Printable · GCSE Foundation · ages 14-16
Geometry and measures worksheet — GCSE Foundation
Fifteen questions across the geometry and measures statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Geometry and measures worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- 1.A vertical line passes through the point (5, 2). Write down the equation of this line.
- 2.Two similar flags have widths in the ratio 2 : 5. The width of the smaller flag is 8 cm. Work out the width of the larger flag.
- 3.The point M(3, 8) is translated by the vector . Write down the coordinates of the image of M.
- 4.An isosceles trapezium has exactly one pair of parallel sides, and its two non-parallel sides are equal in length. How many lines of symmetry does it have?
- 5.The angle between north and a footpath is 35°, measured clockwise from north. What is the three-figure bearing of the footpath?
- 6.Write down the number of lines of symmetry a rhombus has.
- 7.Two sides of a triangle are 20 cm and 8 cm long. Write down which one of these lengths is possible for the third side.
- 8.A polygon has 12 straight sides. What is the mathematical name for this polygon?
- 9.Compasses are opened to exactly half the length of AB, and arcs are drawn centred at A and at B, to construct the perpendicular bisector of AB. Why does this fail?
- 10.Triangle ABC is drawn. The interior angle bisectors from vertices A and B are constructed and meet at point I inside the triangle. Which statement about point I must be true?
- 11.The curved part of a circle's circumference, between two points on the circle, has its own name. Write down this name.
- 12.A solid rubber ball has a radius of 3 cm. Work out the volume of the ball. Use π = 3.14.
- 13.A cake recipe takes 135 minutes from start to finish. Write this time as hours and minutes.
- 14.Two straight paths cross at a junction in a park. One of the angles between them, measured with a protractor, is 76°. What is the size of the angle immediately next to it on a straight line?
- 15.A builder lays a low wall made from identical bricks. The diagram shows the plan of the wall's footprint on a grid, where each square is one brick. The wall is built up to a height of 4 bricks everywhere. Work out the total number of bricks used.
Answer key
- (b) x = 5 — Every point on a vertical line has the same x-coordinate, so the equation of a vertical line through (5, 2) is x = 5. "y = 5" mixes up the coordinates, using the x-value of 5 to write a y-equation. "y = 2" is the equation of the horizontal line through (5, 2), not the vertical one. "x = 2" uses the correct letter but the wrong coordinate, the y-value of 2 instead of the x-value of 5.
- (a) 20 cm — The scale factor from the smaller flag to the larger flag is 5 ÷ 2 = 2.5, so the larger width is 8 × 2.5 = 20 cm. The distractor 3.2 cm comes from using the ratio the wrong way round, 8 × 2 ÷ 5 = 3.2. The distractor 11 cm comes from adding the difference between the ratio numbers (5 − 2 = 3) to the given width, 8 + 3 = 11. The distractor 40 cm comes from multiplying by 5 without dividing by 2 first, 8 × 5 = 40.
- (c) (−2, 10) — To translate M(3, 8) by $\binom{−5}{2}$, add −5 to the x-coordinate and 2 to the y-coordinate: (3 + (−5), 8 + 2) = (−2, 10). (5, 3) comes from swapping the two components of the vector before applying them. (−2, 8) applies only the x-component and forgets to add the y-component. (3, 10) applies only the y-component and forgets to add the x-component.
- (d) 1 — An isosceles trapezium has one line of symmetry, running through the midpoints of the two parallel sides. 0 would be true for a scalene trapezium, whose non-parallel sides are unequal, but this trapezium's non-parallel sides are equal, so it is symmetrical. 2 is the number of lines of symmetry of a rectangle, not a trapezium. 4 comes from wrongly applying the 'number of sides equals number of lines of symmetry' rule, which only holds for REGULAR polygons — a trapezium is not regular.
- (a) 035° — A bearing is measured clockwise from north, so an angle of 35° clockwise from north is a bearing of 035° (written with three figures). Choosing 325° measures the angle anticlockwise instead of clockwise (360 − 35 = 325). Choosing 215° adds 180° to the angle, mixing this up with a back-bearing calculation (35 + 180 = 215). Choosing 350° reorders the digits of 035, writing the ones digit before the tens digit by mistake.
- (b) 2 — A rhombus has two lines of symmetry — along each of its two diagonals.
- (d) 15 cm — Method: any two sides of a triangle must together be longer than the third, so the third side must be longer than the difference of the two given sides and shorter than their sum. Working: the difference is 20 − 8 = 12 cm and the sum is 20 + 8 = 28 cm, so the third side must be between 12 cm and 28 cm, and 15 cm lies inside that range. Answer: 15 cm. The distractors: 12 cm is exactly the difference, so the three lengths would lie flat along a straight line and never close into a triangle; 5 cm is shorter than the difference — 5 + 8 = 13 cm cannot reach across the 20 cm side — and is chosen by candidates who check no lower limit at all; 30 cm is longer than the sum of the other two, so those two sides could never meet, and it is chosen by candidates who check no upper limit.
- (c) Dodecagon — Deca- means 10, so Decagon names a 10-sided polygon, two sides short of this one, so it is wrong. Hendeca- means 11, one side short of 12, so Hendecagon is also wrong. Icosa- means 20, double the number of sides given here, so Icosagon is wrong too. Dodeca- means 12, so Dodecagon correctly names this polygon.
- (b) The arcs only meet exactly on AB, not above or below it. — With a radius of exactly half of AB, the arc centred at A and the arc centred at B each reach precisely to the midpoint of AB, so they meet only at that one point, on the line AB itself — there are no two intersection points above and below the line to join, so the perpendicular bisector cannot be drawn. (The claim that this radius is always too short to draw any arc is wrong, since a radius equal to half of AB is a perfectly valid, positive length for a compass arc; the claim that the radius must equal the full length of AB is wrong — a longer radius than half of AB would also work, it does not have to equal AB exactly; the claim that the arcs would not cross line AB at all is wrong, since they do cross it — that is exactly the problem, they meet only on it.)
- (c) I is the same distance from all three sides. — The angle bisector from A is the locus of points equidistant from sides AB and AC, and the angle bisector from B is the locus of points equidistant from sides AB and BC. Point I lies on both bisectors, so I is equidistant from AB and AC, and also equidistant from AB and BC — meaning I is the same distance from all three sides. (Being the same distance from all three vertices instead describes the circumcentre, found from the perpendicular bisectors of the sides, not the angle bisectors; I being the midpoint of AB confuses the angle bisector construction with the perpendicular bisector of a side; I lying on side AC is wrong because the angle bisectors meet inside the triangle, not on one of its sides.)
- (a) arc — A curved part of a circle's circumference, between two points, is called an arc. A chord is the straight line joining those two points, not the curved part. A segment is the region enclosed between a chord and an arc, and a sector is the region enclosed between two radii and an arc — both segment and sector are regions, not curved lengths.
- (a) 113.04 cm³ — Method: the volume of a sphere is (4 ÷ 3) × π × r³. Cube the radius, multiply by π, then multiply by 4 and divide by 3. Working: r³ = 3³ = 27, then 3.14 × 27 = 84.78, then 84.78 × 4 = 339.12 and 339.12 ÷ 3 = 113.04. Answer: 113.04 cm³. The distractors: 84.78 cm³ comes from stopping at πr³ and leaving out the four thirds; 37.68 cm³ comes from squaring the radius instead of cubing it, (4 ÷ 3) × 3.14 × 9; 28.26 cm³ comes from using πr², the area of a circle, and labelling it as a volume.
- (c) 2 hours 15 minutes — Divide the total minutes by 60: 135 ÷ 60 = 2 remainder 15, so that is 2 hours 15 minutes. Treating 100 minutes as one hour, a metric-style mistake, gives 135 − 100 = 35, so 1 hour 35 minutes. Subtracting 60 twice to reach the 15 minutes left over, but losing count and recording only one of the two hours removed, gives 1 hour 15 minutes. Writing 135 ÷ 60 = 2.25 and then reading the '25' as minutes, instead of converting the 0.25 of an hour into 15 minutes, gives 2 hours 25 minutes.
- (b) 104 — Method: angles on a straight line add up to 180°. Working: 180° − 76° = 104°. A student who answers 76 has mistaken this for the vertically opposite angle, which is equal, rather than the adjacent angle on a straight line. A student who answers 90 has wrongly assumed the two paths must be perpendicular. A student who answers 14 has subtracted 76° from 90° instead of from 180°. Answer: 104°.
- (b) 28 — Method: total bricks = (number of squares in the footprint) × (the height of the wall in bricks). Working: the footprint has the row of 5 squares plus the 2 squares in the arm that stands out from the middle of that row, and they do not overlap, giving 5 + 2 = 7 squares; multiplying by the height of 4 bricks gives 7 × 4 = 28. Answer: 28. The distractors: 20 comes from using only the row of 5 and ignoring the arm (5 × 4). 24 comes from treating the bottom square of the arm as if it were one of the row's own squares, so the arm is counted as adding only 1 new square instead of 2 (5 + 1 = 6, then 6 × 4). 32 comes from counting the square of the row directly below the arm a second time as part of the arm (5 + 3 = 8, then 8 × 4).
Build your own mix at the worksheet builder.