Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A parallelogram has a base of 9 cm and a perpendicular height of 4 cm. Work out its area.
- 2.Point D is at (3, 7). It is reflected in the line y = x. Work out the coordinates of the image of point D.y = x
- 3.A right-angled triangle has its two shorter sides equal to 8 cm and 15 cm. Work out the value of cos θ, where θ is the angle opposite the 8 cm side. Give your answer as a fraction.
- 4.A student says the reverse of the translation vector is . Write down the correct reverse translation vector.
- 5.A parallelogram has a base of 9 cm and a perpendicular height of 6 cm. Work out the area of the parallelogram.
- 6.Write down the name given to a quadrilateral with exactly one pair of parallel sides.
- 7.Which of these describes an obtuse angle?
- 8.Triangles LMN and XYZ have LM = XY, MN = YZ and LN = XZ. Give a reason why triangle LMN is congruent to triangle XYZ.
- 9.A quadrilateral has vertices A(1, 1), B(5, 1), C(6, 4) and D(2, 4). By comparing the y-coordinates of A, B and of D, C, write down whether the sides AB and DC are parallel, and give a reason for your answer.
- 10.Quadrilateral PQRS has angle P = 92°, angle Q = 84° and angle R = 106°. Work out the size of angle S.
- 11.The point R(−6, 9) is translated by the vector . Write down the coordinates of the image of R.
- 12.The diagram shows the plan of the base layer of a solid built from identical cubes. A second layer of cubes is added on top, filling the entire base layer to a height of 2 cubes everywhere. Work out how many squares are visible in the plan view of this solid.
- 13.A parallelogram has an area of 54 cm² and a base of 9 cm. Work out its perpendicular height.
- 14.Point B is at (1, 6). It is reflected in the x-axis. Work out the coordinates of the image of point B.
- 15.A builder lays a low wall made from identical bricks. The diagram shows the plan of the wall's footprint on a grid, where each square is one brick. The wall is built up to a height of 4 bricks everywhere. Work out the total number of bricks used.
Answer key
- (c) 36 cm² — The area of a parallelogram is base × height = 9 × 4 = 36 cm². 26 cm² is 2 × (9 + 4), the perimeter you would get by treating the perpendicular height as though it were a side length — and a perimeter is a length, not an area. 18 cm² uses the triangle formula, half of base × height, by mistake. 72 cm² doubles the correct area.
- (b) (7, 3) — Reflecting in the line y = x swaps the x- and y-coordinates: (3, 7) → (7, 3). A pupil who reflects in the x-axis instead gets (3, −7). A pupil who reflects in the y-axis instead gets (−3, 7). A pupil who confuses y = x with y = −x, swapping the coordinates and changing both signs, gets (−7, −3). The correct image is (7, 3).
- (c) 15/17 — Method: cos θ = adjacent ÷ hypotenuse, so find the hypotenuse with Pythagoras' theorem first and then decide which short side is next to θ. Working: the hypotenuse is √(8² + 15²) = √(64 + 225) = √289 = 17 cm. The angle θ is opposite the 8 cm side, so the side next to it is the 15 cm side, and cos θ = 15 ÷ 17. Answer: 15/17. The distractors: 8/17 is sin θ, opposite over hypotenuse, used in place of the cosine; 8/15 is tan θ, opposite over adjacent; 17/15 comes from writing the cosine ratio upside down, as hypotenuse over adjacent.
- (c) $\binom{-4}{9}$ — The reverse of a translation negates both components, so the reverse of $\binom{4}{-9}$ is $\binom{-4}{9}$. $\binom{4}{9}$ is the student's mistake — only the bottom number has been negated, and the top number was left unchanged. $\binom{-4}{-9}$ makes the opposite error, negating only the top number. $\binom{4}{-9}$ is simply the original vector, unchanged.
- (b) 54 cm² — Area of a parallelogram = base × perpendicular height = 9 × 6 = 54 cm². (27 cm² comes from halving the product as if it were a triangle, 1/2 × 9 × 6; 15 cm² comes from adding the base and height instead of multiplying, 9 + 6; 30 cm² comes from doubling the sum of the base and height, as if finding a perimeter, 2 × (9 + 6).)
- (a) Trapezium — A trapezium is defined as a quadrilateral with exactly one pair of parallel sides. A parallelogram has two pairs, and a kite and rhombus are defined by side lengths, not by having only one pair of parallel sides.
- (b) An angle between 90° and 180° — Method: angle names are fixed by two markers, a right angle at 90° and a straight line at 180°. An obtuse angle is one that has opened past the right angle but has not reached the straight line. Working: an obtuse angle is greater than 90° and smaller than 180°. Answer: an angle between 90° and 180°. The distractors: an angle between 0° and 90° is the definition of an acute angle, chosen by a candidate who remembers the wrong side of the right-angle marker; an angle between 180° and 360° is the definition of a reflex angle, chosen by a candidate who knows the angle is past 90° and then takes the largest category; an angle of exactly 90° is the right angle itself, which is the marker an obtuse angle has passed rather than the obtuse angle.
- (a) SSS – all three corresponding sides are equal — All three pairs of corresponding sides are stated as equal — LM = XY, MN = YZ and LN = XZ — with no angle mentioned. This matches the SSS condition, so triangle LMN is congruent to triangle XYZ.
- (b) Parallel, since AB and DC are both horizontal lines — A and B both have y-coordinate 1, so AB is horizontal; D and C both have y-coordinate 4, so DC is horizontal too. Two horizontal lines are always parallel, so AB and DC are parallel. "Not parallel, since AB and DC have different lengths" is wrong twice over: AB runs from x = 1 to x = 5 and DC from x = 2 to x = 6, so both are in fact 4 units long, and in any case length has no bearing on whether two lines are parallel — only direction does. "Not parallel, since AB is horizontal and DC is vertical" misreads the coordinates of D and C, which share the y-coordinate 4 and so give a horizontal line, not a vertical one. "Parallel, since A and D have the same x-coordinate" rests on a false claim: A has x-coordinate 1 and D has x-coordinate 2, so they do not share an x-coordinate — and even if they did, it would say nothing about whether AB is parallel to DC.
- (c) 78° — The angles in any quadrilateral add up to 360°. Add the three given angles: 92° + 84° + 106° = 282°. Angle S = 360° − 282° = 78°. A pupil who only adds angle P and angle Q, forgetting angle R, gets 360° − (92° + 84°) = 184°. A pupil who only adds angle Q and angle R, forgetting angle P, gets 360° − (84° + 106°) = 170°. A pupil who makes a carrying slip adding the three angles, getting 292° instead of 282°, gets 360° − 292° = 68°. The correct answer is 78°.
- (b) (−1, −2) — To translate R(−6, 9) by $\binom{5}{−11}$, add 5 to the x-coordinate and −11 to the y-coordinate: (−6 + 5, 9 + (−11)) = (−1, −2). (−1, 9) applies only the x-component and leaves the y-coordinate unchanged. (−6, −2) applies only the y-component and leaves the x-coordinate unchanged. (−11, 20) comes from subtracting the vector instead of adding it.
- (c) 6 squares — Method: the plan view shows the footprint of the solid; a second layer stacked on top of floor positions that are already covered does not create any new squares in the plan. Working: the row of 4 cubes and the row of 2 cubes attached at the end do not overlap, so the footprint has 4 + 2 = 6 distinct squares. Answer: 6 squares. The distractors: 12 squares comes from counting the total number of cubes used, including the second layer (6 floor positions × 2 layers = 12), instead of the footprint. 4 squares comes from counting only the row of four and forgetting the attached row of two. 5 squares comes from wrongly treating the corner square as shared between the two rows (4 + 1 instead of 4 + 2).
- (c) 6 cm — For a parallelogram, area = base × height, so height = area ÷ base = 54 ÷ 9 = 6 cm. 12 cm comes from using the triangle's reverse formula, height = 2 × area ÷ base, which does not apply to a parallelogram. 45 cm comes from subtracting the base from the area, 54 − 9, instead of dividing. 486 cm comes from multiplying the area by the base, 54 × 9, instead of dividing.
- (d) (1, −6) — Reflecting in the x-axis keeps the x-coordinate the same and changes the sign of the y-coordinate: (1, 6) → (1, −6). A pupil who reflects in the y-axis instead gets (−1, 6). A pupil who changes the sign of both coordinates gets (−1, −6). A pupil who forgets to change any sign leaves the point unmoved at (1, 6). The correct image is (1, −6).
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
Build your own mix at the worksheet builder.