Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.The column vector r has top number 2 and bottom number 6. Which of these column vectors is parallel to r?
- 2.Triangle ABC has AB = 5 cm, BC = 7 cm and CA = 9 cm. Triangle DEF has DE = 5 cm, EF = 7 cm and FD = 9 cm. Which condition proves the two triangles are congruent?
- 3.A builder lays a low wall made from identical bricks. The diagram shows the plan of the wall's footprint on a grid, where each square is one brick. The wall is built up to a height of 4 bricks everywhere. Work out the total number of bricks used.
- 4.A line segment is measured with a ruler and found to be 6.5 cm long. What is this length in millimetres?
- 5.In triangle ABC and triangle DEF, AB = DE, angle ABC = angle DEF and BC = EF. Write down the congruence condition that proves the two triangles are congruent.
- 6.Compasses are opened to exactly half the length of AB, and arcs are drawn centred at A and at B, to construct the perpendicular bisector of AB. Why does this fail?
- 7.Two similar triangles have lengths in the ratio 3 : 4. The perimeter of the smaller triangle is 24 cm. Work out the perimeter of the larger triangle.
- 8.A scale drawing of a rectangular lawn uses a scale of 1 : 125. On the drawing, the lawn measures 4 cm by 2.4 cm. Work out the perimeter of the real lawn, in metres.
- 9.A chocolate bar is a prism. Its cross-section is a triangle with a base of 6 cm and a perpendicular height of 5 cm, and the bar is 12 cm long. Work out the volume of the bar.
- 10.Freya is designing a triangular flower bed. Two of its corners have equal angles, and the angle at the third corner is 40°. Work out the size of one of the two equal corner angles.
- 11.In an isosceles triangle each of the two base angles is 46°. Work out the size of the angle at the apex.
- 12.A circular table mat has diameter 20 cm. Yasmin has a 70 cm length of ribbon and sews it around the edge of the mat with no overlap. Using π = 3.14, work out how much ribbon is left over after going around the mat once.
- 13.A scale drawing uses a scale of 1 : 60. A path on the drawing is measured as 9.8 cm long. What is the real length of the path, in metres, to 1 decimal place?
- 14.The point M(3, 8) is translated by the vector . Write down the coordinates of the image of M.
- 15.The point (0, −5) lies on one of the two coordinate axes. Write down which axis this is.
Answer key
- (a) (3, 9) — Two column vectors are parallel only when one is the other multiplied by a single scalar — both numbers scaled by the same factor with the same sign. r has top:bottom ratio 2:6, which simplifies to 1:3. (3, 9) has ratio 3:9, also 1:3, so (3, 9) = 1.5 × r: it is parallel to r. (6, 2) swaps the top and bottom numbers of r, giving ratio 6:2 (3:1), which is not the same ratio. (2, 3) halves only the bottom number of r, giving ratio 2:3, not 1:3. (−2, 6) changes the sign of only the top number of r, giving ratio −2:6, which no longer matches 2:6 throughout.
- (d) SSS - three sides equal — All three pairs of corresponding sides are equal in length (5 cm, 7 cm and 9 cm in both triangles), so the triangles are congruent by SSS. SAS needs an angle to be given as well as two sides, but no angle is given here. ASA needs two angles and the side between them, but no angles are given at all. RHS needs a right angle and the hypotenuse, but no angle is stated to be a right angle.
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
- (a) 65 — There are 10 millimetres in every centimetre, so to convert from cm to mm, multiply by 10: 6.5 × 10 = 65 mm. A candidate who forgets to convert at all writes down the original number, 6.5. A candidate who multiplies by 100 instead of 10, confusing cm-to-mm with m-to-cm, gets 650. A candidate who divides by 10 instead of multiplying gets 0.65. The correct length in millimetres is 65.
- (b) SAS — Two pairs of matching sides are equal (AB = DE and BC = EF) and the angle between them is equal (angle ABC = angle DEF), which is exactly the Side-Angle-Side congruence test: SAS. SSS is wrong because only two pairs of sides are given, not three. ASA is wrong because only one angle is given, and it sits between the two sides rather than the side sitting between two angles. RHS is wrong because no right angle is mentioned in either triangle.
- (b) The arcs only meet exactly on AB, not above or below it. — With a radius of exactly half of AB, the arc centred at A and the arc centred at B each reach precisely to the midpoint of AB, so they meet only at that one point, on the line AB itself — there are no two intersection points above and below the line to join, so the perpendicular bisector cannot be drawn. (The claim that this radius is always too short to draw any arc is wrong, since a radius equal to half of AB is a perfectly valid, positive length for a compass arc; the claim that the radius must equal the full length of AB is wrong — a longer radius than half of AB would also work, it does not have to equal AB exactly; the claim that the arcs would not cross line AB at all is wrong, since they do cross it — that is exactly the problem, they meet only on it.)
- (c) 32 cm — Method: a perimeter is lengths added together, so it scales by the length scale factor itself, which is 4 ÷ 3 going from the smaller triangle to the larger one — not by its square. Working: 24 ÷ 3 = 8, and 8 × 4 = 32. Answer: 32 cm. The distractors: 18 cm comes from multiplying by 3 ÷ 4, scaling from the larger triangle down to the smaller one; 25 cm comes from adding the difference between the parts of the ratio, 4 − 3 = 1, to the perimeter; 8 cm comes from dividing by 3 and stopping there, before multiplying by 4.
- (d) 16 — Method: use the scale to find the real length and width separately, then use the perimeter formula. Working: real length = 4 cm × 125 = 500 cm = 5 m; real width = 2.4 cm × 125 = 300 cm = 3 m; perimeter = 2 × (5 + 3) = 16 m. A student who answers 8 has added the real length and width but forgotten to double the total for the perimeter. A student who answers 1600 has correctly worked out the perimeter in centimetres but forgotten to convert it to metres. A student who answers 500 has only converted the length to real centimetres and stopped there, ignoring the width and the perimeter step. Answer: 16 m.
- (a) 180 cm³ — Method: the volume of a right prism is the area of its cross-section multiplied by its length, and the area of a triangle is half the base multiplied by the perpendicular height. Working: the cross-section has area (6 × 5) ÷ 2 = 15 cm², and 15 × 12 = 180. Answer: 180 cm³. The distractors: 360 cm³ comes from taking the cross-section as 6 × 5 = 30 and never halving it, which measures the rectangle around the triangular face rather than the face itself; 66 cm³ comes from adding the base and the perpendicular height and halving, (6 + 5) ÷ 2 = 5.5, which is the trapezium rule used where the triangle rule is needed, and then multiplying by the 12 cm length; 15 cm³ comes from working out the triangular cross-section correctly and stopping there, so the 12 cm length is never used and an area is handed in as a volume.
- (a) 70° — Method: the three angles of a triangle add up to 180°, so take the known corner away from 180° to find what is left for the other two corners, then share that remainder equally because those two corners are equal. Working: 180 − 40 = 140, and the two equal corners share that 140° between them, so 140 ÷ 2 = 70. Answer: 70°. The distractors: 140° comes from stopping after 180 − 40 and offering the combined total of the two equal corners as though it were the size of one of them; 20° comes from halving the 40° corner that was given instead of halving the 140° that the other two corners have to share; 50° comes from 90 − 40, using the two acute angles of a right-angled triangle as the fixed total rather than the 180° angle sum of the whole triangle.
- (d) 88° — Method: the three angles add up to 180°, and here it is the two equal base angles that are known, so take both of them away from 180°. Working: the two base angles come to 2 × 46° = 92°, and 180° − 92° = 88°. Answer: 88°. The distractors: 134° comes from subtracting only one base angle, 180° − 46°, and forgetting that there are two of them; 92° comes from doubling the base angle and stopping there, which is the two base angles together rather than the apex; 46° comes from assuming that all three angles of the triangle are equal to the one that is given.
- (a) 7.2 cm — The distance around the mat is the circumference, π × diameter = 3.14 × 20 = 62.8 cm. Yasmin started with 70 cm, so the ribbon left over is 70 − 62.8 = 7.2 cm. 62.8 cm is the circumference itself, the amount of ribbon used, not what is left over. 50 cm comes from subtracting the diameter instead of the circumference: 70 − 20 = 50. 20 cm is simply the diameter of the mat and involves no calculation with the ribbon length at all.
- (a) 5.9 — The real length is 9.8 × 60 = 588 cm. Converting to metres, by dividing by 100, gives 5.88 m, which rounds to 5.9 m to 1 decimal place. A candidate who rounds 5.88 down instead of up gets 5.8 m. A candidate who forgets to convert from centimetres to metres gets 58.8. A candidate who divides by 60 instead of multiplying gets 0.16, to 2 decimal places. The real length, to 1 decimal place, is 5.9 m.
- (c) (−2, 10) — To translate M(3, 8) by $\binom{−5}{2}$, add −5 to the x-coordinate and 2 to the y-coordinate: (3 + (−5), 8 + 2) = (−2, 10). (5, 3) comes from swapping the two components of the vector before applying them. (−2, 8) applies only the x-component and forgets to add the y-component. (3, 10) applies only the y-component and forgets to add the x-component.
- (b) y-axis — A point lies on the y-axis when its x-coordinate is 0; here the x-coordinate of (0, −5) is 0, so it lies on the y-axis. "x-axis" would need the y-coordinate to be 0 instead, which is not the case here. "the origin" is the single point (0, 0), not a whole axis, and this point is not (0, 0). "both axes" would only be true for the origin itself, where both coordinates are 0.
Build your own mix at the worksheet builder.