Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A square-based pyramid has a square base and four identical triangular sloping faces, with its apex directly above the centre of the base. How many planes of symmetry does it have?
- 2.A circular plate has a diameter of 20 cm. Work out the area of the plate. Use π = 3.14.
- 3.The point R(−6, 9) is translated by the vector . Write down the coordinates of the image of R.
- 4.A builder lays a low wall made from identical bricks. The diagram shows the plan of the wall's footprint on a grid, where each square is one brick. The wall is built up to a height of 4 bricks everywhere. Work out the total number of bricks used.
- 5.A market stall sells apples at £2.40 per kilogram. Which of these expressions gives the cost, in pounds, of buying m kilograms of apples?
- 6.A trapezium-shaped garden bed has parallel sides of 2.5 m and 4.5 m, and a perpendicular width of 3 m. A gardener wants to know the area of the bed before ordering topsoil. Work out the area of the garden bed.
- 7.Two similar shapes have lengths in the ratio 1 : 3. A side of the smaller shape is 4 cm long. Work out the length of the corresponding side of the larger shape.
- 8.Two angles lie on a straight line. One angle is 37°. Work out the size of the other angle.
- 9.The vector describes a translation. A student writes it as by mistake. Write down what error the student has made.
- 10.Triangle ABC has a right angle at B. Triangle DEF has a right angle at E. The hypotenuse of triangle ABC equals the hypotenuse of triangle DEF, and side AB equals side DE. Which condition proves that the two triangles are congruent?
- 11.A(1, 2), B(5, 2) and C(5, 6) are three of the four vertices of a square ABCD. Work out the coordinates of D.
- 12.In pentagon PQRST, which of the following correctly names the interior angle at vertex R, using standard three-letter angle notation?
- 13.A line segment joins two points on the circumference of a circle, without necessarily passing through the centre. Write down the general term for this line segment.
- 14.A ship's radar shows a lighthouse at the point (12, −4) on a grid measured in nautical miles. The ship is at (2, 5). The ship sails along the vector that takes it directly to the lighthouse, then sails along that same vector again. Work out the ship's final position.
- 15.How many edges does a cube have?
Answer key
- (d) 4 — Method: a plane of symmetry must pass through the apex and cut the base along one of the base's own lines of symmetry. Working: a square has 4 lines of symmetry (2 through opposite edge midpoints, 2 through opposite corners), and each of these, combined with the apex, gives one plane of symmetry of the pyramid. A student who answers 2 has only found the planes through the edge midpoints, or only the ones through the corners, and missed the other pair. A student who answers 8 has doubled the correct count, perhaps confusing it with a different solid. A student who answers 1 has only spotted the one obvious front-to-back plane. Answer: 4.
- (a) 314 cm² — Method: the area of a circle is πr², and the radius is half the diameter, so halve the 20 cm before squaring. Working: r = 20 ÷ 2 = 10 cm, so the area is 3.14 × 10² = 3.14 × 100 = 314. Answer: 314 cm². The distractors: 1256 cm² comes from putting the diameter straight into πr² without halving it, 3.14 × 20²; 628 cm² comes from halving correctly but then using 2πr², a mixture of the circumference and area formulae; 62.8 cm² comes from working out πd = 3.14 × 20, which is the circumference of the plate rather than its area.
- (b) (−1, −2) — To translate R(−6, 9) by $\binom{5}{−11}$, add 5 to the x-coordinate and −11 to the y-coordinate: (−6 + 5, 9 + (−11)) = (−1, −2). (−1, 9) applies only the x-component and leaves the y-coordinate unchanged. (−6, −2) applies only the y-component and leaves the x-coordinate unchanged. (−11, 20) comes from subtracting the vector instead of adding it.
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
- (a) 2.40m — Method: a cost found from a rate is the rate multiplied by the amount bought. Working: the rate is £2.40 per kilogram and the amount is m kilograms, so the cost is 2.40 × m. Answer: 2.40m. A candidate who divides the amount by the rate instead of multiplying writes m/2.40. A candidate who adds the rate to the amount instead of multiplying writes 2.40 + m. A candidate who subtracts the rate from the amount instead of multiplying writes m − 2.40.
- (b) 10.5 m² — The area of a trapezium is half of the sum of the parallel sides, multiplied by the width. Add the parallel sides: 2.5 + 4.5 = 7. Multiply by the width: 7 × 3 = 21. Half of 21 is 10.5 m². 21 m² forgets to halve, using the full (2.5+4.5)×3. 3.5 m² averages the two parallel sides, (2.5+4.5)÷2 = 3.5, but forgets to multiply by the width. 6.75 m² treats the bed as a triangle, using only the longer parallel side: half of 4.5 × 3.
- (b) 12 cm — Method: in similar shapes every length is multiplied by the same scale factor, and a ratio of 1 : 3 means that factor is 3 going from the smaller shape to the larger one. Working: 4 × 3 = 12. Answer: 12 cm. The distractors: 7 cm comes from adding 3 to the side instead of multiplying by it, which is what happens when a ratio is read as a difference; 36 cm comes from multiplying by 3² = 9, the factor that scales areas, and applying it to a length; 4 cm comes from treating the two shapes as congruent, so that corresponding sides stay equal — similar shapes have equal angles, but their sides are in proportion.
- (a) 143° — Angles on a straight line add up to 180°. Set up 37° + x = 180°. Subtract: x = 180° − 37° = 143°. 53° comes from using 90° as the total, as if the two angles made a right angle, instead of the 180° of a straight line.
- (c) Swapped the x and y components — The student's vector has the same two numbers, 5 and −2, but in swapped positions, so the error is swapping the x and y components rather than an error with signs or size. 'Reversed both signs' is wrong because the numbers 5 and −2 have not changed sign, only position. 'Reversed only the y sign' is wrong for the same reason — no sign has actually changed. 'Doubled the x component' is wrong because neither number has changed in size.
- (d) RHS — Both triangles have a right angle, their hypotenuses are equal, and one further pair of sides (AB and DE) are equal, exactly the RHS condition, so RHS is correct. SAS needs two sides and the angle between them; here the right angle at B is not between the hypotenuse and AB, so this is not a valid SAS setup, making SAS wrong. SSS needs three pairs of equal sides, but only two sides are given here, so SSS is wrong. ASA needs two angles and the side between them, but only one angle, the right angle, is given, so ASA is wrong.
- (b) (1, 6) — Method: when a square is set square-on to the grid, so that its sides run parallel to the axes, each vertex shares its x-coordinate with one neighbour and its y-coordinate with the other, and the missing vertex then borrows one coordinate from each of the two vertices it is joined to; so the first job is to check from the given points that the sides really do run parallel to the axes. Working: A(1, 2) and B(5, 2) share y = 2, so AB is a horizontal side; B(5, 2) and C(5, 6) share x = 5, so BC is a vertical side, which confirms that this square lies square-on to the axes and that the rule may be used. In square ABCD the vertex D is joined to C and to A. DC must be horizontal like AB, so D takes the y-coordinate of C, which is 6; DA must be vertical like CB, so D takes the x-coordinate of A, which is 1. D is therefore (1, 6), and checking confirms every side is 4 long. Answer: (1, 6). The distractors: (1, 5) comes from lifting the first number out of each of A and C, pairing the x-coordinate of A with the x-coordinate of C; (6, 1) comes from finding the right two numbers but writing them the wrong way round, height before sideways position; (9, 6) comes from stepping a further 4 to the right from C instead of closing the square back to the column A stands in.
- (a) ∠QRS — Method: the middle letter in three-letter angle notation is always the vertex of the angle, and the outer two letters are the neighbouring vertices along the shape's sides. Working: at vertex R, the two adjacent vertices along the pentagon are Q and S, so the interior angle is written ∠QRS, with R in the middle. Options: ∠PQR names the angle at Q, not R, since Q is the middle letter there; ∠RST puts R first rather than in the middle, so it actually names the angle at S; ∠TRP does have R in the middle, but T and P are not the vertices adjacent to R along the pentagon's sides, so it does not describe R's interior angle. Answer: ∠QRS.
- (a) Chord — Method: identify what the two endpoints of the line segment are, and whether it must pass through the centre. Working: a line joining any two points on the circumference, whether or not it passes through the centre, is a chord, and the diameter is just a special case of it. A student who answers diameter has wrongly assumed the line must pass through the centre. A student who answers radius has confused joining two circumference points with joining the centre to the circumference. A student who answers tangent has confused a line crossing through the circle with one that only touches its outside. Answer: chord.
- (b) (22, −13) — The vector from the ship to the lighthouse is (12, −4) − (2, 5) = (10, −9). Sailing along this vector twice from the start gives (2, 5) + 2 × (10, −9) = (2 + 20, 5 − 18) = (22, −13). '(12, −4)' stops after the ship reaches the lighthouse and ignores the second identical leg. '(−18, 23)' comes from finding the vector the wrong way round, as (2, 5) − (12, −4) = (−10, 9), and then doubling that. '(2, 5)' comes from adding the vector and then subtracting it again, wrongly cancelling the two legs instead of adding them.
- (a) 12 — A cube has 6 square faces, 12 edges and 8 vertices. The edges are the straight lines where two faces meet: 4 edges around the top face, 4 edges around the bottom face, and 4 vertical edges joining them, giving 4 + 4 + 4 = 12. A candidate who counts the vertices instead of the edges answers 8. A candidate who counts the faces instead answers 6. A candidate who counts only the edges around the top face, forgetting the bottom face and the vertical edges, answers 4. The correct number of edges is 12.
Build your own mix at the worksheet builder.