Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A cylinder has a radius of 3 cm and a height of 10 cm. Using π = 3.14, work out the volume of the cylinder. Give your answer to the nearest whole number of cubic centimetres.
- 2.A trapezium-shaped garden bed has parallel sides of 2.5 m and 4.5 m, and a perpendicular width of 3 m. A gardener wants to know the area of the bed before ordering topsoil. Work out the area of the garden bed.
- 3.A sector of a circle has radius 10 cm and angle 72°. Using π = 3.14, work out the arc length of the sector.
- 4.A sector of a circle has radius 6 cm and angle 150°. Using π = 3.14, work out the perimeter of the sector.
- 5.In a right-angled triangle, θ is one of the acute angles. Write down the trigonometric ratio, in terms of the opposite and adjacent sides, that is used to find θ.
- 6.A line segment is measured with a ruler and found to be 6.5 cm long. What is this length in millimetres?
- 7.A circular decoration has a radius of 10 cm. A ribbon costs £0.50 per centimetre and is fixed along the curved edge (the arc) of a sector-shaped section with an angle of 90°. Using π = 3.14, work out the cost of the ribbon for this section.
- 8.A sector has an angle of 45°. Priti says: 'The area of the sector is one eighth of the area of the full circle, whatever the radius is.' Is Priti correct?
- 9.Lines PQ and RS are parallel. A straight line crosses PQ at point X and crosses RS at point Y. Angle PXY = 63°. Angle PXY and angle XYS are co-interior (allied) angles, which add up to 180°. Work out the size of angle XYS.
- 10.A gardener wants to buy edging trim to go all the way around a circular flower bed with a diameter of 8 m. Work out the length of edging trim needed, using π = 3.14. Give your answer to the nearest metre.
- 11.In a right-angled triangle, the side opposite angle θ is 6 cm and the hypotenuse is 10 cm. Work out the size of angle θ. Give your answer correct to 1 decimal place.
- 12.A scale drawing shows a room that is 5 cm wide. The real room is 15 m wide. Write the scale of the drawing in the form 1 : n.
- 13.A sector of a circle has radius 9 cm and angle 40°. Work out the area of the sector, in terms of π.
- 14.A vertical line passes through the point (5, 2). Write down the equation of this line.
- 15.A sector of a circle has radius 12 cm and angle 45°. Using π = 3.14, work out the area of the sector.
Answer key
- (d) 283 cm³ — Volume of a cylinder = πr²h. Using π = 3.14: V = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6, which rounds to 283 cm³. A pupil who uses the diameter, 6 cm, instead of the radius gets 3.14 × 6² × 10 = 1130.4 ≈ 1130 cm³. A pupil who forgets to square the radius gets 3.14 × 3 × 10 = 94.2 ≈ 94 cm³. A pupil who uses the circumference formula 2πr instead of πr² gets 2 × 3.14 × 3 × 10 = 188.4 ≈ 188 cm³. The correct volume is 283 cm³.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (d) 12.56 cm — Arc length = (angle ÷ 360) × 2 × π × r = (72 ÷ 360) × 2 × 3.14 × 10 = 0.2 × 62.8 = 12.56 cm. (62.8 cm comes from finding the full circumference and forgetting to take the angle fraction; 6.28 cm comes from leaving out the factor of 2, using πr instead of 2πr; 25.12 cm comes from using the diameter, 20 cm, in place of the radius.)
- (c) 27.7 cm — Arc length = (150 ÷ 360) × 2 × 3.14 × 6 = (5 ÷ 12) × 37.68 = 15.7 cm. The perimeter of a sector also includes the two straight radii, so perimeter = 15.7 + 6 + 6 = 27.7 cm. (15.7 cm comes from stopping after the arc length and forgetting the two straight edges; 21.7 cm comes from adding only one radius instead of two; 31.4 cm comes from doubling the arc length instead of adding the two straight edges.)
- (c) tan θ = opposite/adjacent — The tangent ratio is defined as tan θ = opposite/adjacent, so this is the ratio that connects the opposite and adjacent sides. "sin θ = opposite/adjacent" wrongly labels this ratio as sine, when sine actually connects the opposite side and the hypotenuse. "cos θ = opposite/adjacent" wrongly labels it as cosine, when cosine connects the adjacent side and the hypotenuse. "tan θ = adjacent/opposite" uses the correct ratio name but has the opposite and adjacent sides the wrong way round.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (c) £7.85 — Arc length = (90 ÷ 360) × 2 × 3.14 × 10 = 0.25 × 62.8 = 15.7 cm. Cost = 15.7 × £0.50 = £7.85. (£31.40 comes from finding the full circumference and forgetting the angle fraction; £15.70 comes from using the diameter, 20 cm, in place of the radius; £157.00 comes from multiplying the arc length by the radius instead of by the cost per centimetre.)
- (d) Yes, because 45 ÷ 360 = 1/8, and this fraction applies to any radius. — Priti is correct: 45 ÷ 360 = 1/8, and because sector area = (angle ÷ 360) × full circle area, this fraction depends only on the angle, not on the radius, so it holds for every circle. (The statement giving 45 ÷ 360 = 1/6 comes from an arithmetic slip when simplifying the fraction; the statement that the fraction depends on the radius is wrong because the radius cancels out of the angle fraction in the sector-area formula; the statement adding that it only works for this particular radius is wrong because the 1/8 fraction is true for every radius, not a special case.)
- (c) 117° — Co-interior (also called allied) angles between parallel lines add up to 180°. Angle PXY and angle XYS are co-interior angles, so angle PXY + angle XYS = 180°. 180° − 63° = 117°, so angle XYS = 117°. A student who mistakes co-interior angles for alternate angles, which are equal rather than supplementary, answers 63° instead. A student who treats the two angles as complementary, subtracting from 90° instead of 180°, gets 90° − 63° = 27°. A student who assumes the transversal meets the parallel lines at right angles answers 90°.
- (c) 25 m — The gardener needs the circumference, since the trim goes around the flower bed. Circumference = πd = 3.14 × 8 = 25.12 m, which rounds to 25 m. A student who mistakes the diameter (8 m) for the radius, then doubles it before multiplying by π, gets 3.14 × 16 = 50.24 m, rounding to 50 m. A student who makes the same mistake but uses the area formula instead of the circumference gets 3.14 × 8² = 200.96 m², rounding to 201. A student who correctly halves the diameter to find the radius (4 m) but then uses πr instead of πd gets 3.14 × 4 = 12.56 m, rounding to 13 m.
- (d) 36.9° — sin θ = opposite/hypotenuse = 6/10 = 0.6, so θ = sin⁻¹(0.6) = 36.86...° ≈ 36.9°. "53.1°" finds the OTHER acute angle in the triangle, 90° − 36.9°, instead of θ itself, as if the two acute angles had been swapped. "31.0°" comes from using the tangent ratio instead of sine, working out tan⁻¹(6/10) = 31.0° with the wrong ratio for the two sides given. "36.8°" rounds sin⁻¹(0.6) = 36.86...° down to 36.8° instead of correctly rounding it up to 36.9°.
- (c) 1 : 300 — First convert both lengths to the same unit: 15 m = 1500 cm. The scale compares 5 cm on the drawing to 1500 cm in real life, so dividing both parts by 5 gives a scale of 1 : 300. A candidate who compares 5 to 15 without converting units gets 1 : 3. A candidate who converts 15 m to 150 cm, using the wrong conversion factor, gets 1 : 30. A candidate who converts 15 m to 15000 cm, again using the wrong conversion factor, gets 1 : 3000. The scale of the drawing is 1 : 300.
- (b) 9π cm² — Sector area is the fraction θ/360 of the full circle's area, πr². Substitute θ = 40 and r = 9: 40 out of 360 is one ninth, and the full circle's area is π × 9² = 81π. One ninth of 81π is 9π, so the sector area is 9π cm². Choosing 2π cm² is this sector's ARC LENGTH, not its area — a different formula and a different quantity. Choosing 81π cm² is the area of the WHOLE circle, forgetting to scale down by the sector's angle. Choosing 18π cm² is the CIRCUMFERENCE of the whole circle, 2π × 9, mixed up with an area.
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (c) 56.52 cm² — Sector area = (45 ÷ 360) × 3.14 × 12² = 0.125 × 3.14 × 144 = 56.52 cm². (4.71 cm² comes from forgetting to square the radius; 452.16 cm² comes from finding the area of the whole circle and forgetting the angle fraction; 9.42 cm² comes from using the arc length formula instead of the sector area formula.)
Build your own mix at the worksheet builder.