Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A sector has an angle of 45°. Priti says: 'The area of the sector is one eighth of the area of the full circle, whatever the radius is.' Is Priti correct?
- 2.A footpath is 3750 m long. Work out this distance in kilometres.
- 3.An angle is measured with a protractor as 47°. What type of angle is this?
- 4.Two triangles are similar. The sides of the first triangle are 3 cm, 4 cm and 5 cm. The shortest side of the second triangle is 9 cm. Work out the scale factor from the first triangle to the second.
- 5.A triangle has vertices A(0, 0), B(10, 0) and C(5, 12). Work out the area of the triangle.
- 6.An angle measures 108°. Write down the name given to an angle of this size.
- 7.A solid is built from centimetre cubes standing on a table. Seen from the front, the left-hand column is 2 cubes high, the middle column is 2 cubes high and the right-hand column is 1 cube high. Work out how many squares make up the front elevation.
- 8.A line segment joins A(1, 1) and B(4, 7). Write down the sign of the gradient of this line.
- 9.Triangle ABC is drawn. The interior angle bisectors from vertices A and B are constructed and meet at point I inside the triangle. Which statement about point I must be true?
- 10.A shopkeeper builds a display from two cuboid boxes, shown in the diagram. She wants to cover the front of the display with coloured paper. Work out the total area of the front elevation, in square centimetres.
- 11.Work out the exact value of (cos 45°)² + (sin 45°)².
- 12.Every diameter of a circle is an example of a more general type of straight line joining two points on the circle. Which term names that more general type of line?
- 13.A zip wire is fixed at an angle of 50° to the horizontal, running from a high platform down to the ground. The zip wire itself, from the platform to the ground, is 12 m long. Work out the horizontal distance covered by the zip wire. Give your answer correct to 1 decimal place.
- 14.A sector of a circle has an angle of 90° and an area of 78.5 cm². Using π = 3.14, work out the radius of the circle.
- 15.Two straight roads cross at a junction. The angle between them, measured with a protractor, is 118°. What is the size of the angle vertically opposite to it?
Answer key
- (d) Yes, because 45 ÷ 360 = 1/8, and this fraction applies to any radius. — Priti is correct: 45 ÷ 360 = 1/8, and because sector area = (angle ÷ 360) × full circle area, this fraction depends only on the angle, not on the radius, so it holds for every circle. (The statement giving 45 ÷ 360 = 1/6 comes from an arithmetic slip when simplifying the fraction; the statement that the fraction depends on the radius is wrong because the radius cancels out of the angle fraction in the sector-area formula; the statement adding that it only works for this particular radius is wrong because the 1/8 fraction is true for every radius, not a special case.)
- (a) 3.75 km — To convert metres to kilometres, divide by 1000: 3750 ÷ 1000 = 3.75 km. Dividing by 100 instead of 1000 gives 37.5 km. Dividing by 10 instead of 1000 gives 375 km. Dividing by 10 000 instead of 1000 gives 0.375 km.
- (b) Acute — An acute angle is any angle less than 90°. Since 47° is less than 90°, it is acute. An obtuse angle is between 90° and 180°, which 47° is not. A reflex angle is greater than 180°, which is far too big for 47°. A right angle is exactly 90°, not 47°. The angle is acute.
- (b) 3 — Method: the scale factor is a length of the second triangle divided by the corresponding length of the first, and corresponding means shortest paired with shortest. Working: the shortest side of the first triangle is 3 cm and the shortest side of the second is 9 cm, so the scale factor is 9 ÷ 3 = 3. Answer: 3. The distractors: 1/3 comes from dividing 3 by 9, which is the scale factor from the second triangle back to the first; 6 comes from subtracting, 9 − 3, treating the scale factor as a difference rather than a multiplier; 1.8 comes from dividing 9 by 5, pairing the second triangle's shortest side with the first triangle's longest side.
- (b) 60 units² — Method: the area of a triangle is half the base times the perpendicular height, so choose a side to act as the base and measure the perpendicular distance from the opposite vertex to it. Working: A(0, 0) and B(10, 0) both lie on the x-axis, so AB is horizontal and AB = 10 − 0 = 10. The perpendicular height is the distance of C from the x-axis, which is its y-coordinate, 12. Area = (10 × 12) ÷ 2 = 120 ÷ 2 = 60. Answer: 60 units². The distractors: 120 units² comes from multiplying base by height and forgetting to halve; 65 units² comes from using the slanting side AC, which is 13 long, as the height in place of the perpendicular distance 12; 30 units² comes from halving the base to 5 before multiplying and then halving the product as well, so the halving is done twice.
- (d) An obtuse angle — Method: compare the angle with the two markers that separate the angle names, a right angle at 90° and a straight line at 180°. Working: 108° is greater than 90° and smaller than 180°, so it lies between the right angle and the straight line. Answer: an obtuse angle. The distractors: an acute angle is one below 90°, and is chosen by a candidate who checks only that 108° is less than 180°; a reflex angle is one above 180°, and is chosen by a candidate who checks only that 108° is more than 90° and then takes the largest category; a right angle is exactly 90°, and is chosen by reading 108° as near enough to 90° instead of comparing it properly.
- (c) 5 — The front elevation shows one square for every cube visible from the front, column by column: the left-hand column is 2 cubes high, so it contributes 2 squares; the middle column is 2 cubes high, so it contributes 2 more; the right-hand column is 1 cube high, so it contributes 1. The total is 2 + 2 + 1 = 5 squares. "6" comes from drawing a full 3 by 2 rectangle, treating every column as if it reached the greatest height. "4" comes from losing a square from one of the two tall columns, counting 2 + 1 + 1. "3" comes from counting one square per column — the width of the solid — and ignoring the heights altogether.
- (d) positive — Moving from A to B, the x-coordinate increases from 1 to 4 and the y-coordinate also increases from 1 to 7, so the line rises as it goes from left to right, which means the gradient is positive. "negative" would need y to decrease as x increases, which is not the case here. "zero" would need the y-coordinate to stay the same, but it changes from 1 to 7. "cannot be determined" is wrong because the coordinates of both points are known, so the direction of the line can always be found.
- (c) I is the same distance from all three sides. — The angle bisector from A is the locus of points equidistant from sides AB and AC, and the angle bisector from B is the locus of points equidistant from sides AB and BC. Point I lies on both bisectors, so I is equidistant from AB and AC, and also equidistant from AB and BC — meaning I is the same distance from all three sides. (Being the same distance from all three vertices instead describes the circumcentre, found from the perpendicular bisectors of the sides, not the angle bisectors; I being the midpoint of AB confuses the angle bisector construction with the perpendicular bisector of a side; I lying on side AC is wrong because the angle bisectors meet inside the triangle, not on one of its sides.)
- (a) 4700 cm² — Method: split the T-shaped outline into the two rectangles it is made from, find the area of each, then add them together. Working: the wide base gives a rectangle 90 cm × 30 cm = 2700 cm²; the narrower block on top gives a rectangle 40 cm × 50 cm = 2000 cm²; adding these, 2700 + 2000 = 4700 cm². Answer: 4700 cm². The distractors: 2700 cm² comes from finding only the area of the base rectangle and forgetting to add the block on top. 2000 cm² comes from finding only the area of the top block and forgetting the base. 7200 cm² comes from treating the whole outline as one large rectangle, 90 cm wide by (30 + 50) = 80 cm tall, instead of splitting it into the two separate rectangles that actually make up the shape.
- (c) 1 — cos 45° = √2/2 and sin 45° = √2/2. Squaring each gives (√2/2)² = 2/4 = 1/2, so (cos 45°)² + (sin 45°)² = 1/2 + 1/2 = 1. The distractor √2 comes from adding cos 45° + sin 45° directly without squaring first (√2/2 + √2/2 = √2). The distractor 2 comes from squaring the top of the fraction, (√2)² = 2, but then dividing by 2 instead of 4 for each term, giving 1 + 1 = 2. The distractor 1/2 comes from squaring only cos 45° and forgetting to add the sin 45° term.
- (c) chord — A diameter is a straight line joining two points on the circle that happens to pass through the centre. The general term for any straight line joining two points on a circle is a chord — every diameter is a chord, but not every chord is a diameter. Calling it a radius is wrong because a radius runs from the centre to just ONE point on the circle, not between two points on the circle. A tangent touches the circle at only one point, so it cannot be a diameter at all. An arc is a curved part of the circle's edge, not a straight line.
- (d) 7.7 m — The horizontal distance is adjacent to the 50° angle and the zip wire is the hypotenuse, so horizontal distance = 12 × cos 50° = 12 × 0.6428... = 7.71...≈ 7.7 m. "9.2 m" uses the sine ratio instead of cosine, 12 × sin 50° = 9.19...≈ 9.2 m, which actually finds the vertical drop of the zip wire, not the horizontal distance. "15.7 m" comes from dividing by the sine ratio instead of multiplying by the cosine ratio, 12 ÷ sin 50° = 15.66...≈ 15.7 m, both the wrong operation and the wrong ratio. "12.0 m" simply uses the length of the zip wire itself as the horizontal distance, ignoring the angle of 50° altogether.
- (a) 10 cm — Sector area is (angle ÷ 360) × π × radius². Here 90 ÷ 360 = 1/4, and 1/4 × 3.14 = 0.785, so radius² is 78.5 ÷ 0.785 = 100, and the radius is √100 = 10 cm. Stopping after finding radius² and not taking the square root gives 100 cm. Treating 78.5 as the area of the WHOLE circle, ignoring the 90° fraction, gives radius² = 78.5 ÷ 3.14 = 25, so a radius of 5 cm. Correctly finding a radius of 10 cm but then doubling it, mistaking the question for asking the diameter, gives 20 cm.
- (a) 118° — When two straight lines cross, the angles that are vertically opposite each other are always equal. So the angle vertically opposite 118° is also 118°. A candidate who instead finds the angle next to it on the straight line, using 180° − 118° = 62°, has found the adjacent angle, not the vertically opposite one. A candidate who answers 180° has confused the rule with angles on a straight line. A candidate who doubles the angle, giving 236°, has applied no valid angle rule at all. The vertically opposite angle is 118°.
Build your own mix at the worksheet builder.