Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A crane's hook starts at the point (3.4, 9.5) on a construction site plan measured in metres. It moves along the vector to pick up a beam, then along the vector to place it. Work out the single column vector that describes the hook's overall movement from its start position to where it places the beam.
- 2.An ice cream is made from a cone of radius 3 cm and height 10 cm, topped with a hemisphere of the same radius sitting exactly on top of the cone. Work out the total volume of the ice cream. Use π = 3.14. Give your answer to the nearest whole number. Volume of a cone = 1/3 × πr²h. Volume of a sphere = 4/3 × πr³.
- 3.Two similar ponds have perimeters in the ratio 4 : 11. The perimeter of the larger pond is 88 m. Work out the perimeter of the smaller pond.
- 4.Write down which quadrant contains the point (−3, 5) when plotted on a coordinate grid.
- 5.A trapezium-shaped garden bed has parallel sides of 2.5 m and 4.5 m, and a perpendicular width of 3 m. A gardener wants to know the area of the bed before ordering topsoil. Work out the area of the garden bed.
- 6.A ladder of length 7 m leans against a vertical wall. The foot of the ladder is 3 m from the base of the wall. Work out how high up the wall the ladder reaches. Give your answer correct to 1 decimal place.
- 7.A television cable runs in a straight line from the edge of a flat roof 20 m above the ground to a bracket on a wall 5 m above the ground. The horizontal distance between the roof edge and the bracket is 15 m. Work out the length of the cable. Give your answer to 1 decimal place.
- 8.A sailmaker cuts two triangular sail panels from a pattern. Panel X has a 10 m side, with angles of 50° and 75° at its two ends. Panel Y also has a 10 m side, with angles of 50° and 75° at its two ends, in the same arrangement. The sailmaker wants to check the panels will match exactly, without cutting a third measurement. Which condition proves the two panels are congruent?
- 9.A flagpole is 12 m tall. Freya stands 9 m from the base of the flagpole on level ground. Work out the angle of elevation of the top of the flagpole from where Freya stands. Give your answer correct to 1 decimal place.
- 10.A plan of a school hall uses a scale of 1 : 250. A wall is drawn 3.4 cm long on the plan. Sam wants to know the wall's real length in metres. What is it?
- 11.A circle has two straight radii drawn from the centre to the edge, together with the arc between them. Write down the name of the region enclosed by these two radii and the arc.
- 12.A circular coaster has a radius of 4 cm. Work out the circumference of the coaster. Give your answer in terms of π.
- 13.A sector of a circle has radius 9 cm and angle 60°. Using π = 3.14, work out the area of the sector, to 1 decimal place.
- 14.A map has a scale of 1 : 20 000. The distance between two villages is 3.4 km in real life. How long is this distance on the map, in centimetres?
- 15.A cylinder has a radius of 5 cm. Its volume is 471 cm³. Using π = 3.14, work out the height of the cylinder.
Answer key
- (b) $\binom{-0.4}{-7}$ — The overall movement is the sum of the two vectors: (−1.2 + 0.8, −4.5 + (−2.5)) = (−0.4, −7). '$\binom{-2}{-2}$' comes from subtracting the second vector from the first instead of adding them. '$\binom{-0.4}{7}$' gets the top number right but drops the negative sign on the bottom number. '$\binom{2}{-7}$' comes from treating −1.2 + 0.8 as if the signs did not matter, giving +2 instead of −0.4.
- (a) 151 cm³ — Volume of the cone = 1/3 × 3.14 × 3² × 10 = 94.2 cm³. Volume of the hemisphere = 1/2 × (4/3 × 3.14 × 3³) = 1/2 × 113.04 = 56.52 cm³. Total volume = 94.2 + 56.52 = 150.72 cm³, which rounds to 151 cm³. A student who uses a full sphere instead of a hemisphere gets 94.2 + 113.04 = 207.24 cm³, rounding to 207. A student who uses a cylinder instead of a cone for the base, forgetting the 1/3, gets 3.14 × 3² × 10 = 282.6 cm³, plus the hemisphere's 56.52 cm³, totalling 339.12 cm³, rounding to 339.
- (a) 32 m — The scale factor from the larger pond to the smaller pond is 4 ÷ 11, so the smaller perimeter is 88 × 4 ÷ 11 = 32 m. The distractor 242 m comes from using the ratio the wrong way round, 88 × 11 ÷ 4 = 242. The distractor 84 m comes from subtracting the smaller ratio number, 88 − 4 = 84, instead of scaling. The distractor 121 m comes from multiplying 11 × 11 = 121, ignoring the given perimeter altogether.
- (b) second quadrant — The point (−3, 5) has a negative x-coordinate and a positive y-coordinate, and this combination lies in the second quadrant. The first quadrant needs both coordinates positive. The third quadrant needs both coordinates negative. The fourth quadrant needs a positive x-coordinate and a negative y-coordinate.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (c) 6.3 m — By Pythagoras' theorem, the height = √(7² − 3²) = √(49 − 9) = √40 = 6.32...≈ 6.3 m. "6.4 m" rounds 6.32...m up to 6.4 instead of correctly rounding it down to 6.3. "4.0 m" comes from subtracting the two given lengths directly, 7 − 3 = 4, instead of subtracting their squares. "10.0 m" comes from adding the two given lengths, 7 + 3 = 10, instead of using Pythagoras' theorem at all.
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (b) 53.1° — The angle of elevation is opposite the height of the flagpole, 12 m, and adjacent to the distance from its base, 9 m, so tan θ = 12/9 = 1.333..., giving θ = tan⁻¹(1.333...) = 53.13...° ≈ 53.1°. "36.9°" finds the OTHER acute angle of the triangle, 90° − 53.1°, the angle at the top of the flagpole rather than the angle of elevation at Freya's position. "48.6°" comes from wrongly treating 9/12 as a sine ratio and finding sin⁻¹(0.75) = 48.6°, when neither side here is the hypotenuse. "41.4°" comes from wrongly treating 9/12 as a cosine ratio and finding cos⁻¹(0.75) = 41.4°, again without a hypotenuse in the ratio at all.
- (b) 8.5 m — First apply the scale to convert the plan length to a real length in centimetres: 3.4 × 250 = 850 cm. Then convert centimetres to metres by dividing by 100: 850 ÷ 100 = 8.5, so the wall is 8.5 m long. Choosing 850 m applies the scale correctly but forgets to convert the answer from centimetres into metres. Choosing 0.85 m divides by 1000 instead of 100, confusing the centimetre-to-metre conversion with a metre-to-kilometre one. Choosing 3.4 m ignores the scale factor completely and just restates the plan length as if it were already the real length.
- (d) sector — The region enclosed by two radii and the arc between them is called a sector. A segment is a different region, enclosed by a CHORD and an arc — it does not touch the centre at all. A chord is a straight line, not a region, so it cannot be the answer to a question asking for a region. A semicircle is only correct when the angle between the two radii is exactly 180°, which is not stated here, so it is too specific to be the general answer.
- (a) 8π cm — Circumference = 2πr. Substitute r = 4: circumference = 2 × π × 4 = 8π cm. Using r in place of 2r (halving the formula) gives 4π cm. Using the area formula πr² in place of the circumference formula gives π × 4² = 16π cm. Multiplying 2 × 4 without including π at all gives 8 cm.
- (d) 42.4 cm² — Sector area = (angle ÷ 360) × π × r². First, 60 ÷ 360 = 1/6. Next, π × r² = 3.14 × 81 = 254.34 cm². So the area = (1/6) × 254.34 = 42.39 cm², which rounds to 42.4 cm². (4.7 cm² comes from forgetting to square the radius: using π × r = 3.14 × 9 = 28.26, then (1/6) × 28.26 = 4.71 cm²; 254.3 cm² comes from finding the area of the whole circle, 254.34 cm², and forgetting the angle fraction; 9.4 cm² comes from using the arc length formula instead: 2 × π × r = 2 × 3.14 × 9 = 56.52 cm, then (1/6) × 56.52 = 9.42 cm.)
- (a) 17 cm — Convert the real distance to centimetres first: 3.4 km = 340 000 cm. Then divide by the scale factor, 20 000, since the map is 20 000 times smaller than real life: 340 000 ÷ 20 000 = 17, so the map distance is 17 cm. Choosing 1700 cm divides by 200 instead of 20 000, losing two zeros from the scale factor (340 000 ÷ 200 = 1700). Choosing 170 cm divides by 2 000 instead of 20 000, losing one zero from the scale factor (340 000 ÷ 2 000 = 170). Choosing 0.17 cm divides by 2 000 000 instead of 20 000, adding two extra zeros to the scale factor (340 000 ÷ 2 000 000 = 0.17).
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
Build your own mix at the worksheet builder.