Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A ship's radar shows a lighthouse at the point (12, −4) on a grid measured in nautical miles. The ship is at (2, 5). The ship sails along the vector that takes it directly to the lighthouse, then sails along that same vector again. Work out the ship's final position.
- 2.Two triangles are proved congruent using the ASA condition. What can be concluded about the two remaining pairs of corresponding sides that were not part of the original ASA facts?
- 3.A tank holds 3.2 m³ of water. Work out this volume in litres.
- 4.A solid is built from centimetre cubes: a base layer of 2 rows of 3 cubes each (a 3 by 2 rectangle of cubes), with one extra cube placed on top of one corner cube of that base. Looking down from directly above (the plan view), how many squares are visible?
- 5.A sailmaker cuts two triangular sail panels from a pattern. Panel X has a 10 m side, with angles of 50° and 75° at its two ends. Panel Y also has a 10 m side, with angles of 50° and 75° at its two ends, in the same arrangement. The sailmaker wants to check the panels will match exactly, without cutting a third measurement. Which condition proves the two panels are congruent?
- 6.Two similar triangles have lengths in the ratio 2 : 5. The sides of the smaller triangle are 4 cm, 6 cm and 8 cm. Work out the length of the longest side of the larger triangle.
- 7.Triangle ABC has angle A = 40°, angle B = 65° and AB = 10 cm. Triangle DEF has angle D = 40°, angle E = 65° and DE = 10 cm. Which condition proves the two triangles are congruent?
- 8.A solid has 5 faces: one square face and four triangular faces, which all meet at a single point above the square. What is the name of this solid?
- 9.A regular polygon has 12 sides. Work out the size of one exterior angle of the polygon.
- 10.Triangle ABC has a right angle at B and hypotenuse AC = 17 cm, with AB = 8 cm. Triangle DEF has a right angle at E and hypotenuse DF = 17 cm. Which extra fact about DEF would complete the RHS condition for proving that ABC ≅ DEF, with the vertices matching in that order?
- 11.Work out the exact value of sin 45° × cos 45°.
- 12.A roof has two triangular sections, P and Q. Section P has a sloping edge of 3.6 m and a base edge of 2.4 m, with an angle of 70° between them. Section Q has a sloping edge of 3.6 m and a base edge of 2.4 m, with an angle of 70° between them, arranged the same way round. A roofer wants to cut identical triangular felt panels for both sections without measuring Section Q separately. Which condition confirms that the two sections are congruent?
- 13.The curved part of a circle's circumference, between two points on the circle, has its own name. Write down this name.
- 14.The point M(3, 8) is translated by the vector . Write down the coordinates of the image of M.
- 15.Line 1 passes through (0, 1) and (2, 5). Line 2 passes through (3, 2) and (5, 6). Work out the gradient of each line. Then write down whether the two lines are parallel.
Answer key
- (b) (22, −13) — The vector from the ship to the lighthouse is (12, −4) − (2, 5) = (10, −9). Sailing along this vector twice from the start gives (2, 5) + 2 × (10, −9) = (2 + 20, 5 − 18) = (22, −13). '(12, −4)' stops after the ship reaches the lighthouse and ignores the second identical leg. '(−18, 23)' comes from finding the vector the wrong way round, as (2, 5) − (12, −4) = (−10, 9), and then doubling that. '(2, 5)' comes from adding the vector and then subtracting it again, wrongly cancelling the two legs instead of adding them.
- (c) They must also be equal — Once two triangles are proved congruent by any condition, including ASA, they are identical in every respect: every pair of corresponding sides and every pair of corresponding angles must be equal, not just the ones originally used to prove the congruence. So the two remaining pairs of corresponding sides must also be equal, making 'they must also be equal' correct. 'They might be equal or not' and 'not enough information to say' both wrongly suggest that congruence only guarantees the specific facts used to prove it, when congruence actually guarantees the triangles are identical overall. 'They must be different' is backwards: the triangles being identical is the entire point of proving congruence, not a reason for a side to differ.
- (c) 3200 — Method: to change cubic metres to litres, multiply by 1000. Working: 3.2 × 1000 = 3200. Answer: 3200 litres. A candidate who multiplies by 100 instead of 1000 gets 320. A candidate who multiplies by 10000 instead of 1000 gets 32000. A candidate who does not convert at all gives 3.2.
- (d) 6 — The plan view shows every square of the base footprint, whether or not there is a taller stack above it — the base layer alone already covers a 3 by 2 rectangle of cubes, which is 6 squares. The extra cube on top of a corner cube sits directly above a square that is already counted, so it adds no NEW square to the plan — height does not show up in a plan view, only footprint does. "7" comes from wrongly counting the extra cube as an additional square. "5" comes from missing one square of the base rectangle, perhaps forgetting a corner. "3" comes from counting only one row of the base rectangle and forgetting that the base is two rows deep.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (b) 20 cm — Method: corresponding sides of similar triangles are in the same ratio, and the longest side of one triangle corresponds to the longest side of the other; a ratio of 2 : 5 means each length is multiplied by 5 ÷ 2 = 2.5 going from the smaller triangle to the larger one. Working: the longest side of the smaller triangle is 8 cm, so the matching side of the larger triangle is 8 × 2.5 = 20. Answer: 20 cm. The distractors: 10 cm comes from scaling the shortest side, 4 cm, instead of the longest; 40 cm comes from multiplying by 5 and forgetting to divide by 2; 3.2 cm comes from multiplying by 2 ÷ 5 instead of 5 ÷ 2, which scales from the larger triangle down to the smaller one.
- (d) ASA - two angles and the included side equal — Two angles (A and B) are given, and AB is the side between them, so this is ASA. SAS needs two sides and the angle between them, but only one side is given. AAS also uses two angles and a side, but the side must NOT be between the two angles — here AB is between angle A and angle B, so it is ASA, not AAS. RHS needs a right angle, and neither 40° nor 65° is 90°.
- (a) Square-based pyramid — A solid with one square base and four triangular faces meeting at a single apex above the base is a square-based pyramid. A triangular prism has two triangular faces and three rectangular faces, not a square base with four triangles, so that is a different solid. A cube has six square faces, and a cuboid has six rectangular faces — neither has any triangular faces at all. The solid described is a square-based pyramid.
- (a) 30° — Method: the exterior angles of any convex polygon add up to 360°, and in a regular polygon they are all equal, so divide 360° by the number of sides. Working: 360 ÷ 12 = 30. Answer: 30°. The distractors: 150° is the interior angle, 180 − 30, which answers for the wrong angle at the vertex; 15° comes from dividing 180 by 12, using the angles on a straight line instead of the full turn; 36° comes from dividing 360 by 12 − 2 = 10, carrying the subtraction of 2 out of the interior angle sum formula into a calculation that does not need it.
- (d) DE = 8 cm — Method: use the stated correspondence ABC ≅ DEF to work out which side in DEF matches the known side AB in ABC. Working: the correspondence sends A to D, B to E and C to F, so AB corresponds to DE; the right angles at B and E and the equal hypotenuses AC = DF = 17 cm are already given, so DE = 8 cm supplies the third ingredient — Right angle, Hypotenuse, Side. Options: EF = 8 cm matches AB to the wrong side, since EF corresponds to BC, and BC = √(17² − 8²) = 15 cm, not 8 cm; BC = 8 cm states something about triangle ABC rather than the missing fact about DEF, and it is false as well, since BC = 15 cm; angle D = angle A does follow once the triangles are congruent, but RHS is completed by a matching side, not by a matching angle. Answer: DE = 8 cm.
- (c) 1/2 — sin 45° = √2/2 and cos 45° = √2/2, so sin 45° × cos 45° = √2/2 × √2/2 = 2/4 = 1/2. √2/2 comes from writing down only one of the two factors and forgetting to multiply by the other. √2 comes from adding the two exact values instead of multiplying them: √2/2 + √2/2 = √2. 1 comes from wrongly treating sin 45° × cos 45° as sin(45° + 45°) = sin 90° = 1 — multiplying two ratios is not the same as adding their angles.
- (d) SAS — two sides, included angle — Each section has two known sides, 3.6 m and 2.4 m, with the 70° angle between them, matching in both sections; this is exactly the SAS condition, so 'SAS — two sides, included angle' is correct. 'SSS — but only two sides given' is wrong because SSS requires three pairs of equal sides, but only two sides are given for each triangle here. 'ASA — angle between two sides' is wrong because ASA requires two angles with a side between them, but only one angle, 70°, is given, not two. 'Cannot prove — only one angle' is wrong because SAS is specifically designed to prove congruence from exactly two sides and the one angle between them, so no further angle is needed.
- (a) arc — A curved part of a circle's circumference, between two points, is called an arc. A chord is the straight line joining those two points, not the curved part. A segment is the region enclosed between a chord and an arc, and a sector is the region enclosed between two radii and an arc — both segment and sector are regions, not curved lengths.
- (c) (−2, 10) — To translate M(3, 8) by $\binom{−5}{2}$, add −5 to the x-coordinate and 2 to the y-coordinate: (3 + (−5), 8 + 2) = (−2, 10). (5, 3) comes from swapping the two components of the vector before applying them. (−2, 8) applies only the x-component and forgets to add the y-component. (3, 10) applies only the y-component and forgets to add the x-component.
- (a) Parallel, since both gradients are 2 — Gradient of line 1 = (5 − 1) ÷ (2 − 0) = 4 ÷ 2 = 2. Gradient of line 2 = (6 − 2) ÷ (5 − 3) = 4 ÷ 2 = 2. The two gradients are equal, so the lines are parallel. "Not parallel, since the gradients are 2 and 4" uses 4 for line 2, which comes from dividing the change in y, 4, by 1 rather than by the change in x, 5 − 3 = 2. "Not parallel, since the two lines cross the y-axis at different points" confuses parallel lines with the same line repeated — parallel lines are distinct lines, and where a line crosses the y-axis has no effect on its gradient. "Parallel, since both lines pass through positive coordinates" reaches the right conclusion for the wrong reason: lines are parallel because their gradients are equal, not because the coordinates given happen to be positive.
Build your own mix at the worksheet builder.