Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A shape is translated by the vector and then by the vector . Write down the single column vector that has the same effect as those two translations together.
- 2.State whether the line segment joining A(−4, 3) and B(2, 6) is horizontal, vertical or neither, and give a reason for your answer.
- 3.A patio plan states: 'Side AB of the patio is parallel to side DC, and AB is longer than DC. Sides BC and AD are not parallel to each other and are not equal in length.' The four sides measure AB = 5.1 m, BC = 3.2 m, DC = 2.8 m and AD = 4.5 m. The tiler needs to order edging strip only for the sides that are not parallel to any other side. What total length of edging strip, in metres, should the tiler order?
- 4.A hiker walks due west. What is the three-figure bearing for this direction?
- 5.A solid has 5 faces, 9 edges and 6 vertices. Two of its faces are triangles and the other three are rectangles. Which solid is it?
- 6.A solid is built from five centimetre cubes, standing side by side on a table in a single straight row. Looking down from directly above (the plan view), how many squares are visible?
- 7.A rectangular photograph is 12 cm long and 5 cm wide. Work out the perimeter of the photograph.
- 8.The diagram shows the plan, front elevation and side elevation of a solid. Which of these solids matches all three views?
- 9.A ladder rests against a wall, making an angle of 60° with the ground. The ladder is 2 m long. Using the exact value of sin 60°, work out how high up the wall the ladder reaches, giving your answer in centimetres.
- 10.A dog is tied by a lead 4 m long to a fixed ring on a straight garden wall. The wall extends much further than the lead can reach in both directions, and the dog cannot cross through it. Describe the region the dog can reach.
- 11.A circular tabletop has a radius of 15 cm. Work out the area of the tabletop. Use π = 3.14. Give your answer to 1 decimal place.
- 12.The bearing of a harbour B from a ferry's position A is 260°. What is the bearing of A from B?
- 13.Here are four trigonometric ratios of special angles. Write down the one that does not have a value.
- 14.A zip wire is fixed at an angle of 50° to the horizontal, running from a high platform down to the ground. The zip wire itself, from the platform to the ground, is 12 m long. Work out the horizontal distance covered by the zip wire. Give your answer correct to 1 decimal place.
- 15.In quadrilateral ABCD, side AB is parallel to side DC. Which statement correctly uses geometric notation to show this?
Answer key
- (a) $\binom{-5}{-4}$ — Method: one translation followed by another is a single translation, and the two vectors are added: top to top, bottom to bottom. Working: across, 4 − 9 = −5; up, −7 + 3 = −4. Answer: $\binom{-5}{-4}$. Subtracting the second vector instead of adding it gives 13 on top and −7 − 3 = −10 underneath. Adding the top numbers correctly but subtracting the bottom ones gives −10 underneath with −5 on top. Adding 4 and 9 as though both were positive and then keeping the minus sign of the larger gives −13 on top.
- (b) Neither, because both coordinates differ — A line segment is horizontal only when both points share the same y-coordinate, and vertical only when both points share the same x-coordinate. Here A has x-coordinate −4 and B has x-coordinate 2, which differ, and A has y-coordinate 3 and B has y-coordinate 6, which also differ, so the segment is neither horizontal nor vertical. Every point has a y-coordinate and an x-coordinate, so simply having one is not a reason for the line to be horizontal or vertical — both of those wrong reasons ignore that the coordinates must match, not just exist. The x-coordinates do increase from A to B, but an increasing x-coordinate on its own describes a slope, not a horizontal line.
- (a) 7.7 m — AB is parallel to DC, so those two sides are each parallel to another side. BC and AD are stated to be not parallel to each other, so neither one is parallel to any other side — these are the two sides that need edging. Adding these: 3.2 + 4.5 = 7.7 m, so 7.7 m is correct. 7.6 m comes from an arithmetic slip when adding 3.2 and 4.5. 15.4 m comes from doubling the correct total, mistakenly assuming edging strip is needed along both faces of each side. 4.5 m comes from using only the longer of the two non-parallel sides and forgetting to add the shorter one.
- (b) 270° — Bearings are measured clockwise from north (000°). Due north is 000°, due east is 090°, due south is 180° and due west is 270°. Choosing 090° gives the bearing for due east, not west. Choosing 180° gives the bearing for due south. Choosing 000° gives the bearing for due north.
- (a) Triangular prism — Count the given properties against each solid. A triangular prism has 5 faces (2 triangular ends + 3 rectangular sides), 9 edges and 6 vertices — this matches exactly, so the solid is a triangular prism. A square-based pyramid also has 5 faces, but 8 edges and 5 vertices, and only one face is a square rather than three rectangles — the edge and vertex counts don't match. A cuboid has 6 faces, 12 edges and 8 vertices, none of which match the numbers given. A tetrahedron has 4 faces, all triangles, with 6 edges and 4 vertices — too few faces, and no rectangular faces at all.
- (a) 5 — Looking straight down on a row of 5 cubes standing side by side, each cube contributes exactly one square to the view from above, since the cubes do not overlap and none is hidden behind another — so the plan shows 5 squares in a row. "1" comes from treating the whole row as a single block instead of counting each cube. "10" comes from doubling the count, perhaps by also counting a front elevation's squares alongside the plan's. "25" comes from squaring the number of cubes (5 × 5) instead of counting them.
- (c) 34 cm — Method: a rectangle has two lengths and two widths, so the perimeter is 2 × (length + width). Working: 12 + 5 = 17, then 2 × 17 = 34. Answer: 34 cm. The distractors: 17 cm comes from adding one length and one width and stopping, which is only half of the way round; 24 cm comes from doubling the length alone, 2 × 12, and leaving the two widths out; 60 cm² comes from working out 12 × 5, which is the area of the photograph and carries a squared unit because two lengths have been multiplied.
- (b) A triangular prism standing on its triangular end — Method: a rectangular elevation with no sloping sides means the solid keeps the same cross-section all the way from the bottom to the top; work out which solid, standing the right way up, has a triangular cross-section that stays that shape as you go higher. Working: a triangular prism standing upright on its triangular end has a triangle as its plan view, and because the cross-section is constant all the way up, both the front and side elevations are plain rectangles. Answer: a triangular prism standing on its triangular end. The distractors: a triangle-based pyramid standing on its triangular base does give a triangle as its plan view, but its cross-section shrinks towards the apex, so its front and side elevations come to a point and are triangles, not rectangles. A cuboid standing on a rectangular face is wrong because its plan view is a rectangle, not a triangle. A triangular prism lying on one of its rectangular faces is wrong because it is then the triangular end that faces the side, so its plan view is a rectangle and one of its elevations is a triangle.
- (c) 100√3 cm — The height is opposite the 60° angle, so height = 2 × sin 60° = 2 × √3/2 = √3 m. Converting to centimetres: √3 m = 100√3 cm. '√3 cm' forgets to convert the answer from metres to centimetres. '200√3 cm' comes from mis-recalling sin 60° as √3 instead of √3/2, dropping the denominator of the exact value: 2 × √3 = 2√3 m = 200√3 cm. '50√3 cm' comes from halving the ladder's length before multiplying by sin 60°, instead of using the full 2 m.
- (b) A semicircle of radius 4 m, away from the wall. — Every point the dog can reach is at most 4 m from the fixed ring, so without any wall the region would be a full circle of radius 4 m. The wall runs straight through the ring and blocks the dog from crossing it, and since the wall extends further than the lead in both directions, exactly half of that circle is cut off — leaving a semicircle of radius 4 m on the side of the wall the dog is tied on. (A full circle of radius 4 m ignores that the wall blocks half of the region; a quarter circle of radius 4 m would only be correct if the ring were fixed at a corner where two walls met, not along a single straight wall; a rectangle 4 m wide along the wall ignores that the lead lets the dog swing round in a curve, not stay a fixed distance out from the wall.)
- (d) 706.5 cm² — Area of a circle = πr². With r = 15 cm and π = 3.14, area = 3.14 × 15² = 3.14 × 225 = 706.5 cm². A student who uses the circumference formula 2πr instead of the area formula gets 2 × 3.14 × 15 = 94.2 cm². A student who uses πr instead, forgetting to double, gets 3.14 × 15 = 47.1 cm². A student who squares the diameter (30 cm) instead of the radius gets 3.14 × 900 = 2826.0 cm².
- (a) 080° — The back bearing differs from the given bearing by 180°. Because 260° is greater than 180°, subtract 180°: 260 − 180 = 80°, so the bearing of A from B is 080°. Choosing 440° adds 180° instead of subtracting it, even though the result would be more than a full turn (260 + 180 = 440). Choosing 180° assumes the back bearing is always exactly 180°, ignoring the original bearing altogether. Choosing 100° comes from measuring the reflex angle the other way round the circle (360 − 260 = 100) instead of applying the 180° back-bearing rule.
- (b) tan 90° — Method: write each ratio as one side of a right-angled triangle divided by another, and look for the one whose bottom line can be zero. Working: sine and cosine are both a side divided by the hypotenuse, and a hypotenuse is never zero, so sin 90° = 1 and cos 90° = 0 are both perfectly good values — a value of zero is still a value. Tangent is the opposite side divided by the adjacent side. As the angle opens out towards 90° the adjacent side shrinks to nothing, and a division by zero has no result, while at the other end of the row the adjacent side is the long one and tan 0° = 0. Answer: tan 90°.
- (d) 7.7 m — The horizontal distance is adjacent to the 50° angle and the zip wire is the hypotenuse, so horizontal distance = 12 × cos 50° = 12 × 0.6428... = 7.71...≈ 7.7 m. "9.2 m" uses the sine ratio instead of cosine, 12 × sin 50° = 9.19...≈ 9.2 m, which actually finds the vertical drop of the zip wire, not the horizontal distance. "15.7 m" comes from dividing by the sine ratio instead of multiplying by the cosine ratio, 12 ÷ sin 50° = 15.66...≈ 15.7 m, both the wrong operation and the wrong ratio. "12.0 m" simply uses the length of the zip wire itself as the horizontal distance, ignoring the angle of 50° altogether.
- (c) AB ∥ DC — The symbol ∥ means ‘is parallel to’, so AB is parallel to DC is written AB ∥ DC. AB = DC would mean the two sides are equal in length, which is not what the question states. AB ⊥ DC would mean the two sides are perpendicular to each other. AB ∥ BC does use the parallel symbol, but it claims AB is parallel to BC — two sides that meet at vertex B, so they cannot be parallel; the question states AB is parallel to DC.
Build your own mix at the worksheet builder.