Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.Write down the exact value of cos 30°.
- 2.A solid pyramid has a square base of side 6 cm. Its apex is directly above the centre of the base, at a vertical height of 8 cm. Work out the volume of the pyramid.
- 3.Triangles PQS and RQS share the common side QS. PQ equals RQ, and PS equals RS. Which condition proves that triangle PQS is congruent to triangle RQS?
- 4.A drone flies from its base in three stages, each stage measured in metres east and north as a column vector. Stage 1 is the column vector with top number 30 and bottom number 40. Stage 2 is the column vector with top number −10 and bottom number 20. Stage 3 is the column vector with top number 15 and bottom number −5. Work out the column vector that would take the drone in a single straight flight back to its base from where it ends up.
- 5.Three angles lie on a straight line. They measure 38°, 95° and x°. Work out the value of x.
- 6.m is the column vector with top number 3 and bottom number −4. Which of these column vectors is a scalar multiple of m?
- 7.A ladder rests against a wall, making an angle of 60° with the ground. The ladder is 2 m long. Using the exact value of sin 60°, work out how high up the wall the ladder reaches, giving your answer in centimetres.
- 8.Here are four trigonometric ratios of special angles. Write down the one that does not have a value.
- 9.A dog is tied by a lead 4 m long to a fixed ring on a straight garden wall. The wall extends much further than the lead can reach in both directions, and the dog cannot cross through it. Describe the region the dog can reach.
- 10.A landscaper marks out two triangular flower beds using stakes and a tape measure. Bed 1 has two edges of 5 m and 7 m, meeting at a corner with a marked angle of 60° between them. Bed 2 has edges of 5 m and 7 m, meeting at a corner also marked at 60° between them. The landscaper wants to check the two beds will be exactly the same size and shape using only these three measurements. Which condition proves the two beds are congruent?
- 11.Triangle LMN has a right angle at M, with hypotenuse LN = 15 cm and LM = 9 cm. Triangle PQR has a right angle at Q, with hypotenuse PR = 15 cm and PQ = 9 cm. Which condition proves the two triangles are congruent?
- 12.A straight line is drawn from the centre of a circle to a point on the circle. Write down the name of this line.
- 13.After a translation by the vector , a point lands on (4, 1). Write down the coordinates of the point before the translation.
- 14.In triangle XYZ, the side opposite vertex X is labelled using the standard lowercase-letter convention. Which label is correct?
- 15.A translation is described by the column vector . Write down a description of this translation in words, stating the horizontal and vertical movement.
Answer key
- (d) √3/2 — cos 30° is one of the exact values you must know: cos 30° = √3/2. The value 1/2 is the exact value of sin 30° (and of cos 60°), not cos 30°. The value √2/2 is the exact value of cos 45° (and of sin 45°). The value 1 is the exact value of cos 0°.
- (b) 96 cm³ — Method: the volume of a pyramid is one third of the base area multiplied by the vertical height. Work out the area of the square base, multiply by the height, then divide by 3. Working: the base area is 6 × 6 = 36 cm², then 36 × 8 = 288, and 288 ÷ 3 = 96. Answer: 96 cm³. The distractors: 288 cm³ comes from multiplying the base area by the height and forgetting the one third, which is the volume of a cuboid with the same base and height; 144 cm³ comes from halving that 288 instead of taking a third of it; 16 cm³ comes from using the base edge of 6 cm in place of the base area, (6 × 8) ÷ 3.
- (d) SSS, using shared side QS — PQ equals RQ and PS equals RS are two given pairs of equal sides, and QS is common to both triangles, so QS equals itself and gives a third pair of equal sides. Three pairs of equal sides is exactly the SSS condition, so 'SSS, using shared side QS' is correct. 'SAS, using the angle at Q' is wrong because no angle is given anywhere in this question; angle PQS and angle RQS are not stated to be equal, and assuming they are would be assuming the very thing being proved. 'Only two pairs of sides — not enough' is wrong because it forgets that the shared side QS is itself a third pair of equal sides. 'Cannot prove — no angle given' is wrong because SSS is one of the four basic congruence conditions and specifically requires no angle at all.
- (c) (−35, −55) — Add the three stages component by component to find the drone's position relative to base: (30+(−10)+15, 40+20+(−5)) = (35, 55). The flight back to base is the negative of this vector, reversing both numbers: (−35, −55). (35, 55) is the vector from base to the drone's position — it forgets to reverse direction for the return flight. (−35, 55) only reverses the top number. (35, −55) only reverses the bottom number.
- (b) 47 — Method: angles on a straight line add up to 180°. Working: 180 − 38 − 95 = 47. Answer: x = 47. A candidate who uses 360° instead of 180° gets 227. A candidate who subtracts only one of the two given angles from 180° gets 142. A candidate who adds the two given angles instead of subtracting them from 180° gets 133.
- (b) (6, −8) — Method: a scalar multiple of m has the same ratio between its top and bottom numbers as m does. Working: m = (3, −4); multiplying both parts by 2 gives 2 × 3 = 6 and 2 × (−4) = −8, so (6, −8) is a scalar multiple of m. Answer: (6, −8). The vector (6, −4) needs a multiplier of 2 for the top number but only 1 for the bottom number, so it is not a multiple. The vector (−6, −8) needs a multiplier of −2 for the top number but 2 for the bottom number, so it is not a multiple. The vector (9, −8) needs a multiplier of 3 for the top number but 2 for the bottom number, so it is not a multiple.
- (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
- (b) tan 90° — Method: write each ratio as one side of a right-angled triangle divided by another, and look for the one whose bottom line can be zero. Working: sine and cosine are both a side divided by the hypotenuse, and a hypotenuse is never zero, so sin 90° = 1 and cos 90° = 0 are both perfectly good values — a value of zero is still a value. Tangent is the opposite side divided by the adjacent side. As the angle opens out towards 90° the adjacent side shrinks to nothing, and a division by zero has no result, while at the other end of the row the adjacent side is the long one and tan 0° = 0. Answer: tan 90°.
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (c) RHS — Method: check which basic congruence condition matches the facts given — a right angle, the hypotenuse, and one other side, in both triangles. Working: both triangles have a right angle (at M and Q), the hypotenuse is given for both (LN = PR = 15 cm), and one other side is given for both (LM = PQ = 9 cm) — this is exactly Right angle, Hypotenuse, Side. Options: SAS would need the given angle to sit between the two given sides, but the right angle at M is not between LM and LN, since LN is the hypotenuse, opposite the right angle; SSS would need three sides given in each triangle, but only two sides are known here; ASA would need two angles and the side between them, but only one angle is given. Answer: RHS.
- (b) The radius — Method: each of the four names describes a line in a fixed position relative to the circle, so match the description in the question against those positions. Working: the line described has one end at the centre and its other end on the circle. A chord joins two points that both lie on the circle, so it is ruled out. A diameter joins two points on the circle by passing through the centre, so it is twice as long as the line described. A tangent touches the circle at exactly one point and never reaches the centre. The line with one end at the centre and one end on the circle is a radius. Answer: The radius. The distractors: The diameter comes from remembering only that the line involves the centre, and not noticing that it stops there instead of carrying on to the far side; The chord comes from seeing one end on the circle and assuming both ends are; The tangent comes from matching the phrase 'a point on the circle' to the line that touches at exactly one point, ignoring that a tangent never reaches the centre.
- (c) (6, −5) — Method: the translation has already happened, so it must be undone: reverse the vector and apply the reverse to the point that is given. Working: reversing $\binom{-2}{6}$ gives $\binom{2}{-6}$, so the x-coordinate is 4 + 2 = 6 and the y-coordinate is 1 − 6 = −5. Check: from (6, −5) the given vector gives 6 − 2 = 4 and −5 + 6 = 1, which is the point named in the question. Answer: (6, −5). Applying the vector forwards instead of backwards gives (2, 7). Reversing the horizontal movement but not the vertical one gives (6, 7), and reversing the vertical movement but not the horizontal one gives (2, −5).
- (c) x — By convention, the side opposite a vertex is labelled with the lowercase version of that vertex's letter, so the side opposite X is labelled x. y is the label for the side opposite Y, not X. z is the label for the side opposite Z, not X. X is the vertex's own uppercase letter — the convention specifically switches to lowercase for the side, so the uppercase letter on its own is not correct.
- (b) 7 units right and 2 units down — In the column vector $\binom{7}{−2}$, the top number gives the horizontal movement and the bottom number gives the vertical movement. A positive top number (7) means 7 units to the right, and a negative bottom number (−2) means 2 units down. The distractor '7 units left and 2 units up' reverses both signs, as if the vector were $\binom{−7}{2}$. The distractor '2 units right and 7 units down' swaps the horizontal and vertical numbers around. The distractor '7 units right and 2 units up' gets the horizontal movement correct but reverses the sign of the vertical movement.
Build your own mix at the worksheet builder.