Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A shape is translated by the vector . The point P(6, 1) lies on the shape. Write down the coordinates of the image of P.
- 2.A hexagonal prism lies on a table. A flat cut is made straight across it, at right angles to its length (so the cut is parallel to the two identical end faces). What shape is the cross-section?
- 3.Vertex X of a triangle is at (−3, 5). After a translation, the image of X is at (2, −1). Write down the column vector of this translation.
- 4.Postcard P is similar to postcard Q. The 6 cm side of P corresponds to the 15 cm side of Q, and the 8 cm side of P corresponds to a matching side of Q. Work out the length of that matching side of Q.
- 5.All four sides of a rhombus are the same length. One side of a rhombus is 7 cm long. Work out the perimeter of the rhombus.
- 6.Two metal window frames are checked before installation. Frame A has edges of 40 cm and 65 cm, with a marked angle of 35° at the far end of the 65 cm edge, away from where the two given edges meet. Frame B has matching edges of 40 cm and 65 cm, with a matching 35° angle in the same position. The fitter wants to know if these measurements alone guarantee the two frames are congruent. What should the fitter be told?
- 7.A drone flies from its base in three stages, each stage measured in metres east and north as a column vector. Stage 1 is the column vector with top number 30 and bottom number 40. Stage 2 is the column vector with top number −10 and bottom number 20. Stage 3 is the column vector with top number 15 and bottom number −5. Work out the column vector that would take the drone in a single straight flight back to its base from where it ends up.
- 8.Priya says: 'To find the arc length of a sector, you divide the circumference by the angle in degrees.' Which statement about Priya's method is correct?
- 9.Triangle ABC is extended so that side BC is extended beyond C to a point D, forming exterior angle ACD. Angle BAC = 48° and angle ABC = 67°. Which single angle fact gives angle ACD = 115° in one step, without first working out the interior angle at C?
- 10.A rectangular bookmark measures 2 cm by 25 cm. Work out the area of the bookmark.
- 11.A garden bed is designed as a trapezium. The two parallel sides are 8 m and 12 m, and the perpendicular distance between them is 5 m. Grass seed covers 4 m² per bag, sold only in whole bags. Work out how many bags of grass seed are needed.
- 12.A chord is drawn across a circle, dividing the circle into two regions. Write down the name of one of these two regions.
- 13.A builder lays a low wall made from identical bricks. The diagram shows the plan of the wall's footprint on a grid, where each square is one brick. The wall is built up to a height of 4 bricks everywhere. Work out the total number of bricks used.
- 14.Triangle ABC has a right angle at B. Triangle DEF has a right angle at E. The hypotenuse of triangle ABC equals the hypotenuse of triangle DEF, and side AB equals side DE. Which condition proves that the two triangles are congruent?
- 15.P is the point (3, 4) and Q is the point (6, 0). Work out the distance of each point from the origin, and write down which point is closer to the origin.
Answer key
- (b) (3, 5) — Method: add the top number of the vector to the x-coordinate and the bottom number to the y-coordinate. Working: adding −3 to the x-coordinate is 6 − 3 = 3, and adding 4 to the y-coordinate is 1 + 4 = 5. Answer: the image of P is (3, 5). Subtracting the vector instead of adding it reverses the translation and gives (9, −3). Adding the top number but subtracting the bottom one, on the assumption that the lower entry always means downwards, gives (3, −3); the minus sign in a vector has already recorded the direction. Reading the two numbers the wrong way round, so that the shape moves 4 across and 3 down, gives (10, −2).
- (b) Hexagon — Cutting straight across a prism, at right angles to its length, always gives a cross-section that is the same shape as its end faces. The end faces of a hexagonal prism are hexagons (6-sided), so the cross-section is a hexagon. Choosing Pentagon comes from miscounting the sides of the hexagonal end as five instead of six. Choosing Rectangle comes from cutting along the LENGTH of the prism instead of across it, which gives a rectangular face, not the cross-section asked for. Choosing Triangle comes from confusing a hexagonal prism with a triangular prism.
- (a) $\binom{5}{−6}$ — The vector is (image − original) in each coordinate: (2 − (−3), −1 − 5) = (5, −6). $\binom{−5}{6}$ comes from working out original − image instead of image − original. $\binom{5}{6}$ gets the x-component right but makes a sign error on the y-component. $\binom{−5}{−6}$ gets the y-component right but makes a sign error on the x-component, working out −3 − 2 = −5 instead of 2 − (−3) = 5.
- (d) 20 cm — The scale factor from P to Q is 15 ÷ 6 = 2.5. Apply the same scale factor to the other side: 8 × 2.5 = 20 cm. A pupil who divides instead of multiplying by the scale factor gets 8 ÷ 2.5 = 3.2 cm. A pupil who adds the difference between the two known sides, 15 − 6 = 9, to 8 instead of scaling gets 8 + 9 = 17 cm. A pupil who rounds the scale factor 2.5 down to 2 gets 8 × 2 = 16 cm. The correct length is 20 cm.
- (a) 28 cm — Method: the perimeter is the total distance round the outside, and a rhombus has four sides of equal length, so the perimeter is 4 × the side length. Working: 4 × 7 = 28. Answer: 28 cm. The distractors: 14 cm comes from 2 × 7, adding only one pair of sides and forgetting that a rhombus has two pairs; 49 cm comes from working out 7 × 7, which is the calculation for the area of a square rather than a distance round the outside; 11 cm comes from adding the side length to the number of sides, 7 + 4, instead of multiplying them.
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (c) (−35, −55) — Add the three stages component by component to find the drone's position relative to base: (30+(−10)+15, 40+20+(−5)) = (35, 55). The flight back to base is the negative of this vector, reversing both numbers: (−35, −55). (35, 55) is the vector from base to the drone's position — it forgets to reverse direction for the return flight. (−35, 55) only reverses the top number. (35, −55) only reverses the bottom number.
- (a) Wrong: multiply by angle ÷ 360, not divide by it. — The arc length is the fraction angle ÷ 360 of the circumference, and that fraction is MULTIPLIED by the circumference — it is never divided by the angle itself. So Priya's method, dividing by the angle, is wrong, and the correct statement names both the fraction and the multiplication. Saying she is correct accepts her wrong division. Saying the arc length is the full circumference multiplied by the angle in degrees, with no division at all, drops the 360 that turns the angle into a fraction. Saying the arc length is the radius multiplied by the angle in degrees swaps the circumference for the radius, which is a different and, in degrees, incorrect formula.
- (c) exterior angle = sum of the two interior opposite angles — Angle ACD is the exterior angle at C, and the exterior angle of a triangle is always equal to the sum of the two interior angles at the other two vertices — here, angle BAC and angle ABC — so angle ACD = 48° + 67° = 115°. "angles in a triangle add up to 180°" is a true fact, but on its own it only gives the INTERIOR angle at C (180 − 48 − 67 = 65°), not the exterior angle 115° — reaching 115° that way still needs a further step. "angles on a straight line add up to 180°" is the fact that links the interior and exterior angles at C to each other, not the fact that gives 115° directly from the two OTHER angles. "exterior angle is always double the smallest angle" is not a genuine angle fact: double the smallest angle here is 48° × 2 = 96°, not 115°.
- (b) 50 cm² — Method: the area of a rectangle is length × width. Working: 2 × 25 = 50. Answer: 50 cm². The distractors: 54 cm comes from working out the perimeter, 2 × (2 + 25), which is a length and not an area; 27 cm comes from adding the two sides, 2 + 25, instead of multiplying them; 25 cm² comes from halving the product, 50 ÷ 2, which is the rule for the area of a triangle rather than of a rectangle.
- (c) 13 — Area of the trapezium = 1/2 × (8 + 12) × 5 = 1/2 × 100 = 50 m². Number of bags = 50 ÷ 4 = 12.5, which rounds up to 13 bags since seed is sold only in whole bags. A student who mistakenly uses 2 m² of coverage per bag instead of 4 m² finds 50 ÷ 2 = 25 bags.
- (a) segment — A chord cuts a circle into two regions, and each of these regions is called a segment. A sector is a different region, bounded by two radii and an arc, not by a chord. An arc is a curved part of the circumference, a length, not a region. A radius is a straight line from the centre to the edge, also a length, not a region.
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
- (d) RHS — Both triangles have a right angle, their hypotenuses are equal, and one further pair of sides (AB and DE) are equal, exactly the RHS condition, so RHS is correct. SAS needs two sides and the angle between them; here the right angle at B is not between the hypotenuse and AB, so this is not a valid SAS setup, making SAS wrong. SSS needs three pairs of equal sides, but only two sides are given here, so SSS is wrong. ASA needs two angles and the side between them, but only one angle, the right angle, is given, so ASA is wrong.
- (b) P, since OP = 5 and OQ = 6 — Using the distance formula, OP = √(3² + 4²) = √(9 + 16) = √25 = 5, and OQ = √(6² + 0²) = √36 = 6. Since 5 is less than 6, P is closer to the origin. Naming Q as closer, with OQ = 5 and OP = 6, has the two distances swapped around the wrong point. Naming P as closer but with OP = 6 and OQ = 5 also has the two values swapped, even though it names the right point. The distances are not equal, since 5 is not the same as 6, so P and Q are not equally distant from the origin.
Build your own mix at the worksheet builder.