Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A trapezium-shaped allotment plot has two parallel sides that face each other, and two sloping sides that are equal in length (an isosceles trapezium). One of the angles next to the shorter parallel side is 118°. Work out the angle next to the other end of the same shorter parallel side.
- 2.A carpenter cuts two triangular metal brackets for a shelf. Bracket P has sides of 12 cm, 16 cm and 20 cm. Bracket Q has sides of 16 cm, 20 cm and 12 cm, listed in a different order. Before fitting them as a matching pair, the carpenter wants to check they are exactly the same shape and size. Which of the following correctly justifies this?
- 3.Sam says: '3.2 litres is the same as 320 ml, because you multiply by 100.' Which statement about Sam's claim is correct?
- 4.Triangle XYZ has angle X = 90°. Angle Y = 34°. Work out angle Z.
- 5.Freya is designing a triangular flower bed. Two of its corners have equal angles, and the angle at the third corner is 40°. Work out the size of one of the two equal corner angles.
- 6.A sector of a circle has an angle of 150°. Work out what fraction of the circle's area the sector is.
- 7.The diagram shows a solid resting on its side on a table. Work out which shape is its plan view, the view looking straight down from above.
- 8.A rhombus has all four sides equal in length. Write down how many pairs of parallel sides a rhombus has.
- 9.A survey team measures the angle between two fences with a protractor and gets a reading of 254°. What type of angle is this?
- 10.A ship's radar shows a lighthouse at the point (12, −4) on a grid measured in nautical miles. The ship is at (2, 5). The ship sails along the vector that takes it directly to the lighthouse, then sails along that same vector again. Work out the ship's final position.
- 11.A postcard measuring 10 cm by 15 cm is enlarged by a scale factor of 2 to make a poster. Work out the area of the poster, in cm².
- 12.In triangle XYZ, the side opposite vertex X is labelled using the standard lowercase-letter convention. Which label is correct?
- 13.A kitchen scale is marked in equal divisions of 20 g. The pointer rests three divisions past the 400 g mark. Work out the reading on the scale.
- 14.Two metal window frames are checked before installation. Frame A has edges of 40 cm and 65 cm, with a marked angle of 35° at the far end of the 65 cm edge, away from where the two given edges meet. Frame B has matching edges of 40 cm and 65 cm, with a matching 35° angle in the same position. The fitter wants to know if these measurements alone guarantee the two frames are congruent. What should the fitter be told?
- 15.A straight fence is 5 m long. Describe the shape of the region made up of every point on the ground within 2 m of any part of the fence.
Answer key
- (d) 118° — In an isosceles trapezium, the two angles next to the same parallel side are equal, because the sloping sides are equal in length. So the angle at the other end of the shorter parallel side also equals 118°.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (b) Wrong: 1 litre = 1000 ml, so 3.2 l = 3200 ml. — 1 litre = 1000 ml, so 3.2 litres = 3.2 × 1000 = 3200 ml — Sam is wrong because he multiplied by 100 instead of 1000. Saying Sam is correct accepts the wrong multiplier. Saying Sam is wrong only because 3.2 should be rounded first misses the real error, which is the multiplier, not the starting number. Saying '1 litre is 100 ml' misstates the basic fact and blames the wrong part of Sam's working.
- (a) 56° — The angles of a triangle add up to 180°. Add the two known angles: 90° + 34° = 124°. Subtract from 180°: 180° − 124° = 56°.
- (a) 70° — Method: the three angles of a triangle add up to 180°, so take the known corner away from 180° to find what is left for the other two corners, then share that remainder equally because those two corners are equal. Working: 180 − 40 = 140, and the two equal corners share that 140° between them, so 140 ÷ 2 = 70. Answer: 70°. The distractors: 140° comes from stopping after 180 − 40 and offering the combined total of the two equal corners as though it were the size of one of them; 20° comes from halving the 40° corner that was given instead of halving the 140° that the other two corners have to share; 50° comes from 90 − 40, using the two acute angles of a right-angled triangle as the fixed total rather than the 180° angle sum of the whole triangle.
- (a) 5/12 — A sector's area is always the same fraction of the circle as its angle is of the full 360° turn. Here that fraction is 150 out of 360, which simplifies (divide both numbers by 30) to 5/12. Treating a full turn as 180° instead of 360° gives 5/6. Confusing the 150° given with the 180° of a half turn gives 1/2. Working out the fraction OUTSIDE the sector instead of inside it gives 7/12.
- (d) A rectangle — Method: to find the plan view, work out the outline traced when looking straight down onto the solid from directly above, not the outline shown in the angled sketch. Working: this solid has two identical flat round ends joined by one curved surface, and it is lying on its side rather than standing upright; viewed from above, the curved surface gives two straight edges running the full length of the solid, the width of the round ends apart, and each flat round end — seen edge-on from directly above — also becomes a straight edge of that same width, with no curve remaining. Four straight edges, with opposite sides equal and meeting at right angles, form a rectangle. Answer: a rectangle. The distractors: a circle comes from picturing the solid as if it were standing upright on one of its flat ends, giving the plan of an upright version instead of working out the plan of the solid as it actually lies. An oval comes from copying the foreshortened shape of a round end as it is drawn in the angled sketch, instead of working out the true shape seen from directly above, which has no such foreshortening. A rectangle with rounded ends comes from carrying the curve of the round ends over into the plan view, when in fact a flat round end viewed edge-on from directly above shows no curve at all, only a straight edge.
- (b) 2 — A rhombus is a special parallelogram, so opposite sides are parallel — that is two pairs of parallel sides. A quadrilateral with only one pair of parallel sides is a trapezium, not a rhombus, so 1 is wrong. A kite has 0 pairs of parallel sides, not a rhombus. There are only two pairs of opposite sides in a quadrilateral altogether, so 4 is not possible. The correct answer is 2.
- (c) Reflex — Method: compare the measured angle to the key boundaries of 90 degrees, 180 degrees and 360 degrees. Working: 254 degrees is greater than 180 degrees but less than 360 degrees, so it lies in the reflex range. A student who answers obtuse knows the angle is bigger than 90 degrees but has not realised it is also bigger than 180 degrees; they may have worked with the smaller angle at the same point, 360 - 254 = 106 degrees, instead of the reading given. A student who answers acute has misread the scale and taken the reading as 54 degrees rather than 254 degrees. A student who answers right has guessed a commonly recognised angle type without comparing the size properly. Answer: reflex.
- (b) (22, −13) — The vector from the ship to the lighthouse is (12, −4) − (2, 5) = (10, −9). Sailing along this vector twice from the start gives (2, 5) + 2 × (10, −9) = (2 + 20, 5 − 18) = (22, −13). '(12, −4)' stops after the ship reaches the lighthouse and ignores the second identical leg. '(−18, 23)' comes from finding the vector the wrong way round, as (2, 5) − (12, −4) = (−10, 9), and then doubling that. '(2, 5)' comes from adding the vector and then subtracting it again, wrongly cancelling the two legs instead of adding them.
- (d) 600 cm² — Enlarging by scale factor 2 makes the new dimensions 10 × 2 = 20 cm and 15 × 2 = 30 cm, so the poster's area = 20 × 30 = 600 cm². A pupil who scales the original area, 150 cm², by the scale factor itself instead of by its square gets 150 × 2 = 300 cm². A pupil who adds the scale factor to each dimension instead of multiplying gets (10 + 2) × (15 + 2) = 204 cm². A pupil who forgets to enlarge the postcard at all just uses the original area, 150 cm². The correct area of the poster is 600 cm².
- (c) x — By convention, the side opposite a vertex is labelled with the lowercase version of that vertex's letter, so the side opposite X is labelled x. y is the label for the side opposite Y, not X. z is the label for the side opposite Z, not X. X is the vertex's own uppercase letter — the convention specifically switches to lowercase for the side, so the uppercase letter on its own is not correct.
- (c) 460 g — Each division is 20 g, so three divisions past the mark is 3 × 20 = 60 g. Adding this to the 400 g mark gives 400 + 60 = 460 g. Treating each division as worth 1 g instead of 20 g gives 400 + 3 = 403 g. Working out the extra amount correctly but forgetting to add the 400 g mark gives just 60 g. Treating each division as worth 10 g instead of 20 g gives 400 + 30 = 430 g.
- (a) No — the angle is not between the two sides — Method: check whether the given angle sits between the two given sides. Working: the 35° angle is marked away from the corner where the 40 cm and 65 cm edges meet, so it is not the included angle — this is SSA, which is not one of the four basic congruence conditions, so it does not guarantee congruence. Options: 'Yes — SAS' wrongly treats any two sides plus any angle as SAS, without checking the angle's position; 'Yes — SSS' wrongly counts the angle as if it were a third side; 'No — only two sides measured' is not the real reason, since SAS itself only needs two sides, so this reasoning is beside the point. Answer: no, the angle is not between the two sides.
- (a) a rounded rectangle: 5 m by 4 m with semicircular ends — Points within 2 m of the straight part of the fence form a rectangle running the 5 m length of the fence and 4 m wide (2 m on each side); points within 2 m of each END of the fence, beyond that rectangle, form a semicircle of radius 2 m there, since the nearest point of the fence to them is just that one end. Together this gives a rounded, stadium-shaped region. "a rectangle, 9 m by 4 m" extends the rectangle by 2 m at each end instead of rounding it, wrongly including corner points that are actually more than 2 m from every part of the fence. "a circle of radius 2 m" treats the whole 5 m fence as a single point. "a rectangle, 5 m by 2 m" uses 2 m as the full width instead of the distance on EACH side, so it only covers one side of the fence.
Build your own mix at the worksheet builder.