Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.The bearing of a campsite B from a walker's position A is 070°. What is the bearing of A from B?
- 2.A television cable runs in a straight line from the edge of a flat roof 20 m above the ground to a bracket on a wall 5 m above the ground. The horizontal distance between the roof edge and the bracket is 15 m. Work out the length of the cable. Give your answer to 1 decimal place.
- 3.A running track has a straight section and a semicircular bend. The bend is a semicircle with radius 32 m. Work out the length of the curved part of the bend, to 1 decimal place. (Use π = 3.14.)
- 4.A model of a bridge is built to a scale where every length on the model is 1/240 of the matching length on the real bridge. A support beam on the model measures 3.6 cm. Work out the length of the real support beam, giving your answer in metres.
- 5.Which of these correctly compares a 'line' with a 'line segment'?
- 6.All four sides of a rhombus are the same length. One side of a rhombus is 7 cm long. Work out the perimeter of the rhombus.
- 7.The perimeter of a square is 20 cm. Work out the area of the square.
- 8.A scale drawing of a bridge uses a scale of 1 : 25. A support beam on the drawing measures 4.4 cm. What is the real length of the beam, in metres?
- 9.In triangle ABC and triangle DEF, AB = DE, AC = DF, and the angle at A equals the angle at D. Write down the congruence condition that proves the two triangles are congruent.
- 10.Vertex X of a triangle is at (−3, 5). After a translation, the image of X is at (2, −1). Write down the column vector of this translation.
- 11.Two triangular offcuts of wood, PQR and STU, are cut for a construction project. PQ = 8 cm, QR = 6 cm and angle PQR = 90°. ST = 8 cm, TU = 6 cm and angle STU = 90°. A carpenter wants to check the two pieces are identical in shape and size before using them as a matching pair. Using only the measurements given, and without working out any further lengths, which condition proves that triangle PQR is congruent to triangle STU?
- 12.In triangle ABC and triangle DEF, the angle at A equals the angle at D, and AB ÷ DE = AC ÷ DF. Write down what this proves about the two triangles.
- 13.a is the column vector with top number 3 and bottom number 2. b is the column vector with top number −1 and bottom number 4. Work out a + b, giving your answer as a column vector in the form (top, bottom).
- 14.A birthday cake is a cylinder of radius 10 cm and height 8 cm, with a thin ribbon fixed exactly once around the curved side, at half the height, and joined with no overlap. Work out the length of ribbon needed. Use π = 3.14.
- 15.Work out the y-coordinate of the midpoint of the line segment joining (2, 4) and (8, 10).
Answer key
- (a) 250° — The back bearing (the bearing of A from B) differs from the bearing of B from A by exactly 180°. Because the given bearing, 070°, is less than 180°, add 180°: 070 + 180 = 250°, so the bearing of A from B is 250°. Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 110° comes from subtracting 180° from 070° and dropping the negative sign (070 − 180 = −110) instead of adding 180°. Choosing 160° comes from adding only 90° instead of 180° (070 + 90 = 160).
- (d) 21.2 m — Method: the cable is the hypotenuse of a right-angled triangle whose vertical side is the drop from the roof to the bracket and whose horizontal side is 15 m, so use Pythagoras' theorem. Working: the drop is 20 − 5 = 15 m, so c² = 15² + 15² = 225 + 225 = 450 and c = √450 = 21.213…, which is 21.2 m to 1 decimal place. Answer: 21.2 m. The distractors: 25.0 m comes from using the whole 20 m height of the roof as the vertical side and forgetting that the bracket is already 5 m up; 30.0 m comes from adding the two sides of the triangle, 15 + 15, instead of using Pythagoras' theorem; 15.0 m is the horizontal distance on its own, which would be the length of the cable only if it ran level.
- (c) 100.5 m — The curved part of a semicircular bend is half of a full circle's circumference. The full circumference would be 2 × 3.14 × 32 = 200.96 m, and half of that is 200.96 ÷ 2 = 100.48 m, which rounds to 100.5 m. Choosing 201.0 m uses the FULL circumference, forgetting to halve it for a semicircle. Choosing 50.2 m halves the radius as well as taking a semicircle, using 3.14 × 16 = 50.24 m instead of the correct radius of 32 m. Choosing 64.0 m uses the diameter, 2 × 32 = 64, as if it were the curved length, ignoring π and the semicircle shape entirely.
- (b) 8.64 m — The real length is 240 times the model length: 3.6 × 240 = 864 cm. Converting to metres, 864 cm ÷ 100 = 8.64 m. The distractor 864 m comes from finding the length correctly in centimetres but forgetting to convert to metres. The distractor 0.0864 m comes from dividing by 100 a second time, converting 864 cm to metres twice over (864 ÷ 10 000) instead of once. The distractor 86.4 m comes from converting centimetres to metres by dividing by 10 instead of 100.
- (c) A line has no endpoints; a segment has two — A line extends without end in both directions, whereas a line segment is the part of a line between two specific fixed endpoints, so 'a line has no endpoints; a segment has two' is correct. 'A line has two endpoints; a segment has none' reverses these two definitions, so it is wrong. 'A line segment is always curved' is wrong because a line segment is straight, not curved, and does not extend infinitely. 'A line segment is a closed shape' is wrong because a line segment is a straight length between two points, not a polygon.
- (a) 28 cm — Method: the perimeter is the total distance round the outside, and a rhombus has four sides of equal length, so the perimeter is 4 × the side length. Working: 4 × 7 = 28. Answer: 28 cm. The distractors: 14 cm comes from 2 × 7, adding only one pair of sides and forgetting that a rhombus has two pairs; 49 cm comes from working out 7 × 7, which is the calculation for the area of a square rather than a distance round the outside; 11 cm comes from adding the side length to the number of sides, 7 + 4, instead of multiplying them.
- (b) 25 cm² — Method: a square has four equal sides, so divide the perimeter by 4 to recover the side length, then square that side to get the area. Working: 20 ÷ 4 = 5 cm, then 5 × 5 = 25. Answer: 25 cm². The distractors: 400 cm² comes from squaring the perimeter itself, 20 × 20, treating the 20 cm as though it were the side length; 100 cm² comes from dividing the perimeter by 2 rather than by 4, giving a side of 10 cm, and squaring that; 5 cm is the side length, from stopping as soon as the perimeter has been divided by 4 and never squaring it, which also leaves a length where an area was asked for.
- (d) 1.1 — Method: multiply the drawing length by the scale factor to get the real length, then convert to the units asked for. Working: 4.4 cm × 25 = 110 cm = 1.1 m. A student who answers 4.4 has forgotten to use the scale at all. A student who answers 110 has correctly worked out the real length in centimetres but forgotten to convert it to metres. A student who answers 11 has used a scale factor of 2.5 instead of 25 by misreading the scale. Answer: 1.1 m.
- (d) SAS — Method: a congruence condition is named by the parts that are given equal and the order in which they sit round the triangle, so count the sides and the angles first. Working: AB = DE and AC = DF are two pairs of equal sides, and the equal angle at A and D lies between AB and AC, so the given parts read side, included angle, side. Answer: SAS. The distractors: SSS needs three pairs of equal sides, and the third pair, BC and EF, is not given — it follows from the proof rather than being part of it; ASA reads the two equal sides as two equal angles, swapping which facts are which; RHS applies only when the triangles contain a right angle and the equal pair includes the hypotenuse, and nothing here says the angle at A is 90°.
- (a) $\binom{5}{−6}$ — The vector is (image − original) in each coordinate: (2 − (−3), −1 − 5) = (5, −6). $\binom{−5}{6}$ comes from working out original − image instead of image − original. $\binom{5}{6}$ gets the x-component right but makes a sign error on the y-component. $\binom{−5}{−6}$ gets the y-component right but makes a sign error on the x-component, working out −3 − 2 = −5 instead of 2 − (−3) = 5.
- (b) SAS (two sides and the included angle) — PQ = ST and QR = TU are two pairs of matching sides, and the angle between them (angle Q and angle T) is 90° in both triangles — two sides and the angle between them are equal, so the triangles are congruent by SAS, using only the measurements given. RHS needs the hypotenuses to be known equal; here only the two legs are given, so you would first have to work out each hypotenuse by Pythagoras' theorem — extra working the question rules out. SSS has the same problem: the third side of each triangle is not given, only calculable. ASA needs two angles and the side between them, but here it is two sides and the angle between them that are given, not two angles.
- (d) Similar, by SAS — Method: read off whether the given sides are equal or only in the same ratio, and where the given angle sits. Sides in proportion point to similarity; sides equal in length would be needed for congruence. Working: AB ÷ DE = AC ÷ DF gives two pairs of corresponding sides in the same ratio, and the equal angle at A and D lies between AB and AC in the first triangle and between DE and DF in the second, so it is the included angle. Two pairs of sides in proportion with the included angle equal is the SAS condition for similarity. Answer: similar, by SAS. The distractors: 'Similar, by AA' quotes a condition that needs two pairs of equal angles, while only one pair is given here; 'Congruent, by SAS' reads AB ÷ DE = AC ÷ DF as AB = DE and AC = DF, turning a statement about proportion into one about equal lengths; 'Congruent, by SSS' makes that same misreading and adds an assumption that the third pair of sides is equal too, which nothing in the question says.
- (b) (2, 6) — To add column vectors, add the top numbers together and add the bottom numbers together, separately: top = 3 + (−1) = 2, bottom = 2 + 4 = 6, giving (2, 6). A candidate who writes the top and bottom numbers of the correct answer in the wrong order gives (6, 2). A candidate who subtracts instead of adds, working out 3 − (−1) = 4 and 2 − 4 = −2, gives (4, −2). A candidate who adds the top numbers correctly but subtracts the bottom numbers by mistake, working out 2 − 4 = −2, gives (2, −2). The correct answer is (2, 6).
- (a) 62.8 cm — The ribbon goes once around the circular cross-section, so its length equals the circumference: 2πr = 2 × 3.14 × 10 = 62.8 cm.
- (b) 7 — Method: each coordinate of a midpoint is the mean of the matching pair of coordinates, so the y-coordinate of the midpoint depends on the two y-coordinates alone. Working: the y-coordinates are 4 and 10, so the mean is (4 + 10) ÷ 2 = 14 ÷ 2 = 7. Answer: 7. The distractors: 5 comes from working out the x-coordinate of the midpoint, (2 + 8) ÷ 2 = 5, and writing that down in place of the y-coordinate the question asked for; 3 comes from halving the difference of the y-coordinates, (10 − 4) ÷ 2 = 3, which is half the vertical gap rather than a position; 14 comes from adding the two y-coordinates and forgetting to halve the total.
Build your own mix at the worksheet builder.