Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A solid has 5 faces: one square face and four triangular faces, which all meet at a single point above the square. What is the name of this solid?
- 2.The diagram shows the plan, front elevation and side elevation of a solid. Which solid could this be?
- 3.Which of these describes an obtuse angle?
- 4.How many edges does a triangular prism have?
- 5.A locus is described as the set of points exactly 4 cm from a fixed point O. What shape is this locus?
- 6.A church tower is due east of a village. What is the three-figure bearing of the church tower from the village?
- 7.Put sin 30°, tan 30° and cos 30° in order of size, starting with the smallest.
- 8.Triangle JKL and triangle MNP are similar, with JK ÷ MN = JL ÷ MP = 2. A student says triangle JKL must be congruent to triangle MNP. Write down why the student is wrong.
- 9.u is the column vector with top number 7 and bottom number 3. v is the column vector with top number 2 and bottom number 5. Work out u − v, giving your answer as a column vector in the form (top, bottom).
- 10.The diagram shows a prism resting on a table. Which shape is its front elevation, the view looking at it from directly in front?
- 11.Write down which quadrant contains the point (−3, 5) when plotted on a coordinate grid.
- 12.A sailmaker cuts two triangular sail panels from a pattern. Panel X has a 10 m side, with angles of 50° and 75° at its two ends. Panel Y also has a 10 m side, with angles of 50° and 75° at its two ends, in the same arrangement. The sailmaker wants to check the panels will match exactly, without cutting a third measurement. Which condition proves the two panels are congruent?
- 13.A trapezium has parallel sides of length 6 cm and 10 cm, and a perpendicular height of 4 cm. Work out its area.
- 14.Which of the following correctly describes what it means for two lines to be perpendicular?
- 15.A solid cube has a volume of 8 cm³. Work out the length of one edge of the cube.
Answer key
- (a) Square-based pyramid — A solid with one square base and four triangular faces meeting at a single apex above the base is a square-based pyramid. A triangular prism has two triangular faces and three rectangular faces, not a square base with four triangles, so that is a different solid. A cube has six square faces, and a cuboid has six rectangular faces — neither has any triangular faces at all. The solid described is a square-based pyramid.
- (a) A cuboid — Method: work out which solid has flat faces only, no curved surfaces and no point where edges meet, since only that gives rectangles for all three views. Working: a solid whose plan, front elevation and side elevation are all rectangles has three pairs of flat rectangular faces meeting at right angles — that is a cuboid. Answer: a cuboid. The distractors: a cylinder is wrong because its plan view (from above) is a circle, not a rectangle. A cone is wrong because its plan view is a circle and its front and side elevations are triangles. A square-based pyramid is wrong because its front and side elevations come to a point at the apex, giving triangles rather than rectangles, even though its plan view could be a square.
- (b) An angle between 90° and 180° — Method: angle names are fixed by two markers, a right angle at 90° and a straight line at 180°. An obtuse angle is one that has opened past the right angle but has not reached the straight line. Working: an obtuse angle is greater than 90° and smaller than 180°. Answer: an angle between 90° and 180°. The distractors: an angle between 0° and 90° is the definition of an acute angle, chosen by a candidate who remembers the wrong side of the right-angle marker; an angle between 180° and 360° is the definition of a reflex angle, chosen by a candidate who knows the angle is past 90° and then takes the largest category; an angle of exactly 90° is the right angle itself, which is the marker an obtuse angle has passed rather than the obtuse angle.
- (a) 9 — A triangular prism has two triangular ends and three rectangular side faces. Each triangular end contributes 3 edges, giving 6 edges for both ends, and three more edges run lengthways to join the two ends together: 6 + 3 = 9 edges. Choosing 6 counts only the vertices (3 on each triangular end). Choosing 5 counts the faces (2 triangular + 3 rectangular) instead of the edges. Choosing 12 is the edge count of a cuboid, not a triangular prism.
- (a) a circle of radius 4 cm, centred at O — Every point exactly 4 cm from a fixed point O sweeps out a full circle of radius 4 cm centred at O — that is the definition of this locus. "a straight line 4 cm long, starting at O" only covers points in one direction, not every direction. "a square with sides of 4 cm, centred at O" would only touch the true locus at a few points on its perimeter, since most of a square's edge is not 4 cm from its centre. "two points, each 4 cm from O" comes from picturing only the points directly left and right of O, forgetting every other direction round it.
- (c) 090 — Method: bearings are measured clockwise from north; east is a quarter turn clockwise. Working: a quarter turn is 90°, written with a leading zero as three figures. A student who answers 009 has kept the correct digits but put the leading zero in the wrong place. A student who answers 180 has confused east with south. A student who answers 270 has confused east with west. Answer: 090.
- (d) sin 30°, tan 30°, cos 30° — sin 30° = 1/2 = 0.5, tan 30° = √3/3 ≈ 0.577 and cos 30° = √3/2 ≈ 0.866, so the correct order from smallest to largest is sin 30°, tan 30°, cos 30°. 'sin 30°, cos 30°, tan 30°' swaps the last two, wrongly putting cos 30° before tan 30°. 'cos 30°, tan 30°, sin 30°' is the correct list written backwards, from largest to smallest. 'tan 30°, sin 30°, cos 30°' wrongly swaps sin 30° and tan 30° at the start.
- (c) The scale factor is 2, not 1, so the sides are not equal — Congruent shapes must be exactly the same size as well as the same shape, which means a scale factor of 1. Here the scale factor between the triangles is 2, so the sides are different lengths and the triangles cannot be congruent, even though they are similar. 'Similar triangles are never congruent' is too strong — a scale factor of exactly 1 would make them both similar and congruent. 'The angles are not necessarily equal' is wrong, since similar triangles always have equal matching angles. 'Congruent triangles must have a right angle' is an unrelated, false fact about congruence.
- (b) (5, −2) — Method: subtract column vectors by subtracting the bottom vector's top number from the top vector's top number, and doing the same for the bottom numbers. Working: top numbers 7 − 2 = 5; bottom numbers 3 − 5 = −2. Answer: u − v = (5, −2). A candidate who drops the negative sign gets (5, 2). A candidate who works out v − u instead of u − v gets (−5, 2). A candidate who adds instead of subtracts gets (9, 8).
- (b) Triangle — Method: the front elevation is the outline you see looking straight at the solid's front face. Working: this solid's front face is one of its two identical triangular ends, so looking directly at the front shows exactly that triangular outline. Answer: triangle. The distractors: rectangle comes from picturing the side view instead of the front view — looking along the ridge of the prism, the sloping roof faces project as a rectangle. Trapezium comes from misreading the two sloping roof faces as if together they formed a single four-sided shape. Pentagon comes from tracing round the outline of the whole sketch as it is drawn on the page, which is a five-sided shape, instead of drawing only the view seen looking straight at the front of the solid.
- (b) second quadrant — The point (−3, 5) has a negative x-coordinate and a positive y-coordinate, and this combination lies in the second quadrant. The first quadrant needs both coordinates positive. The third quadrant needs both coordinates negative. The fourth quadrant needs a positive x-coordinate and a negative y-coordinate.
- (c) ASA — Method: check which condition matches two angles and the side between them, since that is all the sailmaker has measured. Working: the 10 m side lies between the 50° and 75° angles in both panels, so this is two Angles and the included Side, ASA. Options: SAS would need two sides and the angle between them, but only one side has been measured here; SSS would need three sides, but only one is known; RHS needs a right angle and a hypotenuse, and neither panel has a stated right angle. Answer: ASA.
- (b) 32 cm² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the height. Add the parallel sides: 6 + 10 = 16. Multiply by the height: 16 × 4 = 64. Half of 64 is 32 cm². 64 cm² forgets to halve and just gives (6+10)×4. 8 cm² averages the two parallel sides, (6+10)÷2 = 8, but forgets to multiply by the height. 20 cm² treats it as a triangle using only the longer parallel side as the base: half of 10 × 4.
- (d) Two lines that cross at right angles — Perpendicular lines are defined as two lines that cross at right angles (90°), so 'two lines that cross at right angles' is correct. 'Two lines that never meet' describes parallel lines, not perpendicular lines, so it is wrong. 'Two lines equal in length' confuses perpendicularity with two lines being the same length, which has nothing to do with the angle between them, so it is wrong. 'Two lines crossing at any angle' is too general, since crossing lines are simply called intersecting unless that angle is specifically 90°, so it is wrong.
- (b) 2 cm — Method: the volume of a cube is edge × edge × edge, so finding the edge from the volume means undoing a cube, not a square or a halving. Working: edge × edge × edge = 8; testing whole numbers, 1 × 1 × 1 = 1 is too small and the next whole number gives 2 × 2 × 2 = 8, which matches. Answer: 2 cm. The distractors: 8 cm comes from writing the volume down as the edge length and changing only the unit; 4 cm comes from halving the volume, 8 ÷ 2, as though a cube were undone by dividing by 2; 2.83 cm is the square root of 8, from taking a square root where a cube root is needed.
Build your own mix at the worksheet builder.