Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.An angle is measured with a protractor as 47°. What type of angle is this?
- 2.A television cable runs in a straight line from the edge of a flat roof 20 m above the ground to a bracket on a wall 5 m above the ground. The horizontal distance between the roof edge and the bracket is 15 m. Work out the length of the cable. Give your answer to 1 decimal place.
- 3.A line segment is measured with a ruler and found to be 6.5 cm long. What is this length in millimetres?
- 4.A sector of a circle has radius 15 cm and angle 216°. Using π = 3.14, work out the arc length of the sector.
- 5.In triangle ABC and triangle DEF, AB = DE, angle ABC = angle DEF and BC = EF. Write down the congruence condition that proves the two triangles are congruent.
- 6.A scale drawing of a park uses a scale of 1 : 2000. A path is drawn 8.5 cm long on the drawing. A cyclist rides the length of the path and then rides straight back again along the same path. How far does the cyclist travel in total, in metres?
- 7.A flagpole is 12 m tall. Freya stands 9 m from the base of the flagpole on level ground. Work out the angle of elevation of the top of the flagpole from where Freya stands. Give your answer correct to 1 decimal place.
- 8.A photograph is 10 cm wide and 15 cm tall. It is enlarged to make a similar poster that is 40 cm wide. The poster costs £0.80 per centimetre of its height to print, based on its full height. Work out the cost of printing the poster.
- 9.A fish tank is a cuboid measuring 40 cm long, 25 cm wide and 30 cm high. Water is poured in to a depth of 20 cm. Work out the volume of water in the tank, in litres.
- 10.A robotic arm's tip starts at the point (12.5, −4.25) on a grid measured in centimetres. It moves by the vector to pick up a component, then by the vector to place it. Work out the coordinates of the tip after both moves.
- 11.A crane's hook starts at the point (3.4, 9.5) on a construction site plan measured in metres. It moves along the vector to pick up a beam, then along the vector to place it. Work out the single column vector that describes the hook's overall movement from its start position to where it places the beam.
- 12.A sprinkler waters a sector-shaped patch of a garden with radius 8 m and angle 90°. Work out the perimeter of the watered sector, to 1 decimal place. (Use π = 3.14.)
- 13.A sector of a circle has an angle of 90° and an arc length of 15.7 cm. Using π = 3.14, work out the radius of the circle.
- 14.The angle between north and a cycle path is 40°, but it is measured anticlockwise from north. What is the three-figure bearing of the cycle path?
- 15.A sector of a circle has radius 9 cm and angle 120°. Using π = 3.14, work out the arc length of the sector, to 1 decimal place.
Answer key
- (b) Acute — An acute angle is any angle less than 90°. Since 47° is less than 90°, it is acute. An obtuse angle is between 90° and 180°, which 47° is not. A reflex angle is greater than 180°, which is far too big for 47°. A right angle is exactly 90°, not 47°. The angle is acute.
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (b) 56.52 cm — Arc length = (216 ÷ 360) × 2 × 3.14 × 15 = 0.6 × 94.2 = 56.52 cm. (28.26 cm comes from leaving out the factor of 2, using πr instead of 2πr; 94.2 cm comes from finding the full circumference and forgetting the angle fraction; 113.04 cm comes from using the diameter, 30 cm, instead of the radius.)
- (b) SAS — Two pairs of matching sides are equal (AB = DE and BC = EF) and the angle between them is equal (angle ABC = angle DEF), which is exactly the Side-Angle-Side congruence test: SAS. SSS is wrong because only two pairs of sides are given, not three. ASA is wrong because only one angle is given, and it sits between the two sides rather than the side sitting between two angles. RHS is wrong because no right angle is mentioned in either triangle.
- (b) 340 — The real length of the path is 8.5 × 2000 = 17000 cm, which converts to 170 m by dividing by 100. The cyclist rides the path there and back, so the total distance is 170 × 2 = 340 m. A candidate who forgets the return journey gives only the one-way distance, 170 m. A candidate who halves the one-way distance instead of doubling it, reading “there and back” as splitting the journey, gets 85 m. A candidate who doubles the scale factor to 4000 by mistake, getting a one-way length of 340 m, and then doubles that for the return journey, gets 680 m. The total distance the cyclist travels is 340 m.
- (b) 53.1° — The angle of elevation is opposite the height of the flagpole, 12 m, and adjacent to the distance from its base, 9 m, so tan θ = 12/9 = 1.333..., giving θ = tan⁻¹(1.333...) = 53.13...° ≈ 53.1°. "36.9°" finds the OTHER acute angle of the triangle, 90° − 53.1°, the angle at the top of the flagpole rather than the angle of elevation at Freya's position. "48.6°" comes from wrongly treating 9/12 as a sine ratio and finding sin⁻¹(0.75) = 48.6°, when neither side here is the hypotenuse. "41.4°" comes from wrongly treating 9/12 as a cosine ratio and finding cos⁻¹(0.75) = 41.4°, again without a hypotenuse in the ratio at all.
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (a) 20 litres — Volume of water = length × width × depth of water = 40 × 25 × 20 = 20 000 cm³. Since 1000 cm³ = 1 litre, divide by 1000: 20 000 ÷ 1000 = 20 litres. A pupil who uses the full height of the tank, 30 cm, instead of the water depth, 20 cm, gets 40 × 25 × 30 = 30 000 cm³ = 30 litres. A pupil who forgets to convert cm³ to litres at all gives 20 000 litres. A pupil who divides by 1000 twice by mistake gets 20 000 ÷ 1000 ÷ 1000 = 0.02 litres. The correct volume of water is 20 litres.
- (d) (11, 0.75) — Add the moves to the starting point one component at a time. x: 12.5 + (−3.75) + 2.25 = 11; y: −4.25 + 6.5 + (−1.5) = 0.75, giving (11, 0.75). (8.75, 2.25) stops after the first move only and never applies the second vector. (6.5, 3.75) comes from subtracting the second vector instead of adding it. (0.75, 11) comes from swapping the final x-coordinate and y-coordinate.
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (a) 28.6 m — The perimeter of a sector is the two straight radii plus the curved arc. This sector's 90° angle is one quarter of a full turn, so its arc length is one quarter of the full circle's circumference. The full circumference is 2 × 3.14 × 8 = 50.24 m, and one quarter of that is 50.24 ÷ 4 = 12.56 m. Add the two 8 m radii: 12.56 + 8 + 8 = 28.56 m, which rounds to 28.6 m. Choosing 12.6 m gives the arc length alone (rounded), forgetting the two straight edges of the sector. Choosing 20.6 m adds only one radius to the arc length instead of two, missing one of the two straight sides. Choosing 41.1 m comes from using the diameter, 16 m, as if it were the radius when working out the arc length (2 × 3.14 × 16 = 100.48, one quarter of which is 25.12), then adding the two correct 8 m radii (25.12 + 8 + 8 = 41.12).
- (b) 10 cm — Arc length = (angle ÷ 360) × 2 × π × r, so 15.7 = (90 ÷ 360) × 2 × 3.14 × r = 1.57r, giving r = 15.7 ÷ 1.57 = 10 cm. (2.5 cm comes from forgetting the angle fraction and dividing by 2π alone; 20 cm comes from leaving out the factor of 2 in the arc length formula before dividing; 5 cm comes from dividing the arc length by π alone, ignoring both the angle fraction and the factor of 2.)
- (b) 320° — A bearing is always measured clockwise from north. An angle measured anticlockwise must be converted by subtracting it from 360°: 360 − 40 = 320°, so the bearing is 320°. Choosing 040° treats the anticlockwise angle as if it were already a clockwise bearing, without converting it. Choosing 220° adds 180° to the angle, mixing this up with a back-bearing calculation (40 + 180 = 220). Choosing 400° adds the angle to 360° instead of subtracting it (40 + 360 = 400), giving a bearing greater than a full turn.
- (d) 18.8 cm — Arc length is a fraction of the full circumference. Here 120 ÷ 360 = 1/3, and the full circumference is 2 × 3.14 × 9 = 56.52 cm, so the arc is 56.52 ÷ 3 = 18.84 cm, which rounds to 18.8 cm. Forgetting the fraction and giving the full circumference rounds to 56.5 cm. Using 9 cm as a diameter instead of a radius gives an arc of 9.4 cm. Using 120 ÷ 180 instead of 120 ÷ 360 for the fraction gives an arc of 37.7 cm.
Build your own mix at the worksheet builder.