Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A square tile has sides of length 6 cm. Work out the area of the tile.
- 2.The point (4, −3) is reflected in the y-axis. Work out the coordinates of the image point.
- 3.A roof truss is shaped like an isosceles triangle resting on a horizontal ceiling joist. The truss's sloping edges are equal in length, and the angle at its apex is 40°. The ceiling joist continues in a straight line beyond the foot of the truss. Work out the angle between the truss's sloping edge and the extended joist, on the outside of the truss.
- 4.A straight line is drawn from the centre of a circle to a point on the circle. Write down the name of this line.
- 5.A straight line crosses a pair of parallel lines. One of the co-interior (allied) angles is 118°. Work out the size of the other co-interior angle.
- 6.A landscaper marks out two triangular flower beds using stakes and a tape measure. Bed 1 has two edges of 5 m and 7 m, meeting at a corner with a marked angle of 60° between them. Bed 2 has edges of 5 m and 7 m, meeting at a corner also marked at 60° between them. The landscaper wants to check the two beds will be exactly the same size and shape using only these three measurements. Which condition proves the two beds are congruent?
- 7.A photograph is 10 cm wide and 15 cm tall. It is enlarged to make a similar poster that is 40 cm wide. The poster costs £0.80 per centimetre of its height to print, based on its full height. Work out the cost of printing the poster.
- 8.A party hat is in the shape of a cone with a base radius of 6 cm and a slant height of 10 cm. Work out the curved surface area of the party hat. Use π = 3.14 and the formula curved surface area = πrl.
- 9.Two sides of a triangle are 9 cm and 15 cm long. Write down which one of these lengths is possible for the third side.
- 10.In triangle PQR and triangle STU, PQ = ST, QR = TU and PR = SU. Write down the congruence condition that proves the two triangles are congruent.
- 11.A sprinkler waters a sector-shaped patch of a garden with radius 8 m and angle 90°. Work out the perimeter of the watered sector, to 1 decimal place. (Use π = 3.14.)
- 12.Write down which one of these statements about quadrilaterals is true.
- 13.A student says the reverse of the translation vector is . Write down the correct reverse translation vector.
- 14.A shape is translated by the vector , and one vertex of the image is at the point (1, 6). The original shape is instead translated by the vector . Work out the coordinates of the image of that same vertex under this second translation.
- 15.A chocolate bar is a prism. Its cross-section is a triangle with a base of 6 cm and a perpendicular height of 5 cm, and the bar is 12 cm long. Work out the volume of the bar.
Answer key
- (c) 36 cm² — Method: the area of a square is its side length multiplied by itself. Working: 6 × 6 = 36. Answer: 36 cm². The distractors: 24 cm comes from working out the perimeter, 4 × 6, which is a length and not an area; 12 cm comes from doubling the side, 6 × 2, instead of squaring it; 18 cm² comes from halving the product, (6 × 6) ÷ 2, using the rule for the area of a triangle.
- (d) (−4, −3) — Reflecting in the y-axis keeps the y-coordinate the same and changes the sign of the x-coordinate, so (4, −3) maps to (−4, −3). "(4, 3)" changes the sign of the y-coordinate instead, which is what happens when reflecting in the x-axis. "(−4, 3)" changes the sign of both coordinates, which is the result of a rotation of 180° about the origin, not a reflection in the y-axis. "(3, −4)" swaps the two coordinates around instead of reflecting either of them.
- (a) 110° — The truss is isosceles, so its two base angles are equal; since the three angles of the triangle add up to 180° and the apex is 40°, each base angle is (180 − 40) ÷ 2 = 70°. The angle between the sloping edge and the joist, extended beyond the base of the truss, sits on a straight line with that 70° base angle, and angles on a straight line add up to 180°, so the required angle is 180 − 70 = 110°. "70°" comes from stopping after finding the base angle and giving it directly, without also using the straight-line fact to find the angle on the OUTSIDE of the truss. "140°" comes from doubling the base angle instead of using the straight-line fact. "20°" comes from taking half of the apex angle (40° ÷ 2), mistaking it for the required angle instead of properly using the triangle's angle sum.
- (b) The radius — Method: each of the four names describes a line in a fixed position relative to the circle, so match the description in the question against those positions. Working: the line described has one end at the centre and its other end on the circle. A chord joins two points that both lie on the circle, so it is ruled out. A diameter joins two points on the circle by passing through the centre, so it is twice as long as the line described. A tangent touches the circle at exactly one point and never reaches the centre. The line with one end at the centre and one end on the circle is a radius. Answer: The radius. The distractors: The diameter comes from remembering only that the line involves the centre, and not noticing that it stops there instead of carrying on to the far side; The chord comes from seeing one end on the circle and assuming both ends are; The tangent comes from matching the phrase 'a point on the circle' to the line that touches at exactly one point, ignoring that a tangent never reaches the centre.
- (b) 62 — Method: co-interior (allied) angles between parallel lines add up to 180°. Working: 180 − 118 = 62. Answer: 62°. A candidate who treats co-interior angles as equal, like corresponding angles, gives 118. A candidate who uses 360° instead of 180°, working out 360 − 118, gets 242. A candidate who subtracts as if the angles were complementary, working out 118 − 90, gets 28.
- (b) SAS — Method: check which condition matches two sides and the angle between them, since that is what has been measured for each bed. Working: the 60° angle is marked at the corner where the 5 m and 7 m edges meet, so it is the included angle — this is two Sides and the included Angle, SAS. Options: SSS would need a third side measured, but only two edges are known; ASA would need two angles and the side between them, but only one angle is measured; RHS needs a right angle, and 60° is not a right angle. Answer: SAS.
- (d) £48 — Scale factor = new width ÷ original width = 40 ÷ 10 = 4. Poster height = 15 × 4 = 60 cm. Cost = 60 × £0.80 = £48. (£12 comes from forgetting to scale the height at all, and pricing the original 15 cm height; £15.20 comes from adding the scale factor 4 to the height instead of multiplying by it; £3 comes from dividing the height by the scale factor instead of multiplying by it.)
- (a) 188.4 cm² — Curved surface area of a cone = πrl. With r = 6 cm, l = 10 cm and π = 3.14, curved surface area = 3.14 × 6 × 10 = 188.4 cm². A student who uses the cylinder's curved surface area formula, 2πrl, instead of the cone's gets 2 × 3.14 × 6 × 10 = 376.8 cm². A student who uses the circle-area formula πr² instead of πrl gets 3.14 × 36 = 113.04 cm². A student who multiplies r × l but leaves out π entirely gets 6 × 10 = 60 cm².
- (d) 10 cm — For a triangle to exist, any two sides must add up to more than the third side. 9 + 10 = 19 > 15, and 15 − 9 = 6 < 10, so 10 cm satisfies the triangle inequality. The other lengths fail: 6 cm gives 9 + 6 = 15, which is not more than 15; 24 cm and 26 cm are each at least as large as 9 + 15 = 24.
- (d) SSS — All three pairs of corresponding sides are equal (PQ = ST, QR = TU, PR = SU), so the triangles are congruent by the SSS (side-side-side) condition. The distractor SAS would apply if two sides and the included angle were given equal, not three sides. The distractor ASA would apply if two angles and the included side were given equal. The distractor RHS would apply only for right-angled triangles with the hypotenuse and one other side equal.
- (a) 28.6 m — The perimeter of a sector is the two straight radii plus the curved arc. This sector's 90° angle is one quarter of a full turn, so its arc length is one quarter of the full circle's circumference. The full circumference is 2 × 3.14 × 8 = 50.24 m, and one quarter of that is 50.24 ÷ 4 = 12.56 m. Add the two 8 m radii: 12.56 + 8 + 8 = 28.56 m, which rounds to 28.6 m. Choosing 12.6 m gives the arc length alone (rounded), forgetting the two straight edges of the sector. Choosing 20.6 m adds only one radius to the arc length instead of two, missing one of the two straight sides. Choosing 41.1 m comes from using the diameter, 16 m, as if it were the radius when working out the arc length (2 × 3.14 × 16 = 100.48, one quarter of which is 25.12), then adding the two correct 8 m radii (25.12 + 8 + 8 = 41.12).
- (a) Every square is a rectangle — Method: test each statement against the definitions. A rectangle is a quadrilateral with four right angles and opposite sides equal; a square is a quadrilateral with four right angles and all four sides equal; a rhombus is a quadrilateral with all four sides equal. Working: a square has four right angles and its opposite sides are equal, so every square meets the definition of a rectangle and the statement that every square is a rectangle is true. Answer: every square is a rectangle. The distractors: the claim that every rectangle is a square reverses the inclusion, and fails for any rectangle whose length and width differ; the claim that every rhombus is a rectangle treats four equal sides as enough, and drops the right-angle condition — a tilted rhombus has no right angles; the claim that every rectangle is a rhombus reads 'opposite sides equal' as though it meant 'all four sides equal'.
- (c) $\binom{-4}{9}$ — The reverse of a translation negates both components, so the reverse of $\binom{4}{-9}$ is $\binom{-4}{9}$. $\binom{4}{9}$ is the student's mistake — only the bottom number has been negated, and the top number was left unchanged. $\binom{-4}{-9}$ makes the opposite error, negating only the top number. $\binom{4}{-9}$ is simply the original vector, unchanged.
- (d) (11, −2) — First undo the original translation to find the vertex on the original shape: (1 − (−8), 6 − 3) = (9, 3). Then apply the second vector to that original vertex: (9 + 2, 3 + (−5)) = (11, −2). (3, 1) comes from applying the second vector to the image point (1, 6) instead of to the original vertex — (1 + 2, 6 + (−5)) = (3, 1). (7, 8) comes from subtracting the second vector from the original vertex (9, 3) instead of adding it — (9 − 2, 3 − (−5)) = (7, 8). (11, 3) comes from applying only the x-component of the second vector to the original vertex and leaving the y-coordinate unchanged.
- (a) 180 cm³ — Method: the volume of a right prism is the area of its cross-section multiplied by its length, and the area of a triangle is half the base multiplied by the perpendicular height. Working: the cross-section has area (6 × 5) ÷ 2 = 15 cm², and 15 × 12 = 180. Answer: 180 cm³. The distractors: 360 cm³ comes from taking the cross-section as 6 × 5 = 30 and never halving it, which measures the rectangle around the triangular face rather than the face itself; 66 cm³ comes from adding the base and the perpendicular height and halving, (6 + 5) ÷ 2 = 5.5, which is the trapezium rule used where the triangle rule is needed, and then multiplying by the 12 cm length; 15 cm³ comes from working out the triangular cross-section correctly and stopping there, so the 12 cm length is never used and an area is handed in as a volume.
Build your own mix at the worksheet builder.