Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.In a right-angled triangle, the two shorter sides are a and b, and the hypotenuse is c. Write down the correct statement of Pythagoras' theorem.
- 2.A sector of a circle has radius 8 cm and takes up three-quarters of the full circle. Work out the perimeter of the sector, in terms of π.
- 3.Write down which one of these quadrilaterals always has diagonals that are equal in length and that cross at right angles.
- 4.A cylinder has a radius of 5 cm. Its volume is 471 cm³. Using π = 3.14, work out the height of the cylinder.
- 5.A triangular sail for a small boat has a base of 2.4 m and a height of 1.75 m. Sailcloth costs £12.50 per m². Work out the total cost of the sailcloth needed for the sail.
- 6.A robot on a grid moves by the vector , then by the vector , then by the vector . Write down the single column vector that has the same overall effect as these three moves.
- 7.In geometry, which of the following best describes a 'plane'?
- 8.A scale drawing of a bridge uses a scale of 1 : 25. A support beam on the drawing measures 4.4 cm. What is the real length of the beam, in metres?
- 9.A line segment is measured with a ruler and found to be 6.5 cm long. What is this length in millimetres?
- 10.A carpenter measures two triangular braces. Brace 1 has a 55° angle, a 65° angle, and, opposite the 55° angle, a side of 8 cm. Brace 2 has matching 55° and 65° angles and, opposite its 55° angle, a side of 8 cm. The carpenter says that because the equal 8 cm side is not between the two equal angles in either brace, he cannot be sure the two braces are the same size. Is the carpenter correct?
- 11.A party hat is in the shape of a cone with a base radius of 6 cm and a slant height of 10 cm. Work out the curved surface area of the party hat. Use π = 3.14 and the formula curved surface area = πrl.
- 12.A ladder of length 7 m leans against a vertical wall. The foot of the ladder is 3 m from the base of the wall. Work out how high up the wall the ladder reaches. Give your answer correct to 1 decimal place.
- 13.The diagram shows the plan, front elevation and side elevation of a solid. Which of these solids matches all three views?
- 14.Which of the following is the correct definition of a regular polygon?
- 15.Work out the distance between the point (0, 0) and the point (5, 12).
Answer key
- (d) a² + b² = c² — Pythagoras' theorem states that the square of the hypotenuse equals the sum of the squares of the other two sides, so a² + b² = c². "a + b = c" adds the sides directly without squaring them at all. "a² − b² = c²" subtracts the squares instead of adding them. "a² + b² = c" adds the squares correctly but forgets to square the hypotenuse on the other side of the equation.
- (a) 12π + 16 cm — A three-quarter sector's perimeter is the curved arc plus the two straight radii that close the shape. The full circumference is 2 × π × 8 = 16π cm, and three-quarters of that is 12π cm. Adding the two straight radii, 8 cm each, gives 12π + 16 cm. Leaving out the straight edges gives just 12π cm. Using one-quarter of the circumference, the piece left over rather than the piece asked for, gives 4π + 16 cm. Adding only one radius instead of two gives 12π + 8 cm.
- (a) Square — Method: two conditions are being asked for at once, so test each shape against both — the two diagonals must always be the same length as each other, and they must always meet at 90°. Working: in a rectangle the diagonals are equal but they meet at 90° only in the special case where the rectangle is also a rhombus; in a rhombus the diagonals do meet at 90° but they are of different lengths unless the rhombus is also a rectangle; the shape that satisfies both conditions for every example of it is the one that is both, and its diagonals are equal and perpendicular. Answer: the square. The distractors: the rectangle is where a candidate stops who tests only the equal-length condition and never checks the angle at the crossing; the rhombus is where a candidate stops who tests only the right-angle condition and never checks the two lengths; the parallelogram is chosen by a candidate who remembers that the diagonals of a parallelogram bisect each other and treats bisecting each other as being equal to each other, which is a different property.
- (d) 6 cm — Volume = πr²h, so height = volume ÷ (πr²) = 471 ÷ (3.14 × 25) = 471 ÷ 78.5 = 6 cm. (30 cm comes from dividing by πr instead of πr², missing one factor of the radius; 150 cm comes from dividing by π only, without using r² at all; 24 cm comes from treating the given 5 cm as a diameter and using a radius of 2.5 cm instead.)
- (b) £26.25 — First multiply the base and height: 2.4 × 1.75 = 4.2. The area of the triangular sail is half of that: half of 4.2 is 2.1 m². Then multiply by the cost per m²: 2.1 × £12.50 = £26.25. £52.50 forgets to halve in the area formula, giving an area of 4.2 m² and doubling the true cost. £30.00 multiplies the base length by the cost per m² (2.4 × £12.50) without ever finding the area. £25.00 rounds the area to 2 m² before multiplying by the cost, losing accuracy.
- (d) $\binom{0}{4}$ — Add the three vectors component by component: x: 3 + (−7) + 4 = 0; y: −2 + 5 + 1 = 4, giving $\binom{0}{4}$. $\binom{−4}{3}$ comes from adding only the first two vectors and forgetting the third. $\binom{14}{−6}$ comes from reading the second vector as $\binom{7}{−5}$ instead of $\binom{−7}{5}$, flipping its signs. $\binom{4}{0}$ comes from swapping the final x-total and y-total.
- (a) A flat surface extending infinitely in two directions — Method: recall the precise geometric meaning of 'plane', versus 'line', 'point' and 'face'. Working: a plane is a flat, two-dimensional surface extending infinitely in every direction within it. Options: 'a straight line extending in one direction' describes a line, not a plane; 'a single fixed position with no size' describes a point; 'a flat, bounded face on a 3D shape' describes a face, a bounded piece of a plane, not the plane itself, which has no boundary. Answer: a flat surface extending infinitely in two directions.
- (d) 1.1 — Method: multiply the drawing length by the scale factor to get the real length, then convert to the units asked for. Working: 4.4 cm × 25 = 110 cm = 1.1 m. A student who answers 4.4 has forgotten to use the scale at all. A student who answers 110 has correctly worked out the real length in centimetres but forgotten to convert it to metres. A student who answers 11 has used a scale factor of 2.5 instead of 25 by misreading the scale. Answer: 1.1 m.
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (d) No — third angle is also fixed — Since both braces have angles of 55° and 65°, their third angles must both be 60°, because angles in a triangle sum to 180°. All three angles now match, so the braces have the same shape. Both 8 cm sides lie in the same position relative to those angles — opposite the 55° angle in each brace — so one matching pair of corresponding sides fixes the size as well, exactly as ASA or AAS would. The braces are therefore guaranteed to be congruent and the carpenter is incorrect: 'No — third angle is also fixed' is correct. 'Yes — side must be included' is wrong because the side does not have to lie physically between the two named angles; once the third angle is fixed, a corresponding equal side anywhere is enough. 'No — any two angles enough alone' is wrong because two equal angles with no side length at all would only show the triangles are similar, not congruent. 'Yes — third angle may differ' is wrong because the third angle is fixed at 60° by the angle sum and cannot vary.
- (a) 188.4 cm² — Curved surface area of a cone = πrl. With r = 6 cm, l = 10 cm and π = 3.14, curved surface area = 3.14 × 6 × 10 = 188.4 cm². A student who uses the cylinder's curved surface area formula, 2πrl, instead of the cone's gets 2 × 3.14 × 6 × 10 = 376.8 cm². A student who uses the circle-area formula πr² instead of πrl gets 3.14 × 36 = 113.04 cm². A student who multiplies r × l but leaves out π entirely gets 6 × 10 = 60 cm².
- (c) 6.3 m — By Pythagoras' theorem, the height = √(7² − 3²) = √(49 − 9) = √40 = 6.32...≈ 6.3 m. "6.4 m" rounds 6.32...m up to 6.4 instead of correctly rounding it down to 6.3. "4.0 m" comes from subtracting the two given lengths directly, 7 − 3 = 4, instead of subtracting their squares. "10.0 m" comes from adding the two given lengths, 7 + 3 = 10, instead of using Pythagoras' theorem at all.
- (b) A triangular prism standing on its triangular end — Method: a rectangular elevation with no sloping sides means the solid keeps the same cross-section all the way from the bottom to the top; work out which solid, standing the right way up, has a triangular cross-section that stays that shape as you go higher. Working: a triangular prism standing upright on its triangular end has a triangle as its plan view, and because the cross-section is constant all the way up, both the front and side elevations are plain rectangles. Answer: a triangular prism standing on its triangular end. The distractors: a triangle-based pyramid standing on its triangular base does give a triangle as its plan view, but its cross-section shrinks towards the apex, so its front and side elevations come to a point and are triangles, not rectangles. A cuboid standing on a rectangular face is wrong because its plan view is a rectangle, not a triangle. A triangular prism lying on one of its rectangular faces is wrong because it is then the triangular end that faces the side, so its plan view is a rectangle and one of its elevations is a triangle.
- (c) Equal sides and equal interior angles — Method: recall the full definition of 'regular' as applied to a polygon. Working: a regular polygon must have both equal side lengths and equal interior angles at the same time. Options: 'all sides equal' alone describes an equilateral but not necessarily equiangular shape, such as a rhombus, which is not regular; 'all angles equal' alone describes an equiangular but not necessarily equilateral shape, such as a rectangle, which is not regular; 'at least one line of symmetry' is a much weaker condition that many irregular shapes also satisfy. Answer: equal sides and equal interior angles.
- (b) 13 — Method: the straight-line distance between two points on a grid is the hypotenuse of a right-angled triangle whose shorter sides are the horizontal gap and the vertical gap between them, so Pythagoras' theorem applies. Working: one point is the origin, so the horizontal gap is 5 and the vertical gap is 12. Then d² = 5² + 12² = 25 + 144 = 169, so d = √169 = 13. Answer: 13. The distractors: 17 comes from adding the two gaps, 5 + 12, instead of adding their squares and taking the root; 12 comes from reading off the vertical gap alone and offering that as the whole distance; 7 comes from subtracting the gaps, 12 − 5, as though a distance were a difference.
Build your own mix at the worksheet builder.