Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A drone flies from its base in three stages, each stage measured in metres east and north as a column vector. Stage 1 is the column vector with top number 30 and bottom number 40. Stage 2 is the column vector with top number −10 and bottom number 20. Stage 3 is the column vector with top number 15 and bottom number −5. Work out the column vector that would take the drone in a single straight flight back to its base from where it ends up.
- 2.In a construction, a point P is marked at the foot of the perpendicular drawn from point X to a straight line. Which statement correctly compares the distance XP with the distance from X to any other point on the line?
- 3.Two similar hexagonal tiles have lengths in the ratio 4 : 7. A side of the smaller tile is 8.4 cm long. Work out the length of the corresponding side of the larger tile.
- 4.Triangle T has a vertex at (8, 4). It is enlarged by a scale factor of 1/2, centre (2, 4). Work out the coordinates of the image of this vertex.
- 5.Point M lies exactly halfway between point A and point B, with A, M and B all on the same straight line. Which term correctly describes point M?
- 6.A roof truss has two horizontal parallel rafters, one above the other. A straight strut crosses both rafters. Where the strut crosses the lower rafter, the angle above the rafter and to the left of the strut is 65°. Work out the size of the angle above the upper rafter and to the right of the strut, where the strut crosses it.
- 7.A builder props a straight plank against a vertical wall to reach a window ledge. The foot of the plank is 2.1 m from the base of the wall, and the plank is 3.5 m long. Work out how high up the wall the plank reaches.
- 8.Four angles meet at a point. Three of them measure 82°, 105° and 96°. Work out the size of the fourth angle.
- 9.Write down the term for the distance all the way around the edge of a circle.
- 10.A furniture catalogue drawing uses a scale of 1 cm to 1.5 m. A sofa in the drawing is measured as 7 cm long. What is the real length of the sofa, in metres?
- 11.A solid is built from five centimetre cubes, standing side by side on a table in a single straight row. Looking down from directly above (the plan view), how many squares are visible?
- 12.Two triangles are congruent to each other. What does this tell you about their angles and sides?
- 13.Triangle ABC has AB = (2x + 3) cm, BC = 11 cm and angle B = 90°. Triangle DEF has DE = 13 cm, EF = 11 cm and angle E = 90°. Given that the two triangles are congruent by SAS, work out the value of x.
- 14.The interior angles of a pentagon are 100°, 110°, 120°, x° and x°. Work out the size of each of the two angles marked x°.
- 15.A drone starts at the point (3.5, −2) on a grid measured in metres. It flies by the vector to check a first sensor. The drone then needs to fly in a straight line to reach the point (−1.7, 9) to check a second sensor. Work out the column vector of this second flight.
Answer key
- (c) (−35, −55) — Add the three stages component by component to find the drone's position relative to base: (30+(−10)+15, 40+20+(−5)) = (35, 55). The flight back to base is the negative of this vector, reversing both numbers: (−35, −55). (35, 55) is the vector from base to the drone's position — it forgets to reverse direction for the return flight. (−35, 55) only reverses the top number. (35, −55) only reverses the bottom number.
- (d) XP is the shortest distance from X to the line — The perpendicular from a point to a line always gives the shortest possible distance to that line — joining X to any other point on the line forms the hypotenuse of a right-angled triangle with XP as one of the shorter sides, and a hypotenuse is always longer than either of the other two sides. So XP is shorter than the distance to every other point on the line. "XP is the longest distance from X to the line" reverses this relationship. "XP equals every other distance from X to the line" would only be true if X were equidistant from every point on the line, which is impossible for a point and a straight line. "XP cannot be compared without knowing the line's length" is false — the shortest-distance fact holds whatever the line's length, since only the local right angle matters.
- (c) 14.7 cm — The scale factor from the smaller tile to the larger tile is 7 ÷ 4 = 1.75, so the larger side is 8.4 × 1.75 = 14.7 cm. '4.8 cm' comes from scaling by 4 ÷ 7 instead, using the ratio the wrong way round. '11.4 cm' comes from adding the difference between the ratio numbers, 7 − 4 = 3, onto 8.4, instead of scaling. '58.8 cm' comes from multiplying by 7 on its own, using a ratio number as the scale factor instead of working out 7 ÷ 4 = 1.75 first.
- (a) (5, 4) — Method: find the vector from the centre to the point, multiply it by the scale factor, then add the result back to the centre. Working: the vector from (2, 4) to (8, 4) is (6, 0); multiplying by 1/2 gives (3, 0); adding this to the centre (2, 4) gives (5, 4). Options: (4, 2) comes from multiplying the original coordinates by 1/2 directly, ignoring the centre of enlargement; (14, 4) comes from using a scale factor of 2 instead of 1/2, giving (2, 4) + 2×(6, 0) = (14, 4); (8, 2) comes from halving only the y-coordinate and leaving the x-coordinate unchanged. Answer: (5, 4).
- (c) The midpoint of AB — M is a single point lying exactly halfway along the straight line AB, so 'the midpoint of AB' correctly describes it. 'The vertex of AB' is wrong because a vertex is a corner point where two edges or lines meet, which does not apply to a point on a single straight line. 'A perpendicular of AB' is wrong because perpendicular describes two lines meeting at right angles, not a single point. 'A plane of AB' is wrong because a plane is a flat two-dimensional surface, not a point.
- (c) 115 — Method: use corresponding angles to carry the 65° angle from the lower rafter up to the upper rafter, then use angles on a straight line to move to the other side of the strut. Working: the angle above the upper rafter and to the left of the strut corresponds to the given angle, so it is 65°; the angle above the upper rafter and to the right of the strut lies on a straight line with it, so it is 180 − 65 = 115. Answer: 115°. A candidate who assumes the angle stays 65° without allowing for the move from the left of the strut to the right of it gives 65. A candidate who uses 90° instead of 180°, working out 90 − 65, gets 25. A candidate who adds instead of subtracting, working out 180 + 65, gets 245.
- (b) 2.8 m — Use Pythagoras' Theorem: the plank is the hypotenuse (3.5 m) of a right-angled triangle formed with the wall and the ground (2.1 m). height² = 3.5² − 2.1² = 12.25 − 4.41 = 7.84. height = √7.84 = 2.8 m. A student who subtracts the two given lengths directly instead of using Pythagoras gets 3.5 − 2.1 = 1.4 m. A student who doubles the distance from the wall by mistake gets 2.1 × 2 = 4.2 m.
- (d) 77 — Method: angles that meet at a point add up to 360°. Working: 82 + 105 + 96 = 283; 360 − 283 = 77. Answer: 77°. A candidate who gives the sum of the three known angles and forgets to subtract it from 360° gets 283. A candidate who leaves out the 105° angle, working out 360 − 82 − 96, gets 182. A candidate who leaves out the 82° angle, working out 360 − 105 − 96, gets 159.
- (b) circumference — The distance all the way around the outside edge of a circle is called the circumference. The diameter is a straight line across the circle through the centre, so it is a length through the circle, not around it. The radius is a straight line from the centre to the edge, again a length across, not around. The area is the amount of surface inside the circle, a region, not a length at all.
- (b) 10.5 — Method: multiply the drawing length by the scale factor to get the real length. Working: 7 cm × 1.5 = 10.5 m. A student who answers 8.5 has added the scale factor to the drawing length instead of multiplying (7 + 1.5). A student who answers 14 has rounded the scale factor up to 2 before multiplying. A student who answers 3.5 has divided the drawing length by 2 instead of multiplying it by 1.5. Answer: 10.5 m.
- (a) 5 — Looking straight down on a row of 5 cubes standing side by side, each cube contributes exactly one square to the view from above, since the cubes do not overlap and none is hidden behind another — so the plan shows 5 squares in a row. "1" comes from treating the whole row as a single block instead of counting each cube. "10" comes from doubling the count, perhaps by also counting a front elevation's squares alongside the plan's. "25" comes from squaring the number of cubes (5 × 5) instead of counting them.
- (d) All angles equal and all sides equal — Congruent triangles are identical in both shape and size, so every corresponding angle is equal and every corresponding side is equal, so 'all angles equal and all sides equal' is correct. 'All angles equal, sides may differ' describes 'similar' triangles, which have equal angles but sides in the same ratio rather than necessarily equal, not congruent ones. 'All sides equal, angles may differ' is not geometrically possible for triangles, since equal sides throughout force the angles to match too. 'Same area, angles and sides may differ' is wrong because equal area alone does not guarantee congruence; two triangles can share an area with completely different shapes.
- (d) 5 — Method: since the triangles are congruent by SAS, the corresponding sides AB and DE must be equal, because both are the side next to the given right angle that is not BC or EF. Working: AB = DE gives 2x + 3 = 13, so 2x = 10, so x = 5. Options: 10 comes from dropping the coefficient of x and solving x + 3 = 13 instead of 2x + 3 = 13; 4 comes from matching AB to the wrong side, EF, giving 2x + 3 = 11, so 2x = 8, so x = 4; 8 comes from a sign error, solving 2x − 3 = 13 instead of 2x + 3 = 13, giving 2x = 16, so x = 8. Answer: 5.
- (a) 105° — The interior angles of a pentagon add up to (5 − 2) × 180° = 540°. Subtracting the three known angles, 540 − 100 − 110 − 120 = 210°, and this 210° is shared equally between the two angles marked x°, so each one is 210 ÷ 2 = 105°. 210° stops one step early, giving the total of the two unknown angles instead of one of them. 108° is the interior angle of a regular pentagon, which does not apply here since this pentagon's angles are not all equal. 55° comes from halving one of the given angles, 110°, instead of halving the remaining total.
- (a) $\binom{1}{6.5}$ — After the first flight, the drone is at (3.5 − 6.2, −2 + 4.5) = (−2.7, 2.5). The second vector takes it from (−2.7, 2.5) to (−1.7, 9): subtract the coordinates, (−1.7 − (−2.7), 9 − 2.5) = (1, 6.5). The distractor $\binom{−4.4}{6.5}$ comes from treating the drone's position after the first flight as (2.7, 2.5) instead of (−2.7, 2.5), giving −1.7 − 2.7 = −4.4 for the top number. The distractor $\binom{−5.2}{11}$ comes from finding the vector straight from the start point (3.5, −2) to (−1.7, 9), ignoring the first flight altogether. The distractor $\binom{−1}{−6.5}$ comes from subtracting the wrong way round, (−2.7 − (−1.7), 2.5 − 9), which reverses both signs of the correct vector.
Build your own mix at the worksheet builder.