Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A solid has 5 faces, 9 edges and 6 vertices. Two of its faces are triangles and the other three are rectangles. Which solid is it?
- 2.A builder lays a low wall made from identical bricks. The diagram shows the plan of the wall's footprint on a grid, where each square is one brick. The wall is built up to a height of 4 bricks everywhere. Work out the total number of bricks used.
- 3.In an isosceles triangle each of the two base angles is 46°. Work out the size of the angle at the apex.
- 4.Line 1 passes through (0, 1) and (2, 5). Line 2 passes through (3, 2) and (5, 6). Work out the gradient of each line. Then write down whether the two lines are parallel.
- 5.A straight line touches the edge of a circle at exactly one point and does not cross into the circle at all. Write down the term for this line.
- 6.A ramp's sloped surface crosses two horizontal parallel rails. At the top rail, the angle between the ramp and the rail on the right of the ramp is (3x + 10)°. At the bottom rail, the angle between the ramp and the rail on the left of the ramp is (5x − 30)°. Work out the value of x.
- 7.Every diameter of a circle is an example of a more general type of straight line joining two points on the circle. Which term names that more general type of line?
- 8.A hiker walks on a bearing of 065°. She then turns clockwise through 90° and continues walking in a straight line. What bearing is she now walking on?
- 9.A roof truss has two horizontal parallel rafters, one above the other. A straight strut crosses both rafters. Where the strut crosses the lower rafter, the angle above the rafter and to the left of the strut is 65°. Work out the size of the angle above the upper rafter and to the right of the strut, where the strut crosses it.
- 10.a is the column vector with top number 3 and bottom number −2. Work out 4a, giving your answer as a column vector in the form (top, bottom).
- 11.A hiker starts by walking on a bearing of 245°. She turns clockwise through 50°, then turns clockwise through a further 15°, and continues walking in a straight line. What bearing is she now walking on?
- 12.In a right-angled triangle, θ is one of the acute angles. Write down the trigonometric ratio, in terms of the opposite and adjacent sides, that is used to find θ.
- 13.Two similar ponds have perimeters in the ratio 4 : 11. The perimeter of the larger pond is 88 m. Work out the perimeter of the smaller pond.
- 14.Two straight lines PQ and RS cross at point O. Angle POR = 52°. Work out angle QOS.
- 15.A solid cylinder is lying on its curved side on a table, with its circular ends facing left and right. What shape is its plan view, looking down from above?
Answer key
- (a) Triangular prism — Count the given properties against each solid. A triangular prism has 5 faces (2 triangular ends + 3 rectangular sides), 9 edges and 6 vertices — this matches exactly, so the solid is a triangular prism. A square-based pyramid also has 5 faces, but 8 edges and 5 vertices, and only one face is a square rather than three rectangles — the edge and vertex counts don't match. A cuboid has 6 faces, 12 edges and 8 vertices, none of which match the numbers given. A tetrahedron has 4 faces, all triangles, with 6 edges and 4 vertices — too few faces, and no rectangular faces at all.
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
- (d) 88° — Method: the three angles add up to 180°, and here it is the two equal base angles that are known, so take both of them away from 180°. Working: the two base angles come to 2 × 46° = 92°, and 180° − 92° = 88°. Answer: 88°. The distractors: 134° comes from subtracting only one base angle, 180° − 46°, and forgetting that there are two of them; 92° comes from doubling the base angle and stopping there, which is the two base angles together rather than the apex; 46° comes from assuming that all three angles of the triangle are equal to the one that is given.
- (a) Parallel, since both gradients are 2 — Gradient of line 1 = (5 − 1) ÷ (2 − 0) = 4 ÷ 2 = 2. Gradient of line 2 = (6 − 2) ÷ (5 − 3) = 4 ÷ 2 = 2. The two gradients are equal, so the lines are parallel. "Not parallel, since the gradients are 2 and 4" uses 4 for line 2, which comes from dividing the change in y, 4, by 1 rather than by the change in x, 5 − 3 = 2. "Not parallel, since the two lines cross the y-axis at different points" confuses parallel lines with the same line repeated — parallel lines are distinct lines, and where a line crosses the y-axis has no effect on its gradient. "Parallel, since both lines pass through positive coordinates" reaches the right conclusion for the wrong reason: lines are parallel because their gradients are equal, not because the coordinates given happen to be positive.
- (d) tangent — A line that touches a circle at exactly one point, without crossing into the circle, is called a tangent. A chord is a straight line joining two points ON the circle, so it touches at two points, not one. A radius runs from the centre to the circle's edge, not along the outside of it. A diameter is a chord that passes through the centre, also touching the circle at two points.
- (d) 20 — Alternate angles between parallel lines are equal, so 3x + 10 = 5x − 30. Rearranging, 10 + 30 = 5x − 3x, so 40 = 2x, and x = 20. −10 comes from a sign error when rearranging, moving a term to the wrong side and getting −20 = 2x instead. 25 comes from wrongly treating the two angles as co-interior and adding them to 180°: (3x + 10) + (5x − 30) = 180 gives 8x − 20 = 180, so x = 25. 47.5 makes the same co-interior mistake but sets the sum equal to 360° instead of 180°, giving 8x − 20 = 360 and x = 47.5.
- (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
- (c) 155° — Turning clockwise adds to the bearing. Starting on a bearing of 065° and turning clockwise through 90° gives 065° + 90° = 155°. A candidate who instead subtracts, working out 90° − 65° = 25°, has performed the wrong operation, giving 025°. A candidate who turns anticlockwise instead of clockwise works out 065° − 90°, which gives a negative number, and adding 360° to fix this gives 335° — the bearing for turning the other way. A candidate who thinks turning does not change the bearing at all keeps the answer as 065°. The new bearing, turning clockwise, is 155°.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (b) (12, −8) — Method: to multiply a column vector by a number, multiply every part of the vector by that number. Working: top number 4 × 3 = 12; bottom number 4 × (−2) = −8. Answer: 4a = (12, −8). A candidate who adds 4 to each part instead of multiplying gets (7, 2). A candidate who multiplies only the top number by 4 and leaves the bottom number unchanged gets (12, −2). A candidate who multiplies only the bottom number by 4 and leaves the top number unchanged gets (3, −8).
- (d) 310 — Method: since both turns are clockwise, add both angles to the starting bearing. Working: 245° + 50° = 295°; 295° + 15° = 310°. A student who answers 295 has only added the first turn and forgotten the second one. A student who answers 180 has subtracted both turns instead of adding them. A student who answers 320 has added the two turns as 75° instead of 65° by misreading the second turn. Answer: 310°.
- (c) tan θ = opposite/adjacent — The tangent ratio is defined as tan θ = opposite/adjacent, so this is the ratio that connects the opposite and adjacent sides. "sin θ = opposite/adjacent" wrongly labels this ratio as sine, when sine actually connects the opposite side and the hypotenuse. "cos θ = opposite/adjacent" wrongly labels it as cosine, when cosine connects the adjacent side and the hypotenuse. "tan θ = adjacent/opposite" uses the correct ratio name but has the opposite and adjacent sides the wrong way round.
- (a) 32 m — The scale factor from the larger pond to the smaller pond is 4 ÷ 11, so the smaller perimeter is 88 × 4 ÷ 11 = 32 m. The distractor 242 m comes from using the ratio the wrong way round, 88 × 11 ÷ 4 = 242. The distractor 84 m comes from subtracting the smaller ratio number, 88 − 4 = 84, instead of scaling. The distractor 121 m comes from multiplying 11 × 11 = 121, ignoring the given perimeter altogether.
- (c) 52° — When two straight lines cross, the angles opposite each other at the crossing point are vertically opposite and are equal. Ray OQ is opposite ray OP and ray OS is opposite ray OR, so angle QOS is vertically opposite angle POR. Therefore angle QOS = 52°.
- (b) a rectangle — Lying on its side, the cylinder's curved surface touches the table along a straight line, and the two flat circular ends face sideways rather than up or down; viewed from directly above, the outline traced is a rectangle — as long as the cylinder and as wide as its diameter. "a circle" would be correct if the cylinder stood upright on one of its circular ends instead of lying on its side. "a triangle" belongs to a cone lying or standing so that it narrows to a point in that view, which a cylinder never does. "an oval" is a common guess from picturing the round ends, but from directly above those ends are edge-on and contribute to the rectangle's short sides, not a curved outline.
Build your own mix at the worksheet builder.