Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A garden bed is designed as a trapezium. The two parallel sides are 8 m and 12 m, and the perpendicular distance between them is 5 m. Grass seed covers 4 m² per bag, sold only in whole bags. Work out how many bags of grass seed are needed.
- 2.Work out the distance between the point (0, 0) and the point (5, 12).
- 3.A cake recipe takes 135 minutes from start to finish. Write this time as hours and minutes.
- 4.Triangles LMN and XYZ have LM = XY, MN = YZ and LN = XZ. Give a reason why triangle LMN is congruent to triangle XYZ.
- 5.A chord divides a circle into two regions, one larger than the other. Write down the term used for the smaller of these two regions.
- 6.A parallelogram has a base of 9 cm and a perpendicular height of 6 cm. Work out the area of the parallelogram.
- 7.A straight fence is 5 m long. Describe the shape of the region made up of every point on the ground within 2 m of any part of the fence.
- 8.P is the point (3, 4) and Q is the point (6, 0). Work out the distance of each point from the origin, and write down which point is closer to the origin.
- 9.A church tower is due east of a village. What is the three-figure bearing of the church tower from the village?
- 10.A roof truss is shaped like an isosceles triangle resting on a horizontal ceiling joist. The truss's sloping edges are equal in length, and the angle at its apex is 40°. The ceiling joist continues in a straight line beyond the foot of the truss. Work out the angle between the truss's sloping edge and the extended joist, on the outside of the truss.
- 11.A trundle wheel has a diameter of 0.5 m. It is rolled along the ground and makes 20 complete turns. Using π = 3.14, work out the total distance rolled, in metres.
- 12.Triangle PQR and triangle XYZ have angle P = angle X, angle Q = angle Y and angle R = angle Z, with no side lengths given for either triangle. Which of the following correctly describes the relationship between the two triangles?
- 13.A drone starts at the point (2, −3) on a coordinate grid. It flies by the vector and then by the vector . Write down the column vector that would take the drone straight back to its starting point.
- 14.Triangle DEF has a right angle at E. Angle DFE = 60° and EF = 9 cm. Work out the exact length of DE.
- 15.A(1, 2), B(5, 2) and C(5, 6) are three of the four vertices of a square ABCD. Work out the coordinates of D.
Answer key
- (c) 13 — Area of the trapezium = 1/2 × (8 + 12) × 5 = 1/2 × 100 = 50 m². Number of bags = 50 ÷ 4 = 12.5, which rounds up to 13 bags since seed is sold only in whole bags. A student who mistakenly uses 2 m² of coverage per bag instead of 4 m² finds 50 ÷ 2 = 25 bags.
- (b) 13 — Method: the straight-line distance between two points on a grid is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal gap and the vertical gap between them, so Pythagoras' theorem applies. Working: one point is the origin, so the horizontal gap is 5 and the vertical gap is 12. Then d² = 5² + 12² = 25 + 144 = 169, so d = √169 = 13. Answer: 13. The distractors: 17 comes from adding the two gaps, 5 + 12, instead of adding their squares and taking the root; 12 comes from reading off the vertical gap alone and offering that as the whole distance; 7 comes from subtracting the gaps, 12 − 5, as though a distance were a difference.
- (c) 2 hours 15 minutes — Divide the total minutes by 60: 135 ÷ 60 = 2 remainder 15, so that is 2 hours 15 minutes. Treating 100 minutes as one hour, a metric-style mistake, gives 135 − 100 = 35, so 1 hour 35 minutes. Subtracting 60 twice to reach the 15 minutes left over, but losing count and recording only one of the two hours removed, gives 1 hour 15 minutes. Writing 135 ÷ 60 = 2.25 and then reading the '25' as minutes, instead of converting the 0.25 of an hour into 15 minutes, gives 2 hours 25 minutes.
- (a) SSS – all three corresponding sides are equal — All three pairs of corresponding sides are stated as equal — LM = XY, MN = YZ and LN = XZ — with no angle mentioned. This matches the SSS condition, so triangle LMN is congruent to triangle XYZ.
- (c) minor segment — A chord splits a circle into two segments; the smaller of the two is called the minor segment and the larger one the major segment. "major segment" names the larger region, the opposite of what is asked for. "sector" is a different region altogether, enclosed by two radii and an arc, not by a chord. "arc" is a curved length along the circumference, not an enclosed region at all.
- (b) 54 cm² — Area of a parallelogram = base × perpendicular height = 9 × 6 = 54 cm². (27 cm² comes from halving the product as if it were a triangle, 1/2 × 9 × 6; 15 cm² comes from adding the base and height instead of multiplying, 9 + 6; 30 cm² comes from doubling the sum of the base and height, as if finding a perimeter, 2 × (9 + 6).)
- (a) a rounded rectangle: 5 m by 4 m with semicircular ends — Points within 2 m of the straight part of the fence form a rectangle running the 5 m length of the fence and 4 m wide (2 m on each side); points within 2 m of each END of the fence, beyond that rectangle, form a semicircle of radius 2 m there, since the nearest point of the fence to them is just that one end. Together this gives a rounded, stadium-shaped region. "a rectangle, 9 m by 4 m" extends the rectangle by 2 m at each end instead of rounding it, wrongly including corner points that are actually more than 2 m from every part of the fence. "a circle of radius 2 m" treats the whole 5 m fence as a single point. "a rectangle, 5 m by 2 m" uses 2 m as the full width instead of the distance on EACH side, so it only covers one side of the fence.
- (b) P, since OP = 5 and OQ = 6 — Using the distance formula, OP = √(3² + 4²) = √(9 + 16) = √25 = 5, and OQ = √(6² + 0²) = √36 = 6. Since 5 is less than 6, P is closer to the origin. Naming Q as closer, with OQ = 5 and OP = 6, has the two distances swapped around the wrong point. Naming P as closer but with OP = 6 and OQ = 5 also has the two values swapped, even though it names the right point. The distances are not equal, since 5 is not the same as 6, so P and Q are not equally distant from the origin.
- (c) 090 — Method: bearings are measured clockwise from north; east is a quarter turn clockwise. Working: a quarter turn is 90°, written with a leading zero as three figures. A student who answers 009 has kept the correct digits but put the leading zero in the wrong place. A student who answers 180 has confused east with south. A student who answers 270 has confused east with west. Answer: 090.
- (a) 110° — The truss is isosceles, so its two base angles are equal; since the three angles of the triangle add up to 180° and the apex is 40°, each base angle is (180 − 40) ÷ 2 = 70°. The angle between the sloping edge and the joist, extended beyond the base of the truss, sits on a straight line with that 70° base angle, and angles on a straight line add up to 180°, so the required angle is 180 − 70 = 110°. "70°" comes from stopping after finding the base angle and giving it directly, without also using the straight-line fact to find the angle on the OUTSIDE of the truss. "140°" comes from doubling the base angle instead of using the straight-line fact. "20°" comes from taking half of the apex angle (40° ÷ 2), mistaking it for the required angle instead of properly using the triangle's angle sum.
- (a) 31.4 — Method: first find the circumference of one turn using π × diameter, then multiply by the number of turns. Working: circumference = 3.14 × 0.5 = 1.57 m; total distance = 1.57 × 20 = 31.4 m. A student who answers 15.7 has mistakenly halved the diameter again before multiplying, using 0.25 m instead of 0.5 m. A student who answers 3.14 has simply written down π itself, without completing the circumference or multiplying by the number of turns. A student who answers 62.8 has mistakenly doubled the diameter to 1 m before multiplying, treating the given length as a radius. Answer: 31.4 m.
- (a) Similar, but AAA alone does not prove congruence — Three equal corresponding angles (AAA) show that the two triangles are similar — the same shape — but says nothing about their size, so it does not prove congruence. They could be congruent, or one could simply be an enlargement of the other; without matching side lengths, congruence is not established, so 'congruent because AAA proves congruence' is wrong. Equal angles do not force equal sides — a triangle can be enlarged to any size while keeping the same angles, so that option is also wrong. Something CAN be said here — that the triangles are similar — so 'no relationship can be determined' is wrong too.
- (b) $\binom{-5}{5}$ — Method: add the two flights to get the single vector of the whole journey out, then reverse that vector to get the journey home. Working: across, 6 − 1 = 5; up, 4 − 9 = −5. So the drone finishes at (7, −8), which is 5 to the right of its start and 5 below it. The way home is therefore 5 to the left and 5 up. Answer: $\binom{-5}{5}$. Giving the combined journey itself, $\binom{5}{-5}$, describes the flight out rather than the flight home. Subtracting the second vector instead of adding it makes the journey out 7 across and 13 up, and reversing that gives $\binom{-7}{-13}$. Reversing the horizontal movement but leaving the vertical one alone gives $\binom{-5}{-5}$.
- (d) 9√3 cm — DE is opposite the 60° angle at F, and EF is adjacent to it, so DE = EF × tan 60° = 9 × √3 = 9√3 cm. 9√3/2 cm comes from using sin 60° = √3/2 instead of tan 60°. 3√3 cm comes from using tan 30° = 1/√3 instead of tan 60° (9 × 1/√3 = 9/√3 = 3√3). 18 cm is the hypotenuse DF, not DE: it comes from using cos 60° = 1/2 and working out 9 ÷ 1/2 = 18, which finds the wrong side of the triangle.
- (b) (1, 6) — Method: when a square is set square-on to the grid, so that its sides run parallel to the axes, each vertex shares its x-coordinate with one neighbour and its y-coordinate with the other, and the missing vertex then borrows one coordinate from each of the two vertices it is joined to; so the first job is to check from the given points that the sides really do run parallel to the axes. Working: A(1, 2) and B(5, 2) share y = 2, so AB is a horizontal side; B(5, 2) and C(5, 6) share x = 5, so BC is a vertical side, which confirms that this square lies square-on to the axes and that the rule may be used. In square ABCD the vertex D is joined to C and to A. DC must be horizontal like AB, so D takes the y-coordinate of C, which is 6; DA must be vertical like CB, so D takes the x-coordinate of A, which is 1. D is therefore (1, 6), and checking confirms every side is 4 long. Answer: (1, 6). The distractors: (1, 5) comes from lifting the first number out of each of A and C, pairing the x-coordinate of A with the x-coordinate of C; (6, 1) comes from finding the right two numbers but writing them the wrong way round, height before sideways position; (9, 6) comes from stepping a further 4 to the right from C instead of closing the square back to the column A stands in.
Build your own mix at the worksheet builder.