Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A rectangular notice board measures 150 cm by 80 cm. Work out its area in m².
- 2.A bead starts at position (2, −1) on a grid, in centimetres. It is moved by the column vector u, with top number 3 and bottom number 5, and then moved by the column vector v, with top number −7 and bottom number 2. Work out the coordinates of the bead's final position.
- 3.A solid metal sphere has a radius of 5 cm. It is melted down and recast into a solid cylinder with the same radius, 5 cm. Work out the height of the cylinder, so that its volume equals the volume of the sphere. Use π = 3.14 and give your answer correct to 1 decimal place.
- 4.A trapezium has parallel sides of 5 cm and 11 cm, and a perpendicular height of 4 cm. Work out the area of the trapezium.
- 5.A cylinder has a radius of 3 cm and a height of 10 cm. Using π = 3.14, work out the volume of the cylinder. Give your answer to the nearest whole number of cubic centimetres.
- 6.An angle measures 108°. Write down the name given to an angle of this size.
- 7.Three angles meet at a single point on one side of a straight line. Two of the angles are 48° and 65°. Work out the third angle.
- 8.A carpenter cuts two triangular metal brackets for a shelf. Bracket P has sides of 12 cm, 16 cm and 20 cm. Bracket Q has sides of 16 cm, 20 cm and 12 cm, listed in a different order. Before fitting them as a matching pair, the carpenter wants to check they are exactly the same shape and size. Which of the following correctly justifies this?
- 9.Triangle T has a vertex at (2, 1). It is enlarged by a scale factor of 3, centre (0, 0). Work out the coordinates of the image of this vertex.
- 10.A robotic arm's tip starts at the point (12.5, −4.25) on a grid measured in centimetres. It moves by the vector to pick up a component, then by the vector to place it. Work out the coordinates of the tip after both moves.
- 11.In the RHS congruence condition, which three facts must be true about two triangles for RHS to prove they are congruent?
- 12.A ladder of length 7 m leans against a vertical wall. The foot of the ladder is 3 m from the base of the wall. Work out how high up the wall the ladder reaches. Give your answer correct to 1 decimal place.
- 13.A locus consists of all the points that are the same perpendicular distance from two parallel lines 6 cm apart. Describe this locus.
- 14.A vertical flagpole casts a shadow 6 m long at the same time as a 1.2 m vertical post casts a shadow 1.8 m long. The flagpole and the post are both vertical, and the triangles formed by each object, its shadow, and the sun's ray are similar. Work out the height of the flagpole.
- 15.Two angles lie on a straight line. One angle is 118°. Which reason correctly explains why the other angle is 62°?
Answer key
- (d) 1.2 m² — Method: an area in square metres needs lengths in metres, so convert first and then multiply. Working: 100 cm = 1 m, so 150 cm = 1.5 m and 80 cm = 0.8 m, and the area = 1.5 × 0.8 = 1.2 m². Answer: 1.2 m². The same result comes from working in centimetres: 150 × 80 = 12 000 cm², and a square metre is a square of side 100 cm, so 100 × 100 = 10 000 cm² make one square metre and 12 000 ÷ 10 000 = 1.2. Dividing the 12 000 cm² by 100 instead, as though a square metre held only 100 square centimetres, gives 120 m²; dividing by 1000 gives 12 m². Working out the perimeter rather than the area gives 1.5 + 0.8 + 1.5 + 0.8 = 4.6, which is a length and not an area.
- (d) (−2, 6) — Method: add the top numbers of both vectors to the starting x-coordinate, and the bottom numbers of both vectors to the starting y-coordinate. Working: x-coordinate 2 + 3 + (−7) = −2; y-coordinate −1 + 5 + 2 = 6. Answer: (−2, 6). A candidate who only applies vector u and forgets v gets (5, 4). A candidate who only applies vector v and forgets u gets (−5, 1). A candidate who works out the combined vector u + v but forgets to add it to the starting point gets (−4, 7).
- (d) 6.7 cm — Volume of the sphere = (4/3)πr³ = (4/3) × 3.14 × 5³ = (4/3) × 3.14 × 125 = 523.33 cm³. Set this equal to the cylinder's volume πr²h: 523.33 = 3.14 × 25 × h = 78.5h. Divide: h = 523.33 ÷ 78.5 = 6.667 cm, which rounds to 6.7 cm. 1.7 cm comes from using the sphere's diameter, 10 cm, as the cylinder's radius: 523.33 ÷ (3.14 × 10²) = 1.7 cm.
- (a) 32 cm² — Area of a trapezium = 1/2 × (sum of parallel sides) × height = 1/2 × (5 + 11) × 4 = 1/2 × 16 × 4 = 32 cm². (64 cm² comes from forgetting to halve the product; 44 cm² comes from using only the longer parallel side, 11 × 4, instead of both parallel sides; 20 cm² comes from adding all three given lengths together, 5 + 11 + 4, instead of using the area formula.)
- (d) 283 cm³ — Volume of a cylinder = πr²h. Using π = 3.14: V = 3.14 × 3² × 10 = 3.14 × 9 × 10 = 282.6, which rounds to 283 cm³. A pupil who uses the diameter, 6 cm, instead of the radius gets 3.14 × 6² × 10 = 1130.4 ≈ 1130 cm³. A pupil who forgets to square the radius gets 3.14 × 3 × 10 = 94.2 ≈ 94 cm³. A pupil who uses the circumference formula 2πr instead of πr² gets 2 × 3.14 × 3 × 10 = 188.4 ≈ 188 cm³. The correct volume is 283 cm³.
- (d) An obtuse angle — Method: compare the angle with the two markers that separate the angle names, a right angle at 90° and a straight line at 180°. Working: 108° is greater than 90° and smaller than 180°, so it lies between the right angle and the straight line. Answer: an obtuse angle. The distractors: an acute angle is one below 90°, and is chosen by a candidate who checks only that 108° is less than 180°; a reflex angle is one above 180°, and is chosen by a candidate who checks only that 108° is more than 90° and then takes the largest category; a right angle is exactly 90°, and is chosen by reading 108° as near enough to 90° instead of comparing it properly.
- (c) 67° — Angles on a straight line add up to 180°. Add the two known angles: 48° + 65° = 113°. Subtract from 180°: 180° − 113° = 67°.
- (a) Yes - SSS, the three side lengths all match — Bracket P's sides (12 cm, 16 cm, 20 cm) can each be matched to one of Bracket Q's sides (16 cm, 20 cm, 12 cm) — the same three lengths, just listed differently — so the brackets are congruent by SSS. SAS is wrong here because no angle is stated for either bracket, only three sides. The order the sides are listed in does not matter for SSS — only whether the SET of three lengths matches, and it does, so 'listed in a different order' is not a reason to say no. Nothing extra is needed: SSS proves congruence from side lengths alone, without any angles, so it can be determined.
- (d) (6, 3) — For an enlargement centred at the origin, each coordinate is multiplied by the scale factor: (2, 1) → (2 × 3, 1 × 3) = (6, 3). ((5, 4) comes from adding the scale factor to each coordinate instead of multiplying; (6, 1) comes from multiplying only the x-coordinate by 3 and leaving the y-coordinate unchanged; (2, 3) comes from multiplying only the y-coordinate by 3 and leaving the x-coordinate unchanged.)
- (d) (11, 0.75) — Add the moves to the starting point one component at a time. x: 12.5 + (−3.75) + 2.25 = 11; y: −4.25 + 6.5 + (−1.5) = 0.75, giving (11, 0.75). (8.75, 2.25) stops after the first move only and never applies the second vector. (6.5, 3.75) comes from subtracting the second vector instead of adding it. (0.75, 11) comes from swapping the final x-coordinate and y-coordinate.
- (b) Right angle, equal hypotenuse, one more side — RHS requires a right angle in each triangle, equal hypotenuses, and one further pair of equal sides, so 'right angle, equal hypotenuse, one more side' is correct. 'Right angle, hypotenuse, one more angle' is wrong because it asks for an extra equal angle instead of an extra equal side, which RHS does not check. 'Two sides and the angle between them' describes SAS, not RHS, so it is wrong. 'Right angle and all three sides equal' describes SSS with an extra right-angle condition, asking for more information than RHS actually needs, so it is wrong.
- (c) 6.3 m — By Pythagoras' theorem, the height = √(7² − 3²) = √(49 − 9) = √40 = 6.32...≈ 6.3 m. "6.4 m" rounds 6.32...m up to 6.4 instead of correctly rounding it down to 6.3. "4.0 m" comes from subtracting the two given lengths directly, 7 − 3 = 4, instead of subtracting their squares. "10.0 m" comes from adding the two given lengths, 7 + 3 = 10, instead of using Pythagoras' theorem at all.
- (a) a line parallel to both, 3 cm from each — Being equidistant from two parallel lines 6 cm apart means being exactly halfway between them all along their length, tracing out a third line, parallel to both, at 3 cm from each — half of the 6 cm gap. "a line parallel to both, 6 cm from each" repeats the full gap instead of halving it, which puts those points past one of the lines entirely. "a circle of radius 3 cm, centred midway" applies to a locus equidistant from a single fixed POINT, not from two parallel lines running the full length. "the perpendicular bisector of the gap" crosses the gap at right angles and meets each line at only one point — it is not the whole locus, which runs parallel to the lines, not across them.
- (b) 4 m — The two triangles are similar, so height ÷ shadow is the same for both objects. For the post, height ÷ shadow = 1.2 ÷ 1.8. Flagpole height = 6 × (1.2 ÷ 1.8) = 4 m. A student who multiplies the flagpole's shadow by the post's height without applying the ratio gets 6 × 1.2 = 7.2 m. A student who assumes a constant DIFFERENCE between shadow and height instead of a constant ratio finds the post's shadow minus height, 1.8 − 1.2 = 0.6 m, then subtracts that from the flagpole's shadow to get 6 − 0.6 = 5.4 m.
- (b) angles on a straight line add up to 180° — 118° and 62° add up to 180°, matching the fact that angles on a straight line always add up to 180° — that is the reason the second angle is 62°. Angles round a point add up to 360° is a different fact, used for angles surrounding a single point, not two angles on a line. Vertically opposite angles are equal would make the second angle 118° too, not 62°. Angles in a triangle add up to 180° is a true fact, but it applies to the three angles inside a triangle, not two angles on a straight line.
Build your own mix at the worksheet builder.