Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A tap fills a tank at a rate of 18 litres per minute. The tank holds 0.45 m³. Work out how long the tap takes to fill the tank.
- 2.In triangle PQR and triangle STU, PQ = ST, QR = TU and PR = SU. Write down the congruence condition that proves the two triangles are congruent.
- 3.How many faces does a cuboid have?
- 4.A circle has a diameter of 4 cm. Work out the radius of the circle.
- 5.A map has a scale of 1 cm : 5 km. A road is drawn 3 cm long on the map. What is the real length of the road?
- 6.A rectangle has vertices A(1, 1), B(4, 1), C(4, 5) and D(1, 5). Work out the perimeter of the rectangle.
- 7.A water tank is a cube with edges of length 2 m. Work out how many cubic centimetres the tank holds when it is full.
- 8.A right-angled triangle has two sides of length 5 cm and 12 cm, and the angle between those two sides is 90°. Work out the length of the hypotenuse.
- 9.Two metal window frames are checked before installation. Frame A has edges of 40 cm and 65 cm, with a marked angle of 35° at the far end of the 65 cm edge, away from where the two given edges meet. Frame B has matching edges of 40 cm and 65 cm, with a matching 35° angle in the same position. The fitter wants to know if these measurements alone guarantee the two frames are congruent. What should the fitter be told?
- 10.Two similar hexagonal tiles have lengths in the ratio 4 : 7. A side of the smaller tile is 8.4 cm long. Work out the length of the corresponding side of the larger tile.
- 11.A triangle has a base of 8 cm and a perpendicular height of 5 cm. Work out its area.
- 12.A straight line is drawn from the centre of a circle to a point on the circle. Write down the name of this line.
- 13.The diagram shows the plan, front elevation and side elevation of a solid. Which solid could this be?
- 14.A recipe uses 1.25 kg of flour. Work out how many grams of flour this is.
- 15.In a right-angled triangle, θ is one of the acute angles. Write down the trigonometric ratio, in terms of the opposite and adjacent sides, that is used to find θ.
Answer key
- (b) 25 minutes — Method: a rate in litres per minute can only be used on a volume measured in litres, so convert the tank first and then divide. Working: 1 m³ = 1000 litres, so the tank holds 0.45 × 1000 = 450 litres, and the time is 450 ÷ 18 = 25. Answer: 25 minutes. Using 1 m³ = 100 litres gives 45 ÷ 18 = 2.5 minutes. Using 1 m³ = 1 000 000 litres, which is the factor that turns cubic metres into cubic centimetres, gives 450 000 ÷ 18 = 25 000 minutes. Multiplying by the rate instead of dividing by it gives 450 × 18 = 8100.
- (d) SSS — All three pairs of corresponding sides are equal (PQ = ST, QR = TU, PR = SU), so the triangles are congruent by the SSS (side-side-side) condition. The distractor SAS would apply if two sides and the included angle were given equal, not three sides. The distractor ASA would apply if two angles and the included side were given equal. The distractor RHS would apply only for right-angled triangles with the hypotenuse and one other side equal.
- (c) 6 — A cuboid has six flat faces: a top, a bottom and four sides. Count each flat surface once: top, bottom, front, back, left, right — six faces in total, so the answer is 6. Choosing 8 counts the vertices (corners) instead of the faces. Choosing 12 counts the edges instead of the faces. Choosing 4 counts only the four side faces and forgets the top and the bottom.
- (b) 2 cm — Method: a diameter is made of two radii end to end, so going back from a diameter to a radius undoes that doubling, which gives radius = diameter ÷ 2. Working: the diameter is 4 cm, so the radius is 4 ÷ 2 = 2 cm. Answer: 2 cm. The distractors: 8 cm comes from multiplying by 2 instead of dividing by it, the relationship applied in the wrong direction; 1 cm comes from halving twice, once to reach the radius and then once more as though a second halving were called for; 0.5 cm comes from writing the division upside down as 2 ÷ 4 rather than 4 ÷ 2.
- (a) 15 km — Multiply the length drawn on the map by the scale: 3 × 5 = 15 km. Choosing 8 km adds the two scale numbers together (3 + 5 = 8) instead of multiplying them. Choosing 30 km comes from misreading the scale as 1 cm : 10 km and doubling the correct answer. Choosing 5 km simply repeats the scale's distance figure and ignores that the road is drawn 3 cm long, not 1 cm.
- (c) 14 units — Method: the perimeter of a rectangle is the distance all the way round its outside, 2 × (length + width), so the two side lengths must be found first; on a coordinate grid a side's length is the difference between the coordinates that change along it. Working: along AB, from (1, 1) to (4, 1), only x changes, so AB = 4 − 1 = 3. Along BC, from (4, 1) to (4, 5), only y changes, so BC = 5 − 1 = 4. Perimeter = 2 × (3 + 4) = 2 × 7 = 14. Answer: 14 units. The distractors: 18 units comes from reading the vertex numbers 4 and 5 as the side lengths instead of subtracting, giving 2 × (4 + 5); 12 units comes from working out the area, 3 × 4, in place of the perimeter; 7 units comes from adding one length to one width and stopping there, without doubling for the opposite pair of sides.
- (a) 8,000,000 cm³ — Method: change the edge length into centimetres first and then cube it, because 1 m = 100 cm and a volume needs that conversion applied to all three dimensions. Working: 2 m = 2 × 100 = 200 cm, so the volume is 200 × 200 × 200. 200 × 200 = 40,000 and 40,000 × 200 = 8,000,000. Answer: 8,000,000 cm³. The distractors: 8,000 cm³ comes from converting 2 m to 20 cm and cubing that; 80,000 cm³ comes from cubing in metres to get 8 m³ and then multiplying by 10,000, the conversion factor for an area rather than the 1,000,000 a volume needs; 8 cm³ comes from cubing the 2 without converting at all and simply writing cm³ because the question asked for that unit.
- (c) 13 cm — Method: the two given sides meet at the right angle, so they are the shorter pair and the hypotenuse comes from Pythagoras' theorem, a² + b² = c². Working: c² = 5² + 12² = 25 + 144 = 169, so c = √169 = 13. Answer: 13 cm. The distractors: 17 cm comes from adding the two sides, 5 + 12, rather than adding their squares; 60 cm comes from multiplying them, 5 × 12, which is twice the area of the triangle and not a length; 7 cm comes from subtracting, 12 − 5, as though the hypotenuse were the difference of the two shorter sides.
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (c) 20 cm² — The area of a triangle is half of base × height. First, base × height = 8 × 5 = 40. Half of 40 is 20 cm². 40 cm² forgets to halve and just gives base × height. 13 cm² adds the base and height together instead of multiplying them. 80 cm² doubles base × height instead of halving it.
- (b) The radius — Method: each of the four names describes a line in a fixed position relative to the circle, so match the description in the question against those positions. Working: the line described has one end at the centre and its other end on the circle. A chord joins two points that both lie on the circle, so it is ruled out. A diameter joins two points on the circle by passing through the centre, so it is twice as long as the line described. A tangent touches the circle at exactly one point and never reaches the centre. The line with one end at the centre and one end on the circle is a radius. Answer: The radius. The distractors: The diameter comes from remembering only that the line involves the centre, and not noticing that it stops there instead of carrying on to the far side; The chord comes from seeing one end on the circle and assuming both ends are; The tangent comes from matching the phrase 'a point on the circle' to the line that touches at exactly one point, ignoring that a tangent never reaches the centre.
- (a) A cuboid — Method: work out which solid has flat faces only, no curved surfaces and no point where edges meet, since only that gives rectangles for all three views. Working: a solid whose plan, front elevation and side elevation are all rectangles has three pairs of flat rectangular faces meeting at right angles — that is a cuboid. Answer: a cuboid. The distractors: a cylinder is wrong because its plan view (from above) is a circle, not a rectangle. A cone is wrong because its plan view is a circle and its front and side elevations are triangles. A square-based pyramid is wrong because its front and side elevations come to a point at the apex, giving triangles rather than rectangles, even though its plan view could be a square.
- (d) 1250 g — There are 1000 g in a kilogram, so 1.25 kg = 1.25 × 1000 = 1250 g. Multiplying by 100 instead of 1000 gives 125 g. Converting only the whole 1 kg and forgetting the extra 0.25 kg gives 1000 g. Treating the 0.25 kg as 25 g instead of 250 g, a quarter of 1000, gives 1025 g.
- (c) tan θ = opposite/adjacent — The tangent ratio is defined as tan θ = opposite/adjacent, so this is the ratio that connects the opposite and adjacent sides. "sin θ = opposite/adjacent" wrongly labels this ratio as sine, when sine actually connects the opposite side and the hypotenuse. "cos θ = opposite/adjacent" wrongly labels it as cosine, when cosine connects the adjacent side and the hypotenuse. "tan θ = adjacent/opposite" uses the correct ratio name but has the opposite and adjacent sides the wrong way round.
Build your own mix at the worksheet builder.