Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.How many edges does a triangular prism have?
- 2.A roof truss is shaped like an isosceles triangle resting on a horizontal ceiling joist. The truss's sloping edges are equal in length, and the angle at its apex is 40°. The ceiling joist continues in a straight line beyond the foot of the truss. Work out the angle between the truss's sloping edge and the extended joist, on the outside of the truss.
- 3.A parallelogram has a base of 9 cm and a perpendicular height of 4 cm. Work out its area.
- 4.Two of the angles in a triangle are 50° and 70°. Work out the size of the third angle.
- 5.Two straight roads cross at a junction. The angle between them, measured with a protractor, is 118°. What is the size of the angle vertically opposite to it?
- 6.A rectangular gate is braced with a diagonal strut. The gate is 1.2 m wide and 0.9 m tall. Work out the exact length of the diagonal strut.
- 7.The angle between north and a footpath is 35°, measured clockwise from north. What is the three-figure bearing of the footpath?
- 8.A rhombus has all four sides equal in length. Which statement about a rhombus is correct?
- 9.A triangle has vertices A(1, 1), B(5, 1) and C(5, 4). Work out the lengths of AB, BC and CA, and write down whether triangle ABC is right-angled.
- 10.The curved part of a circle's circumference, between two points on the circle, has its own name. Write down this name.
- 11.Two triangles are similar. The sides of the first triangle are 3 cm, 4 cm and 5 cm. The shortest side of the second triangle is 9 cm. Work out the scale factor from the first triangle to the second.
- 12.A line segment is measured with a ruler and found to be 6.5 cm long. What is this length in millimetres?
- 13.A sector of a circle has radius 8 cm and takes up three-quarters of the full circle. Work out the perimeter of the sector, in terms of π.
- 14.A roof truss has two horizontal parallel rafters, one above the other. A straight strut crosses both rafters. Where the strut crosses the lower rafter, the angle above the rafter and to the left of the strut is 65°. Work out the size of the angle above the upper rafter and to the right of the strut, where the strut crosses it.
- 15.A cable supporting a flagpole is anchored to the ground 5 m from the base of the pole. The cable makes an angle of 60° with the ground. Using the exact value of tan 60°, work out the exact height of the flagpole.
Answer key
- (a) 9 — A triangular prism has two triangular ends and three rectangular side faces. Each triangular end contributes 3 edges, giving 6 edges for both ends, and three more edges run lengthways to join the two ends together: 6 + 3 = 9 edges. Choosing 6 counts only the vertices (3 on each triangular end). Choosing 5 counts the faces (2 triangular + 3 rectangular) instead of the edges. Choosing 12 is the edge count of a cuboid, not a triangular prism.
- (a) 110° — The truss is isosceles, so its two base angles are equal; since the three angles of the triangle add up to 180° and the apex is 40°, each base angle is (180 − 40) ÷ 2 = 70°. The angle between the sloping edge and the joist, extended beyond the base of the truss, sits on a straight line with that 70° base angle, and angles on a straight line add up to 180°, so the required angle is 180 − 70 = 110°. "70°" comes from stopping after finding the base angle and giving it directly, without also using the straight-line fact to find the angle on the OUTSIDE of the truss. "140°" comes from doubling the base angle instead of using the straight-line fact. "20°" comes from taking half of the apex angle (40° ÷ 2), mistaking it for the required angle instead of properly using the triangle's angle sum.
- (c) 36 cm² — The area of a parallelogram is base × height = 9 × 4 = 36 cm². 26 cm² is 2 × (9 + 4), the perimeter you would get by treating the perpendicular height as though it were a side length — and a perimeter is a length, not an area. 18 cm² uses the triangle formula, half of base × height, by mistake. 72 cm² doubles the correct area.
- (a) 60° — Method: the three angles of a triangle add up to 180°, so add the two known angles and subtract the total from 180°. Working: 50 + 70 = 120, then 180 − 120 = 60. Answer: 60°. The distractors: 120° is the sum of the two known angles, given as the answer instead of being subtracted from 180°; 110° comes from subtracting only the 70° angle from 180° and forgetting the 50° one; 240° comes from subtracting the sum from 360°, using the angles at a point rather than the angle sum of a triangle.
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
- (d) 1.5 m — By Pythagoras' theorem, diagonal² = 1.2² + 0.9² = 1.44 + 0.81 = 2.25, so diagonal = √2.25 = 1.5 m. 2.1 m comes from simply adding the two sides (1.2 + 0.9) instead of using Pythagoras' theorem. 0.3 m comes from subtracting the two sides (1.2 − 0.9) instead. 2.25 m comes from correctly finding 1.2² + 0.9² = 2.25 but forgetting to take the square root at the end.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (b) Its diagonals cross at right angles — In a rhombus, the diagonals always bisect each other at right angles, because a rhombus is a parallelogram with all four sides equal. Its diagonals are not always equal in length — that is a property of a rectangle, and only holds for a rhombus in the special case where it is also a square. It does not always have four right angles — again, that is only true when the rhombus is also a square. Its order of rotational symmetry is generally 2, not 4; order 4 only happens when the rhombus is a square.
- (d) Yes, since 3² + 4² = 5² — AB is horizontal with length 5 − 1 = 4, BC is vertical with length 4 − 1 = 3, and CA = √(4² + 3²) = √25 = 5. Since the two shorter sides satisfy 3² + 4² = 5², the triangle is right-angled, with the right angle at B. "No, since 3 + 4 ≠ 5" wrongly tests Pythagoras' theorem by adding the sides instead of squaring them first. "No, since AB, BC and CA are not all equal" confuses a right-angled triangle with an equilateral one — a triangle does not need equal sides to have a right angle. "Yes, since 4² + 5² = 3²" reaches the correct conclusion but puts the longest side, 5, on the wrong side of the equation, as if it were one of the two shorter sides instead of the hypotenuse.
- (a) arc — A curved part of a circle's circumference, between two points, is called an arc. A chord is the straight line joining those two points, not the curved part. A segment is the region enclosed between a chord and an arc, and a sector is the region enclosed between two radii and an arc — both segment and sector are regions, not curved lengths.
- (b) 3 — Method: the scale factor is a length of the second triangle divided by the corresponding length of the first, and corresponding means shortest paired with shortest. Working: the shortest side of the first triangle is 3 cm and the shortest side of the second is 9 cm, so the scale factor is 9 ÷ 3 = 3. Answer: 3. The distractors: 1/3 comes from dividing 3 by 9, which is the scale factor from the second triangle back to the first; 6 comes from subtracting, 9 − 3, treating the scale factor as a difference rather than a multiplier; 1.8 comes from dividing 9 by 5, pairing the second triangle's shortest side with the first triangle's longest side.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (a) 12π + 16 cm — A three-quarter sector's perimeter is the curved arc plus the two straight radii that close the shape. The full circumference is 2 × π × 8 = 16π cm, and three-quarters of that is 12π cm. Adding the two straight radii, 8 cm each, gives 12π + 16 cm. Leaving out the straight edges gives just 12π cm. Using one-quarter of the circumference, the piece left over rather than the piece asked for, gives 4π + 16 cm. Adding only one radius instead of two gives 12π + 8 cm.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (c) 5√3 m — The cable, the pole and the ground form a right-angled triangle: the ground distance (5 m) is adjacent to the 60° angle, and the height of the pole is opposite it, so height = 5 × tan 60° = 5 × √3 = 5√3 m. 5√3/2 m comes from using sin 60° = √3/2 instead of tan 60°. 5/√3 m comes from using tan 30° = 1/√3, the reciprocal-angle value, instead of tan 60°. 10√3 m comes from doubling the correct height by mistake.
Build your own mix at the worksheet builder.