÷ 60 = 2 remainder 15, so that is 2 hours 15 minutes. Treating 100 minutes as one hour, a metric-style mistake, gives 135 − 100 = 35, so 1 hour 35 minutes. Subtracting 60 twice to reach the 15 minutes left over, but losing count and recording only one of the two hours removed, gives 1 hour 15 minutes. Writing 135 ÷ 60 = 2.25 and then reading the '25' as minutes, instead of converting the 0.25 of an hour into 15 minutes, gives 2 hours 25 minutes.
- (a) 376.8 cm³ — Volume of a cone = (1/3)πr²h. Substitute r = 6 and h = 10: (1/3) × 3.14 × 6² × 10 = (1/3) × 3.14 × 36 × 10 = (1/3) × 1130.4 = 376.8 cm³.
- (d) (11, 0.75) — Add the moves to the starting point one component at a time. x: 12.5 + (−3.75) + 2.25 = 11; y: −4.25 + 6.5 + (−1.5) = 0.75, giving (11, 0.75). (8.75, 2.25) stops after the first move only and never applies the second vector. (6.5, 3.75) comes from subtracting the second vector instead of adding it. (0.75, 11) comes from swapping the final x-coordinate and y-coordinate.
- (a) 150° — The arc length is the same fraction of the circumference as the angle is of 360°. The full circumference is 2 × 3.14 × 6 = 37.68 cm, so the angle is 15.7 ÷ 37.68 × 360 = 150°. Treating the 6 cm as a diameter instead of a radius gives a circumference of 18.84 cm and an angle of 300°. Using π = 3 instead of the given 3.14 gives a circumference of 36 cm and an angle of 157°. Treating the fraction 15.7 ÷ 37.68 as being out of 100 rather than 360 gives about 42°.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (c) 500 cm² — The area of a triangle is half of base × height. First, base × height = 40 × 25 = 1,000. Half of 1,000 is 500 cm². 1,000 cm² forgets to halve and just gives base × height. 65 cm² adds the base and height together instead of multiplying them. 2,000 cm² doubles base × height instead of halving it.
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (a) 113.04 cm³ — Method: the volume of a sphere is (4 ÷ 3) × π × r³. Cube the radius, multiply by π, then multiply by 4 and divide by 3. Working: r³ = 3³ = 27, then 3.14 × 27 = 84.78, then 84.78 × 4 = 339.12 and 339.12 ÷ 3 = 113.04. Answer: 113.04 cm³. The distractors: 84.78 cm³ comes from stopping at πr³ and leaving out the four thirds; 37.68 cm³ comes from squaring the radius instead of cubing it, (4 ÷ 3) × 3.14 × 9; 28.26 cm³ comes from using πr², the area of a circle, and labelling it as a volume.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (a) 8π cm — Circumference = 2πr. Substitute r = 4: circumference = 2 × π × 4 = 8π cm. Using r in place of 2r (halving the formula) gives 4π cm. Using the area formula πr² in place of the circumference formula gives π × 4² = 16π cm. Multiplying 2 × 4 without including π at all gives 8 cm.
- (d) 56.5 cm — Circumference = 2πr. With r = 9 cm and π = 3.14, circumference = 2 × 3.14 × 9 = 56.52 cm, which rounds to 56.5 cm. A student who uses πr instead of 2πr, forgetting to double, gets 3.14 × 9 = 28.26 cm, rounding to 28.3 cm. A student who uses the area formula πr² instead of the circumference formula gets 3.14 × 81 = 254.34 cm², rounding to 254.3. A student who doubles the correct circumference by mistake gets 56.52 × 2 = 113.04 cm, rounding to 113.0 cm.
- (d) 310 — Method: since both turns are clockwise, add both angles to the starting bearing. Working: 245° + 50° = 295°; 295° + 15° = 310°. A student who answers 295 has only added the first turn and forgotten the second one. A student who answers 180 has subtracted both turns instead of adding them. A student who answers 320 has added the two turns as 75° instead of 65° by misreading the second turn. Answer: 310°.
Build your own mix at the worksheet builder.