Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A train leaves Leeds at 08:47 and arrives in London at 11:05. Work out how long the journey takes.
- 2.A support strut for a shed roof is in the shape of a right-angled triangle. The two shorter sides of the strut are 5 m and 9 m. Work out the length of the sloping strut (the hypotenuse). Give your answer correct to 1 decimal place.
- 3.A carpenter cuts two triangular metal brackets for a shelf. Bracket P has sides of 12 cm, 16 cm and 20 cm. Bracket Q has sides of 16 cm, 20 cm and 12 cm, listed in a different order. Before fitting them as a matching pair, the carpenter wants to check they are exactly the same shape and size. Which of the following correctly justifies this?
- 4.Two circles are drawn with the same centre but different radii. Write down the term used to describe this pair of circles.
- 5.The angle between north and a footpath is 35°, measured clockwise from north. What is the three-figure bearing of the footpath?
- 6.Two angles are complementary. One of them is 35°. Work out the size of the other angle.
- 7.A sector of a circle has radius 8 cm and takes up three-quarters of the full circle. Work out the perimeter of the sector, in terms of π.
- 8.A wooden cube has edges of length 4 cm. Work out the total surface area of the cube.
- 9.A chord is drawn across a circle, dividing the circle into two regions. Write down the name of one of these two regions.
- 10.In triangle ABC the angle at C is 90°, AC = 8 cm and the angle at A is 30°. Work out the length of BC. Give your answer to 1 decimal place.
- 11.A parallelogram has a base of 4 cm and a perpendicular height of 17 cm. Work out the area of the parallelogram.
- 12.A solid is built from centimetre cubes standing on a table. Seen from the front, the left-hand column is 2 cubes high, the middle column is 2 cubes high and the right-hand column is 1 cube high. Work out how many squares make up the front elevation.
- 13.A rectangle has vertices at (2, 1), (9, 1), (9, 5) and (2, 5). Work out the area of the rectangle.
- 14.Two straight paths cross at a junction in a park. One of the angles between them, measured with a protractor, is 76°. What is the size of the angle immediately next to it on a straight line?
- 15.A water tank holds 2.5 m³. Work out this volume in cm³.
Answer key
- (d) 2 h 18 min — Method: count on from the departure time in whole steps, rather than subtracting the two clock readings as if they were ordinary decimals. Working: from 08:47 to 09:00 is 13 minutes; from 09:00 to 11:00 is 2 hours; from 11:00 to 11:05 is a further 5 minutes. 13 + 5 = 18, so the journey lasts 2 hours and 18 minutes. Answer: 2 h 18 min. Subtracting as decimals gives 11.05 − 8.47 = 2.58 and the false reading 2 h 58 min, because an hour holds 60 minutes and not 100. Taking the minutes the wrong way round, 47 take away 5, gives 2 h 42 min. Counting the hours as 11 − 8 = 3 and then attaching the 18 minutes gives 3 h 18 min.
- (d) 10.3 m — By Pythagoras' theorem, the hypotenuse = √(5² + 9²) = √(25 + 81) = √106 = 10.29...≈ 10.3 m. "106 m" is the value under the square root sign, correct as far as it goes but with the final square root step left out. "14 m" comes from adding the two shorter sides, 5 + 9, instead of using Pythagoras' theorem at all. "10.2 m" comes from rounding 10.29...m down to 10.2 instead of correctly rounding it up to 10.3.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (d) Concentric circles — Method: focus on what the two circles have in common — their centre, not their size. Working: both circles share exactly the same centre point but have different radii, which is the defining feature of this pair of circles. A student who answers congruent circles has confused 'same centre' with 'same size', but congruent circles simply have equal radii and need not share a centre. A student who answers tangential circles has confused circles that touch each other at one point with ones that share a centre. A student who answers similar circles has used the general term for the same shape at different sizes, missing the specific 'same centre' fact. Answer: concentric circles.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (b) 55° — Method: complementary angles are a pair that add up to 90°, so subtract the known angle from 90°. Working: 90 − 35 = 55. Answer: 55°. The distractors: 145° comes from subtracting from 180°, which is the rule for supplementary angles and not for complementary ones; 325° comes from subtracting from 360°, the total of the angles at a point; 90° is the total that the pair must make, written down in place of the missing angle.
- (a) 12π + 16 cm — A three-quarter sector's perimeter is the curved arc plus the two straight radii that close the shape. The full circumference is 2 × π × 8 = 16π cm, and three-quarters of that is 12π cm. Adding the two straight radii, 8 cm each, gives 12π + 16 cm. Leaving out the straight edges gives just 12π cm. Using one-quarter of the circumference, the piece left over rather than the piece asked for, gives 4π + 16 cm. Adding only one radius instead of two gives 12π + 8 cm.
- (a) 96 cm² — Method: a cube has six identical square faces, so the total surface area is six times the area of one face. Working: one face has area 4 × 4 = 16 cm², and 6 × 16 = 96. Answer: 96 cm². The distractors: 16 cm² is the area of a single face, from stopping before multiplying by the six faces; 64 cm³ comes from working out the volume, 4 × 4 × 4, which is a different measure and carries a different unit; 24 cm² comes from multiplying the six faces by the edge length, 6 × 4, instead of by the area of a face.
- (a) segment — A chord cuts a circle into two regions, and each of these regions is called a segment. A sector is a different region, bounded by two radii and an arc, not by a chord. An arc is a curved part of the circumference, a length, not a region. A radius is a straight line from the centre to the edge, also a length, not a region.
- (d) 4.6 cm — Method: BC is opposite the 30° angle and AC is next to it, so the ratio that links the two is tan θ = opposite ÷ adjacent. Working: tan 30° = BC ÷ 8, so BC = 8 × tan 30° = 4.6188…, which is 4.6 to 1 decimal place. Answer: 4.6 cm. The distractors: 13.9 cm comes from dividing by tan 30° instead of multiplying by it; 4.0 cm comes from using sin 30°, which treats the 8 cm side as the hypotenuse when it is the side next to the 30° angle; 6.9 cm comes from using cos 30° in place of tan 30°, which gives the wrong pair of sides.
- (d) 68 cm² — Method: the area of a parallelogram is base × perpendicular height. Working: 4 × 17 = 68. Answer: 68 cm². The distractors: 34 cm² comes from halving the product, which is the rule for a triangle and not for a parallelogram; 42 cm comes from treating the two given lengths as the sides of the shape and working out a perimeter, 2 × (4 + 17), which is a length and not an area; 21 cm comes from adding the base and the height, 4 + 17, instead of multiplying them.
- (c) 5 — The front elevation shows one square for every cube visible from the front, column by column: the left-hand column is 2 cubes high, so it contributes 2 squares; the middle column is 2 cubes high, so it contributes 2 more; the right-hand column is 1 cube high, so it contributes 1. The total is 2 + 2 + 1 = 5 squares. "6" comes from drawing a full 3 by 2 rectangle, treating every column as if it reached the greatest height. "4" comes from losing a square from one of the two tall columns, counting 2 + 1 + 1. "3" comes from counting one square per column — the width of the solid — and ignoring the heights altogether.
- (b) 28 — The width of the rectangle is the difference in x-coordinates, 9 − 2 = 7, and the height is the difference in y-coordinates, 5 − 1 = 4. The area is width × height = 7 × 4 = 28. 22 comes from using the perimeter formula, 2 × (7 + 4), instead of the area formula. 35 comes from multiplying 7 by 5 instead of 4, misreading one of the y-coordinates. 63 comes from multiplying 9 by 7, using an x-coordinate instead of the height.
- (b) 104 — Method: angles on a straight line add up to 180°. Working: 180° − 76° = 104°. A student who answers 76 has mistaken this for the vertically opposite angle, which is equal, rather than the adjacent angle on a straight line. A student who answers 90 has wrongly assumed the two paths must be perpendicular. A student who answers 14 has subtracted 76° from 90° instead of from 180°. Answer: 104°.
- (b) 2 500 000 cm³ — Method: a volume conversion uses the length factor three times, once for each dimension. Working: 1 m = 100 cm, so a cube of side 1 m is a cube of side 100 cm, and 100 × 100 × 100 = 1 000 000, giving 1 m³ = 1 000 000 cm³. Then 2.5 × 1 000 000 = 2 500 000. Answer: 2 500 000 cm³. Using the plain length factor 100 gives 250 cm³. Using 1000, which is the factor that turns cubic metres into litres, gives 2500 cm³. Using 10 000, which is the factor that belongs to square metres and square centimetres, gives 25 000 cm³.
Build your own mix at the worksheet builder.